Mohammad Ali Asadollahi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Mohammad Ali Asadollahi has a total of 78 co-authors. Here are the top co-authors by number of shared publications:
- Hamid Amiri
Department of Biotechnology, Faculty of Biological Science and Technology University of Isfahan Isfahan Iran
6 shared publications - Davoud Biria
Department of Chemical Engineering, University of Isfahan, Isfahan, Iran
5 shared publications Hamid Amiri
5 shared publications- Ayyoob Arpanaei
Scion
3 shared publications Azar Shahpiri
Department of Biotechnology, College of Agriculture, Isfahan University of Technology, Isfahan, Iran
3 shared publications- Bin Li
Chinese Academy of Sciences
3 shared publications
Latest Publications
- 11 September 2026
- Published by Elsevier in Process Safety and Environmental Protection
- Vol. 220
Selective phenolic detoxification of pretreatment liquors for integrated valorization of potato peel waste
- 11 September 2026
- Published by Elsevier in Process Safety and Environmental Protection
- Vol. 220
Selective phenolic detoxification of pretreatment liquors for integrated valorization of potato peel waste
- Open Access
- 1 June 2026
- Published by Elsevier in Current Research in Biotechnology
- Vol. 12
Isolation and characterization of a lignin-degrading Escherichia sp. strain SFD3 and its potential for lignocellulosic biomass valorization
- 1 June 2026
- Published by Elsevier in Current Research in Biotechnology
- Vol. 12
Open AccessIsolation and characterization of a lignin-degrading Escherichia sp. strain SFD3 and its potential for lignocellulosic biomass valorization
- Open Access
Sustainable Strategies for Full Use of Miscanthus: Biodegradable Seedling Pots and Lignin-Based Fertilizers
Miscanthus (Panicum virgatum L.), a biomass material known for its rapid growth and high biomass yield, is considered a suitable resource for producing biobased materials. Nevertheless, the dense and complex structure of Miscanthus hinders its full utilization. In this study, alkaline sulfite pretreatment of Miscanthus was carried out to separate the cellulosic fiber fraction and sulfonated lignin. Then, the fiber fraction was used to prepare biobased seedling pots via the wet foaming technique, and the maximum compressive strength of the prepared seeding pot could reach 1317 kPa. The surface coating of the seeding pot with wood wax oil further improved its hydrophobicity and water resistance. Furthermore, the resulting seedling pot with good biodegradability can be used to replace the petroleum-based plastic seedling pot, which could reduce plastic pollution. In addition, the fractionated sulfonated lignin was directly utilized as a fertilizer, showcasing a 6% increase in root and stem height of cabbage and a 15% rise in biomass (dry weight), compared to the humic acid treatment group. Therefore, this work offers a promising and sustainable strategy for the comprehensive utilization of Miscanthus, which can also be a beneficial reference for the better use of other kinds of lignocellulosic biomass.
Open AccessSustainable Strategies for Full Use of Miscanthus: Biodegradable Seedling Pots and Lignin-Based Fertilizers
Miscanthus (Panicum virgatum L.), a biomass material known for its rapid growth and high biomass yield, is considered a suitable resource for producing biobased materials. Nevertheless, the dense and complex structure of Miscanthus hinders its full utilization. In this study, alkaline sulfite pretreatment of Miscanthus was carried out to separate the cellulosic fiber fraction and sulfonated lignin. Then, the fiber fraction was used to prepare biobased seedling pots via the wet foaming technique, and the maximum compressive strength of the prepared seeding pot could reach 1317 kPa. The surface coating of the seeding pot with wood wax oil further improved its hydrophobicity and water resistance. Furthermore, the resulting seedling pot with good biodegradability can be used to replace the petroleum-based plastic seedling pot, which could reduce plastic pollution. In addition, the fractionated sulfonated lignin was directly utilized as a fertilizer, showcasing a 6% increase in root and stem height of cabbage and a 15% rise in biomass (dry weight), compared to the humic acid treatment group. Therefore, this work offers a promising and sustainable strategy for the comprehensive utilization of Miscanthus, which can also be a beneficial reference for the better use of other kinds of lignocellulosic biomass.
