Catherine Mével
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Catherine Mével has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Mathilde Cannat
CNRS, Laboratoire de Géosciences Marines Institut de Physique du Globe 4 place Jussieu, 75252 Paris cédex France
2 shared publications - A. Bralee1 shared publication
- Etienne Deloule
Université de Lorraine, CNRS, CRPG, Vandoeuvre-les-Nancy, France
1 shared publication - Hiromi Fujimoto
Tohoku University
1 shared publication - Kantaro Fujioka
Institute for Research on Earth Evolution, Research Program for Plate Dynamics, Japan Agency for Marine‐Earth Science and Technology (JAMSTEC), 3137‐25 Showa‐machi, Kanazawa‐ku Yokohama Kanagawa 236‐0001, Japan
1 shared publication - Laurie Reisberg
CRPG-CNRS UPR 2300, BP 20, 54501 Vandoeuvre-lès-Nancy, France
1 shared publication
Latest Publications
- Open Access
- 8 August 2003
- Published by American Geophysical Union (AGU) in Geochemistry, Geophysics, Geosystems
- Vol. 4 (8)
FUJI Dome: A large detachment fault near 64°E on the very slow‐spreading southwest Indian Ridge
A continuous, domed detachment surface (FUJI Dome) has been imaged on the very slow‐spreading southwest Indian Ridge using deep‐towed side‐scan sonar, and has been investigated by manned submersible and sea‐surface geophysics. The Dome is morphologically similar to other oceanic detachments, core complexes or mega‐mullions. In addition to bathymetric mullions observed in ship‐borne bathymetry, finer scale spreading‐parallel striations were imaged with the side scan. On the detachment surface, metabasalt crops out near the termination, probably as part of a thin fault sliver. Gabbro and troctolite probably crop out near the summit of the dome. The rest of the detachment surface is covered with sediment and rubble which is basaltic except for a single sample of serpentinite. Most of the detachment surface dips toward the ridge axis at 10°–20°, but near the breakaway it is strongly rotated outward, and dips away from the axis at up to 40°. Normal, undeformed volcanic seafloor crops out adjacent to the detachment. Modeling of sea surface magnetic data suggest the detachment was active from 1.95 Ma for about 1 Ma during a period of reduced and asymmetric magmatic accretion. Modeling of sea surface and seafloor gravity requires laterally fairly uniform but high density material under the Dome, and precludes steeply dipping contacts between bodies with large density contrasts at shallow levels under the Dome.
- 8 August 2003
- Published by American Geophysical Union (AGU) in Geochemistry, Geophysics, Geosystems
- Vol. 4 (8)
Open AccessFUJI Dome: A large detachment fault near 64°E on the very slow‐spreading southwest Indian Ridge
A continuous, domed detachment surface (FUJI Dome) has been imaged on the very slow‐spreading southwest Indian Ridge using deep‐towed side‐scan sonar, and has been investigated by manned submersible and sea‐surface geophysics. The Dome is morphologically similar to other oceanic detachments, core complexes or mega‐mullions. In addition to bathymetric mullions observed in ship‐borne bathymetry, finer scale spreading‐parallel striations were imaged with the side scan. On the detachment surface, metabasalt crops out near the termination, probably as part of a thin fault sliver. Gabbro and troctolite probably crop out near the summit of the dome. The rest of the detachment surface is covered with sediment and rubble which is basaltic except for a single sample of serpentinite. Most of the detachment surface dips toward the ridge axis at 10°–20°, but near the breakaway it is strongly rotated outward, and dips away from the axis at up to 40°. Normal, undeformed volcanic seafloor crops out adjacent to the detachment. Modeling of sea surface magnetic data suggest the detachment was active from 1.95 Ma for about 1 Ma during a period of reduced and asymmetric magmatic accretion. Modeling of sea surface and seafloor gravity requires laterally fairly uniform but high density material under the Dome, and precludes steeply dipping contacts between bodies with large density contrasts at shallow levels under the Dome.
- 6 February 2003
- Published by American Geophysical Union (AGU) in Geochemistry, Geophysics, Geosystems
- Vol. 4 (2)
Evidence for major‐element heterogeneity in the mantle source of abyssal peridotites from the Southwest Indian Ridge (52° to 68°E)
A suite of 53 samples of mantle spinel lherzolites and harzburgites dredged at 13 sites between 52°E and 68°E along the Southwest Indian Ridge has been studied for petrography and mineral major element chemistry. Results show that the residual mantle beneath this very slow‐spreading/cold ridge is strongly heterogeneous in modal and mineral compositions at local and regional scales and underwent greater extents of melting than predicted by melting model and by compositions of the basalts dredged with the peridotites. Along‐axis, the peridotite compositional variability defines a concave pattern with increasing depletion at both ends of the studied section (e.g., approaching Rodrigues Triple Junction to the East and Gallieni fracture zone to the west) that cannot be matched with the basalt compositions. Clinoyroxenes reflect depleted compositions (low modal abundances, high Cr and Mg, low Ti contents) but are paradoxally enriched in jadeite component, a feature that distinguishes these peridotites from common abyssal peridotites. Textural data show that major depletion in basaltic components and pyroxene Na enrichment are early features of the studied peridotites. In most samples, Na is nevertheless correlated with Ti suggesting that initial clinopyroxenes had high Na/Ti contents. Samples at both ends of the studied area have even higher Na/Ti ratios because of higher Na enrichment and higher Ti depletion, indicating metasomatic interaction. We conclude that along‐axis compositional variations characterizing these peridotites are primary controlled by major element heterogeneity in the initial mantle, that have been preserved because of low degrees of melting beneath the Southwest Indian Ridge.
