SSSusanne Scheinert

Susanne Scheinert

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Susanne Scheinert has a total of 13 co-authors. Here are the top co-authors by number of shared publications:

  • I. Hörselmann

    Ilmenau Technical University Institute of Solid State Electronics P. Box 100565, 98684 Ilmenau, Germany

    4 shared publications
  • G. Paasch

    Leibniz Institute for Solid State and Materials Research IFW Dresden 2 , PF 270116, D-01171 Dresden, Germany

    3 shared publications
  • Gernot Paasch

    Leibniz Institute for Solid State and Materials Research IFW Dresden

    3 shared publications
  • J. Sprogies

    Ilmenau Technical University Institute of Solid State Electronics P. Box 100565, 98684 Ilmenau, Germany

    2 shared publications
  • M. Knupfer

    Leibniz Institute for Solid State and Materials Research IFW Dresden 2 , PF 270116, D-01171 Dresden, Germany

    2 shared publications
  • Mandy Grobosch

    Leibniz Institute for Solid State and Materials Research IFW Dresden 2 , PF 270116, D-01171 Dresden, Germany

    2 shared publications

Latest Publications

  • Analyzing the influence of negative gate bias stress on the transconductance of solution-processed, organic thin-film transistors

    by J. Sprogies, S. Scheinert, I. Hörselmann

    We have investigated the bias stress stability of poly(3-hexylthiophene) (P3HT)-based organic field-effect transistors (OFETs), prepared from chloroform or trichlorobenzene solutions on a thin SiO2 dielectric (bottom gate) with an additional self-assembled monolayer. Three different processes of gate oxide treatment were compared with regard to their reaction to prolonged constant gate bias. Furthermore, we analyzed the transconductance gm during gate bias stress, as well as the contact resistance Rc using the transmission line method and found that the bias stress has no influence on the contact resistance of P3HT-based OFETs, but with the addition that Rc strongly affects gm. The most stable characteristics were achieved for transistors with a dielectric coated with hexamethyldisilazane over 22 h, which exhibited a pronounced reduction of the threshold voltage shift and contact resistance in comparison with the other variants of gate dielectric treatment. Based on two-dimensional simulations, we demonstrate that an increased Rc in combination with a carrier concentration dependent, high mobility leads to a maximum in the transconductance curve, which can be prevented by optimizing the contact between source/drain and the channel region.


  • Organic [6,6]-phenyl-C61-butyric-acid-methyl-ester field effect transistors: Analysis of the contact properties by combined photoemission spectroscopy and electrical measurements

    by S. Scheinert, M. Grobosch, J. Sprogies, I. Hörselmann, M. Knupfer, G. Paasch

    Carrier injection barriers determined by photoemission spectroscopy for organic/metal interfaces are widely accepted to determine the performance of organic field-effect transistors (OFET), which strongly depends on this interface at the source/drain contacts. This assumption is checked here in detail, and a more sophisticated connection is presented. According to the preparation process described in our recently published article [S. Scheinert, J. Appl. Phys. 111, 064502 (2012)], we prepared PCBM/Au and PCBM/Al samples to characterize the interface by photoemission and electrical measurements of PCBM based OFETs with bottom and top (TOC) contacts, respectively. The larger drain currents for TOC OFETs indicate the presence of Schottky contacts at source/drain for both metals. The hole injection barrier as determined by photoemission is 1.8 eV for both Al and Au. Therefore, the electron injection barriers are also the same. In contrast, the drain currents are orders of magnitude larger for the transistors with the Al contacts than for those with the Au contacts. We show that indeed the injection is determined by two other properties measured also by photoemission, the (reduced) work functions, and the interface dipoles, which have different sign for each contact material. In addition, we demonstrate by core-level and valence band photoemission that the deposition of gold as top contact onto PCBM results in the growth of small gold clusters. With increasing gold coverage, the clusters grow inside and begin to form a metallic, but not uniform, closed film onto PCBM.


  • Contact characterization by photoemission and device performance in P3HT based organic transistors

    by S. Scheinert, M. Grobosch, G. Paasch, I. Hörselmann, M. Knupfer, J. Bartsch

    The operation of organic devices as organic field-effect transistors (OFET) depends critically on the contact between the organic layer and the material for source/drain electrodes. Small barriers for carrier injection are required for efficient operation. In order to support the understanding of organic devices, photoemission spectroscopy has been used to determine the properties of metal/organic interfaces. Values for the hole injection barrier determined in the last decade by different groups are frequently of the order of 0.5–1 eV. It is not clear whether barrier lowering due to the image charge is sufficient to make contacts with such barriers efficient for carrier injection. Indeed, no results have been reported where the preparation of the samples for the photoemission study and for the devices are the same. Here we present results of such an investigation for OFETs with gold source/drain contacts. The measured hole barrier at the gold contact of 0.6 eV results from the Au work function of 4.6 eV. Taking into account the dependencies of the mobility on the carrier concentration and on the field for the Gaussian density of states (DOS) of disordered organics, measured OFET current characteristics cannot be described well with such contacts but rather for work functions of 4.7 eV or larger. Considering the method in determining the barrier from photoemission data and the Gaussian DOS of the hopping transport states, we present a quantitative connection between the barrier as determined from photoemission and the barrier as used in the device simulation.


