Davide Ruffoni
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Davide Ruffoni has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
- Ralph Müller
Institute for Biomechanics, ETH Zürich, Zürich, Switzerland
9 shared publications - Claudia Weigt
Institute for Biomechanics, ETH Zürich, Zürich, Switzerland
3 shared publications - Gerrit Harry van Lenthe
KU Leuven
3 shared publications Gisela Kuhn
3 shared publications- Alina Levchuk
Swiss Fed Inst Technol, Inst Biomech, Zurich, Switzerland
2 shared publications G. Harry van Lenthe
2 shared publications
Latest Publications
- 1 May 2013
- Published by Bioscientifica in Bone Abstracts
The spatial relationship between bone formation and bone resorption in healthy and ovariectomized mice treated with PTH, bisphosphonate or mechanical loading
Bone is continuously remodeled to remove damage, to adapt to changes in mechanical demands and to regulate calcium homeostasis. The first aim is accomplished by coupled bone formation and resorption whereas adaptation requires sites of formation to differ from those of resorption. The regulation of circulating ions is achieved by a stochastic exchange of bone packets. Here, we investigated these different aspects of remodeling in healthy and ovariectomized (OVX) mice treated with PTH, bisphosphonate or mechanical loading. 15-week old C57BL/6J female mice were divided into the following groups: untreated OVX (OVX, n=17); treated daily with PTH (PTH, n=9); treated once with zolendronate (BIS, n=9); treated with cyclic mechanical loading (8 N, 10 Hz, 3000 cycles) at the 6th caudal vertebra (CML, n=17); and sham operated mice (SHM, n=8). Treatment started 11 weeks after ovariectomy and micro-CT measurements were performed at start of the treatment and after 2 and 4 weeks. Registration of three consecutive scans allowed estimating the amount of coupled bone formation (i.e., bone formed at the locations where it was previously resorbed) and coupled bone resorption (i.e., bone resorbed at the locations where it was previously formed). Considering that it is biologically irrational that newly formed bone gets immediately removed, coupled resorption could be interpreted as stochastic untargeted remodeling. OVX significantly increased the amount of coupled resorption by 44% when compared to SHM (PPPP<0.001). The proposed analysis allowed measuring the coexisting types of remodeling in living bone and indicated that PTH caused the strongest increase in coupled bone formation and the highest reduction of untargeted remodeling.
- 1 May 2013
- Published by Bioscientifica in Bone Abstracts
The spatial relationship between bone formation and bone resorption in healthy and ovariectomized mice treated with PTH, bisphosphonate or mechanical loading
Bone is continuously remodeled to remove damage, to adapt to changes in mechanical demands and to regulate calcium homeostasis. The first aim is accomplished by coupled bone formation and resorption whereas adaptation requires sites of formation to differ from those of resorption. The regulation of circulating ions is achieved by a stochastic exchange of bone packets. Here, we investigated these different aspects of remodeling in healthy and ovariectomized (OVX) mice treated with PTH, bisphosphonate or mechanical loading. 15-week old C57BL/6J female mice were divided into the following groups: untreated OVX (OVX, n=17); treated daily with PTH (PTH, n=9); treated once with zolendronate (BIS, n=9); treated with cyclic mechanical loading (8 N, 10 Hz, 3000 cycles) at the 6th caudal vertebra (CML, n=17); and sham operated mice (SHM, n=8). Treatment started 11 weeks after ovariectomy and micro-CT measurements were performed at start of the treatment and after 2 and 4 weeks. Registration of three consecutive scans allowed estimating the amount of coupled bone formation (i.e., bone formed at the locations where it was previously resorbed) and coupled bone resorption (i.e., bone resorbed at the locations where it was previously formed). Considering that it is biologically irrational that newly formed bone gets immediately removed, coupled resorption could be interpreted as stochastic untargeted remodeling. OVX significantly increased the amount of coupled resorption by 44% when compared to SHM (PPPP<0.001). The proposed analysis allowed measuring the coexisting types of remodeling in living bone and indicated that PTH caused the strongest increase in coupled bone formation and the highest reduction of untargeted remodeling.
