A. Handstein
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
A. Handstein has a total of 52 co-authors. Here are the top co-authors by number of shared publications:
D. Eckert
IFW Dresden, P.O.B. 270116, 01171 Dresden, Germany
7 shared publicationsK. Nenkov
Institut für Festkörper- und Werkstoffforschung Dresden, Postfach 270116, D-01171 Dresden, Germany
6 shared publicationsK.-H. Muller
5 shared publications- Karl-Hartmut Müller
IFW Dresden, P.O.B. 270116, 01171 Dresden, Germany
5 shared publications L. Schultz
Institut für Festkörper- und Werkstoffforschung Dresden, Postfach 270116, D-01171 Dresden, Germany
5 shared publicationsK.-H. Müller
Institut für Festkörper- und Werkstofforschung Dresden, Postfach 270016, D-01171 Dresden, Germany
4 shared publications
Latest Publications
- 5 November 2004
- Published by American Physical Society (APS) in Physical Review B
- Vol. 70 (17) , 174503
Evidence for strong electron-phonon coupling inThe title compound is investigated by specific heat measurements in the normal and superconducting states supplemented by upper critical field transport, susceptibility, and magnetization measurements. From a detailed analysis including also full potential electronic structure calculations for the Fermi surface sheets, Fermi velocities, and partial densities of states the presence of both strong electron-phonon interactions and considerable pair breaking has been revealed. The specific heat and the upper critical field data can be described to a first approximation by an effective single-band model close to the clean limit derived from a strongly coupled predominant hole subsystem with small Fermi velocities. However, in order to account also for Hall-conductivity and thermopower data in the literature, an effective general two-band model is proposed. This two-band model provides a flexible enough frame to describe consistently all available data within a scenario of phonon mediated -wave superconductivity somewhat suppressed by a sizable electron-paramagnon or electron-electron Coulomb interaction. For quantitative details the relevance of soft phonons and of a Van Hove–type singularity in the electronic density of states near the Fermi energy is suggested.- 5 November 2004
- Published by American Physical Society (APS) in Physical Review B
- Vol. 70 (17) , 174503
Evidence for strong electron-phonon coupling inThe title compound is investigated by specific heat measurements in the normal and superconducting states supplemented by upper critical field transport, susceptibility, and magnetization measurements. From a detailed analysis including also full potential electronic structure calculations for the Fermi surface sheets, Fermi velocities, and partial densities of states the presence of both strong electron-phonon interactions and considerable pair breaking has been revealed. The specific heat and the upper critical field data can be described to a first approximation by an effective single-band model close to the clean limit derived from a strongly coupled predominant hole subsystem with small Fermi velocities. However, in order to account also for Hall-conductivity and thermopower data in the literature, an effective general two-band model is proposed. This two-band model provides a flexible enough frame to describe consistently all available data within a scenario of phonon mediated -wave superconductivity somewhat suppressed by a sizable electron-paramagnon or electron-electron Coulomb interaction. For quantitative details the relevance of soft phonons and of a Van Hove–type singularity in the electronic density of states near the Fermi energy is suggested.- Open Access
- 1 December 2003
- Published by FapUNIFESP (SciELO) in Brazilian Journal of Physics
- Vol. 33 (4) , 718-722
Electronic structure and aspects of unconventional superconductivity in Na xCoO2.yH2O
- 1 December 2003
- Published by FapUNIFESP (SciELO) in Brazilian Journal of Physics
- Vol. 33 (4) , 718-722
Open AccessElectronic structure and aspects of unconventional superconductivity in Na xCoO2.yH2O
- 9 May 2003
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 93 (10) , 8325-8327
