Wuchang Wang has a total of 57 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Effects of Diameter Transitions on Cyclopentane Hydrate Blockage and Dissociation in Flow Loops

    by Jigang Liu, Meijin Tian, Yanyun Xiao, Wuchang Wang

    Hydrate blockage in pipelines poses a significant risk during oil and gas production as well as natural gas hydrate exploitation. Existing studies on hydrate blockage have primarily focused on pipelines with constant diameters, while the formation and evolution of hydrate blockage in variable-diameter pipelines remain insufficiently understood. However, diameter transitions such as reducers are ubiquitous in practical oil and gas production systems. In this study, the formation, blockage, and dissociation behaviors of cyclopentane hydrates in two types of reducing pipelines were systematically investigated using a self-designed flow loop equipped with reducers, under varying cyclopentane–water volume ratios and flow conditions. The results show that at low flow velocities of 0.4 and 0.8 m/s, cyclopentane preferentially accumulates in the larger-diameter section and cannot be uniformly dispersed in water, resulting in incomplete hydrate formation. At a higher flow velocity of 1.6 m/s, diameter reduction significantly increases the susceptibility of the pipeline to hydrate blockage, and the blockage time decreases progressively with increasing cyclopentane-to-water ratio. For the thin pipe to the thick pipe (pipeline I), hydrate deposition initiates at the upper shoulder of the reducer and subsequently propagates downward to form a complete blockage. The unplugging process occurs in two stages: first, the hydrate plug in the larger pipe section migrates downstream and gradually dissociates; subsequently, hydrates in the smaller pipe are transported into the larger pipe under the action of the inverter pump, where they further dissociate. For the thick pipe to the thin pipe (pipeline II), hydrate deposition follows a similar initial pattern; however, during dissociation, secondary blockage occurs due to the reduced pipe diameter, leading to a longer dissociation time under identical heating conditions compared with reducing pipeline I. These findings provide important insights into hydrate blockage mechanisms in reducing pipelines and offer practical guidance for hydrate blockage prevention and removal at diameter-transition sections.

  • Open Access

    A PSO-Optimized Convolutional Neural Network for Viscosity Prediction in High-Water-Cut Crude Oil Systems

    by Xiaoyuan Miao, Wuchang Wang, Qing Li, Kun Wang, Chaohui Chen, Ze Song

    As oilfield development progresses to its later stages, the produced fluid increasingly becomes high-water-cut crude oil. In such systems, the intricate interaction between oil and water phases results in viscosity being influenced by several factors, including temperature, water cut, and flow velocity, in a complex and interrelated manner. This complexity makes it challenging to precisely characterise the dynamic changes in viscosity. Traditional empirical correlation equations often fall short in accuracy and generalisation, particularly within the high-water-cut range. To address the need for accurate predictions of apparent viscosity, this paper introduces a prediction model based on a convolutional neural network optimised by particle swarm optimisation.Utilising viscosity data obtained through indoor loop experiments on a high-water-cut oil-water mixed system using a certain crude oil from China, this model integrates the number and size of convolution kernels with training hyperparameters, including learning rate, batch size, and training epochs, into the particle swarm global optimisation process. This method addresses parameter tuning issues in both the structure and training domains simultaneously, thereby enhancing convergence stability and accuracy in scenarios characterised by small samples and strong nonlinearity, surpassing manual or grid parameter tuning methods. Comparative evaluations with existing models, namely the Multilayer Perceptron and the Transformer, reveal that the proposed model achieves a superior coefficient of determination of 0.9420 and a root-mean-square error of 6.695, indicating significantly greater accuracy and robustness.

  • Open Access

    Variable-Condition Operational Optimization of Oil and Gas Gathering Systems Considering Renewable Energy Accommodation: A Comprehensive Review and Future Perspectives

