Rainer Friedrich
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Rainer Friedrich has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Inga Mahle
Technische Universität München
2 shared publications C Wagner
Lehrstuhl für Fluidmechanik, Technische Universität München, Boltzmannstr. 15, 85747 Garching, Germany
1 shared publicationChristoph Schaupp
TU München
1 shared publication- Christoph Schaupp
Lehrstuhl für Aerodynamik und Strömungsmechanik , Technische Universität München , Garching , Germany
1 shared publication - Holger Foysi
Lehrstuhl für Strömungsmechanik , Universität Siegen , Siegen , Germany
1 shared publication - Joseph Mathew
Department of Aerospace Engineering, Indian Institute of Science, Bangalore 560012, India
1 shared publication
Latest Publications
- 1 January 2012
- Published by Taylor & Francis in Journal of Turbulence
- Vol. 13, N24
Transverse injection of a plane-reacting jet into compressible turbulent channel flow
- 1 January 2012
- Published by Taylor & Francis in Journal of Turbulence
- Vol. 13, N24
Transverse injection of a plane-reacting jet into compressible turbulent channel flow
- 5 October 2009
- Published by Springer Nature
- p. 877-880
Injection of a plane reacting jet into a supersonic turbulent channel flow
- 5 October 2009
- Published by Springer Nature
- p. 877-880
Injection of a plane reacting jet into a supersonic turbulent channel flow
- 1 January 2008
- Published by Taylor & Francis in Journal of Turbulence
- Vol. 9, N14
Effects of compressibility and heat release on entrainment processes in mixing layers
Characteristics of the process of entrainment in plane mixing layers, and the changes with compressibility and heat release, were studied using temporal DNS with simultaneous fluid packet tracking. Convective Mach numbers of the simulations are 0.15, 0.7 and 1.1. The Reynolds number is quite high (between 11 000 and 37 000 based on layer width and velocity difference), and is above the mixing transition. The study agrees with recent findings in round jets: first, engulfed fluid volume and its growth rate are both very small compared with the volume of the turbulent region and its growth rate, respectively. Secondly, most often, the process occurs close to the turbulent–nonturbulent boundaries. A new finding is that both compressibility and heat release retard the entrainment process so that it takes an O(1) time for vorticity or scalar levels to grow even after growth has been initiated. This delay is manifested as the fall in mixing layer growth rates as compressibility and heat release levels increase.
- 1 January 2008
- Published by Taylor & Francis in Journal of Turbulence
- Vol. 9, N14
Effects of compressibility and heat release on entrainment processes in mixing layers
Characteristics of the process of entrainment in plane mixing layers, and the changes with compressibility and heat release, were studied using temporal DNS with simultaneous fluid packet tracking. Convective Mach numbers of the simulations are 0.15, 0.7 and 1.1. The Reynolds number is quite high (between 11 000 and 37 000 based on layer width and velocity difference), and is above the mixing transition. The study agrees with recent findings in round jets: first, engulfed fluid volume and its growth rate are both very small compared with the volume of the turbulent region and its growth rate, respectively. Secondly, most often, the process occurs close to the turbulent–nonturbulent boundaries. A new finding is that both compressibility and heat release retard the entrainment process so that it takes an O(1) time for vorticity or scalar levels to grow even after growth has been initiated. This delay is manifested as the fall in mixing layer growth rates as compressibility and heat release levels increase.
