Eliziane Cossetin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Eliziane Cossetin has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- José Fernando Castanha Henriques
Department of Orthodontics, Bauru Dental School, University of São Paulo, Bauru, Brazil
2 shared publications - Alberto Consolaro
Universidade de São Paulo
1 shared publication Arnaldo Pinzan
Bauru Dental School, University of São Paulo, Bauru - SP, Brazil
1 shared publicationAroline Nemetz Bronfman
Bauru Dental School, University of São Paulo, Bauru - SP, Brazil
1 shared publicationCardoso de Oliveira
Bauru Dental School, University of São Paulo, Bauru - SP, Brazil
1 shared publication- Daniela Gamba Garib
Universidade de São Paulo
1 shared publication
Latest Publications
- Open Access
- 18 July 2016
- Published by Maad Rayan Publishing Company in Journal of lasers in medical sciences
- Vol. 7 (3) , 146-151
Low-Level Laser Action on Orthodontically Induced Root Resorption: Histological and Histomorphometric Evaluation
Low-Level Laser Action on Orthodontically Induced Root Resorption: Histological and Histomorphometric Evaluation
- 18 July 2016
- Published by Maad Rayan Publishing Company in Journal of lasers in medical sciences
- Vol. 7 (3) , 146-151
Open AccessLow-Level Laser Action on Orthodontically Induced Root Resorption: Histological and Histomorphometric Evaluation
Low-Level Laser Action on Orthodontically Induced Root Resorption: Histological and Histomorphometric Evaluation
- 1 November 2013
- Published by The Angle Orthodontist (EH Angle Education & Research Foundation) in The Angle Orthodontist
- Vol. 83 (6) , 1015-1021
Influence of low-level laser on bone remodeling during induced tooth movement in rats
Objective: To analyze the effect of low-level laser on bone remodeling during induced tooth movement in rats. Materials and Methods: A diode laser (808 nm, 100 mW, 54 J on an area of 0.0028 cm2) was used. The application was continuous, punctual, and with contact. Forty-two 70-day-old Wistar rats had the maxillary left first molar moved using a force level of 25 g. In two experimental subgroups the movement was performed over 7 days and in three subgroups the movement occurred over 14 days. In the 7-day movement subgroups, one subgroup received laser irradiation on day 1 only; the other subgroup received laser irradiation on days 1, 3, and 5. In the 14-day movement subgroups, one subgroup received laser irradiation on day 1 only; the second on days 1, 3, and 5; and the third on days 1, 3, 5, 7, 9, 11, and 13. The control group was also divided into two subgroups, and movement occurred over two different periods of treatment (7 days and 14 days) without laser application; these were used as controls for the respective experimental subgroups. Inter-subgroup comparison was performed with Kruskal-Wallis, followed by Mann-Whitney and analysis of variance, followed by Tukey tests within the 7- and 14-day subgroups. Results: The subgroup with three laser applications showed significantly greater osteoclastic activity and bone resorption than the other subgroups in the 7-day movement subgroups. Conclusions: Low-level laser application significantly increased the osteoclastic but not the osteoblastic activity during the initial phases of tooth movement. In addition, the osteoclastic activity was dose-dependent.
- 1 November 2013
- Published by The Angle Orthodontist (EH Angle Education & Research Foundation) in The Angle Orthodontist
- Vol. 83 (6) , 1015-1021
Influence of low-level laser on bone remodeling during induced tooth movement in rats
Objective: To analyze the effect of low-level laser on bone remodeling during induced tooth movement in rats. Materials and Methods: A diode laser (808 nm, 100 mW, 54 J on an area of 0.0028 cm2) was used. The application was continuous, punctual, and with contact. Forty-two 70-day-old Wistar rats had the maxillary left first molar moved using a force level of 25 g. In two experimental subgroups the movement was performed over 7 days and in three subgroups the movement occurred over 14 days. In the 7-day movement subgroups, one subgroup received laser irradiation on day 1 only; the other subgroup received laser irradiation on days 1, 3, and 5. In the 14-day movement subgroups, one subgroup received laser irradiation on day 1 only; the second on days 1, 3, and 5; and the third on days 1, 3, 5, 7, 9, 11, and 13. The control group was also divided into two subgroups, and movement occurred over two different periods of treatment (7 days and 14 days) without laser application; these were used as controls for the respective experimental subgroups. Inter-subgroup comparison was performed with Kruskal-Wallis, followed by Mann-Whitney and analysis of variance, followed by Tukey tests within the 7- and 14-day subgroups. Results: The subgroup with three laser applications showed significantly greater osteoclastic activity and bone resorption than the other subgroups in the 7-day movement subgroups. Conclusions: Low-level laser application significantly increased the osteoclastic but not the osteoblastic activity during the initial phases of tooth movement. In addition, the osteoclastic activity was dose-dependent.
- Open Access
- 1 February 2012
- Published by FapUNIFESP (SciELO) in Dental Press Journal of Orthodontics
- Vol. 17 (1) , 47-49
Study of tension in the periodontal ligament using the finite elements method
Orthodontic movement is process of transformation of a physical stimulation into a force applied to a tooth, with a biological response identified as bone remodelling. Although it is possible to measure the force applied on a tooth, its distribution around the root is irregular forming areas of higher concentration of tensions, which do not correspond to the force initially applied. To evaluate the behavior of the periodontal ligament after the application of an external action and to prove which would be the areas of higher tension generated in the periodontium, the Finite Elements Method (FEM) was used in comparison to the results obtained in vivo on experimental models in rat. To test the error susceptibility of the technique used in the experimental model, the force application was simulated in three different heights on the mesial surface of the molar. The resulting histological analysis was compared with the result obtained for the computational code and disclosed that the greater focus of osteoclasts in activity had coincided with the compressed areas of the periodontal ligament. The alteration of points of force application generated areas of more extensive deformations in the periodontal ligament, as the point of application was more distant of the initial point, the horizontal force vector became bigger. These results demonstrate that the FEM is an adequate tool to study the distribution of orthodontic forces. The sensitivity of the experimental model used was also observed in relation to the installation of the dental movement device, which should be considered depending on the objective of the research
- 1 February 2012
- Published by FapUNIFESP (SciELO) in Dental Press Journal of Orthodontics
- Vol. 17 (1) , 47-49
Open AccessStudy of tension in the periodontal ligament using the finite elements method
Orthodontic movement is process of transformation of a physical stimulation into a force applied to a tooth, with a biological response identified as bone remodelling. Although it is possible to measure the force applied on a tooth, its distribution around the root is irregular forming areas of higher concentration of tensions, which do not correspond to the force initially applied. To evaluate the behavior of the periodontal ligament after the application of an external action and to prove which would be the areas of higher tension generated in the periodontium, the Finite Elements Method (FEM) was used in comparison to the results obtained in vivo on experimental models in rat. To test the error susceptibility of the technique used in the experimental model, the force application was simulated in three different heights on the mesial surface of the molar. The resulting histological analysis was compared with the result obtained for the computational code and disclosed that the greater focus of osteoclasts in activity had coincided with the compressed areas of the periodontal ligament. The alteration of points of force application generated areas of more extensive deformations in the periodontal ligament, as the point of application was more distant of the initial point, the horizontal force vector became bigger. These results demonstrate that the FEM is an adequate tool to study the distribution of orthodontic forces. The sensitivity of the experimental model used was also observed in relation to the installation of the dental movement device, which should be considered depending on the objective of the research