    by Shichen Wang, Wuchang Wang

    The accelerating global energy transition imposes a pressing need for decarbonizing upstream oil and gas production. Characterized by significant thermal–hydraulic inertia, gathering systems possess immense potential as “flexible loads” for accommodating local wind and solar energy. However, this potential is constrained by stringent Flow Assurance (FA) boundaries, primarily due to nonlinear rheological transitions and blockage risks during the variable-condition transport of high-water-cut waxy crude oil. Addressing this bottleneck, this review elucidates advances in utilizing crude oil–water blending as a pivotal physical control lever to synergize system safety and renewable accommodation. An integrated “mechanism–modeling–control” framework is established, analyzing oil–water interfacial evolution, Wall-Sticking Onset Temperature (WSOT) drift, and blockage hysteresis to define actionable safety boundaries. Dynamic modeling techniquesfrom High-Fidelity Physics-Based Models (PBMs) to Physics-Informed Neural Networks (PINN) and Digital Twins (DT)are critically evaluated, highlighting hybrid paradigms resolving the accuracy–efficiency trade-off. Furthermore, hierarchical optimization strategies integrating Robust/Stochastic Programming with Deep Reinforcement Learning (DRL) are systematically presented to reconcile renewable uncertainty with rigid safety constraints. The review indicates that transforming gathering systems into “Flexible Prosumers” requires an integrated paradigm encompassing transient multiphase flow mechanisms, high-fidelity hybrid modeling, and adaptive robust control, providing a scientific basis for maximizing renewable utilization while ensuring flow assurance.


  • Inhibition Performance of Cocamidopropyl Betaine on Hydrate Formation and Agglomeration and Its Synergistic Effect with Pectin

    by Tianhong Xu, Yuchuan Qian, Wuchang Wang, Zheng Xu, Yun Zhong, Yanyun Xiao, Yuxing Li

  • Decomposition Characteristics of Hydrate Sediment Shedding Blocks under Flow Conditions: Effect of Temperature, Inhibitor Concentration, and Stirring

    by Yun Zhong, Yanyun Xiao, Yuchuan Qian, Zheng Xu, Tianhong Xu, Wuchang Wang, Yuxing Li

    The dynamics of the hydrate deposit layer and its potential risks during the flow assurance process of oil and gas transmission pipelines have not been fully clarified. Although existing measures can affect the sedimentary layer, the dislodged blocks generated during its decomposition may trigger secondary plugging, which in turn threatens the safe operation of pipelines. In this study, the decomposition pattern of the hydrate shedding block was investigated by a visual high-pressure reactor at different temperatures (3-11 °C), stirring rates (0-200 rpm), and methyl ethylene glycol (MEG) concentrations (0-40 wt %), with hydrate formation at 5 MPa and decomposition at 1.013 MPa. The study has, for the first time, discovered that a critical temperature exists in the decomposition process. When temperatures fall below this critical threshold, decomposition is governed by heat transfer or diffusion; upon reaching or exceeding this value, the process shifts to being dominated by interfacial reactions, resulting in a "sensitive jump" in decomposition rate. Further research reveals that the promoting effect of fluid shear (stirring) exhibits temperature dependency: at a low temperature of 3 °C, vigorous stirring at 200 rpm can increase the decomposition rate by over 330%; however, at temperatures ≥9 °C, this enhancing effect significantly diminishes. Additionally, a nonlinear synergistic relationship exists between MEG concentration and stirring intensity: moderate MEG concentrations (10-20%) exhibit optimal synergistic effects with 150 rpm stirring, whereas excessive MEG (≥30%) actually diminishes the stirring enhancement effect. It is suggested for the first time that there may be sensitive jump values or intervals for hydrate decomposition, and an operational window for the synergistic regulation of "inhibitor concentration-fluid shear" is established, which provides a new kinetic regulation strategy for the safe development of hydrates.


  • Study on the Dynamic Damage Mechanism and Kinetic Evolution Law of the Hydrate Deposit Layer under Stress in Deep-Water Pipelines

    by Yuchuan Qian, Tianhong Xu, Haiyuan Yao, Guangchun Song, Dan Li, Yuxing Li, Wuchang Wang