- 1 July 2012
- Published by Elsevier in Journal of Biomechanics
- Vol. 45, S107
PARATHYROID HORMONE INTERFERES WITH THE MECHANOREGULATION OF BONE REMODELING
- 1 July 2012
- Published by Elsevier in Journal of Biomechanics
- Vol. 45, S107
PARATHYROID HORMONE INTERFERES WITH THE MECHANOREGULATION OF BONE REMODELING
- 1 July 2012
- Published by Elsevier in Journal of Biomechanics
- Vol. 45, S116
A BEAM LATTICE MODEL TO INVESTIGATE BASIC ASPECTS OF BONE REMODELING
- 1 July 2012
- Published by Elsevier in Journal of Biomechanics
- Vol. 45, S116
A BEAM LATTICE MODEL TO INVESTIGATE BASIC ASPECTS OF BONE REMODELING
- 1 July 2012
- Published by Elsevier in Journal of Biomechanics
- Vol. 45, S341
THREE-DIMENSIONAL IN VIVO MONITORING OF BONE RESPONSE TO IMPLANT INSERTION
- 1 July 2012
- Published by Elsevier in Journal of Biomechanics
- Vol. 45, S341
THREE-DIMENSIONAL IN VIVO MONITORING OF BONE RESPONSE TO IMPLANT INSERTION
- 1 July 2012
- Published by Elsevier in Journal of Biomechanics
- Vol. 45, S340
IN SILICO QUANTIFICATION OF THE ELASTIC AND FAILURE PROPERTIES OF BONE SCREWS IN TRABECULAR BONE
- 1 July 2012
- Published by Elsevier in Journal of Biomechanics
- Vol. 45, S340
IN SILICO QUANTIFICATION OF THE ELASTIC AND FAILURE PROPERTIES OF BONE SCREWS IN TRABECULAR BONE
The different contributions of cortical and trabecular bone to implant anchorage in a human vertebra
- 12 May 2011
- Published by Springer Nature in Biomechanics and Modeling in Mechanobiology
- Vol. 11 (3-4) , 313-323
Mechanisms of reduced implant stability in osteoporotic bone
The determining factors for the fixation of uncemented screws in bone are the bone-implant interface and the peri-implant bone. The goal of this work was to explore the role of the peri-implant bone architecture on the mechanics of the bone-implant system. In particular, the specific aims of the study were to investigate: (i) the impact of the different architectural parameters, (ii) the effects of disorder, and (iii) the deformations in the peri-implant region. A three-dimensional beam lattice model to describe trabecular bone was developed. Various microstructural features of the lattice were varied in a systematic way. Implant pull-out tests were simulated, and the stiffness and strength of the bone-implant system were computed. The results indicated that the strongest decrease in pull-out strength was obtained by trabecular thinning, whereas pull-out stiffness was mostly affected by trabecular removal. These findings could be explained by investigating the peri-implant deformation field. For small implant displacements, a large amount of trabeculae in the peri-implant region were involved in the load transfer from implant to bone. Therefore, trabecular removal in this region had a strong negative effect on pull-out stiffness. Conversely, at higher displacements, deformations mainly localized in the trabeculae in contact with the implant; hence, thinning those trabeculae produced the strongest decrease in the strength of the system. Although idealized, the current approach is helpful for a mechanical understanding of the role played by peri-implant bone.
- 12 May 2011
- Published by Springer Nature in Biomechanics and Modeling in Mechanobiology
- Vol. 11 (3-4) , 313-323
Mechanisms of reduced implant stability in osteoporotic bone
The determining factors for the fixation of uncemented screws in bone are the bone-implant interface and the peri-implant bone. The goal of this work was to explore the role of the peri-implant bone architecture on the mechanics of the bone-implant system. In particular, the specific aims of the study were to investigate: (i) the impact of the different architectural parameters, (ii) the effects of disorder, and (iii) the deformations in the peri-implant region. A three-dimensional beam lattice model to describe trabecular bone was developed. Various microstructural features of the lattice were varied in a systematic way. Implant pull-out tests were simulated, and the stiffness and strength of the bone-implant system were computed. The results indicated that the strongest decrease in pull-out strength was obtained by trabecular thinning, whereas pull-out stiffness was mostly affected by trabecular removal. These findings could be explained by investigating the peri-implant deformation field. For small implant displacements, a large amount of trabeculae in the peri-implant region were involved in the load transfer from implant to bone. Therefore, trabecular removal in this region had a strong negative effect on pull-out stiffness. Conversely, at higher displacements, deformations mainly localized in the trabeculae in contact with the implant; hence, thinning those trabeculae produced the strongest decrease in the strength of the system. Although idealized, the current approach is helpful for a mechanical understanding of the role played by peri-implant bone.