Tivadar Lohner
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Tivadar Lohner has a total of 47 co-authors. Here are the top co-authors by number of shared publications:
P. Petrik
Institute for Technical Physics and Materials Science Research Centre for Natural Sciences Hungarian Academy of Sciences Konkoly Thege Miklós út 29-33 H-1121 Budapest Hungary
3 shared publications- Peter Petrik
Research Institute for Technical Physics and Materials Science
3 shared publications - Essam Ramadan Shaaban
Physics Department, Faculty of Science, Al-Azhar University, Assiut 11751, Egypt
2 shared publications M. Fried
Research Institute for Technical Physics and Materials Science, Konkoly Thege Miklós út 29‐33, 1121 Budapest, Hungary
2 shared publicationsA. Koós
Research Institute for Technical Physics and Materials Science, Konkoly Thege Miklós út 29‐33, 1121 Budapest, Hungary
1 shared publicationA. L. Tóth
Institute for Technical Physics and Materials Science Research Centre for Natural Sciences Hungarian Academy of Sciences Konkoly Thege Miklós út 29-33 H-1121 Budapest Hungary
1 shared publication
Latest Publications
- Open Access
Determination of the Complex Dielectric Function of Ion-Implanted Amorphous Germanium by Spectroscopic Ellipsometry
Accurate reference dielectric functions play an important role in the research and development of optical materials. Libraries of such data are required in many applications in which amorphous semiconductors are gaining increasing interest, such as in integrated optics, optoelectronics or photovoltaics. The preparation of materials of high optical quality in a reproducible way is crucial in device fabrication. In this work, amorphous Ge (a-Ge) was created in single-crystalline Ge by ion implantation. It was shown that high optical density is available when implanting low-mass Al ions using a dual-energy approach. The optical properties were measured by multiple angle of incidence spectroscopic ellipsometry identifying the Cody-Lorentz dispersion model as the most suitable, that was capable of describing the dielectric function by a few parameters in the wavelength range from 210 to 1690 nm. The results of the optical measurements were consistent with the high material quality revealed by complementary Rutherford backscattering spectrometry and cross-sectional electron microscopy measurements, including the agreement of the layer thickness within experimental uncertainty.
Open AccessDetermination of the Complex Dielectric Function of Ion-Implanted Amorphous Germanium by Spectroscopic Ellipsometry
Accurate reference dielectric functions play an important role in the research and development of optical materials. Libraries of such data are required in many applications in which amorphous semiconductors are gaining increasing interest, such as in integrated optics, optoelectronics or photovoltaics. The preparation of materials of high optical quality in a reproducible way is crucial in device fabrication. In this work, amorphous Ge (a-Ge) was created in single-crystalline Ge by ion implantation. It was shown that high optical density is available when implanting low-mass Al ions using a dual-energy approach. The optical properties were measured by multiple angle of incidence spectroscopic ellipsometry identifying the Cody-Lorentz dispersion model as the most suitable, that was capable of describing the dielectric function by a few parameters in the wavelength range from 210 to 1690 nm. The results of the optical measurements were consistent with the high material quality revealed by complementary Rutherford backscattering spectrometry and cross-sectional electron microscopy measurements, including the agreement of the layer thickness within experimental uncertainty.
- Open Access
Spectroellipsometric and ion beam analytical studies on a glazed ceramic object with metallic lustre decoration
In this work recently produced and commercially available glazed ceramic object with metallic lustre decoration was studied by using a spectroscopic ellipsometer with rotating compensator. The thickness and metal content of the surface lustre layers are determined by ion beam analytical techniques, i.e., Rutherford backscattering spectrometry and external beam particle-induced X-ray emission and the results were utilized in the construction of multilayer optical models for the evaluation and interpretation of the spectroellipsometric measurements.