    Natural gas hydrate deposition poses a significant threat to pipeline transportation safety. Due to the high-pressure, sealed environment in which hydrates form, it is challenging to analyze the microdamage characteristics of hydrate layers under dynamic conditions using conventional equipment. This limitation hinders our understanding of the damage evolution patterns and mechanisms within deposited layers under stress loading. This study combines experimental and numerical simulation methods to clarify the mechanical evolution of hydrate deposits. A predictive model was established for consolidation forces as a function of the consolidation time and subcooling degree. For the first time, a discrete element simulation was used to model deposits with structural strength gradients, analyzing damage mechanisms and evolution patterns under stress loading. The consolidation strength of the hydrate deposit layer exhibits a trend of initially increasing significantly with the consolidation time before gradually stabilizing. Under stress loading, tensile damage dominates the failure mechanism. Consolidation time has little effect on the crack ratio; however, as stress loading intensifies, the ratio of tensile cracks to shear cracks decreases from 7:1 to 4:1. Furthermore, the codirectional nature of gravitational and contact forces results in a greater tendency for damage along the deposit layer's longitudinal direction. The failure patterns of these deposits are influenced by stress concentration paths and the direction of aging consolidation gradients, which lead to differences in the degree of destruction. This study establishes the first research framework for examining damage evolution in deep-water pipeline hydrate deposits, providing a theoretical foundation for the study of hydrate deposit stability.


  • Effect of Water Content and Shear Rate on Wax-Containing Water-in-Oil Emulsion Hydrate Formation and Aggregation

    by Wuchang Wang, Tianhong Xu, Xin Geng, Guangchun Song, Zheng Xu, Minghui Yao, Yuchuan Qian, Yuxing Li


  • Study on the Effect of Hydrate Kinetic Inhibitors on the Structural Stability of Gas Hydrates and the Development of Fractures during Fluid Scouring

    by Yuchuan Qian, Tianhong Xu, Haiyuan Yao, Guangchun Song, Yuxing Li, Wuchang Wang, Xinran Yu, Zheng Xu

    Flow blockage caused by hydrate deposition in deep-water-oil and gas pipelines seriously affects the safety of energy transmission. The structural stability of hydrates has a direct influence on the assessment of the development of hydrate deposition in pipelines, and the situation under hydrate-inhibitor-containing conditions may be more complicated. The effect of inhibitors on the structural stability of hydrate deposition under the action of flow scouring has not yet been clarified. The present study was based on the process of hydrate formation transformation under kinetic inhibitor-containing pectin conditions. The "concentration effect" of the pectin system causes the hydrate particle morphology to change from acicular to punctate. For the first time, the evolution model of microscopic fracture in the hydrate bed under the action of flow scouring in the high-mass transfer region was clarified. It was determined by microscopic dynamic data that there was reformation and filling of hydrate particles between the flow scouring fracture as well as growth and extension behavior, and a chain initiation-induced nucleation effect of hydrate particles was proposed. It was further found that pectin weakened the cohesion of hydrate particles, but when the pectin concentration was 0.25 wt %, there was an abnormal increase in cohesion. Enhanced mass transfer due to structural destabilization of the hydrate layer may be responsible for the continued formation and transformation of pectin system hydrates at low shear rates. This study shows for the first time the correlation between inhibitor concentration and hydrate conversion from the perspective of structural stability of hydrate beds and provides a theoretical basis for the engineering application of green inhibitors.


  • Study on Decomposition Characteristics of Natural Gas Hydrate in Pipeline under the Condition of Thermodynamic Inhibitor

    by Wuchang Wang, Zheng Xu, Kunming Song, Tianhong Xu, Yuchuan Qian, Minghui Yao, Guangchun Song, Yuxing Li

    Hydrate deposits in gathering pipelines for deep-sea oil and gas extraction can reduce the flow area of the pipeline and, in severe cases, cause pipeline blockage, resulting in huge economic losses. A high-pressure reactor and a semicircular pipe were used to simulate hydrate decomposition in a pipe wall environment. A steel plate of the same material was used to investigate the decomposition mechanism of thermodynamic inhibitors under microscopic conditions. The mechanism and model for hydrate decomposition in the pipe wall under thermodynamic inhibitor conditions were proposed. The decomposition mode of glycol solution is contact-induced decomposition. The hydrate decomposes from bottom to top, forming areas of different colors: decomposed, transitional, and undecomposed. The decomposition rate of hydrate accelerates with the increase of injection rate, but the decomposition efficiency decreases gradually. In the volume concentration range of 30-70%, increasing the concentration of glycol solution can significantly reduce the decomposition time of hydrates. It is demonstrated that high-concentration glycol solutions mainly accelerate the decomposition of hydrates away from the injection point, thereby increasing the decomposition rate. Decomposition efficiency peaks at 50% concentration and drops sharply when concentration rises from 50 to 70%.