- Open Access
- 24 February 2026
- Published by Elsevier in Industrial Crops and Products
- Vol. 242
Closed-loop biorefinery valorization of forage sorghum straw for xanthan gum production using a lignin-derived hydrogel for in-situ detoxification
- 24 February 2026
- Published by Elsevier in Industrial Crops and Products
- Vol. 242
Open AccessClosed-loop biorefinery valorization of forage sorghum straw for xanthan gum production using a lignin-derived hydrogel for in-situ detoxification
- Open Access
The Effect of Enzyme Synergism on Generation of Fermentable Sugars After Alkali Pretreatment of Wheat Straw, Assessed and Predicted Using Multivariate Analysis
Alkaline pretreatment of wheat straw could significantly augment enzymatic hydrolysis for producing fermentable sugars, which is a pivotal process for the conversion of lignocellulosic biomass into advanced biofuels, biomaterials, or biochemicals. Yet, the enzymatic conversion process system is complex and multivariate, and study on the interaction mechanism of the key parameters in enzymatic hydrolysis is still lacking. Therefore, in this work, multivariate data analysis (MDA) (i.e., principal component analysis (PCA) and partial least square (PLS)) was conducted to reveal the inherent relationship and the significance of these factors in a modified alkali pretreatment system. A robust model, developed from 140 enzymatic hydrolysis datasets, was validated with an additional 20 datasets, demonstrating the predictive prowess of the PLS model. MDA identified that cellulase dosage, mechanical refining, dye adsorption value, and solid content were paramount variables. The integration of cellulase and xylanase notably elevated sugar yields and the conversion rates of carbohydrates, surpassing those of single enzyme treatments. The model’s predictive accuracy, reflected in the close alignment between observed and predicted data, underscores its suitability for optimizing and controlling the enzymatic hydrolysis process. This study paves a way for data-driven strategies to enhance industrial bioprocessing of lignocellulosic feedstocks.
Open AccessThe Effect of Enzyme Synergism on Generation of Fermentable Sugars After Alkali Pretreatment of Wheat Straw, Assessed and Predicted Using Multivariate Analysis
Alkaline pretreatment of wheat straw could significantly augment enzymatic hydrolysis for producing fermentable sugars, which is a pivotal process for the conversion of lignocellulosic biomass into advanced biofuels, biomaterials, or biochemicals. Yet, the enzymatic conversion process system is complex and multivariate, and study on the interaction mechanism of the key parameters in enzymatic hydrolysis is still lacking. Therefore, in this work, multivariate data analysis (MDA) (i.e., principal component analysis (PCA) and partial least square (PLS)) was conducted to reveal the inherent relationship and the significance of these factors in a modified alkali pretreatment system. A robust model, developed from 140 enzymatic hydrolysis datasets, was validated with an additional 20 datasets, demonstrating the predictive prowess of the PLS model. MDA identified that cellulase dosage, mechanical refining, dye adsorption value, and solid content were paramount variables. The integration of cellulase and xylanase notably elevated sugar yields and the conversion rates of carbohydrates, surpassing those of single enzyme treatments. The model’s predictive accuracy, reflected in the close alignment between observed and predicted data, underscores its suitability for optimizing and controlling the enzymatic hydrolysis process. This study paves a way for data-driven strategies to enhance industrial bioprocessing of lignocellulosic feedstocks.
