Kyung Shik Lee
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Kyung Shik Lee has a total of 2 co-authors. Here are the top co-authors by number of shared publications:
Turan Erdogan
The Institute of Optics, The University of Rochester, Rochester, New York 14627
2 shared publicationsJoon Yong Cho
School of Electrical and Computer Engineering, Sung Kyun Kwan University, Suwon 440-746, Korea
1 shared publication
Latest Publications
- 1 August 2002
- Published by Optica Publishing Group in Journal of the Optical Society of America A
- Vol. 19 (8) , 1621-1631
Polarization-mode coupling in birefringent fiber gratings
Polarization-mode coupling in birefringent fiber gratings is analyzed. The general expression for coupling coefficient components is also derived. It indicates that the polarization-mode coupling between any two linearly polarized (LP) core modes is possible by appropriately adjusting the grating parameters such as the grating tilt angle, the grating length, the orientation of the grating plane, the grating period, the birefringence, and the birefringent axis. It is analytically found that the complete -to- mode coupling and -to- mode coupling occur when fiber is pressed periodically. The -to- mode coupling in the linearly birefringent gratings created by pressing a two-mode fiber with a groove plate with a period of 80 µm at a tilt angle between 81.5° and 83.5° has also been experimentally demonstrated. The resonant -to- mode coupling in the birefringent gratings and their experimental transmission spectra were reasonably well predicted by the coupled-mode analysis.- 1 August 2002
- Published by Optica Publishing Group in Journal of the Optical Society of America A
- Vol. 19 (8) , 1621-1631
Polarization-mode coupling in birefringent fiber gratings
Polarization-mode coupling in birefringent fiber gratings is analyzed. The general expression for coupling coefficient components is also derived. It indicates that the polarization-mode coupling between any two linearly polarized (LP) core modes is possible by appropriately adjusting the grating parameters such as the grating tilt angle, the grating length, the orientation of the grating plane, the grating period, the birefringence, and the birefringent axis. It is analytically found that the complete -to- mode coupling and -to- mode coupling occur when fiber is pressed periodically. The -to- mode coupling in the linearly birefringent gratings created by pressing a two-mode fiber with a groove plate with a period of 80 µm at a tilt angle between 81.5° and 83.5° has also been experimentally demonstrated. The resonant -to- mode coupling in the birefringent gratings and their experimental transmission spectra were reasonably well predicted by the coupled-mode analysis.- 1 May 2001
- Published by Optica Publishing Group in Journal of the Optical Society of America A
- Vol. 18 (5) , 1176-1185
Fiber mode conversion with tilted gratings in an optical fiber
The mode coupling in double-sided tilted gratings between the and modes is analyzed for three different excitation conditions. It is found that a number of modes, including various modes with different polarization states and and modes, can be formed through the mode conversion process in the gratings and with a linear combination of four different modes. Efficient single-sided and double-sided tilted gratings are demonstrated. The tilted gratings presented exhibit mode coupling over a spectral width as wide as 160 nm. The transmission spectra of the tilted fiber gratings agree well with the spectrum predicted by the coupled-mode analysis.- 1 May 2001
- Published by Optica Publishing Group in Journal of the Optical Society of America A
- Vol. 18 (5) , 1176-1185
Fiber mode conversion with tilted gratings in an optical fiber
The mode coupling in double-sided tilted gratings between the and modes is analyzed for three different excitation conditions. It is found that a number of modes, including various modes with different polarization states and and modes, can be formed through the mode conversion process in the gratings and with a linear combination of four different modes. Efficient single-sided and double-sided tilted gratings are demonstrated. The tilted gratings presented exhibit mode coupling over a spectral width as wide as 160 nm. The transmission spectra of the tilted fiber gratings agree well with the spectrum predicted by the coupled-mode analysis.- 20 November 2000
- Published by Optica Publishing Group in Applied Optics
- Vol. 39 (33) , 6144-6149
Mode coupling in tilted planar waveguide gratings
Three different grating tilting formulas for predicting the optimum grating tilt angle for strong mode coupling in planar waveguide gratings are derived. The optimum tilt angles obtained by the ray-optics approach deviate ∼1° for transmissive mode coupling and ∼1.5° for reflective mode coupling from those computed by the coupled-mode approach. The coupled-mode analysis and ray-optics analysis of the tilted planar waveguide gratings show that the transmissive planar waveguide gratings should be tilted more than 84° for strong TE0-to-TEμ mode coupling near 1550 nm.
- 20 November 2000
- Published by Optica Publishing Group in Applied Optics
- Vol. 39 (33) , 6144-6149
Mode coupling in tilted planar waveguide gratings
Three different grating tilting formulas for predicting the optimum grating tilt angle for strong mode coupling in planar waveguide gratings are derived. The optimum tilt angles obtained by the ray-optics approach deviate ∼1° for transmissive mode coupling and ∼1.5° for reflective mode coupling from those computed by the coupled-mode approach. The coupled-mode analysis and ray-optics analysis of the tilted planar waveguide gratings show that the transmissive planar waveguide gratings should be tilted more than 84° for strong TE0-to-TEμ mode coupling near 1550 nm.
- 20 March 2000
- Published by Optica Publishing Group in Applied Optics
- Vol. 39 (9) , 1394-1404
Fiber mode coupling in transmissive and reflective tilted fiber gratings
Whereas core-mode reflection and core-mode-to-radiation-mode coupling in tilted fiber Bragg gratings is well understood, as is coupling between a core mode and higher-order core and cladding modes in untilted gratings, here we analyze in detail the coupling among core modes and cladding modes in reflective and transmissive tilted fiber gratings. We show that strong coupling between an LP01 core mode and the exact (1m) cladding modes occurs in a transmissive tilted grating for nearly any tilt angle except angles close to 90°, whereas the LP01-to-(lm) cladding mode coupling (l ≠ 1) is appreciable only for tilt angles just below 90° (∼88°). In a reflective grating, strong coupling between the LP01 core mode and the exact (1m) cladding modes occurs only for angles less than ∼5°, whereas coupling to (1m) cladding modes for m > 1 occurs only for angles greater than ∼5°. Coupling among bound core modes exhibits a similar behavior, except that in general the coupling is stronger. Experimentally we show coupling to both higher-order bound core modes and cladding modes in a transmissive tilted grating at visible and near-infrared wavelengths.
- 20 March 2000
- Published by Optica Publishing Group in Applied Optics
- Vol. 39 (9) , 1394-1404
Fiber mode coupling in transmissive and reflective tilted fiber gratings
Whereas core-mode reflection and core-mode-to-radiation-mode coupling in tilted fiber Bragg gratings is well understood, as is coupling between a core mode and higher-order core and cladding modes in untilted gratings, here we analyze in detail the coupling among core modes and cladding modes in reflective and transmissive tilted fiber gratings. We show that strong coupling between an LP01 core mode and the exact (1m) cladding modes occurs in a transmissive tilted grating for nearly any tilt angle except angles close to 90°, whereas the LP01-to-(lm) cladding mode coupling (l ≠ 1) is appreciable only for tilt angles just below 90° (∼88°). In a reflective grating, strong coupling between the LP01 core mode and the exact (1m) cladding modes occurs only for angles less than ∼5°, whereas coupling to (1m) cladding modes for m > 1 occurs only for angles greater than ∼5°. Coupling among bound core modes exhibits a similar behavior, except that in general the coupling is stronger. Experimentally we show coupling to both higher-order bound core modes and cladding modes in a transmissive tilted grating at visible and near-infrared wavelengths.