C. J. Summers
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
C. J. Summers has a total of 53 co-authors. Here are the top co-authors by number of shared publications:
B. K. Wagner
Georgia Institute of Technology (United States)
8 shared publicationsW. Tong
Phosphor Technology Center of Excellence, Manufacturing Research Center, Georgia Institute of Technology, Atlanta, Georgia 30332-0560
7 shared publications- Wounjhang Park
Department of Electrical, Computer, and Energy Engineering, University of Colorado Boulder 1 , 425 UCB, Boulder, Colorado 80309
7 shared publications A. Parikh
Georgia Institute of Technology
3 shared publicationsB.K. Wagner
Phosphor Technology Center of Excellence, Manufacturing Research Center, Georgia Institute of Technology, Atlanta, Georgia 30332-0560, USA
3 shared publicationsT.K. Tran
Phosphor Technology Center of Excellence, Manufacturing Research Center, Georgia Institute of Technology, Atlanta, Georgia 30332-0560, USA
3 shared publications
Latest Publications
- 31 August 2006
- Published by SPIE-Intl Soc Optical Eng
- Vol. 6337, 633710
White photoluminescence from SiN x films prepared by plasma enhanced chemical vapor deposition
Intense visible blue to red emissions were obtained from SiNx thin films prepared by plasma enhanced chemical vapor deposition (PECVD) using SiH4 and NH3 as the source gases. A continuous blue shift of the photoluminescence (PL) peak from 660nm to 440nm was observed by increasing the NH3 flow rate from 20 to 150sccm, while the flow rate of N2 diluted 2% SiH4 was fixed at 650sccm. This controllable PL was attributed to the quantum confinement effect of Si quantum dots (QDs) which were formed during the deposition process and embedded in the SiNx films. White photoluminescence with multiple emission peaks was achieved for potential solid state lighting applications from multi-layered SiNx films by changing the SiH4/NH3 ratio during the deposition process. This was attributed to a combination of Si quantum dots with different sizes within the different layers. Surface texturing of the thin film samples was conducted by potassium hydroxide (0.56%) etching the (100) Si substrate for 3~40 min at 80°C before deposition. The reflectivity of the etched samples decreased with increasing etch time due to increased surface roughness. The extraction efficiency of light emission from the textured SiNx thin films was significantly improved, owing to a depression of the internal reflection and interference effects. In addition, the elimination of the multiple emission peaks by surface texturing significantly affected the color coordinates of the output spectrum.
- 31 August 2006
- Published by SPIE-Intl Soc Optical Eng
- Vol. 6337, 633710
White photoluminescence from SiN x films prepared by plasma enhanced chemical vapor deposition
Intense visible blue to red emissions were obtained from SiNx thin films prepared by plasma enhanced chemical vapor deposition (PECVD) using SiH4 and NH3 as the source gases. A continuous blue shift of the photoluminescence (PL) peak from 660nm to 440nm was observed by increasing the NH3 flow rate from 20 to 150sccm, while the flow rate of N2 diluted 2% SiH4 was fixed at 650sccm. This controllable PL was attributed to the quantum confinement effect of Si quantum dots (QDs) which were formed during the deposition process and embedded in the SiNx films. White photoluminescence with multiple emission peaks was achieved for potential solid state lighting applications from multi-layered SiNx films by changing the SiH4/NH3 ratio during the deposition process. This was attributed to a combination of Si quantum dots with different sizes within the different layers. Surface texturing of the thin film samples was conducted by potassium hydroxide (0.56%) etching the (100) Si substrate for 3~40 min at 80°C before deposition. The reflectivity of the etched samples decreased with increasing etch time due to increased surface roughness. The extraction efficiency of light emission from the textured SiNx thin films was significantly improved, owing to a depression of the internal reflection and interference effects. In addition, the elimination of the multiple emission peaks by surface texturing significantly affected the color coordinates of the output spectrum.