- 27 February 2007
- Published by Wiley in ZAMM - Journal of Applied Mathematics and Mechanics / Zeitschrift für Angewandte Mathematik und Mechanik
- Vol. 87 (3) , 189-211
Compressible turbulent flows: Aspects of prediction and analysis
Compressible turbulent flows are an important element of high‐speed flight. Boundary layers developing along fuselage and wings of an aircraft and along engine compressor and turbine blades are compressible and mostly turbulent. The high‐speed flow around rockets and through rocket nozzles involves compressible turbulence and flow separation. Turbulent mixing and combustion in scramjet engines is another example where compressibility dominates the flow physics. Although compressible turbulent flows have attracted researchers since the fifties of the last century, they are not completely understood. Especially interactions between compressible turbulence and combustion lead to challenging, yet unsolved problems. Direct numerical simulation (DNS) and large‐eddy simulation (LES) represent modern powerful research tools which allow to mimic such flows in great detail and to analyze underlying physical mechanisms, even those which cannot be accessed by the experiment. The present lecture provides a short description of these tools and some of their numerical characteristics. It then describes DNS and LES results of fully‐developed channel and pipe flow and highlights effects of compressibility on the turbulence structure. The analysis of pressure fluctuations in such flows with isothermal cooled walls leads to the conclusion that the pressure‐strain correlation tensor decreases in the wall layer and that the turbulence anisotropy increases, since the mean density falls off relative to the incompressible flow case. Similar increases in turbulence anisotropy due to compressibility are observed in inert and reacting temporal mixing layers. The nature of the pressure fluctuations is however two‐facetted. While inert compressible mixing layers reveal wave‐propagation effects in the pressure and density fluctuations, compressible reacting mixing layers seem to generate pressure fluctuations that are controlled by the time‐rate of change of heat release and mean density variation as sources in the pressure Poisson equation rather than wave propagation phenomena. This opens new challenges to turbulence modellers and underlines the need to treat compressibility effects via the full Reynolds stress equations.
- 27 February 2007
- Published by Wiley in ZAMM - Journal of Applied Mathematics and Mechanics / Zeitschrift für Angewandte Mathematik und Mechanik
- Vol. 87 (3) , 189-211
Compressible turbulent flows: Aspects of prediction and analysis
Compressible turbulent flows are an important element of high‐speed flight. Boundary layers developing along fuselage and wings of an aircraft and along engine compressor and turbine blades are compressible and mostly turbulent. The high‐speed flow around rockets and through rocket nozzles involves compressible turbulence and flow separation. Turbulent mixing and combustion in scramjet engines is another example where compressibility dominates the flow physics. Although compressible turbulent flows have attracted researchers since the fifties of the last century, they are not completely understood. Especially interactions between compressible turbulence and combustion lead to challenging, yet unsolved problems. Direct numerical simulation (DNS) and large‐eddy simulation (LES) represent modern powerful research tools which allow to mimic such flows in great detail and to analyze underlying physical mechanisms, even those which cannot be accessed by the experiment. The present lecture provides a short description of these tools and some of their numerical characteristics. It then describes DNS and LES results of fully‐developed channel and pipe flow and highlights effects of compressibility on the turbulence structure. The analysis of pressure fluctuations in such flows with isothermal cooled walls leads to the conclusion that the pressure‐strain correlation tensor decreases in the wall layer and that the turbulence anisotropy increases, since the mean density falls off relative to the incompressible flow case. Similar increases in turbulence anisotropy due to compressibility are observed in inert and reacting temporal mixing layers. The nature of the pressure fluctuations is however two‐facetted. While inert compressible mixing layers reveal wave‐propagation effects in the pressure and density fluctuations, compressible reacting mixing layers seem to generate pressure fluctuations that are controlled by the time‐rate of change of heat release and mean density variation as sources in the pressure Poisson equation rather than wave propagation phenomena. This opens new challenges to turbulence modellers and underlines the need to treat compressibility effects via the full Reynolds stress equations.
- 1 January 2007
- Published by Taylor & Francis in Journal of Turbulence
- Vol. 8, N1-21
Turbulent mixing in temporal compressible shear layers involving detailed diffusion processes
- 1 January 2007
- Published by Taylor & Francis in Journal of Turbulence
- Vol. 8, N1-21
Turbulent mixing in temporal compressible shear layers involving detailed diffusion processes
- 31 October 1998
- Published by Elsevier in International Journal of Heat and Fluid Flow
- Vol. 19 (5) , 459-469
On the turbulence structure in solid and permeable pipes
- 31 October 1998
- Published by Elsevier in International Journal of Heat and Fluid Flow
- Vol. 19 (5) , 459-469
On the turbulence structure in solid and permeable pipes