MDM. L. Doan

M. L. Doan

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


M. L. Doan has a total of 4 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Thermal anomaly near the Aigio fault, Gulf of Corinth, Greece, maybe due to convection below the fault

    by M. L. Doan, F. H. Cornet

    A thermal profile has been measured in a 1000 m deep borehole intersecting the active Aigio fault, Corinth Rift, Greece. The heat flow is 53 mW/m2, indicating that the rifting process has no effect in heat flow. The temperature near the fault is higher than expected from a pure conductive model. This discrepancy is not due to fluid flow above the fault as shown by the long term monitoring of downhole pressure. Neither can it be attributed to the fault slip since the Aigio fault is a minor normal fault of the rift, with no very recent earthquake. We propose that the anomaly is due to the convection within the karst that constitutes the footwall. Numerical simulations give a correct estimate for the recorded temperature increase. This is an extreme case of thermal disturbance induced near a fault by local fluid circulation. The occurrence of convection outside geothermal area is very rare.


  • In situ measurement of the hydraulic diffusivity of the active Chelungpu Fault, Taiwan

    by M. L. Doan, E. E. Brodsky, Y. Kano, K. F. Ma

    Hydraulic diffusivity controls fluid pressure and hence affects effective normal stress during rupture. Models suggest a particularly spectacular example of fluid pressurization during the Mw = 7.6 1999 Chichi earthquake when pressurization may have reduced high‐frequency shaking in the regions of large slip if the fault was sufficiently sealed. We investigate in situ hydraulic diffusivity which is the key parameter in such models through a cross‐hole experiment. We find a diffusivity of D = (7 ± 1) × 10−5 m2/s, which is a low value compatible with pressurization of the Chelungpu fault during the earthquake. In most poroelastic media, the hydraulic storativity S lies between 10−7 and 10−5, so that the transmissivity T along the fault zone is comprised between 10−11 m2/s and 10−9 m2/s. The corresponding permeability (10−18–10−16 m2) is at most one hundred times larger than the value obtained on core samples from the host rock. The fault zone is overpressurized by 0.06 to 6 MPa, which is between 0.2% and 20% of the lithostatic pressure.