- 23 May 2006
- Published by American Physical Society (APS) in Physical Review B
- Vol. 73 (19) , 195117
Negative-index imaging by an index-matched photonic crystal slab
We report negative-index imaging at near infrared wavelengths using a photonic crystal (PC) with an effective index matched closely to air as the incident medium. A tapered waveguide is used to generate a point-sourcelike object field; and to probe the focusing behavior of the PC, an array of wide photonic wire waveguides is placed in the backplane of the PC lens. This represents a sampling of the image field at the rate of one data point per free space wavelength . For TM polarization, a well-defined spot is observed, while the TE polarization lies near the photonic band edge and exhibits spreading and low transmission. We also investigate the wavelength dependence and experimentally show the performance of the negative index lens as a function of frequency.- 23 May 2006
- Published by American Physical Society (APS) in Physical Review B
- Vol. 73 (19) , 195117
Negative-index imaging by an index-matched photonic crystal slab
We report negative-index imaging at near infrared wavelengths using a photonic crystal (PC) with an effective index matched closely to air as the incident medium. A tapered waveguide is used to generate a point-sourcelike object field; and to probe the focusing behavior of the PC, an array of wide photonic wire waveguides is placed in the backplane of the PC lens. This represents a sampling of the image field at the rate of one data point per free space wavelength . For TM polarization, a well-defined spot is observed, while the TE polarization lies near the photonic band edge and exhibits spreading and low transmission. We also investigate the wavelength dependence and experimentally show the performance of the negative index lens as a function of frequency.- 23 August 2004
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Dynamic photonic crystal superlattices
Enhanced tunability and switching are exhibited in two-dimensional photonic crystal slabs through a superlattice addressing scheme that creates additional periodicity in the crystal lattice. According to the direction of incident light, the photonic crystal will act as a superprism, an optical switch, or an out-coupling device. Detailed results as well as results on other superlattice systems are presented.
- 23 August 2004
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Dynamic photonic crystal superlattices
Enhanced tunability and switching are exhibited in two-dimensional photonic crystal slabs through a superlattice addressing scheme that creates additional periodicity in the crystal lattice. According to the direction of incident light, the photonic crystal will act as a superprism, an optical switch, or an out-coupling device. Detailed results as well as results on other superlattice systems are presented.
- 21 February 2000
- Published by AIP Publishing in Applied Physics Letters
- Vol. 76 (8) , 949-951
Saturation effects in Y2SiO5:Tb under low-voltage excitation
Low-voltage field emission device phosphors that are excited at high current densities often exhibit brightness saturation with increasing current. The physical processes responsible for saturation can be complex, with several mechanisms contributing, including ground state depletion and excited energy transfer. A two-level model, in conjunction with cathodoluminescencebrightness and transient measurements, is used to show the influence of ground state depletion and thermal quenching on the saturation behavior of Y 2 SiO 5 : Tb under low-voltage excitation.
- 21 February 2000
- Published by AIP Publishing in Applied Physics Letters
- Vol. 76 (8) , 949-951
Saturation effects in Y2SiO5:Tb under low-voltage excitation
Low-voltage field emission device phosphors that are excited at high current densities often exhibit brightness saturation with increasing current. The physical processes responsible for saturation can be complex, with several mechanisms contributing, including ground state depletion and excited energy transfer. A two-level model, in conjunction with cathodoluminescencebrightness and transient measurements, is used to show the influence of ground state depletion and thermal quenching on the saturation behavior of Y 2 SiO 5 : Tb under low-voltage excitation.
- 18 October 1999
- Published by AIP Publishing in Applied Physics Letters
- Vol. 75 (16) , 2398-2400
A two-component phosphor approach for engineering electroluminescence phosphors
- 18 October 1999
- Published by AIP Publishing in Applied Physics Letters
- Vol. 75 (16) , 2398-2400
A two-component phosphor approach for engineering electroluminescence phosphors
- 15 April 1999
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 85 (8) , 3999-4002
Effect of annealing on the grain growth and luminescent properties of SrS:Cu blue phosphors
Systematic studies of the postgrowth annealing of molecular beam epitaxial deposited SrS:Cu films are reported. In the as-grown SrS:Cu films, the grain size was small and the luminescence very weak. A step-annealing procedure in a H2S atmosphere was developed and found to be a very efficient way to improve the crystallinity and luminescent properties without damage to the low temperature glass substrate and insulator layer of the device. A model is presented in terms of the free energy of formation and the reaction kinetics of Cu with H2S. It was proposed that the weak luminescence in the as-grown films was attributed to Cu atoms segregated at the grain boundaries in the SrS film. The oxidation of atomic Cu by H2S and the diffusion of Cu+ into the SrS lattice during annealing were responsible for the grain growth and the improved luminescent properties.
