S. Agliozzo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
S. Agliozzo has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Lucia Mancini
Slovenian National Building and Civil Engineering Institute
5 shared publications H. Klein
CNRS, Laboratoire de Cristallographie , BP 16, 38042 Grenoble , France
4 shared publications- J. Gastaldi
CRMCN-CNRS, Campus de Luminy, Case 913, 13288 Marseille Cedex 9, France
4 shared publications J. Härtwig
ESRF , BP 220, Grenoble , France
4 shared publications- José Baruchel
European Synchrotron Radiation Facility, 71 avenue des Martyrs, F-38043 Grenoble, France
4 shared publications E. Brunello
Laboratorio di Fisiologia, DBAG, Università degli Studi di Firenze, I-50019 Sesto, Fiorentino (FI), Italy
3 shared publications
Latest Publications
- Open Access
- 24 November 2006
- Published by Taylor & Francis in Philosophical Magazine
- Vol. 86 (36) , 5897-5908
Synchrotron X-ray diffractometry and imaging of strains and defects in icosahedral quasicrystal grains
In order to better understand the long-range propagation of quasicrystalline order, as well as quasicrystal stability, it is important to know if defects are generated in the quasicrystal grains during their growth. Previously, we studied the degree of perfection of about ten icosahedral quasicrystal grains of various alloys (Al–Pd–Mn, Al–Cu–Fe, Zn–Mg–Y), as grown or annealed, and we disclosed that some of them were much more perfect than the others. In this work we have concentrated on another slice of such a grain of the Al–Pd–Mn alloy. Similarly, we have performed an extensive synchrotron X-ray topographic investigation of strain and defects in this grain, combined with phase-contrast radiography and high resolution X-ray diffraction examinations. Very few two-lobe contrasts associated with pores and no loop-shaped contrasts were observed on the X-ray topographs, but straight line segments and band contrasts have been identified. Line segments could be considered as the result of the climbing of polygonal dislocation loops, as observed by TEM by Caillard and coworkers. This would indicate that most strains and defects observed in quasicrystal grains, at room temperature, are the result of stresses (external and internal) acting after growth.
- 24 November 2006
- Published by Taylor & Francis in Philosophical Magazine
- Vol. 86 (36) , 5897-5908
Open AccessSynchrotron X-ray diffractometry and imaging of strains and defects in icosahedral quasicrystal grains
In order to better understand the long-range propagation of quasicrystalline order, as well as quasicrystal stability, it is important to know if defects are generated in the quasicrystal grains during their growth. Previously, we studied the degree of perfection of about ten icosahedral quasicrystal grains of various alloys (Al–Pd–Mn, Al–Cu–Fe, Zn–Mg–Y), as grown or annealed, and we disclosed that some of them were much more perfect than the others. In this work we have concentrated on another slice of such a grain of the Al–Pd–Mn alloy. Similarly, we have performed an extensive synchrotron X-ray topographic investigation of strain and defects in this grain, combined with phase-contrast radiography and high resolution X-ray diffraction examinations. Very few two-lobe contrasts associated with pores and no loop-shaped contrasts were observed on the X-ray topographs, but straight line segments and band contrasts have been identified. Line segments could be considered as the result of the climbing of polygonal dislocation loops, as observed by TEM by Caillard and coworkers. This would indicate that most strains and defects observed in quasicrystal grains, at room temperature, are the result of stresses (external and internal) acting after growth.
- 15 August 2005
- Published by Elsevier in Journal of Crystal Growth
- Vol. 282 (1-2) , 228-235
Extended investigation of porosity in quasicrystals by synchrotron X-ray phase contrast radiography: Part II, in grains of other alloys and structures than AlPdMn
- 15 August 2005
- Published by Elsevier in Journal of Crystal Growth
- Vol. 282 (1-2) , 228-235
Extended investigation of porosity in quasicrystals by synchrotron X-ray phase contrast radiography: Part II, in grains of other alloys and structures than AlPdMn
- 20 June 2005
- Published by Elsevier in Journal of Crystal Growth
- Vol. 281 (2-4) , 623-638
Extended investigation of porosity in quasicrystals by synchrotron X-ray phase contrast radiography—I: In icosahedral AlPdMn grains
- 20 June 2005
- Published by Elsevier in Journal of Crystal Growth
- Vol. 281 (2-4) , 623-638
Extended investigation of porosity in quasicrystals by synchrotron X-ray phase contrast radiography—I: In icosahedral AlPdMn grains
- 15 September 2004
- Published by Wiley in Journal of Microscopy
- Vol. 216 (1) , 62-69
Quantification of micrometre‐sized porosity in quasicrystals using coherent synchrotron radiation imaging
Phase contrast radiography has been applied to investigate porosity in the bulk of quasicrystals. The pores act on X-rays as lenses, leading to drastic changes in the phase contrast images of pores. Depending on the recording conditions and pore features, different imaging regimes are accessed. The variation of the contrast makes the direct characterization of pores from image data, in terms of a precise determination of their size and volume, unreliable. The contrast in Fresnel diffraction images of pores was thus investigated with the support of numerical simulations. A phase retrieval procedure was carried out in order to obtain the correct information from the pore images.