Open AccessSpectroellipsometric and ion beam analytical studies on a glazed ceramic object with metallic lustre decoration
In this work recently produced and commercially available glazed ceramic object with metallic lustre decoration was studied by using a spectroscopic ellipsometer with rotating compensator. The thickness and metal content of the surface lustre layers are determined by ion beam analytical techniques, i.e., Rutherford backscattering spectrometry and external beam particle-induced X-ray emission and the results were utilized in the construction of multilayer optical models for the evaluation and interpretation of the spectroellipsometric measurements.
- 28 July 2014
- Published by Springer Nature in Journal of Materials Research
- Vol. 29 (14) , 1528-1536
Optical analysis of room temperature magnetron sputtered ITO films by reflectometry and spectroscopic ellipsometry
- 28 July 2014
- Published by Springer Nature in Journal of Materials Research
- Vol. 29 (14) , 1528-1536
Optical analysis of room temperature magnetron sputtered ITO films by reflectometry and spectroscopic ellipsometry
- 8 May 2008
- Published by Wiley in physica status solidi (c)
- Vol. 5 (5) , 1337-1340
Comparative investigation of the Si/SiO2 interface layer containing SiC crystallites using spectroscopic ellipsometry, ion beam analysis and XPS
It is known from earlier publications that SiC crystallites grow at the interface of a Si/SiO2 system during heat treatment in CO containing ambient. First 100 nm thick SiO2 layers were thermally grown on Si substrates. The Si/SiO2 structures were heat treated in CO containing atmosphere for 20 and 102 hours at 1190 oC for investigation. Spectroellipsometry was applied to study the microstructure of the heat‐treated samples. We assumed a layer at the Si/SiO2 interface that contains crystalline Si and crystalline SiC. After 20 and 102 hour annealing the layer thickness extracted from evaluation of ellipsometric data was 15 nm and 25 nm, the volume fraction of SiC was 38% and 89%, respectively. To confirm the results of the ellipsometry characterization we applied ion beam analysis and X‐ray photoelectron spectroscopy. For determination of the carbon content a 4He+ ion beam of 3.5 MeV was selected to take advantage of the scattering cross section of carbon at 165o detection angle is about six times larger than the Rutherford type one.
- 8 May 2008
- Published by Wiley in physica status solidi (c)
- Vol. 5 (5) , 1337-1340
Comparative investigation of the Si/SiO2 interface layer containing SiC crystallites using spectroscopic ellipsometry, ion beam analysis and XPS
It is known from earlier publications that SiC crystallites grow at the interface of a Si/SiO2 system during heat treatment in CO containing ambient. First 100 nm thick SiO2 layers were thermally grown on Si substrates. The Si/SiO2 structures were heat treated in CO containing atmosphere for 20 and 102 hours at 1190 oC for investigation. Spectroellipsometry was applied to study the microstructure of the heat‐treated samples. We assumed a layer at the Si/SiO2 interface that contains crystalline Si and crystalline SiC. After 20 and 102 hour annealing the layer thickness extracted from evaluation of ellipsometric data was 15 nm and 25 nm, the volume fraction of SiC was 38% and 89%, respectively. To confirm the results of the ellipsometry characterization we applied ion beam analysis and X‐ray photoelectron spectroscopy. For determination of the carbon content a 4He+ ion beam of 3.5 MeV was selected to take advantage of the scattering cross section of carbon at 165o detection angle is about six times larger than the Rutherford type one.
- 8 May 2008
- Published by Wiley in physica status solidi (c)
- Vol. 5 (5) , 1374-1377
Complex dielectric function of ion implantation amorphized SiC determined by spectroscopic ellipsometry
- 8 May 2008
- Published by Wiley in physica status solidi (c)
- Vol. 5 (5) , 1374-1377
Complex dielectric function of ion implantation amorphized SiC determined by spectroscopic ellipsometry
- 14 January 2003
- Published by Wiley in Physica Status Solidi (a)
- Vol. 195 (1) , 277-281
Determination of the complex dielectric function of ion implanted amorphous SiC by spectroscopic ellipsometry
- 14 January 2003
- Published by Wiley in Physica Status Solidi (a)
- Vol. 195 (1) , 277-281
Determination of the complex dielectric function of ion implanted amorphous SiC by spectroscopic ellipsometry