Gustav Plesch
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Gustav Plesch has a total of 32 co-authors. Here are the top co-authors by number of shared publications:
Agáta Dujavová
Institute of Electrical Engineering, SAS SK-841 04 Bratislava Slovakia SK-841 04 Bratislava Slovakia
2 shared publicationsAlexander Cigáň
Institute of Measurement Science, Slovak Academy of Sciences, 841 04, Bratislava, Slovak Republic
2 shared publicationsJán Maňka
Institute of Measurement Science, Slovak Academy of Sciences, 841 04, Bratislava, Slovak Republic
2 shared publicationsMichaela Valeriánová
2 shared publicationsVladimír Štrbík
2 shared publicationsZuzana Matkovičová
2 shared publications
Latest Publications
- Open Access
- 31 August 2023
- Published by MDPI AG in International Journal of Molecular Sciences
- Vol. 24 (17) , 13553
Mechanism of Action and Efficiency of Ag3PO4-Based Photocatalysts for the Control of Hazardous Gram-Positive Pathogens
Silver phosphate and its composites have been attracting extensive interest as photocatalysts potentially effective against pathogenic microorganisms. The purpose of the present study was to investigate the mechanism of bactericidal action on cells of opportunistic pathogens. The Ag3PO4/P25 (AGP/P25) and Ag3PO4/HA (HA/AGP) powders were prepared via a co-precipitation method. Thereafter, their antimicrobial properties against Enterococcus faecalis, Staphylococcus epidermidis, and Staphylococcus aureus (clinical and reference strains) were analyzed in the dark and after exposure to visible light (VIS). The mechanism leading to cell death was investigated by the leakage of metabolites and potassium ions, oxidative stress, and ROS production. Morphological changes of the bacterial cells were visualized by transmission electron microscopy (TEM) and scanning transmission electron microscopy with energy-dispersive X-ray spectroscopy (SEM EDS) analysis. It has been shown that Ag3PO4-based composites are highly effective agents that can eradicate 100% of bacterial populations during the 60 min photocatalytic inactivation. Their action is mainly due to the production of hydroxyl radicals and photogenerated holes which lead to oxidative stress in cells. The strong affinity to the bacterial cell wall, as well as the well-known biocidal properties of silver itself, increase undoubtedly the antimicrobial potential of the Ag3PO4-based composites.
- 31 August 2023
- Published by MDPI AG in International Journal of Molecular Sciences
- Vol. 24 (17) , 13553
Open AccessMechanism of Action and Efficiency of Ag3PO4-Based Photocatalysts for the Control of Hazardous Gram-Positive Pathogens
Silver phosphate and its composites have been attracting extensive interest as photocatalysts potentially effective against pathogenic microorganisms. The purpose of the present study was to investigate the mechanism of bactericidal action on cells of opportunistic pathogens. The Ag3PO4/P25 (AGP/P25) and Ag3PO4/HA (HA/AGP) powders were prepared via a co-precipitation method. Thereafter, their antimicrobial properties against Enterococcus faecalis, Staphylococcus epidermidis, and Staphylococcus aureus (clinical and reference strains) were analyzed in the dark and after exposure to visible light (VIS). The mechanism leading to cell death was investigated by the leakage of metabolites and potassium ions, oxidative stress, and ROS production. Morphological changes of the bacterial cells were visualized by transmission electron microscopy (TEM) and scanning transmission electron microscopy with energy-dispersive X-ray spectroscopy (SEM EDS) analysis. It has been shown that Ag3PO4-based composites are highly effective agents that can eradicate 100% of bacterial populations during the 60 min photocatalytic inactivation. Their action is mainly due to the production of hydroxyl radicals and photogenerated holes which lead to oxidative stress in cells. The strong affinity to the bacterial cell wall, as well as the well-known biocidal properties of silver itself, increase undoubtedly the antimicrobial potential of the Ag3PO4-based composites.
