Jérôme Bernard
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jérôme Bernard has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- David Houivet
Laboratoire Universitaire des Sciences Appliquées de Cherbourg (LUSAC), Normandie Univ, UNICAEN, LUSAC, EA 4253, France
4 shared publications Brahim Itaalit
Laboratoire Universitaire des Sciences Appliquées de Cherbourg (LUSAC), Normandie Univ, UNICAEN, LUSAC, EA 4253, France
2 shared publications- Mohamed Mouyane
Laboratoire Universitaire des Sciences Appliquées de Cherbourg (LUSAC)—EA 4253, Normandie Universitaire (UNICAEN), 50130 Cherbourg en Cotentin, France
2 shared publications Ahcène Chaouchi
Laboratoire de Chimie Appliquée et Génie chimique de l’Université Mouloud Mammeri de Tizi-Ouzou, Tizi-Ouzou, Algeria
1 shared publication- Brahim Itaalit
Laboratoire Universitaire des Sciences Appliquées de Cherbourg (LUSAC), Université de Caen Basse-Normandie (UCBN), EA 4253, Site Universitaire-60 rue Max Pol Fouchet, CS 20082, Cherbourg-Octeville 50130, France
1 shared publication C. Lelievre
LUSAC (EA4253), Site Universitaire, B.P. 78, 50130 Cherbourg Octeville, France
1 shared publication
Latest Publications
- Open Access
- 22 July 2022
- Published by Wiley in Advances in Materials Science and Engineering
- Vol. 2022, 1-9
A Novel Approach to the Sintering Schedule of Ba (Co0.7Zn0.3)1/3Nb2/3O3 Dielectric Ceramics for Microwave Applications
The present research is devoted to the optimization of the sintering schedule of Ba (Co0.7Zn0.3)1/3Nb2/3O3 (BCZN) dielectric ceramics for microwaves applications. A novel approach to the heat treatment of these ceramics based on the rapid-rate sintering (RRS) technique followed by a lower temperature annealing cycle has been developed. The relationships among the heat treatment process optimization, the structural, microstructural characteristics, and the microwave dielectric properties of the BCZN ceramics were investigated using X-ray diffraction, scanning electron microscopy, energy dispersion analysis, and vector network analysis. The RRS-technique shortens substantially the time required for the elaboration of these components in comparison with conventional sintering techniques and prevents simultaneously the formation of secondary phases as Ba5Nb4O15 and Ba8(Co, Zn) 1Nb6O24 on the surface of the ceramics. All of the sintered and annealed ceramics exhibit a high quality factor QF close to 110 000GHz at 6GHz. The high dielectric constant εr of 34.5 and a temperature coefficient of the resonant frequency τf of 0ppm.C-1 were obtained in all annealed ceramics.
- 22 July 2022
- Published by Wiley in Advances in Materials Science and Engineering
- Vol. 2022, 1-9
Open AccessA Novel Approach to the Sintering Schedule of Ba (Co0.7Zn0.3)1/3Nb2/3O3 Dielectric Ceramics for Microwave Applications
The present research is devoted to the optimization of the sintering schedule of Ba (Co0.7Zn0.3)1/3Nb2/3O3 (BCZN) dielectric ceramics for microwaves applications. A novel approach to the heat treatment of these ceramics based on the rapid-rate sintering (RRS) technique followed by a lower temperature annealing cycle has been developed. The relationships among the heat treatment process optimization, the structural, microstructural characteristics, and the microwave dielectric properties of the BCZN ceramics were investigated using X-ray diffraction, scanning electron microscopy, energy dispersion analysis, and vector network analysis. The RRS-technique shortens substantially the time required for the elaboration of these components in comparison with conventional sintering techniques and prevents simultaneously the formation of secondary phases as Ba5Nb4O15 and Ba8(Co, Zn) 1Nb6O24 on the surface of the ceramics. All of the sintered and annealed ceramics exhibit a high quality factor QF close to 110 000GHz at 6GHz. The high dielectric constant εr of 34.5 and a temperature coefficient of the resonant frequency τf of 0ppm.C-1 were obtained in all annealed ceramics.
- Open Access
- 22 December 2015
- Published by MDPI AG in Applied Sciences
- Vol. 6 (1) , 2
Effect of Post-Annealing on the Microstructure and Microwave Dielectric Properties of Ba(Co0.7Zn0.3)1/3Nb2/3O3 Ceramics
The effects of post-annealing on the crystal structure, microstructure, and microwave dielectric properties for Ba(Co0.7Zn0.3)1/3Nb2/3O3 ceramics were investigated. The as-prepared materials were characterized by X-ray diffraction, scanning electron microscopy and energy dispersive spectroscopy. The microwave dielectric properties are measured at 6 GHz using a network analyzer. Ba5Nb4O15 and/or Ba8(Co,Zn)1Nb6O24 secondary phases were found on the surface according to sintering conditions due to volatilization of some Zn and Co elements. The experimental results show that the beneficial effect of the annealing steps to improved the microwave dielectric properties. Excellent microwave dielectric properties were achieved for the coarse-grained microstructures by a higher sintering temperature and with a shorter holding time followed by annealing steps at lower temperatures with a longer holding time. This improvement can be attributed to 1:2 cation ordering within the crystal, which is taking place during annealing process. The Ba(Co0.7Zn0.3)1/3Nb2/3O3 ceramic could be used successfully for realization of dielectric microwave resonators, since it has a high quality factor Qf value of 123,700 GHz, a high dielectric constant εr value of 34.5 and a temperature coefficient of the resonant frequency τf of 0 ppm/°C.