- 13 September 2025
- Published by Elsevier in Biomass and Bioenergy
- Vol. 204
Sustainable production of biobutanol and biodiesel from municipal solid waste: Optimization and process integration
- 13 September 2025
- Published by Elsevier in Biomass and Bioenergy
- Vol. 204
Sustainable production of biobutanol and biodiesel from municipal solid waste: Optimization and process integration
- 1 April 2025
- Published by Bentham Science Publishers Ltd. in Nanoscience & Nanotechnology-Asia
- Vol. 15 (2) , 54-61
Electrospun Polyvinyl Alcohol Nanofibers Loaded with Ferula assa-foetida Gum Extract: Fabrication, Characterization, and Antibacterial Activity
Background: Therapeutic effects of plant metabolites have been used for the treatment of burns, wounds and infections over the centuries. Electrospun nanofibers containing plant metabolites have also been considered recently for the development of new and efficient wound dressings. Ferula assa-foetida has received much attention in traditional medicine due to its numerous healing properties. Objective: In the present study, polyvinyl alcohol (PVA) nanofibers containing aqueous extracts of F. assa-foetida gum (FAE) were prepared and characterized. The antibacterial activity of nanofibers was investigated. Methods: Electrospinning was utilized for the fabrication of PVA/FAE nanofibers. The morphology, physical and chemical properties of the synthesized nanofibers were investigated by scanning electron microscope (SEM), Fourier transform infrared (FTIR) spectroscopy, and contact angle test. Results: The uniform nanofibers with the average diameter of 256 nm were obtained by using 8 wt.% PVA, 1:4 (w: w %) ratio of PVA/FAE, needle to collector distance of 13 cm, 20 kV voltage, collector rotation speed of 3 m/min, and flow rate of 0.5 mL/h. The use of FAE led to the increased diameter of nanofibers and their contact angle compared to PVA nanofibers. Interestingly, the PVA/FAE nanofibers displayed considerable antibacterial activity against Escherichia coli and Staphylococcus aureus. Conclusion: The overall results indicated that PVA/FAE nanofibers can be considered as a potential candidate for the preparation of wound dressings with antibacterial properties.
- 1 April 2025
- Published by Bentham Science Publishers Ltd. in Nanoscience & Nanotechnology-Asia
- Vol. 15 (2) , 54-61
Electrospun Polyvinyl Alcohol Nanofibers Loaded with Ferula assa-foetida Gum Extract: Fabrication, Characterization, and Antibacterial Activity
Background: Therapeutic effects of plant metabolites have been used for the treatment of burns, wounds and infections over the centuries. Electrospun nanofibers containing plant metabolites have also been considered recently for the development of new and efficient wound dressings. Ferula assa-foetida has received much attention in traditional medicine due to its numerous healing properties. Objective: In the present study, polyvinyl alcohol (PVA) nanofibers containing aqueous extracts of F. assa-foetida gum (FAE) were prepared and characterized. The antibacterial activity of nanofibers was investigated. Methods: Electrospinning was utilized for the fabrication of PVA/FAE nanofibers. The morphology, physical and chemical properties of the synthesized nanofibers were investigated by scanning electron microscope (SEM), Fourier transform infrared (FTIR) spectroscopy, and contact angle test. Results: The uniform nanofibers with the average diameter of 256 nm were obtained by using 8 wt.% PVA, 1:4 (w: w %) ratio of PVA/FAE, needle to collector distance of 13 cm, 20 kV voltage, collector rotation speed of 3 m/min, and flow rate of 0.5 mL/h. The use of FAE led to the increased diameter of nanofibers and their contact angle compared to PVA nanofibers. Interestingly, the PVA/FAE nanofibers displayed considerable antibacterial activity against Escherichia coli and Staphylococcus aureus. Conclusion: The overall results indicated that PVA/FAE nanofibers can be considered as a potential candidate for the preparation of wound dressings with antibacterial properties.
- 28 December 2024
- Published by Elsevier in Biomass and Bioenergy
- Vol. 193
The effect of combining mineral salt with ball milling for promoting enzymatic saccharification of cellulose
- 28 December 2024
- Published by Elsevier in Biomass and Bioenergy
- Vol. 193
The effect of combining mineral salt with ball milling for promoting enzymatic saccharification of cellulose