Cornelis J. Van der Veen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Cornelis J. Van der Veen has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
B. M. Csatho
Department of Geology University at Buffalo, State University of New York Buffalo New York USA
3 shared publicationsB. Csatho
Department of Geology, University at Buffalo
1 shared publicationC. J.
1 shared publicationC. Kim
1 shared publicationD. H. Bromwich
1 shared publicationE. Mosley‐Thompson
Byrd Polar Research Center Ohio State University Columbus Ohio USA
1 shared publication
Latest Publications
- Open Access
- 29 June 2016
- Published by Copernicus GmbH in The Cryosphere
- Vol. 10 (3) , 1331-1337
Basal buoyancy and fast-moving glaciers: in defense of analytic force balance
The geometric approach to force balance advocated by T. Hughes in a series of publications has challenged the analytic approach by implying that the latter does not adequately account for basal buoyancy on ice streams, thereby neglecting the contribution to the gravitational driving force associated with this basal buoyancy. Application of the geometric approach to Byrd Glacier, Antarctica, yields physically unrealistic results, and it is argued that this is because of a key limiting assumption in the geometric approach. A more traditional analytic treatment of force balance shows that basal buoyancy does not affect the balance of forces on ice streams, except locally perhaps, through bridging effects.
- 29 June 2016
- Published by Copernicus GmbH in The Cryosphere
- Vol. 10 (3) , 1331-1337
Open AccessBasal buoyancy and fast-moving glaciers: in defense of analytic force balance
The geometric approach to force balance advocated by T. Hughes in a series of publications has challenged the analytic approach by implying that the latter does not adequately account for basal buoyancy on ice streams, thereby neglecting the contribution to the gravitational driving force associated with this basal buoyancy. Application of the geometric approach to Byrd Glacier, Antarctica, yields physically unrealistic results, and it is argued that this is because of a key limiting assumption in the geometric approach. A more traditional analytic treatment of force balance shows that basal buoyancy does not affect the balance of forces on ice streams, except locally perhaps, through bridging effects.
- 1 January 2016
- Published by Society of Exploration Geophysicists in Geophysics
- Vol. 81 (1) , WA111-WA118
Distribution of preferred ice crystal orientation determined from seismic anisotropy: Evidence from Jakobshavn Isbræ and the North Greenland Eemian Ice Drilling facility, Greenland
Preferred crystal orientation fabrics (COFs) within an ice sheet or glacier are typically found from ice cores. We conducted experiments at the North Greenland Eemian Ice Drilling (NEEM) facility ice core location, where COF data were available at Jakobshavn Isbræ west Greenland, to test if COF can be determined seismically. We used observations of anisotropic seismic wave propagation on multioffset gathers and englacial imaging from a 2D reflection profile. Anisotropy analysis of the NEEM data yielded mean c-axes distributed over a conical region of 30° to 32° from vertical. No internal ice seismic reflectors were imaged. Direct COF measurements collected in the ice core agreed with the seismic observations. At Jakobshavn Isbræ, we used a multioffset gather and a 2D reflection profile, but we lacked ice core data. Englacial reflectors allowed the determination of ice column interval properties. Anisotropy analysis found that the upper 1640 m of the ice column consisted of cold () and mostly isotropic ice with c-axes distributed over a conical region of 80° from vertical. The lower 300 m of the ice column was characterized by warm () ice with COF. These observations were consistent with complex ice fabric development and temperature estimations over the same region of Jakobshavn Isbræ. This study demonstrated that the ice sheet and glacier ice anisotropy information can be gained from seismic field observations.- 1 January 2016
- Published by Society of Exploration Geophysicists in Geophysics
- Vol. 81 (1) , WA111-WA118
Distribution of preferred ice crystal orientation determined from seismic anisotropy: Evidence from Jakobshavn Isbræ and the North Greenland Eemian Ice Drilling facility, Greenland