- 22 December 2015
- Published by MDPI AG in Applied Sciences
- Vol. 6 (1) , 2
Open AccessEffect of Post-Annealing on the Microstructure and Microwave Dielectric Properties of Ba(Co0.7Zn0.3)1/3Nb2/3O3 Ceramics
The effects of post-annealing on the crystal structure, microstructure, and microwave dielectric properties for Ba(Co0.7Zn0.3)1/3Nb2/3O3 ceramics were investigated. The as-prepared materials were characterized by X-ray diffraction, scanning electron microscopy and energy dispersive spectroscopy. The microwave dielectric properties are measured at 6 GHz using a network analyzer. Ba5Nb4O15 and/or Ba8(Co,Zn)1Nb6O24 secondary phases were found on the surface according to sintering conditions due to volatilization of some Zn and Co elements. The experimental results show that the beneficial effect of the annealing steps to improved the microwave dielectric properties. Excellent microwave dielectric properties were achieved for the coarse-grained microstructures by a higher sintering temperature and with a shorter holding time followed by annealing steps at lower temperatures with a longer holding time. This improvement can be attributed to 1:2 cation ordering within the crystal, which is taking place during annealing process. The Ba(Co0.7Zn0.3)1/3Nb2/3O3 ceramic could be used successfully for realization of dielectric microwave resonators, since it has a high quality factor Qf value of 123,700 GHz, a high dielectric constant εr value of 34.5 and a temperature coefficient of the resonant frequency τf of 0 ppm/°C.
- Open Access
- 1 January 2014
- Published by National Library of Serbia in Processing and Application of Ceramics
- Vol. 8 (2) , 101-108
Influence of Li2Co3 and V2O5 combined additions on the sintering and dielectric properties of Ca0.5Sr0.5TiO3 ceramics prepared from powders synthesized by sol-gel method
In this work, we have studied the influence of lithium carbonate (Li2CO3) associated with the vanadium oxide (V2O5) on sintering and dielectrics properties of Ca0.5Sr0.5TiO3 ceramic materials obtained from nanopowder synthesized by sol-gel method. The nanopowder was obtained by controlled mixing of titanium butoxide dissolved in butanol-2 and acetic acid with a saturated aqueous solution of calcium acetate and strontium carbonate and subsequent drying of the formed gel at 80 ?C and calcination at 1100?C. The synthesized nanopowder was mixed with different amount of additives, and then uniaxally pressed and sintered in air atmosphere at temperature determined by dilatomertic measurements. The pure Ca0.5Sr0.5TiO3 sample obtained by this process required a sintering temperature around 1500?C. The addition of Li2CO3 combined with V2O5 improved sinterability and caused a shift of dilatimeric shrinkage curve to much lower temperatures. Thus, dense ceramics (98% of theoretical density) were obtained at sintering temperature ? 1300?C. The effect of adding Li2CO3-V2O5 on the structure of ceramics and the dielectric properties is discussed and show that type I dielectric properties (linear variation of the permittivity) are conserved, but with an increase of dielectric loss.
- 1 January 2014
- Published by National Library of Serbia in Processing and Application of Ceramics
- Vol. 8 (2) , 101-108
Open AccessInfluence of Li2Co3 and V2O5 combined additions on the sintering and dielectric properties of Ca0.5Sr0.5TiO3 ceramics prepared from powders synthesized by sol-gel method
In this work, we have studied the influence of lithium carbonate (Li2CO3) associated with the vanadium oxide (V2O5) on sintering and dielectrics properties of Ca0.5Sr0.5TiO3 ceramic materials obtained from nanopowder synthesized by sol-gel method. The nanopowder was obtained by controlled mixing of titanium butoxide dissolved in butanol-2 and acetic acid with a saturated aqueous solution of calcium acetate and strontium carbonate and subsequent drying of the formed gel at 80 ?C and calcination at 1100?C. The synthesized nanopowder was mixed with different amount of additives, and then uniaxally pressed and sintered in air atmosphere at temperature determined by dilatomertic measurements. The pure Ca0.5Sr0.5TiO3 sample obtained by this process required a sintering temperature around 1500?C. The addition of Li2CO3 combined with V2O5 improved sinterability and caused a shift of dilatimeric shrinkage curve to much lower temperatures. Thus, dense ceramics (98% of theoretical density) were obtained at sintering temperature ? 1300?C. The effect of adding Li2CO3-V2O5 on the structure of ceramics and the dielectric properties is discussed and show that type I dielectric properties (linear variation of the permittivity) are conserved, but with an increase of dielectric loss.
- 1 April 2010
- Published by Elsevier in Ceramics International
- Vol. 36 (3) , 929-935
Moisture sensitivity of YCr(1−x)MnxO3 perovskites
- 1 April 2010
- Published by Elsevier in Ceramics International
- Vol. 36 (3) , 929-935
Moisture sensitivity of YCr(1−x)MnxO3 perovskites