Dmitry Naumenko
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Dmitry Naumenko has a total of 44 co-authors. Here are the top co-authors by number of shared publications:
- Willem Joseph Quadakkers
Institute for Energy and Climate Research, IEK-2, Forschungszentrum Jülich GmbH, Jülich, Germany
14 shared publications E. Wessel
Forschungszentrum Jülich GmbH
4 shared publicationsL. Singheiser
Forschungszentrum Jülich GmbH
4 shared publicationsV. Kochubey
Forschungszentrum Jülich GmbH
3 shared publications- David John Young
School of Materials Science and Engineering, University of New South Wales, Sydney, Australia
2 shared publications - Joachim Mayer
Forschungszentrum Jülich GmbH
2 shared publications
Latest Publications
- Open Access
Influence of Different Annealing Atmospheres on the Mechanical Properties of Freestanding MCrAlY Bond Coats Investigated by Micro-Tensile Creep Tests
The mechanical properties of low-pressure plasma sprayed (LPPS) MCrAlY (M = Ni, Co) bond coats, Amdry 386, Amdry 9954 and oxide dispersion strengthened (ODS) Amdry 9954 (named Amdry 9954 + ODS) were investigated after annealing in three atmospheres: Ar–O2, Ar–H2O, and Ar–H2–H2O. Freestanding bond coats were investigated to avoid any influence from the substrate. Miniaturized cylindrical tensile specimens were produced by a special grinding process and then tested in a thermomechanical analyzer (TMA) within a temperature range of 900–950 °C. Grain size and phase fraction of all bond coats were investigated by EBSD before testing and no difference in microstructure was revealed due to annealing in various atmospheres. The influence of annealing in different atmospheres on the creep strength was not very pronounced for the Co-based bond coats Amdry 9954 and Amdry 9954 + ODS in the tested conditions. The ODS bond coats revealed significantly higher creep strength but a lower strain to failure than the ODS-free Amdry 9954. The Ni-based bond coat Amdry 386 showed higher creep strength than Amdry 9954 due to the higher fraction of the β-NiAl phase. Additionally, its creep properties at 900 °C were much more affected by annealing in different atmospheres. The bond coat Amdry 386 annealed in an Ar–H2O atmosphere showed a significantly lower creep rate than the bond coat annealed in Ar–O2 and Ar–H2–H2O atmospheres.
Open AccessInfluence of Different Annealing Atmospheres on the Mechanical Properties of Freestanding MCrAlY Bond Coats Investigated by Micro-Tensile Creep Tests
The mechanical properties of low-pressure plasma sprayed (LPPS) MCrAlY (M = Ni, Co) bond coats, Amdry 386, Amdry 9954 and oxide dispersion strengthened (ODS) Amdry 9954 (named Amdry 9954 + ODS) were investigated after annealing in three atmospheres: Ar–O2, Ar–H2O, and Ar–H2–H2O. Freestanding bond coats were investigated to avoid any influence from the substrate. Miniaturized cylindrical tensile specimens were produced by a special grinding process and then tested in a thermomechanical analyzer (TMA) within a temperature range of 900–950 °C. Grain size and phase fraction of all bond coats were investigated by EBSD before testing and no difference in microstructure was revealed due to annealing in various atmospheres. The influence of annealing in different atmospheres on the creep strength was not very pronounced for the Co-based bond coats Amdry 9954 and Amdry 9954 + ODS in the tested conditions. The ODS bond coats revealed significantly higher creep strength but a lower strain to failure than the ODS-free Amdry 9954. The Ni-based bond coat Amdry 386 showed higher creep strength than Amdry 9954 due to the higher fraction of the β-NiAl phase. Additionally, its creep properties at 900 °C were much more affected by annealing in different atmospheres. The bond coat Amdry 386 annealed in an Ar–H2O atmosphere showed a significantly lower creep rate than the bond coat annealed in Ar–O2 and Ar–H2–H2O atmospheres.