- 6 February 2003
- Published by American Geophysical Union (AGU) in Geochemistry, Geophysics, Geosystems
- Vol. 4 (2)
Evidence for major‐element heterogeneity in the mantle source of abyssal peridotites from the Southwest Indian Ridge (52° to 68°E)
A suite of 53 samples of mantle spinel lherzolites and harzburgites dredged at 13 sites between 52°E and 68°E along the Southwest Indian Ridge has been studied for petrography and mineral major element chemistry. Results show that the residual mantle beneath this very slow‐spreading/cold ridge is strongly heterogeneous in modal and mineral compositions at local and regional scales and underwent greater extents of melting than predicted by melting model and by compositions of the basalts dredged with the peridotites. Along‐axis, the peridotite compositional variability defines a concave pattern with increasing depletion at both ends of the studied section (e.g., approaching Rodrigues Triple Junction to the East and Gallieni fracture zone to the west) that cannot be matched with the basalt compositions. Clinoyroxenes reflect depleted compositions (low modal abundances, high Cr and Mg, low Ti contents) but are paradoxally enriched in jadeite component, a feature that distinguishes these peridotites from common abyssal peridotites. Textural data show that major depletion in basaltic components and pyroxene Na enrichment are early features of the studied peridotites. In most samples, Na is nevertheless correlated with Ti suggesting that initial clinopyroxenes had high Na/Ti contents. Samples at both ends of the studied area have even higher Na/Ti ratios because of higher Na enrichment and higher Ti depletion, indicating metasomatic interaction. We conclude that along‐axis compositional variations characterizing these peridotites are primary controlled by major element heterogeneity in the initial mantle, that have been preserved because of low degrees of melting beneath the Southwest Indian Ridge.
- 31 January 2002
- Published by American Geophysical Union (AGU) in Geochemistry, Geophysics, Geosystems
- Vol. 3 (1) , 1-20
Behavior of Li and its isotopes during serpentinization of oceanic peridotites
Analyses of Li and Li isotopes in serpentinized peridotites have been performed using Thermo‐Ionisation Mass Spectrometry (TIMS) and Secondary Ion Mass Spectrometry (SIMS) techniques on samples collected from the southwest Indian Ridge (SWIR). In the bulk samples, Li concentrations range from 0.6 to 8.2 ppm, while whole rock δ6Li values range from −2.9 to −14‰. In situ analyses display a greater range in both Li concentration (0.1–19.5 ppm) and Li isotopic composition (−27 to +19‰), with the serpentinized portions having higher Li concentrations than the associated relict phases. These variations may reflect changes in Li partitioning and isotopic fractionation between serpentine and fluid with temperature and water/rock ratio. They may also be explained by changes in the composition of the serpentinizing fluid over the course of serpentinization. As the serpentine forms by interaction with a circulating fluid, it preferentially removes 6Li, causing the Li in the fluid to become isotopically heavier. The isotopic composition of the initial hydrothermal fluid is dominated by basalt‐derived Li, which easily overwhelms the very low Li content originally present in seawater. As this fluid circulates through ultramafic rocks, it induces the formation of serpentine that incorporates this mantle‐derived Li. Hence, Li in serpentine is mainly derived from oceanic crust rather than from seawater and serpentinization involves Li recycling within this crust. Consequently, Li isotopes are good tracers of the hydrothermal contribution in serpentinizing fluid. These results imply that serpentinized peridotites are probably only a minor sink of oceanic Li.
- 31 January 2002
- Published by American Geophysical Union (AGU) in Geochemistry, Geophysics, Geosystems
- Vol. 3 (1) , 1-20
Behavior of Li and its isotopes during serpentinization of oceanic peridotites
Analyses of Li and Li isotopes in serpentinized peridotites have been performed using Thermo‐Ionisation Mass Spectrometry (TIMS) and Secondary Ion Mass Spectrometry (SIMS) techniques on samples collected from the southwest Indian Ridge (SWIR). In the bulk samples, Li concentrations range from 0.6 to 8.2 ppm, while whole rock δ6Li values range from −2.9 to −14‰. In situ analyses display a greater range in both Li concentration (0.1–19.5 ppm) and Li isotopic composition (−27 to +19‰), with the serpentinized portions having higher Li concentrations than the associated relict phases. These variations may reflect changes in Li partitioning and isotopic fractionation between serpentine and fluid with temperature and water/rock ratio. They may also be explained by changes in the composition of the serpentinizing fluid over the course of serpentinization. As the serpentine forms by interaction with a circulating fluid, it preferentially removes 6Li, causing the Li in the fluid to become isotopically heavier. The isotopic composition of the initial hydrothermal fluid is dominated by basalt‐derived Li, which easily overwhelms the very low Li content originally present in seawater. As this fluid circulates through ultramafic rocks, it induces the formation of serpentine that incorporates this mantle‐derived Li. Hence, Li in serpentine is mainly derived from oceanic crust rather than from seawater and serpentinization involves Li recycling within this crust. Consequently, Li isotopes are good tracers of the hydrothermal contribution in serpentinizing fluid. These results imply that serpentinized peridotites are probably only a minor sink of oceanic Li.