Diederik Verkest
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Diederik Verkest has a total of 36 co-authors. Here are the top co-authors by number of shared publications:
- Henk Corporaal
Eindhoven University of Technology, Eindhoven, The Netherlands
4 shared publications Julien Ryckaert
IMEC (Belgium)
2 shared publications- Kristof Denolf
Nomadic Embedded Systems (NES), Interuniversity Micro Electronics Centre (IMEC)
2 shared publications - Peter Debacker
IMEC, Leuven, Belgium
2 shared publications Praveen Raghavan
IMEC (Belgium)
2 shared publicationsRyan Ryoung-Han Kim
2 shared publications
Latest Publications
- 20 March 2018
- Published by SPIE-Intl Soc Optical Eng
- Vol. 10588, 105880N
IMEC N7, N5 and beyond: DTCO, STCO and EUV insertion strategy to maintain affordable scaling trend
In order to maintain the scaling trend in logic technology node progression, imec technology nodes started heavily utilizing design technology co-optimization (DTCO) on top of loosen pitch scaling trend to mitigate the burden from steep cost increase and yield challenge. Scaling boosters are adopted to enable DTCO process on top of patterning near its cliff to mitigate the cost increase. As the technology node further proceeds, DTCO also starts facing its cliff, and system technology co-optimization (STCO) is introduced to assist pitch and DTCO scaling to bridge 2-D IC technology to evolutionary technology options such as MRAM, 2.5-D heterogeneous integration, 3-D integration and 3-D IC. EUV is used to further assist pitch and DTCO scaling to maintain low cost with higher yield and faster turn-around-time (TAT). EUV single patterning, multiple patterning and high-NA EUV are considered on top of DTCO and STCO landscape to define imec technology nodes.
- 20 March 2018
- Published by SPIE-Intl Soc Optical Eng
- Vol. 10588, 105880N
IMEC N7, N5 and beyond: DTCO, STCO and EUV insertion strategy to maintain affordable scaling trend
In order to maintain the scaling trend in logic technology node progression, imec technology nodes started heavily utilizing design technology co-optimization (DTCO) on top of loosen pitch scaling trend to mitigate the burden from steep cost increase and yield challenge. Scaling boosters are adopted to enable DTCO process on top of patterning near its cliff to mitigate the cost increase. As the technology node further proceeds, DTCO also starts facing its cliff, and system technology co-optimization (STCO) is introduced to assist pitch and DTCO scaling to bridge 2-D IC technology to evolutionary technology options such as MRAM, 2.5-D heterogeneous integration, 3-D integration and 3-D IC. EUV is used to further assist pitch and DTCO scaling to maintain low cost with higher yield and faster turn-around-time (TAT). EUV single patterning, multiple patterning and high-NA EUV are considered on top of DTCO and STCO landscape to define imec technology nodes.
- 20 March 2018
- Published by SPIE-Intl Soc Optical Eng
- Vol. 10588, 1058803
Efficient place and route enablement of 5-tracks standard-cells through EUV compatible N5 ruleset
In imec predictive N5 technology platform (poly pitch 42nm, metal pitch 32nm), enabling cell height reduction from 6 to 5 tracks constitutes an interesting opportunity to reduce area of digital IP-blocks without increasing wafer cost. From a physical point of view, the two main challenges of reducing the number of tracks are posed by the increased difficulty of completing inter-cell connections in standard cell design, and by increased pin density that makes more challenging for the router to maintain high placement densities. Both these issues can potentially result into cell and chip area enlargement, thus mitigating or canceling the benefits of moving to 5-Tracks. In this study this side effect was avoided through a careful Design-Technology Co-Optimization approach (DTCO) [1], where a set of design arcs was used in conjunction with an EUV compatible ruleset that allowed efficient 5-Tracks standard cell design, resulting in final area gains up to 17% that were validated through a commercial state-of-the-art Place and Route (P&R) flow.
- 20 March 2018
- Published by SPIE-Intl Soc Optical Eng
- Vol. 10588, 1058803
Efficient place and route enablement of 5-tracks standard-cells through EUV compatible N5 ruleset
In imec predictive N5 technology platform (poly pitch 42nm, metal pitch 32nm), enabling cell height reduction from 6 to 5 tracks constitutes an interesting opportunity to reduce area of digital IP-blocks without increasing wafer cost. From a physical point of view, the two main challenges of reducing the number of tracks are posed by the increased difficulty of completing inter-cell connections in standard cell design, and by increased pin density that makes more challenging for the router to maintain high placement densities. Both these issues can potentially result into cell and chip area enlargement, thus mitigating or canceling the benefits of moving to 5-Tracks. In this study this side effect was avoided through a careful Design-Technology Co-Optimization approach (DTCO) [1], where a set of design arcs was used in conjunction with an EUV compatible ruleset that allowed efficient 5-Tracks standard cell design, resulting in final area gains up to 17% that were validated through a commercial state-of-the-art Place and Route (P&R) flow.