  • Low-Cost Submicrometer Organic Field-Effect Transistors

    by Susanne Scheinert, Gernot Paasch, Ingo Hörselmann, Andrei Herasimovich


  • Interdependence of contact properties and field- and density-dependent mobility in organic field-effect transistors

    by Susanne Scheinert, Gernot Paasch

    The current characteristics of organic field-effect transistors (OFET) often show a disadvantageous nonlinearity at low drain voltages. It has been shown recently [J. Appl. Phys. 102, 054509 (2007)] that in top contact (TOC) OFETs this effect can be caused by trap recharging if the contacts are of Schottky type. For bottom contact (BOC) OFETs, in spite of controversial discussions, Schottky contacts as origin of the nonlinearity are often stated. At first, it is shown here by a mixed mode simulation that for large ideality factors a Schottky contact only at drain leads to such a nonlinearity. However, with the same Schottky contacts at drain and source the effect is covered by the high resistance of the contact at source. Next, the different influences of Schottky contacts on BOC OFETs and TOC OFETs with varying overlap of the source/drain contacts with the gate are clarified. Further, it is demonstrated with detailed two-dimensional simulations that the combination of the presence of Schottky contacts with a field dependence of the mobility can cause the nonlinearity. For the mobility we use the field dependent Pool/Frenkel model, and the models of Limketai et al.[Phys. Rev. B 75, 113203 (2007)] and Pasveer/Coehoorn et al.[Phys. Rev. Lett. 94, 206601 (2005)], which depend in addition on the carrier concentration. Their influence on the device performance has been clarified by the simulations. Simulated profiles of concentrations and fields lead to the understanding of the mechanism causing the nonlinearity. This mechanism is especially effective for the Pasveer/Coehoorn model. The field dependence of the mobility is a consequence of the energetic distribution of the hopping states and can hardly be avoided in solution based deposition of the active polymer layer. A strategy to prevent the nonlinearity is therefore an optimization of the contact-polymer interface such that the contacts become Ohmic.


  • Determination of trap distributions from current characteristics of pentacene field-effect transistors with surface modified gate oxide

    by Susanne Scheinert, Kurt P. Pernstich, Bertram Batlogg, Gernot Paasch

    It has been demonstrated [K. P. Pernstich, S. Haas, D. Oberhoff, C. Goldmann, D. J. Gundlach, B. Batlogg, A. N. Rashid, and G. Schitter, J. Appl. Phys. 96, 6431 (2004)] that a controllable shift of the threshold voltage in pentacene thin film transistors is caused by the use of organosilanes with different functional groups forming a self-assembled monolayer (SAM) on the gate oxide. The observed broadening of the subthreshold region indicates that the SAM creates additional trap states. Indeed, it is well known that traps strongly influence the behavior of organic field-effect transistors (OFETs). Therefore, the so-called “amorphous silicon (a-Si) model” has been suggested to be an appropriate model to describe OFETs. The main specifics of this model are transport of carriers above a mobility edge obeying Boltzmann statistics and exponentially distributed tail states and deep trap states. Here, approximate trap distributions are determined by adjusting two-dimensional numerical simulations to the experimental data. It follows from a systematic variation of parameters describing the trap distributions that the existence of both donorlike and acceptorlike trap distributions near the valence band, respectively, and a fixed negative interface charge have to be assumed. For two typical devices with different organosilanes the electrical characteristics can be described well with a donorlike bulk trap distribution, an acceptorlike interface distribution, and/or a fixed negative interface charge. As expected, the density of the fixed or trapped interface charge depends strongly on the surface treatment of the dielectric. There are some limitations in determining the trap distributions caused by either slow time-dependent processes resulting in differences between transfer and output characteristics, or in the uncertainty of the effective mobility.


  • Influence of source/drain contacts on sub‐micrometer organic field‐effect transistors

    by S. Scheinert, G. Paasch, I. Hörselmann, A. Herasimovich

    Measured output characteristics of our prepared short‐channel organic transistor show the well known effect of a nonlinear increase of the drain current with positive curvature at low drain voltages. We investigated this peculiarity by means of 2D simulations considering the bilayer contact for source or drain, respectively. The simulations show that the low work function of the chromium adhesion layer causes the nonlinearity. Another important aspect demonstrated by the simulations is the estimation of the mobility applying the simple Shockley equation. The influence of the contact properties on the rise of the drain current results in erroneous values for the mobility as estimated directly from the current–voltage characteristics. Output characteristics of a 1 µm channel length transistor. magnified image Output characteristics of a 1 µm channel length transistor.