Slow relaxation of grain boundary resistance in a ferromagnetic manganite
The resistance relaxation of a polycrystalline ferromagnetic thin film has been studied. Time-dependent resistance data recorded after field pulses of 7 and 47 T, respectively, show a pronounced relaxation of approximately logarithmic type for and temperatures The resistance relaxation has also been measured in a superconducting quantum interference device magnetometer, yielding similar relaxation rates. An unusual increase of the relaxation rate with decreasing temperature down to 4.2 K is observed. While polycrystalline samples show this type of relaxation, it is absent in an epitaxial film, indicating the origin in the grain boundary regions between misaligned grains. Slow relaxation might be caused by spin glass-like magnetic order at grain boundaries; however, no freezing temperature has been found down to 4.2 K.- 9 May 2003
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 93 (10) , 8325-8327
Slow relaxation of grain boundary resistance in a ferromagnetic manganite
The resistance relaxation of a polycrystalline ferromagnetic thin film has been studied. Time-dependent resistance data recorded after field pulses of 7 and 47 T, respectively, show a pronounced relaxation of approximately logarithmic type for and temperatures The resistance relaxation has also been measured in a superconducting quantum interference device magnetometer, yielding similar relaxation rates. An unusual increase of the relaxation rate with decreasing temperature down to 4.2 K is observed. While polycrystalline samples show this type of relaxation, it is absent in an epitaxial film, indicating the origin in the grain boundary regions between misaligned grains. Slow relaxation might be caused by spin glass-like magnetic order at grain boundaries; however, no freezing temperature has been found down to 4.2 K.- Open Access
Fully dense MgB_2 superconductor textured by hot deformation
Bulk textured MgB_2 material of nearly full density showing a weak c-axis alignment of the hexagonal MgB_2 grains parallel to the pressure direction was obtained by hot deformation of a stoichiometric MgB_2 pellet prepared by a gas-solid reaction. The texture of the material was verified by comparing the x-ray diffraction patterns of the hot deformed material with isotropic MgB_2 powder. A small, but distinct anisotropy of the upper critical field up to Hc2^{a,b}/Hc2^{c}~1.2 depending on degree of texture was found by resistance and susceptibility measurements. No anisotropy of the critical current density determined from magnetization measurements was found for the textured material.
Open AccessFully dense MgB_2 superconductor textured by hot deformation
Bulk textured MgB_2 material of nearly full density showing a weak c-axis alignment of the hexagonal MgB_2 grains parallel to the pressure direction was obtained by hot deformation of a stoichiometric MgB_2 pellet prepared by a gas-solid reaction. The texture of the material was verified by comparing the x-ray diffraction patterns of the hot deformed material with isotropic MgB_2 powder. A small, but distinct anisotropy of the upper critical field up to Hc2^{a,b}/Hc2^{c}~1.2 depending on degree of texture was found by resistance and susceptibility measurements. No anisotropy of the critical current density determined from magnetization measurements was found for the textured material.
- 12 June 2000
- Published by AIP Publishing in Applied Physics Letters
- Vol. 76 (24) , 3627-3629
High coercivity of Nd–Dy–Fe–(C, B) ribbons prepared by melt spinning
- 12 June 2000
- Published by AIP Publishing in Applied Physics Letters
- Vol. 76 (24) , 3627-3629
High coercivity of Nd–Dy–Fe–(C, B) ribbons prepared by melt spinning
- Open Access
- 1 May 2000
- Published by Institute of Physics, Polish Academy of Sciences in Acta Physica Polonica A
- Vol. 97 (5) , 791-794
Giant Magnetoresistance in Melt-Spun Co-Cu Modified by Rare Earths
- 1 May 2000
- Published by Institute of Physics, Polish Academy of Sciences in Acta Physica Polonica A
- Vol. 97 (5) , 791-794
Open AccessGiant Magnetoresistance in Melt-Spun Co-Cu Modified by Rare Earths
