Youngkyoo Kim
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Youngkyoo Kim has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Hwajeong Kim
Organic Nanoelectronics Laboratory and KNU Institute for Nanophotonics Applications (KINPA)
3 shared publications - Jaehoon Jeong
Organic Nanoelectronics Laboratory and KNU Institute for Nanophotonics Applications (KINPA), Department of Chemical Engineering, School of Applied Chemical Engineering, Kyungpook National University, University Road 80, Daegu 41566, Korea
2 shared publications Sungho Nam
2 shared publicationsChang-Sik Ha
Department of Polymer Science and Engineering, Pusan National University,Pusan 609-735,South Korea
1 shared publicationChulyeon Lee
1 shared publication- Donal Donat Conor Bradley
Physical Sciences and Engineering (PSE) Division King Abdullah University of Science and Technology (KAUST) Saudi Arabia
1 shared publication
Latest Publications
- 1 August 2015
- Published by American Scientific Publishers in Journal of Nanoelectronics and Optoelectronics
- Vol. 10 (4) , 494-497
Characteristics of Photodetectors Fabricated with Fullerene Derivatives: Influence of Light Intensity and Voltage
We report planar photodetectors with a fullerene UV-sensing layer which are coated on the micro-channel substrates. The fullerene layers were prepared by wet-coating processes from the fullerene solution at room temperature. The resulting fullerene layers exhibited a porous morphology but a relatively smooth continuous surface, while their optical absorption spectrum covered UV to visible range (up to 500 nm). The planar fullerene photodetectors were examined by varying the incident UV light intensity and the applied voltage. Results showed that the photocurrent of the planar fullerene photodetectors was pronouncedly increased as the applied increased under illumination of UV light (380 nm). However, the incident light intensity was less effective than the applied voltage because of the limited charge separation in the present planar device structure.
- 1 August 2015
- Published by American Scientific Publishers in Journal of Nanoelectronics and Optoelectronics
- Vol. 10 (4) , 494-497
Characteristics of Photodetectors Fabricated with Fullerene Derivatives: Influence of Light Intensity and Voltage
We report planar photodetectors with a fullerene UV-sensing layer which are coated on the micro-channel substrates. The fullerene layers were prepared by wet-coating processes from the fullerene solution at room temperature. The resulting fullerene layers exhibited a porous morphology but a relatively smooth continuous surface, while their optical absorption spectrum covered UV to visible range (up to 500 nm). The planar fullerene photodetectors were examined by varying the incident UV light intensity and the applied voltage. Results showed that the photocurrent of the planar fullerene photodetectors was pronouncedly increased as the applied increased under illumination of UV light (380 nm). However, the incident light intensity was less effective than the applied voltage because of the limited charge separation in the present planar device structure.
- 20 December 2010
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 3 (3) , 1073-1077
Diimide nanoclusters play hole trapping and electron injection roles in organic light-emitting devices
We report thermally stable diimide nanoclusters that could potentially replace the conventional thick electron transport layer (ETL) in organic light-emitting devices (OLEDs). Bis-[1,10]phenanthrolin-5-yl-bicyclo[2.2.2]oct-7-ene-2,3,5,6-tetracarboxylic diimide (Bphen-BCDI) was synthesized from the corresponding dianhydride and amine moieties, and its purified product exhibited a high glass transition temperature (232 °C) and a wide band gap (3.8 eV). The Bphen-BCDI subnanolayers deposited on substrates were found to form organic nanoclusters, not a conventional layer. The OLED made with a subnanolayer of Bphen-BCDI nanoclusters, instead of a conventional ETL, showed greatly improved efficiency (about 2-fold) compared with an OLED without the diimide nanoclusters. The role of the BPhen-BCDI nanoclusters was assigned to hole trapping and electron injection in the present OLED structure.