- Open Access
- 24 September 2010
- Published by Walter de Gruyter GmbH in Open Physics
- Vol. 9 (1) , 213-221
Effects of low-level La doping and ageing on TlPb-1223 high T c superconductors
Bulk samples of the nominal composition of (Tl0.6Pb0.5)(Sr0.8Ba0.2)2Ca2Cu3O8+δ−xLaO1.5 (x = 0–0.1) were prepared by using two-step process and their microstructure, T c values, and magnetization were studied. The samples consist of the Tl-1223 dominant phase with small Tl-1212 admixture, which increases with a rise of La content. Five years ageing and following oxygen annealing at 450°C and subsequently at 750°C have only a modest effect on T c values of the studied samples. Low-level La doping (x = 0:04) leads to an increase of T c values by about 2 K in comparison with undoped samples. Oxygen annealing at 750°C results in an increase in the volume magnetization hysteresis in low applied magnetic fields and rise of critical current density at zero magnetic field and 77 K. This effect is most pronounced for the low La doped sample with x = 0.04. Changes of the induced voltage, U originating in the Meissner effect and of its harmonics in dependence on temperature were measured and used for characterization of the temperature distribution of inter-grain junctions.
- 24 September 2010
- Published by Walter de Gruyter GmbH in Open Physics
- Vol. 9 (1) , 213-221
Open AccessEffects of low-level La doping and ageing on TlPb-1223 high T c superconductors
Bulk samples of the nominal composition of (Tl0.6Pb0.5)(Sr0.8Ba0.2)2Ca2Cu3O8+δ−xLaO1.5 (x = 0–0.1) were prepared by using two-step process and their microstructure, T c values, and magnetization were studied. The samples consist of the Tl-1223 dominant phase with small Tl-1212 admixture, which increases with a rise of La content. Five years ageing and following oxygen annealing at 450°C and subsequently at 750°C have only a modest effect on T c values of the studied samples. Low-level La doping (x = 0:04) leads to an increase of T c values by about 2 K in comparison with undoped samples. Oxygen annealing at 750°C results in an increase in the volume magnetization hysteresis in low applied magnetic fields and rise of critical current density at zero magnetic field and 77 K. This effect is most pronounced for the low La doped sample with x = 0.04. Changes of the induced voltage, U originating in the Meissner effect and of its harmonics in dependence on temperature were measured and used for characterization of the temperature distribution of inter-grain junctions.
- 11 August 2008
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 461 (1-2) , 61-65
YBa2Cu3O7 melt textured thick films grown by infiltration process on YSZ substrate prepared by sol–gel method
- 11 August 2008
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 461 (1-2) , 61-65
YBa2Cu3O7 melt textured thick films grown by infiltration process on YSZ substrate prepared by sol–gel method
- Open Access
- 1 January 2007
- Published by Walter de Gruyter GmbH in Open Physics
- Vol. 5 (3) , 398-404
Tl-based superconducting films prepared by aerosol spray deposition and thallinated in an open system
Superconducting Tl-based films were prepared on a LaAlO3 single crystal substrate. Spray pyrolysis of Ba, Ca and Cu nitrate solutions was used for deposition of the precursor films. They were subsequently ex-situ thallinated in flowing oxygen (open system). While the superconducting Tl-2212 phase formed at an annealing temperature of 880°C, thallination at 900°C led to the formation of a Tl-2223 /Tl-2212 mixture. The amount of Tl-2223 increased with prolonged thallination, whereas the Tl-2212 phase progressively disappeared. Films prepared in such a manner were c-oriented and contained only low amounts of non-superconducting impurities. The resulting samples were characterized by XRD and SEM and their T C values were determined by resistive four-point measurements. They showed critical temperatures in the range of T ON = 125–135 K, T C0 = 91–93 K. Differences between the composition and properties of the obtained films and those thallinated in closed systems under 50 kPa of oxygen are discussed in this paper. Results show that the Tl-2212 → Tl-2223 transformation proceeds at a slower rate under flowing oxygen than in a closed system.