- Open Access
- 1 May 2000
- Published by Institute of Physics, Polish Academy of Sciences in Acta Physica Polonica A
- Vol. 97 (5) , 787-790
Low-Field Magnetoresistance in Manganite Thin Films
- 1 May 2000
- Published by Institute of Physics, Polish Academy of Sciences in Acta Physica Polonica A
- Vol. 97 (5) , 787-790
Open AccessLow-Field Magnetoresistance in Manganite Thin Films
- 1 January 1999
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 35 (5) , 3247-3249
High pressure gas-solid interstitial modification with H and N atoms and HDDR processing of Nd(Fe,M)/sub 12/ (M=Ti,V,Mo)
- 1 January 1999
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 35 (5) , 3247-3249
High pressure gas-solid interstitial modification with H and N atoms and HDDR processing of Nd(Fe,M)/sub 12/ (M=Ti,V,Mo)
- Open Access
- 1 August 1997
- Published by Institute of Physics, Polish Academy of Sciences in Acta Physica Polonica A
- Vol. 92 (2) , 307-310
Composition and Temperature Dependence of Giant Magnetoresistance in Melt-Spun Co x Cu 100-x Ribbons
- 1 August 1997
- Published by Institute of Physics, Polish Academy of Sciences in Acta Physica Polonica A
- Vol. 92 (2) , 307-310
Open AccessComposition and Temperature Dependence of Giant Magnetoresistance in Melt-Spun Co x Cu 100-x Ribbons
- 15 April 1997
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 81 (8) , 4539-4541
Thermostability of Sm2(FeGa)17Cy prepared by gas-solid reaction (GSR)
The gas-solid-reaction (GSR) was used to introduce interstitial carbon atoms into Sm2Fe17−xGax compounds with x=0, 0.5, 1, and 2. For this process, powders made from homogenized ingots were annealed at 500 °C under methane for different times. The thermostability increases for small amounts of Ga and the investigation shows that Sm2Fe16.5Ga0.5Cy is stable up to 750 °C. In the case of Sm2Fe15Ga2Cy carburized for 6 h (y=2.0) and 18 h (y=2.2), the x-ray diffraction patterns show the Th2Zn17-type structure only. After annealing at 800 °C for 20 min the 6 h carburized sample shows a small amount of α-Fe and other phases and there is a large Fe content after annealing at 850 °C. For an 18 h carburized sample, less Fe and no other phases have be seen after annealing at 800 °C, i.e., the material is nearly single phase. The result that longer carburization times stabilize the Th2Zn17-type structure could also be manifested by Kerr microscopy. A comparison with mechanically alloyed Sm2Fe15Ga2C2 powders prepared with Sm excess shows that those are very stable up to 900 °C. The density of fine-grained Sm2Fe17−xGaxCy could be increased by hot pressing, but the degree of compaction and the phase purity very sensitively depend on the Ga content.
- 15 April 1997
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 81 (8) , 4539-4541
Thermostability of Sm2(FeGa)17Cy prepared by gas-solid reaction (GSR)
The gas-solid-reaction (GSR) was used to introduce interstitial carbon atoms into Sm2Fe17−xGax compounds with x=0, 0.5, 1, and 2. For this process, powders made from homogenized ingots were annealed at 500 °C under methane for different times. The thermostability increases for small amounts of Ga and the investigation shows that Sm2Fe16.5Ga0.5Cy is stable up to 750 °C. In the case of Sm2Fe15Ga2Cy carburized for 6 h (y=2.0) and 18 h (y=2.2), the x-ray diffraction patterns show the Th2Zn17-type structure only. After annealing at 800 °C for 20 min the 6 h carburized sample shows a small amount of α-Fe and other phases and there is a large Fe content after annealing at 850 °C. For an 18 h carburized sample, less Fe and no other phases have be seen after annealing at 800 °C, i.e., the material is nearly single phase. The result that longer carburization times stabilize the Th2Zn17-type structure could also be manifested by Kerr microscopy. A comparison with mechanically alloyed Sm2Fe15Ga2C2 powders prepared with Sm excess shows that those are very stable up to 900 °C. The density of fine-grained Sm2Fe17−xGaxCy could be increased by hot pressing, but the degree of compaction and the phase purity very sensitively depend on the Ga content.