- 13 November 2008
- Published by Springer Nature in Journal of Signal Processing Systems
- Vol. 60 (2) , 251-268
A Safari Through the MPSoC Run-Time Management Jungle
- 13 November 2008
- Published by Springer Nature in Journal of Signal Processing Systems
- Vol. 60 (2) , 251-268
A Safari Through the MPSoC Run-Time Management Jungle
- 19 September 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Micro
- Vol. 28 (4) , 41-50
A Coarse-Grained Array Accelerator for Software-Defined Radio Baseband Processing
A shrinking energy budget for mobile devices and increasingly complex communication standards make architecture development for software-defined radio very challenging. Coarse-grained array accelerators are strong candidates for achieving both high performance and low power. The C-programmable hybrid CGA-SIMD accelerator presented here targets emerging broadband cellular and wireless LAN standards, achieving up to 100-Mbps throughput with an average power consumption of 220 mW.
- 19 September 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Micro
- Vol. 28 (4) , 41-50
A Coarse-Grained Array Accelerator for Software-Defined Radio Baseband Processing
A shrinking energy budget for mobile devices and increasingly complex communication standards make architecture development for software-defined radio very challenging. Coarse-grained array accelerators are strong candidates for achieving both high performance and low power. The C-programmable hybrid CGA-SIMD accelerator presented here targets emerging broadband cellular and wireless LAN standards, achieving up to 100-Mbps throughput with an average power consumption of 220 mW.
- 31 January 2008
- Published by Elsevier in Integration
- Vol. 41 (1) , 38-48
Joint hardware–software leakage minimization approach for the register file of VLIW embedded architectures
- 31 January 2008
- Published by Elsevier in Integration
- Vol. 41 (1) , 38-48
Joint hardware–software leakage minimization approach for the register file of VLIW embedded architectures
- 1 October 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 23251271,p. 41-46
A Quick Safari Through the MPSoC Run-Time Management Jungle
The multiprocessor SoC (MPSoC) revolution is fueled by the need to execute multiple advanced multimedia applications on a single embedded computing platform. At design-time, the applications that will run in parallel and their respective user requirements are unknown. Hence, a run-time manager is needed to match all application needs with the available platform resources and services. Creating such run-time manager requires two decisions. First, one needs to decide what functionality to implement. Second, one has to decide how to implement this functionality in order to meet boundary conditions like e.g. real-time performance. This paper is the first to detail a generic view on MPSoC runtime management functionality and its design space tradeoffs. We substantiate the run-time components and the implementation trade-offs with state-of-the-art solutions and a brief overview of some industrial and academic multiprocessor run-time management examples. We show a clear trend towards more hardware acceleration, a limited distribution of management functionality over the platform and increasing support for adaptive multimedia applications.
- 1 October 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 23251271,p. 41-46
A Quick Safari Through the MPSoC Run-Time Management Jungle
The multiprocessor SoC (MPSoC) revolution is fueled by the need to execute multiple advanced multimedia applications on a single embedded computing platform. At design-time, the applications that will run in parallel and their respective user requirements are unknown. Hence, a run-time manager is needed to match all application needs with the available platform resources and services. Creating such run-time manager requires two decisions. First, one needs to decide what functionality to implement. Second, one has to decide how to implement this functionality in order to meet boundary conditions like e.g. real-time performance. This paper is the first to detail a generic view on MPSoC runtime management functionality and its design space tradeoffs. We substantiate the run-time components and the implementation trade-offs with state-of-the-art solutions and a brief overview of some industrial and academic multiprocessor run-time management examples. We show a clear trend towards more hardware acceleration, a limited distribution of management functionality over the platform and increasing support for adaptive multimedia applications.
- Open Access
- 21 June 2007
- Published by Springer Nature in EURASIP Journal on Advances in Signal Processing
- Vol. 2007 (1) , 084078
Exploiting the Expressiveness of Cyclo-Static Dataflow to Model Multimedia Implementations
- 21 June 2007
- Published by Springer Nature in EURASIP Journal on Advances in Signal Processing
- Vol. 2007 (1) , 084078
Open AccessExploiting the Expressiveness of Cyclo-Static Dataflow to Model Multimedia Implementations
- Open Access
- 1 January 2007
- Published by Springer Nature in EURASIP Journal on Embedded Systems
- Vol. 2007 (1)
A Systematic Approach to Design Low-Power Video Codec Cores
- 1 January 2007
- Published by Springer Nature in EURASIP Journal on Embedded Systems
- Vol. 2007 (1)
Open AccessA Systematic Approach to Design Low-Power Video Codec Cores