XZX.-Y. Zhu

X.-Y. Zhu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


X.-Y. Zhu has a total of 21 co-authors. Here are the top co-authors by number of shared publications:

  • Matthias Muntwiler

    Paul Scherrer Institut

    3 shared publications
  • Qingxin Yang

    Department of Chemistry, University of Minnesota, 207 Pleasant St SE, Minneapolis, MN 55455, USA

    2 shared publications
  • William A. Tisdale

    Massachusetts Institute of Technology

    2 shared publications
  • Athena Guo

    Department of Chemistry, University of Minnesota, Minneapolis, Minnesota 55455, MicroSurfaces, Inc., 4001 Stinson Boulevard Suite 430, Minneapolis, Minnesota 55421, Department of Physics, Augsburg College, Minneapolis, Minnesota 55454, Department of Neuroscience, University of Minnesota, Minneapolis, Minnesota 55455, and Department of Pharmacology, University of Minnesota, Minneapolis, Minnesota 55455

    1 shared publication
  • Benjamin J. Stottrup

    Department of Chemistry, University of Minnesota, Minneapolis, Minnesota 55455, MicroSurfaces, Inc., 4001 Stinson Boulevard Suite 430, Minneapolis, Minnesota 55421, Department of Physics, Augsburg College, Minneapolis, Minnesota 55454, Department of Neuroscience, University of Minnesota, Minneapolis, Minnesota 55455, and Department of Pharmacology, University of Minnesota, Minneapolis, Minnesota 55455

    1 shared publication
  • Bryan Holtz

    Department of Chemistry, University of Minnesota, Minneapolis, Minnesota 55455, MicroSurfaces, Inc., 4001 Stinson Boulevard Suite 430, Minneapolis, Minnesota 55421, Department of Physics, Augsburg College, Minneapolis, Minnesota 55454, Department of Neuroscience, University of Minnesota, Minneapolis, Minnesota 55455, and Department of Pharmacology, University of Minnesota, Minneapolis, Minnesota 55455

    1 shared publication

Latest Publications

  • Strong Electronic Coupling in Two-Dimensional Assemblies of Colloidal PbSe Quantum Dots

    by Kenrick J. Williams, William A. Tisdale, Kurtis S. Leschkies, Greg Haugstad, David J. Norris, Eray S. Aydil, X.-Y. Zhu

    Thin films of colloidal PbSe quantum dots can exhibit very high carrier mobilities when the surface ligands are removed or replaced by small molecules, such as hydrazine. Charge transport in such films is governed by the electronic exchange coupling energy (β) between quantum dots. Here we show that two-dimensional quantum dot arrays assembled on a surface provide a powerful system for studying this electronic coupling. We combine optical spectroscopy with atomic force microscopy to examine the chemical, structural, and electronic changes that occur when a submonolayer of PbSe QDs is exposed to hydrazine. We find that this treatment leads to strong and tunable electronic coupling, with the β value as large as 13 meV, which is 1 order of magnitude greater than that previously achieved in 3D QD solids with the same chemical treatment. We attribute this much enhanced electronic coupling to reduced geometric frustration in 2D films. The strongly coupled quantum dot assemblies serve as both charge and energy sinks. The existence of such coupling has serious implications for electronic devices, such as photovoltaic cells, that utilize quantum dots.


  • Charge-Transfer Excitons at Organic Semiconductor Surfaces and Interfaces

    by X.-Y. Zhu, Q. Yang, M. Muntwiler

    When a material of low dielectric constant is excited electronically from the absorption of a photon, the Coulomb attraction between the excited electron and the hole gives rise to an atomic H-like quasi-particle called an exciton. The bound electron−hole pair also forms across a material interface, such as the donor/acceptor interface in an organic heterojunction solar cell; the result is a charge-transfer (CT) exciton. On the basis of typical dielectric constants of organic semiconductors and the sizes of conjugated molecules, one can estimate that the binding energy of a CT exciton across a donor/acceptor interface is 1 order of magnitude greater than kBT at room temperature (kB is the Boltzmann constant and T is the temperature). How can the electron−hole pair escape this Coulomb trap in a successful photovoltaic device? To answer this question, we use a crystalline pentacene thin film as a model system and the ubiquitous image band on the surface as the electron acceptor. We observe, in time-resolved two-photon photoemission, a series of CT excitons with binding energies ≤0.5 eV below the image band minimum. These CT excitons are essential solutions to the atomic H-like Schrödinger equation with cylindrical symmetry. They are characterized by principal and angular momentum quantum numbers. The binding energy of the lowest lying CT exciton with 1s character is more than 1 order of magnitude higher than kBT at room temperature. The CT1s exciton is essentially the so-called exciplex and has a very low probability of dissociation. We conclude that hot CT exciton states must be involved in charge separation in organic heterojunction solar cells because (1) in comparison to CT1s, hot CT excitons are more weakly bound by the Coulomb potential and more easily dissociated, (2) density-of-states of these hot excitons increase with energy in the Coulomb potential, and (3) electronic coupling from a donor exciton to a hot CT exciton across the D/A interface can be higher than that to CT1s as expected from energy resonance arguments. We suggest a design principle in organic heterojunction solar cells: there must be strong electronic coupling between molecular excitons in the donor and hot CT excitons across the D/A interface.


  • Coulomb Barrier for Charge Separation at an Organic Semiconductor Interface

    by Matthias Muntwiler, Qingxin Yang, William A. Tisdale, X.-Y. Zhu

    Charge transfer (CT) excitons across donor-acceptor interfaces are believed to be barriers to charge separation in organic solar cells, but little is known about their physical characteristics. Here, we probe CT excitons on a crystalline pentacene surface using time-resolved two-photon photoemission spectroscopy. CT excitons of 1s, 2s, and 3s characters are bound by Coulomb energies of 0.43, 0.21, 0.12 eV, respectively, in agreement with quantum mechanical modeling. The large binding energy of the 1s CT exciton excludes its participation in photovoltaics. Efficient charge separation in organic heterojunction solar cells must involve a series of hot CT excitons.


  • Fluidic and Air-Stable Supported Lipid Bilayer and Cell-Mimicking Microarrays

    by Yang Deng, Yini Wang, Bryan Holtz, Jingyi Li, Nathan Traaseth, Gianluigi Veglia, Benjamin J. Stottrup, Robert Elde, Duanqing Pei, Athena Guo, et al.

    As drug delivery, therapy, and medical imaging are becoming increasingly cell-specific, there is a critical need for high fidelity and high-throughput screening methods for cell surface interactions. Cell membrane-mimicking surfaces, i.e., supported lipid bilayers (SLBs), are currently not sufficiently robust to meet this need. Here we describe a method of forming fluidic and air-stable SLBs through tethered and dispersed cholesterol groups incorporated into the bottom leaflet. Achieving air stability allows us to easily fabricate SLB microarrays from direct robotic spotting of vesicle solutions. We demonstrate their application as cell membrane-mimicking microarrays by reconstituting peripheral as well as integral membrane components that can be recognized by their respective targets. These demonstrations establish the viability of the fluidic and air-stable SLB platform for generating content microarrays in high throughput studies, e.g., the screening of drugs and nanomedicine targeting cell surface receptors.