Preferred crystal orientation fabrics (COFs) within an ice sheet or glacier are typically found from ice cores. We conducted experiments at the North Greenland Eemian Ice Drilling (NEEM) facility ice core location, where COF data were available at Jakobshavn Isbræ west Greenland, to test if COF can be determined seismically. We used observations of anisotropic seismic wave propagation on multioffset gathers and englacial imaging from a 2D reflection profile. Anisotropy analysis of the NEEM data yielded mean c-axes distributed over a conical region of 30° to 32° from vertical. No internal ice seismic reflectors were imaged. Direct COF measurements collected in the ice core agreed with the seismic observations. At Jakobshavn Isbræ, we used a multioffset gather and a 2D reflection profile, but we lacked ice core data. Englacial reflectors allowed the determination of ice column interval properties. Anisotropy analysis found that the upper 1640 m of the ice column consisted of cold () and mostly isotropic ice with c-axes distributed over a conical region of 80° from vertical. The lower 300 m of the ice column was characterized by warm () ice with COF. These observations were consistent with complex ice fabric development and temperature estimations over the same region of Jakobshavn Isbræ. This study demonstrated that the ice sheet and glacier ice anisotropy information can be gained from seismic field observations.- Open Access
- 1 January 2014
- Published by International Glaciological Society in Journal of Glaciology
- Vol. 60 (224) , 1053-1064
Flow dynamics of Byrd Glacier, East Antarctica
Force-balance calculations on Byrd Glacier, East Antarctica, reveal large spatial variations in the along-flow component of driving stress with corresponding sticky spots that are stationary over time. On the large scale, flow resistance is partitioned between basal (~80%) and lateral (~20%) drag. Ice flow is due mostly to basal sliding and concentrated vertical shear in the basal ice layers, indicating the bed is at or close to the pressure-melting temperature. There is a significant component of driving stress in the across-flow direction resulting in nonzero basal drag in that direction. This is an unrealistic result and we propose that there are spatial variations of bed features resulting in small-scale flow disturbances. The grounding line of Byrd Glacier is located in a region where the bed slopes upward. Nevertheless, despite a 10% increase in ice discharge between December 2005 and February 2007, following drainage of two subglacial lakes in the catchment area, the position of the grounding line has not retreated significantly and the glacier has decelerated since then. During the speed-up event, partitioning of flow resistance did not change, suggesting the increase in velocity was caused by a temporary decrease in basal effective pressure.
- 1 January 2014
- Published by International Glaciological Society in Journal of Glaciology
- Vol. 60 (224) , 1053-1064
Open AccessFlow dynamics of Byrd Glacier, East Antarctica
Force-balance calculations on Byrd Glacier, East Antarctica, reveal large spatial variations in the along-flow component of driving stress with corresponding sticky spots that are stationary over time. On the large scale, flow resistance is partitioned between basal (~80%) and lateral (~20%) drag. Ice flow is due mostly to basal sliding and concentrated vertical shear in the basal ice layers, indicating the bed is at or close to the pressure-melting temperature. There is a significant component of driving stress in the across-flow direction resulting in nonzero basal drag in that direction. This is an unrealistic result and we propose that there are spatial variations of bed features resulting in small-scale flow disturbances. The grounding line of Byrd Glacier is located in a region where the bed slopes upward. Nevertheless, despite a 10% increase in ice discharge between December 2005 and February 2007, following drainage of two subglacial lakes in the catchment area, the position of the grounding line has not retreated significantly and the glacier has decelerated since then. During the speed-up event, partitioning of flow resistance did not change, suggesting the increase in velocity was caused by a temporary decrease in basal effective pressure.
- 8 January 2009
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Earth Surface
- Vol. 114 (F1)
Surface roughness over the northern half of the Greenland Ice Sheet from airborne laser altimetry
Surface roughness, defined as the standard deviation of small‐scale elevation fluctuations from the linear trend over 0.5 km, can be estimated from high‐resolution airborne laser altimetry. Here we present results for the northern half of the Greenland Ice Sheet using laser data collected in May 1995. Roughness is smallest in the central region straddling the ice divide, increases in amplitude toward the coast, and appears to be correlated with slope of the ice surface. For most of the study region surface roughness is 8 cm or less (<2.5 cm water equivalent). In smaller regions associated with fast flow, larger values are found. Comparison of the size of small‐scale topographic disturbances with the spatial noise estimated from five closely spaced ice cores drilled in northwest Greenland shows good agreement. Similar correspondence was found earlier using nine ice cores from the Summit region. These results indicate that the airborne laser altimeter provides an efficient platform for characterizing the statistical nature of the snow surface over large areas of the polar ice sheets.