- 15 September 2004
- Published by Wiley in Journal of Microscopy
- Vol. 216 (1) , 62-69
Quantification of micrometre‐sized porosity in quasicrystals using coherent synchrotron radiation imaging
Phase contrast radiography has been applied to investigate porosity in the bulk of quasicrystals. The pores act on X-rays as lenses, leading to drastic changes in the phase contrast images of pores. Depending on the recording conditions and pore features, different imaging regimes are accessed. The variation of the contrast makes the direct characterization of pores from image data, in terms of a precise determination of their size and volume, unreliable. The contrast in Fresnel diffraction images of pores was thus investigated with the support of numerical simulations. A phase retrieval procedure was carried out in order to obtain the correct information from the pore images.
- 6 April 2004
- Published by American Physical Society (APS) in Physical Review B
- Vol. 69 (14) , 144204
In situstudy of the annealing behavior of porosity in icosahedral Al-Pd-Mn quasicrystals using third generation x-ray synchrotron radiation imaging
The evolution of porosity in an icosahedral Al-Pd-Mn quasicrystal single grain has been studied in situ during an annealing at A drastic shrinkage of pores was observed and interpreted in the frame of a vacancy-mediated diffusion model.- 6 April 2004
- Published by American Physical Society (APS) in Physical Review B
- Vol. 69 (14) , 144204
In situstudy of the annealing behavior of porosity in icosahedral Al-Pd-Mn quasicrystals using third generation x-ray synchrotron radiation imaging
The evolution of porosity in an icosahedral Al-Pd-Mn quasicrystal single grain has been studied in situ during an annealing at A drastic shrinkage of pores was observed and interpreted in the frame of a vacancy-mediated diffusion model.- 3 May 2001
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 34 (10A) , A103-A108
Anomalous transmission of x-rays in quasicrystals
The perfection of one of the quasicrystal grains with the highest degrees of perfection was checked by means of x-ray diffractometry and x-ray topography. Full widths at half maximum of de-convoluted reflectivity curves were close to the theoretical values and a partial Borrmann effect was clearly visible in the measured reflection and transmission curves, whereas the topographs still showed rather strong intricate contrast, which means that strong deformations (defects) still exist in the grain. Consequently, dynamical effects like anomalous transmission were confirmed to exist in selected quasicrystalline grains, but even then the structural quality is still far from being `highly perfect'.
- 3 May 2001
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 34 (10A) , A103-A108
Anomalous transmission of x-rays in quasicrystals
The perfection of one of the quasicrystal grains with the highest degrees of perfection was checked by means of x-ray diffractometry and x-ray topography. Full widths at half maximum of de-convoluted reflectivity curves were close to the theoretical values and a partial Borrmann effect was clearly visible in the measured reflection and transmission curves, whereas the topographs still showed rather strong intricate contrast, which means that strong deformations (defects) still exist in the grain. Consequently, dynamical effects like anomalous transmission were confirmed to exist in selected quasicrystalline grains, but even then the structural quality is still far from being `highly perfect'.
- 3 May 2001
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 34 (10A) , A98-A102
The variation of quasicrystal defect contrast: how and why
We carried out a systematic study of typical defect contrasts in various single grains of icosahedral Al-Pd-Mn quasicrystals. White-beam topographs with different sample-to-detector distances and multiple-crystal topographs with different sample-to-detector distances, different working points on the rocking curve and different harmonic reflections have been recorded. Despite the extreme geometrical resolution at the ID19 topography beamline of the ESRF, white-beam topography showed reasonable (not blurred) contrast only for very short sample-to-detector distances ({<}4 cm). Depending on the defect type, in synchrotron multiple-crystal topography the defect contrast changes considerably as a function of the position of the working point on the rocking curve. Under the special conditions chosen, the dependence of contrast shape and size on the harmonic reflection used was rather weak.
- 3 May 2001
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 34 (10A) , A98-A102
The variation of quasicrystal defect contrast: how and why
We carried out a systematic study of typical defect contrasts in various single grains of icosahedral Al-Pd-Mn quasicrystals. White-beam topographs with different sample-to-detector distances and multiple-crystal topographs with different sample-to-detector distances, different working points on the rocking curve and different harmonic reflections have been recorded. Despite the extreme geometrical resolution at the ID19 topography beamline of the ESRF, white-beam topography showed reasonable (not blurred) contrast only for very short sample-to-detector distances ({<}4 cm). Depending on the defect type, in synchrotron multiple-crystal topography the defect contrast changes considerably as a function of the position of the working point on the rocking curve. Under the special conditions chosen, the dependence of contrast shape and size on the harmonic reflection used was rather weak.