Denis Guimard
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Denis Guimard has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
Masao Nishioka
3 shared publicationsYasuhiko Arakawa
3 shared publicationsDamien Bordel
Institute for Nano Quantum Information Electronics, University of Tokyo, 4‐6‐1 Komaba, Meguro‐ku, Tokyo 153‐8505, Japan and Institute of Industrial Science, University of Tokyo, 4‐6‐1 Komaba, Meguro‐ku, Tokyo 153‐8505, Japan
2 shared publicationsH. Sudo
Fujitsu Laboratories Ltd. , 10-1 Morinosato-Wakamiya, Atsugi 243-0197, Japan
2 shared publicationsM. Ishida
University of Tokyo Nano Collaborative Research Center, Institute of Industrial Science 4-6-1 Komaba, Meguro-ku, Tokyo 153-8505, Japan
2 shared publicationsM. Nishioka
University of Tokyo Nano Collaborative Research Center, Institute of Industrial Science 4-6-1 Komaba, Meguro-ku, Tokyo 153-8505, Japan
2 shared publications
Latest Publications
- 9 November 2011
- Published by IOP Publishing in Applied Physics Express
- Vol. 4 (11)
Metal Organic Chemical Vapor Deposition Growth of High Spectral Quality Site-Controlled InAs Quantum Dots UsingIn situPatterning
- 9 November 2011
- Published by IOP Publishing in Applied Physics Express
- Vol. 4 (11)
Metal Organic Chemical Vapor Deposition Growth of High Spectral Quality Site-Controlled InAs Quantum Dots UsingIn situPatterning
- 11 April 2011
- Published by IOP Publishing in Applied Physics Express
- Vol. 4 (4) , 045201
Effect of Antimony on the Photoluminescence Intensity of InAs Quantum Dots Grown on Germanium-on-Insulator-on-Silicon Substrate
- 11 April 2011
- Published by IOP Publishing in Applied Physics Express
- Vol. 4 (4) , 045201
Effect of Antimony on the Photoluminescence Intensity of InAs Quantum Dots Grown on Germanium-on-Insulator-on-Silicon Substrate
- 21 October 2010
- Published by Wiley in physica status solidi (c)
- Vol. 8 (2) , 319-321
Fabrication of electrically pumped InAs/GaAs quantum dot lasers on Si substrates by Au‐mediated wafer bonding
- 21 October 2010
- Published by Wiley in physica status solidi (c)
- Vol. 8 (2) , 319-321
Fabrication of electrically pumped InAs/GaAs quantum dot lasers on Si substrates by Au‐mediated wafer bonding
- 16 February 2010
- Published by IOP Publishing in Nanotechnology
- Vol. 21 (10) , 105604
Ground state lasing at 1.30 µm from InAs/GaAs quantum dot lasers grown by metal–organic chemical vapor deposition
We investigated the effects of post-growth annealing on the photoluminescence (PL) characteristics of InAs/GaAs quantum dots (QDs) grown by metal-organic chemical vapor deposition (MOCVD). The onset temperature at which both the peak linewidth and the PL intensity degraded and the blueshift of the ground state emission wavelength occurred was found to depend on both the QD density and the In composition of the capping layer. This behavior is particularly important in view of QD integration in photonic devices. From the knowledge of the dependences of the PL characteristics after annealing on the QD and capping growth conditions, ground state lasing at 1.30 mu m could be demonstrated from InAs/GaAs QDs grown by MOCVD. Finally, we compared the laser characteristics of InAs/GaAs QDs with those of InAs/Sb: GaAs QDs, grown according to the antimony-mediated growth technique, and showed that InAs/Sb: GaAs QDs are more appropriate for laser fabrication at 1.3 mu m by MOCVD.
