FSFrancesco Svelto
Francesco Svelto
*This is an algorithmically generated author record based on publicly available information.
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Francesco Svelto has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
- Andrea Mazzanti
Dipartimento di Ingegneria dell’Informazione, Università di Modena e Reggio Emila, via Vignolese 905, 41100 Modena, Italy
4 shared publications - Dan Li
Faculty of Electronic and Information Engineering, Xi’an Jiaotong University, Xi’an 710049, China
2 shared publications - Paolo Rossi
Università di Pavia
2 shared publications - Pietro Andreani
Technical University of Denmark
2 shared publications Andrea Ghilioni
Università degli Studi di Pavia
1 shared publication- Andrea Ghilioni
Pavia R&D center, eSilicon, Pavia, Lombardia Italy
1 shared publication
Latest Publications
- Open Access
- 17 May 2025
- Published by MDPI AG in Micromachines
- Vol. 16 (5) , 587
CMOS Low-Power Optical Transceiver for Short Reach
The emergence of the AI era driven by Large Language Models (LLMs) and the next-generation high-definition multimedia interface for immersive technologies (AR/VR/metaverse) have created an unprecedented demand for high-bandwidth interconnects. While optical communication systems provide a broad bandwidth, their relatively low power efficiency continues to limit their deployment in new applications. This work addresses the power efficiency challenges in CMOS optical transceiver design, leveraging the inherent cost and integration advantages of CMOS technology. After outlining the design principles for low-power optical transmitter (Tx) and receiver (Rx) design, we present a comprehensive design of a low-power optical transceiver chipset implemented in 28 nm CMOS. The Tx features a high-impedance asymmetric current-steering output stage with a stacked architecture that facilitates unipolar power supply operation for the efficient anode driving of a common-cathode VCSEL array and achieved a power efficiency of 1.59 pJ/bit. The Rx incorporates a tail-current-controlled Cherry–Hooper-based variable gain amplifier (VGA), which achieved a transimpedance gain that ranged from 68.4 to 78.5 dB and a power efficiency of 1.06 pJ/bit. The Rx–Tx back-to-back measurements confirmed successful data transmission at 4 × 20 Gbps, which demonstrated an overall power efficiency of 2.65 pJ/bit.- 17 May 2025
- Published by MDPI AG in Micromachines
- Vol. 16 (5) , 587
Open AccessCMOS Low-Power Optical Transceiver for Short Reach
The emergence of the AI era driven by Large Language Models (LLMs) and the next-generation high-definition multimedia interface for immersive technologies (AR/VR/metaverse) have created an unprecedented demand for high-bandwidth interconnects. While optical communication systems provide a broad bandwidth, their relatively low power efficiency continues to limit their deployment in new applications. This work addresses the power efficiency challenges in CMOS optical transceiver design, leveraging the inherent cost and integration advantages of CMOS technology. After outlining the design principles for low-power optical transmitter (Tx) and receiver (Rx) design, we present a comprehensive design of a low-power optical transceiver chipset implemented in 28 nm CMOS. The Tx features a high-impedance asymmetric current-steering output stage with a stacked architecture that facilitates unipolar power supply operation for the efficient anode driving of a common-cathode VCSEL array and achieved a power efficiency of 1.59 pJ/bit. The Rx incorporates a tail-current-controlled Cherry–Hooper-based variable gain amplifier (VGA), which achieved a transimpedance gain that ranged from 68.4 to 78.5 dB and a power efficiency of 1.06 pJ/bit. The Rx–Tx back-to-back measurements confirmed successful data transmission at 4 × 20 Gbps, which demonstrated an overall power efficiency of 2.65 pJ/bit. - 15 September 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 38 (18) , 4978-4986
Multi-Rate Low-Noise Optical Receiver Front-End