- 20 December 2010
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 3 (3) , 1073-1077
Diimide nanoclusters play hole trapping and electron injection roles in organic light-emitting devices
We report thermally stable diimide nanoclusters that could potentially replace the conventional thick electron transport layer (ETL) in organic light-emitting devices (OLEDs). Bis-[1,10]phenanthrolin-5-yl-bicyclo[2.2.2]oct-7-ene-2,3,5,6-tetracarboxylic diimide (Bphen-BCDI) was synthesized from the corresponding dianhydride and amine moieties, and its purified product exhibited a high glass transition temperature (232 °C) and a wide band gap (3.8 eV). The Bphen-BCDI subnanolayers deposited on substrates were found to form organic nanoclusters, not a conventional layer. The OLED made with a subnanolayer of Bphen-BCDI nanoclusters, instead of a conventional ETL, showed greatly improved efficiency (about 2-fold) compared with an OLED without the diimide nanoclusters. The role of the BPhen-BCDI nanoclusters was assigned to hole trapping and electron injection in the present OLED structure.
- Open Access
- 3 November 2006
- Published by Royal Society of Chemistry (RSC) in Soft Matter
- Vol. 3 (1) , 117-121
Polymer chain/nanocrystal ordering in thin films of regioregular poly(3-hexylthiophene) and blends with a soluble fullerene
Here we report a study of the polymer chain/nanocrystal ordering in thin films (nanolayers) of regioregular poly(3-hexylthiophene) (P3HT) and blends of P3HT with a soluble fullerene derivative. A detailed analysis has been made of two dimensional (2D) grazing incidence X-ray diffraction (GIXRD) measurements with synchrotron radiation. P3HT samples with three different levels of regioregularity (RR) were synthesized and used to investigate the influence of RR on the chain ordering in thin films. Blend films were also prepared to investigate the influence of fullerene molecule addition on chain ordering. For the analysis, one dimensional (1D) GIXRD patterns were extracted from the 2D images for varying azimuthal angles, allowing information to be obtained for chain ordering in both the out-of-plane (OOP) and in-plane (IP) directions. These results show that the degree of P3HT chain ordering is strongly affected by RR, and that thermal annealing improves chain ordering in the OOP direction. This observation is in good agreement with high resolution transmission electron microscope measurements of film nanomorphology.
- 3 November 2006
- Published by Royal Society of Chemistry (RSC) in Soft Matter
- Vol. 3 (1) , 117-121
Open AccessPolymer chain/nanocrystal ordering in thin films of regioregular poly(3-hexylthiophene) and blends with a soluble fullerene
Here we report a study of the polymer chain/nanocrystal ordering in thin films (nanolayers) of regioregular poly(3-hexylthiophene) (P3HT) and blends of P3HT with a soluble fullerene derivative. A detailed analysis has been made of two dimensional (2D) grazing incidence X-ray diffraction (GIXRD) measurements with synchrotron radiation. P3HT samples with three different levels of regioregularity (RR) were synthesized and used to investigate the influence of RR on the chain ordering in thin films. Blend films were also prepared to investigate the influence of fullerene molecule addition on chain ordering. For the analysis, one dimensional (1D) GIXRD patterns were extracted from the 2D images for varying azimuthal angles, allowing information to be obtained for chain ordering in both the out-of-plane (OOP) and in-plane (IP) directions. These results show that the degree of P3HT chain ordering is strongly affected by RR, and that thermal annealing improves chain ordering in the OOP direction. This observation is in good agreement with high resolution transmission electron microscope measurements of film nanomorphology.
- 15 June 2004
- Published by Wiley in Physica Status Solidi (a)
- Vol. 201 (9) , 2148-2153
Effect of hole-blocking layer doped with electron-transport molecules on the performance of blue organic light-emitting device
- 15 June 2004
- Published by Wiley in Physica Status Solidi (a)
- Vol. 201 (9) , 2148-2153
Effect of hole-blocking layer doped with electron-transport molecules on the performance of blue organic light-emitting device