- 8 January 2009
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Earth Surface
- Vol. 114 (F1)
Surface roughness over the northern half of the Greenland Ice Sheet from airborne laser altimetry
Surface roughness, defined as the standard deviation of small‐scale elevation fluctuations from the linear trend over 0.5 km, can be estimated from high‐resolution airborne laser altimetry. Here we present results for the northern half of the Greenland Ice Sheet using laser data collected in May 1995. Roughness is smallest in the central region straddling the ice divide, increases in amplitude toward the coast, and appears to be correlated with slope of the ice surface. For most of the study region surface roughness is 8 cm or less (<2.5 cm water equivalent). In smaller regions associated with fast flow, larger values are found. Comparison of the size of small‐scale topographic disturbances with the spatial noise estimated from five closely spaced ice cores drilled in northwest Greenland shows good agreement. Similar correspondence was found earlier using nine ice cores from the Summit region. These results indicate that the airborne laser altimeter provides an efficient platform for characterizing the statistical nature of the snow surface over large areas of the polar ice sheets.
- 21 June 2007
- Published by American Geophysical Union (AGU) in Geophysical Research Letters
- Vol. 34 (12)
Subglacial topography and geothermal heat flux: Potential interactions with drainage of the Greenland ice sheet
Many of the outlet glaciers in Greenland overlie deep and narrow trenches cut into the bedrock. It is well known that pronounced topography intensifies the geothermal heat flux in deep valleys and attenuates this flux on mountains. Here we investigate the magnitude of this effect for two subglacial trenches in Greenland. Heat flux variations are estimated for idealized geometries using solutions for plane slopes derived by Lachenbruch (1968). It is found that for channels such as the one under Jakobshavn Isbræ, topographic effects may increase the local geothermal heat flux by as much as 100%.
- 21 June 2007
- Published by American Geophysical Union (AGU) in Geophysical Research Letters
- Vol. 34 (12)
Subglacial topography and geothermal heat flux: Potential interactions with drainage of the Greenland ice sheet
Many of the outlet glaciers in Greenland overlie deep and narrow trenches cut into the bedrock. It is well known that pronounced topography intensifies the geothermal heat flux in deep valleys and attenuates this flux on mountains. Here we investigate the magnitude of this effect for two subglacial trenches in Greenland. Heat flux variations are estimated for idealized geometries using solutions for plane slopes derived by Lachenbruch (1968). It is found that for channels such as the one under Jakobshavn Isbræ, topographic effects may increase the local geothermal heat flux by as much as 100%.
- 4 January 2007
- Published by American Geophysical Union (AGU) in Geophysical Research Letters
- Vol. 34 (1)
Fracture propagation as means of rapidly transferring surface meltwater to the base of glaciers
Propagation of water‐filled crevasses through glaciers is investigated based on the linear elastic fracture mechanics approach. A crevasse will penetrate to the depth where the stress intensity factor at the crevasse tip equals the fracture toughness of glacier ice. A crevasse subjected to inflow of water will continue to propagate downward with the propagation speed controlled primarily by the rate of water injection. While the far‐field tensile stress and fracture toughness determine where crevasses can form, once initiated, the rate of water‐driven crevasse propagation is nearly independent of these two parameters. Thus, rapid transfer of surface meltwater to the bed of a cold glacier requires abundant ponding at the surface to initiate and sustain full thickness fracturing before refreezing occurs.
- 4 January 2007
- Published by American Geophysical Union (AGU) in Geophysical Research Letters
- Vol. 34 (1)
Fracture propagation as means of rapidly transferring surface meltwater to the base of glaciers
Propagation of water‐filled crevasses through glaciers is investigated based on the linear elastic fracture mechanics approach. A crevasse will penetrate to the depth where the stress intensity factor at the crevasse tip equals the fracture toughness of glacier ice. A crevasse subjected to inflow of water will continue to propagate downward with the propagation speed controlled primarily by the rate of water injection. While the far‐field tensile stress and fracture toughness determine where crevasses can form, once initiated, the rate of water‐driven crevasse propagation is nearly independent of these two parameters. Thus, rapid transfer of surface meltwater to the bed of a cold glacier requires abundant ponding at the surface to initiate and sustain full thickness fracturing before refreezing occurs.
- 27 December 2001
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Atmospheres
- Vol. 106 (D24) , 33909-33918
Trend surface analysis of Greenland accumulation
- 27 December 2001
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Atmospheres
- Vol. 106 (D24) , 33909-33918
Trend surface analysis of Greenland accumulation