- 16 February 2010
- Published by IOP Publishing in Nanotechnology
- Vol. 21 (10) , 105604
Ground state lasing at 1.30 µm from InAs/GaAs quantum dot lasers grown by metal–organic chemical vapor deposition
We investigated the effects of post-growth annealing on the photoluminescence (PL) characteristics of InAs/GaAs quantum dots (QDs) grown by metal-organic chemical vapor deposition (MOCVD). The onset temperature at which both the peak linewidth and the PL intensity degraded and the blueshift of the ground state emission wavelength occurred was found to depend on both the QD density and the In composition of the capping layer. This behavior is particularly important in view of QD integration in photonic devices. From the knowledge of the dependences of the PL characteristics after annealing on the QD and capping growth conditions, ground state lasing at 1.30 mu m could be demonstrated from InAs/GaAs QDs grown by MOCVD. Finally, we compared the laser characteristics of InAs/GaAs QDs with those of InAs/Sb: GaAs QDs, grown according to the antimony-mediated growth technique, and showed that InAs/Sb: GaAs QDs are more appropriate for laser fabrication at 1.3 mu m by MOCVD.
- 23 January 2010
- Published by SPIE-Intl Soc Optical Eng
- Vol. 7608
Advances in 3D photonic crystal nanocavity with quantum dots
We discuss recent advances in light-matter coupling in quantum dots with a point-defect nanocavity in a woodpile three-dimensional (3D) photonic crystal with the highest quality (Q) factor among those for 3D photonic crystal cavities. The Q factor over 10,000 was so far achieved by optimizing the size of the defect cavity, in which the defect was not so large that power loss into the in-plane direction limited the Q factor.
- 23 January 2010
- Published by SPIE-Intl Soc Optical Eng
- Vol. 7608
Advances in 3D photonic crystal nanocavity with quantum dots
We discuss recent advances in light-matter coupling in quantum dots with a point-defect nanocavity in a woodpile three-dimensional (3D) photonic crystal with the highest quality (Q) factor among those for 3D photonic crystal cavities. The Q factor over 10,000 was so far achieved by optimizing the size of the defect cavity, in which the defect was not so large that power loss into the in-plane direction limited the Q factor.
- 11 June 2007
- Published by AIP Publishing in Applied Physics Letters
- Vol. 90 (24) , 241110
Ground state lasing at 1.34μm from InAs∕GaAs quantum dots grown by antimony-mediated metal organic chemical vapor deposition
The authors report the fabrication of GaAs-based quantum dot (QD) lasers grown by metal organic chemical vapor deposition above . They fabricated a laser diode with five stacked QD layers, grown by antimony-surfactant-mediated growth. Ground state lasing was obtained at , with internal quantum efficiency of 62%, internal loss of and ground state modal gain above . Lasing above could be achieved because of the beneficial effects of antimony on both the coherent QD density and the suppression of the emission blueshift, usually observed for QDs during postgrowth annealing at .- 11 June 2007
- Published by AIP Publishing in Applied Physics Letters
- Vol. 90 (24) , 241110
Ground state lasing at 1.34μm from InAs∕GaAs quantum dots grown by antimony-mediated metal organic chemical vapor deposition
The authors report the fabrication of GaAs-based quantum dot (QD) lasers grown by metal organic chemical vapor deposition above . They fabricated a laser diode with five stacked QD layers, grown by antimony-surfactant-mediated growth. Ground state lasing was obtained at , with internal quantum efficiency of 62%, internal loss of and ground state modal gain above . Lasing above could be achieved because of the beneficial effects of antimony on both the coherent QD density and the suppression of the emission blueshift, usually observed for QDs during postgrowth annealing at .- 1 May 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
Ground State Lasing at 1.34 μm from InAs Quantum Dots Grown on GaAs Substrate by Antimony-Mediated Metal Organic Chemical Vapor Deposition
Ground state lasing above 1.30 mum (1.34 mum) was obtained for the first time from InAs quantum dots grown on GaAs substrate by metal organic chemical vapor deposition.
- 1 May 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
Ground State Lasing at 1.34 μm from InAs Quantum Dots Grown on GaAs Substrate by Antimony-Mediated Metal Organic Chemical Vapor Deposition
Ground state lasing above 1.30 mum (1.34 mum) was obtained for the first time from InAs quantum dots grown on GaAs substrate by metal organic chemical vapor deposition.