- 4 August 2018
- Published by Springer Nature in Oxidation of Metals
- Vol. 90 (5-6) , 671-690
Effect of Titanium Addition on Alumina Growth Mechanism on Yttria-Containing FeCrAl-Base Alloy
- 4 August 2018
- Published by Springer Nature in Oxidation of Metals
- Vol. 90 (5-6) , 671-690
Effect of Titanium Addition on Alumina Growth Mechanism on Yttria-Containing FeCrAl-Base Alloy
- 30 October 2017
- Published by Springer Nature in Journal of Thermal Spray Technology
- Vol. 26 (8) , 1743-1757
Overview on Recent Developments of Bondcoats for Plasma-Sprayed Thermal Barrier Coatings
- 30 October 2017
- Published by Springer Nature in Journal of Thermal Spray Technology
- Vol. 26 (8) , 1743-1757
Overview on Recent Developments of Bondcoats for Plasma-Sprayed Thermal Barrier Coatings
- Top Cited Papers
- 6 May 2016
- Published by Springer Nature in Oxidation of Metals
- Vol. 86 (1-2) , 1-43
Current Thoughts on Reactive Element Effects in Alumina-Forming Systems: In Memory of John Stringer
- 6 May 2016
- Published by Springer Nature in Oxidation of Metals
- Vol. 86 (1-2) , 1-43
Top Cited PapersCurrent Thoughts on Reactive Element Effects in Alumina-Forming Systems: In Memory of John Stringer
- 8 December 2010
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 42 (5) , 1173-1183
Effect of Zr Additions on the Oxidation Kinetics of FeCrAlY Alloys in Low and High pO2 Gases
- 8 December 2010
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 42 (5) , 1173-1183
Effect of Zr Additions on the Oxidation Kinetics of FeCrAlY Alloys in Low and High pO2 Gases
- 14 January 2010
- Published by Wiley in Materials and Corrosion
- Vol. 61 (10) , 838-844
Oxidation kinetics of Y‐doped FeCrAl‐alloys in low and high pO2 gases
A model Fe‐20Cr‐5Al‐0.05Y alloy was oxidized in Ar‐20%O2 and Ar‐4%H2‐7%H2O at 1200–1300 °C. Two‐stage oxidation experiments using oxygen isotope tracers showed that inward oxygen diffusion was predominant in both gases, but more isotope exchange was observed in the H2/H2O gas reaction. The alumina scales formed in both gases were composed of columnar grains, the lateral size of which increased linearly with depth beneath the scale surface. Thermogravimetric measurement of oxygen uptake revealed kinetics which were intermediate to parabolic and cubic kinetic rate laws. A model based on grain boundary diffusion control coupled with competitive oxide grain growth accounts satisfactorily for the results when the requirement for a divergence‐free flux within the scale is imposed. This treatment shows that the oxide grain boundary diffusion coefficient is lower when H2O is the oxidant. It is concluded that hydrogen slows the grain boundary diffusion process by altering the nature of the diffusing species.
- 14 January 2010
- Published by Wiley in Materials and Corrosion
- Vol. 61 (10) , 838-844
Oxidation kinetics of Y‐doped FeCrAl‐alloys in low and high pO2 gases
A model Fe‐20Cr‐5Al‐0.05Y alloy was oxidized in Ar‐20%O2 and Ar‐4%H2‐7%H2O at 1200–1300 °C. Two‐stage oxidation experiments using oxygen isotope tracers showed that inward oxygen diffusion was predominant in both gases, but more isotope exchange was observed in the H2/H2O gas reaction. The alumina scales formed in both gases were composed of columnar grains, the lateral size of which increased linearly with depth beneath the scale surface. Thermogravimetric measurement of oxygen uptake revealed kinetics which were intermediate to parabolic and cubic kinetic rate laws. A model based on grain boundary diffusion control coupled with competitive oxide grain growth accounts satisfactorily for the results when the requirement for a divergence‐free flux within the scale is imposed. This treatment shows that the oxide grain boundary diffusion coefficient is lower when H2O is the oxidant. It is concluded that hydrogen slows the grain boundary diffusion process by altering the nature of the diffusing species.
- 1 April 2009
- Published by Springer Nature in Journal of Materials Science
- Vol. 44 (7) , 1687-1703
Failure mechanisms of thermal barrier coatings on MCrAlY-type bondcoats associated with the formation of the thermally grown oxide
- 1 April 2009
- Published by Springer Nature in Journal of Materials Science
- Vol. 44 (7) , 1687-1703
Failure mechanisms of thermal barrier coatings on MCrAlY-type bondcoats associated with the formation of the thermally grown oxide
- 1 July 2008
- Published by Springer Nature in Journal of Materials Science
- Vol. 43 (13) , 4550-4560
Modification of alumina scale formation on FeCrAlY alloys by minor additions of group IVa elements
- 1 July 2008
- Published by Springer Nature in Journal of Materials Science
- Vol. 43 (13) , 4550-4560
Modification of alumina scale formation on FeCrAlY alloys by minor additions of group IVa elements
- 1 November 2007
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 38 (12) , 2974-2983
Correlation between the Microstructure, Growth Mechanism, and Growth Kinetics of Alumina Scales on a FeCrAlY Alloy
- 1 November 2007
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 38 (12) , 2974-2983
Correlation between the Microstructure, Growth Mechanism, and Growth Kinetics of Alumina Scales on a FeCrAlY Alloy
- 19 December 2005
- Published by Wiley in Materials and Corrosion
- Vol. 56 (12) , 848-853
Effects of minor additions and impurities on oxidation behaviour of FeCrAl alloys. Development of novel surface coatings compositions
- 19 December 2005
- Published by Wiley in Materials and Corrosion
- Vol. 56 (12) , 848-853
Effects of minor additions and impurities on oxidation behaviour of FeCrAl alloys. Development of novel surface coatings compositions