- 1 January 2007
- Published by Walter de Gruyter GmbH in Open Physics
- Vol. 5 (3) , 398-404
Open AccessTl-based superconducting films prepared by aerosol spray deposition and thallinated in an open system
Superconducting Tl-based films were prepared on a LaAlO3 single crystal substrate. Spray pyrolysis of Ba, Ca and Cu nitrate solutions was used for deposition of the precursor films. They were subsequently ex-situ thallinated in flowing oxygen (open system). While the superconducting Tl-2212 phase formed at an annealing temperature of 880°C, thallination at 900°C led to the formation of a Tl-2223 /Tl-2212 mixture. The amount of Tl-2223 increased with prolonged thallination, whereas the Tl-2212 phase progressively disappeared. Films prepared in such a manner were c-oriented and contained only low amounts of non-superconducting impurities. The resulting samples were characterized by XRD and SEM and their T C values were determined by resistive four-point measurements. They showed critical temperatures in the range of T ON = 125–135 K, T C0 = 91–93 K. Differences between the composition and properties of the obtained films and those thallinated in closed systems under 50 kPa of oxygen are discussed in this paper. Results show that the Tl-2212 → Tl-2223 transformation proceeds at a slower rate under flowing oxygen than in a closed system.
- 1 January 2007
- Published by Walter de Gruyter GmbH in Open Physics
- Vol. 5 (2) , 229-235
Influence of the reaction conditions on the formation of Tl(Re)-Ba-Ca-Cu-O superconducting thin films by thallination in open system
Rhenium avoids air degradation of the target as well as of precursor thin films during the preparation of high temperature Tl-based superconductors. Addition of Re has been used during synthesis of oriented Tl(Re)-Ba-Ca-Cu-O films. High temperature superconducting Tl-based thin films were prepared by a two step method combining RF magnetron sputtering and ex-situ thallination. Precursors with a composition of Re0.1Ba2Ca2Cu3Ox were deposited on a CeO2 buffered R-plane sapphire substrate. The sputtered films were prepared at room temperature in an Ar atmosphere. The thallination of the precursor films was performed in a one zone configuration, where both the pellet and precursor film were kept at the same temperature. The thallination temperature varied in the range of 850–880°C and samples were held for 30, 45 and 60 min at this temperature in a flowing oxygen atmosphere. Besides Tl-2212, X-ray diffraction reveals the possibility of also preparing the Tl-2223 phase, which was until now not reported in a Re doped form.
- 1 January 2007
- Published by Walter de Gruyter GmbH in Open Physics
- Vol. 5 (2) , 229-235
Influence of the reaction conditions on the formation of Tl(Re)-Ba-Ca-Cu-O superconducting thin films by thallination in open system
Rhenium avoids air degradation of the target as well as of precursor thin films during the preparation of high temperature Tl-based superconductors. Addition of Re has been used during synthesis of oriented Tl(Re)-Ba-Ca-Cu-O films. High temperature superconducting Tl-based thin films were prepared by a two step method combining RF magnetron sputtering and ex-situ thallination. Precursors with a composition of Re0.1Ba2Ca2Cu3Ox were deposited on a CeO2 buffered R-plane sapphire substrate. The sputtered films were prepared at room temperature in an Ar atmosphere. The thallination of the precursor films was performed in a one zone configuration, where both the pellet and precursor film were kept at the same temperature. The thallination temperature varied in the range of 850–880°C and samples were held for 30, 45 and 60 min at this temperature in a flowing oxygen atmosphere. Besides Tl-2212, X-ray diffraction reveals the possibility of also preparing the Tl-2223 phase, which was until now not reported in a Re doped form.
- 1 December 1999
- Published by Elsevier in International Journal of Inorganic Materials
- Vol. 1 (5-6) , 337-341
Tl-based high-Tc superconducting films prepared by aerosol deposition
- 1 December 1999
- Published by Elsevier in International Journal of Inorganic Materials
- Vol. 1 (5-6) , 337-341
Tl-based high-Tc superconducting films prepared by aerosol deposition
- 1 October 1998
- Published by Elsevier in Physica C: Superconductivity and its Applications
- Vol. 307 (1-2) , 74-78
Thin (Hg,Pb)Ba2CaCu2Oy films prepared from thermally evaporated precursors by post annealing in Hg-atmosphere
- 1 October 1998
- Published by Elsevier in Physica C: Superconductivity and its Applications
- Vol. 307 (1-2) , 74-78
Thin (Hg,Pb)Ba2CaCu2Oy films prepared from thermally evaporated precursors by post annealing in Hg-atmosphere