- 15 April 1999
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 85 (8) , 3999-4002
Effect of annealing on the grain growth and luminescent properties of SrS:Cu blue phosphors
Systematic studies of the postgrowth annealing of molecular beam epitaxial deposited SrS:Cu films are reported. In the as-grown SrS:Cu films, the grain size was small and the luminescence very weak. A step-annealing procedure in a H2S atmosphere was developed and found to be a very efficient way to improve the crystallinity and luminescent properties without damage to the low temperature glass substrate and insulator layer of the device. A model is presented in terms of the free energy of formation and the reaction kinetics of Cu with H2S. It was proposed that the weak luminescence in the as-grown films was attributed to Cu atoms segregated at the grain boundaries in the SrS film. The oxidation of atomic Cu by H2S and the diffusion of Cu+ into the SrS lattice during annealing were responsible for the grain growth and the improved luminescent properties.
- 15 March 1999
- Published by AIP Publishing in Applied Physics Letters
- Vol. 74 (11) , 1567-1569
Mn pinning effect in SrS thin-film electroluminescent phosphors
An Mn pinning effect which limits the grain size in SrS:Mn thin films is reported. The SrS:Mn films exhibit spectrally identical saturated electroluminescent (EL) and photoluminescent (PL) green emissions at 5400 Å with CIE coordinates of x=0.33 and y=0.64. However, although strong PL emission was obtained, the EL emission was very weak. It is proposed that the weak EL emission is attributed to the small grain size caused by a Mn pinning effect. The mechanisms of the grain growth and Mn pinning effect in SrS are proposed and discussed in this letter.
- 15 March 1999
- Published by AIP Publishing in Applied Physics Letters
- Vol. 74 (11) , 1567-1569
Mn pinning effect in SrS thin-film electroluminescent phosphors
An Mn pinning effect which limits the grain size in SrS:Mn thin films is reported. The SrS:Mn films exhibit spectrally identical saturated electroluminescent (EL) and photoluminescent (PL) green emissions at 5400 Å with CIE coordinates of x=0.33 and y=0.64. However, although strong PL emission was obtained, the EL emission was very weak. It is proposed that the weak EL emission is attributed to the small grain size caused by a Mn pinning effect. The mechanisms of the grain growth and Mn pinning effect in SrS are proposed and discussed in this letter.
- 8 March 1999
- Published by AIP Publishing in Applied Physics Letters
- Vol. 74 (10) , 1379-1381
In situ annealing studies of molecular-beam epitaxial growth of SrS:Cu
Annealing studies are reported on molecular-beam epitaxial grown SrS:Cu which has potential as a blue phosphor for full color electroluminescent (EL) displays. It was found that annealing under a sulfur flux at 650 °C greatly improved film quality and luminescent brightness. This was attributed to the reduction of sulfur vacancies, and a large enhancement in the grain size of these thin-film phosphors. Using this procedure, EL devices with a luminance of 26 cd/m2 at 40 V above the turn-on threshold voltage with chromaticity coordinates of were obtained.- 8 March 1999
- Published by AIP Publishing in Applied Physics Letters
- Vol. 74 (10) , 1379-1381
In situ annealing studies of molecular-beam epitaxial growth of SrS:Cu
Annealing studies are reported on molecular-beam epitaxial grown SrS:Cu which has potential as a blue phosphor for full color electroluminescent (EL) displays. It was found that annealing under a sulfur flux at 650 °C greatly improved film quality and luminescent brightness. This was attributed to the reduction of sulfur vacancies, and a large enhancement in the grain size of these thin-film phosphors. Using this procedure, EL devices with a luminance of 26 cd/m2 at 40 V above the turn-on threshold voltage with chromaticity coordinates of were obtained.- 4 May 1998
- Published by AIP Publishing in Applied Physics Letters
- Vol. 72 (18) , 2226-2228
Low voltage cathodoluminescence properties of blue emitting SrGa2S4:Ce3+ and ZnS:Ag,Cl phosphors
- 4 May 1998
- Published by AIP Publishing in Applied Physics Letters
- Vol. 72 (18) , 2226-2228
Low voltage cathodoluminescence properties of blue emitting SrGa2S4:Ce3+ and ZnS:Ag,Cl phosphors
- 20 October 1997
- Published by AIP Publishing in Applied Physics Letters
- Vol. 71 (16) , 2268-2270
Charge compensation study of molecular beam epitaxy grown SrS:Ce
- 20 October 1997
- Published by AIP Publishing in Applied Physics Letters
- Vol. 71 (16) , 2268-2270
Charge compensation study of molecular beam epitaxy grown SrS:Ce