Conventional optical receivers are mostly optimized for single data rate. In this work, after examining various types of optical receiver front-ends, we present the low-noise tunable front-end (LNTF) topology, which is able to achieve optimized noise performance at multiple data rates. In addition, colored noise optimization techniques including capacitive noise scaling and CMOS inverter based transimpedance amplifier (TIA) are also studied, which together with the LNTF form a low-noise design methodology for silicon photonics based CMOS optical receiver. Employing these techniques, the implemented 3D hybrid-integrated silicon photonics receiver achieves excellent noise performance of 0.91μArms and 0.5μArms input-referred noise current at 25Gb/s and 10Gb/s, respectively, which enables high sensitivity of -14.6dBm and -16.5dBm OMA at BER = 10 $^12$ , correspondingly.- 15 September 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 38 (18) , 4978-4986
Multi-Rate Low-Noise Optical Receiver Front-End
Conventional optical receivers are mostly optimized for single data rate. In this work, after examining various types of optical receiver front-ends, we present the low-noise tunable front-end (LNTF) topology, which is able to achieve optimized noise performance at multiple data rates. In addition, colored noise optimization techniques including capacitive noise scaling and CMOS inverter based transimpedance amplifier (TIA) are also studied, which together with the LNTF form a low-noise design methodology for silicon photonics based CMOS optical receiver. Employing these techniques, the implemented 3D hybrid-integrated silicon photonics receiver achieves excellent noise performance of 0.91μArms and 0.5μArms input-referred noise current at 25Gb/s and 10Gb/s, respectively, which enables high sensitivity of -14.6dBm and -16.5dBm OMA at BER = 10 $^12$ , correspondingly.- 24 July 2014
- Published by Springer Nature
- p. 233-252
The Impact of CMOS Scaling on the Design of Circuits for mm-Wave Frequency Synthesizers
- 24 July 2014
- Published by Springer Nature
- p. 233-252
The Impact of CMOS Scaling on the Design of Circuits for mm-Wave Frequency Synthesizers
- 30 November 2007
- Published by Elsevier in Microelectronics Journal
- Vol. 38 (10-11) , 1057-1063
CMOS balanced regenerative frequency dividers for wide-band quadrature LO generation
- 30 November 2007
- Published by Elsevier in Microelectronics Journal
- Vol. 38 (10-11) , 1057-1063
CMOS balanced regenerative frequency dividers for wide-band quadrature LO generation
- 18 January 2007
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 53 (1) , 35-42
A 0.18 μm CMOS direct down-converter for highly integrated 3G receivers
- 18 January 2007
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 53 (1) , 35-42
A 0.18 μm CMOS direct down-converter for highly integrated 3G receivers
- 1 November 2006
- Published by Elsevier in Microelectronics Journal
- Vol. 37 (11) , 1241-1250
CMOS injection locked oscillators for quadrature generation at radio-frequency
- 1 November 2006
- Published by Elsevier in Microelectronics Journal
- Vol. 37 (11) , 1241-1250
CMOS injection locked oscillators for quadrature generation at radio-frequency
- 1 November 2005
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 45 (2) , 115-122
A 0.18 μm CMOS TIA Plus Limiting Amplifier with a 5.3 GHz Overall Bandwidth for Fiber Optic Communications
- 1 November 2005
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 45 (2) , 115-122
A 0.18 μm CMOS TIA Plus Limiting Amplifier with a 5.3 GHz Overall Bandwidth for Fiber Optic Communications
- 31 May 2005
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 123-124, 515-521
A simple lumped electrical model for an RF MEMS switch considering lossy substrate effects
- 31 May 2005
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 123-124, 515-521
A simple lumped electrical model for an RF MEMS switch considering lossy substrate effects
- 1 January 2005
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 42 (1) , 31-36
Reduced Impact of Induced Gate Noise on Inductively Degenerated LNAs in Deep Submicron CMOS Technologies
- 1 January 2005
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 42 (1) , 31-36
Reduced Impact of Induced Gate Noise on Inductively Degenerated LNAs in Deep Submicron CMOS Technologies
- 1 January 2004
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 42 (1) , 31-36
Reduced Impact of Induced Gate Noise on Inductively Degenerated LNAs in Deep Submicron CMOS Technologies
- 1 January 2004
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 42 (1) , 31-36
Reduced Impact of Induced Gate Noise on Inductively Degenerated LNAs in Deep Submicron CMOS Technologies