Stephen R. Forrest
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Stephen R. Forrest has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Mark E. Thompson
Department of Chemistry University of Southern California Los Angeles California USA
3 shared publications - Paul E. Burrows
Princeton Univ. (United States)
2 shared publications B.W.
1 shared publicationB.W. D’andrade
Center for Photonics and Optoelectronic Materials (POEM), Princeton Materials Institute (PMI), Department of Electrical Engineering, Princeton University, Princeton, NJ 08544 (USA)
1 shared publicationC. Kim
Center for Photonics and Optoelectronic Materials (POEM), Department of Electrical Engineering, Princeton University, Princeton, NJ 08544, USA
1 shared publicationChih-Ping Chao
Advanced Technology Center for Photonics and Optoelectronic Materials, Department of Electrical Engineering, Princeton University, Princeton, New Jersey 08544
1 shared publication
Latest Publications
- 30 June 2003
- Published by Wiley in Advanced Materials
- Vol. 15 (13) , 1043-1048
Measuring the Efficiency of Organic Light‐Emitting Devices
As organic light‐emitting devices emerge from the stage of being a research curiosity to that of becoming a practical appliance with important commercial applications, the need for a coherent and accurate standard technique for measuring device efficiencies becomes increasingly important. By following the methods described in this contribution, measurements made in disparate laboratories testing a wide range of materials and device structures should agree, to within small experimental errors, on the properties of the subject devices.
- 30 June 2003
- Published by Wiley in Advanced Materials
- Vol. 15 (13) , 1043-1048
Measuring the Efficiency of Organic Light‐Emitting Devices
As organic light‐emitting devices emerge from the stage of being a research curiosity to that of becoming a practical appliance with important commercial applications, the need for a coherent and accurate standard technique for measuring device efficiencies becomes increasingly important. By following the methods described in this contribution, measurements made in disparate laboratories testing a wide range of materials and device structures should agree, to within small experimental errors, on the properties of the subject devices.
- 17 March 2003
- Published by Wiley in Advanced Materials
- Vol. 15 (6) , 541-545
Fabrication of Organic Light‐Emitting Devices by Low‐Pressure Cold Welding
Low‐pressure cold welding has been used to fabricate 200 μm diameter organic light‐emitting devices (OLEDs) (see Figure). The contacts are made by transferring a metal film from a patterned, soft elastomeric stamp onto unpatterned organic and metal layers on a substrate. The process does not adversely affect the OLED performance when compared with those fabricated by shadow mask patterning.
- 17 March 2003
- Published by Wiley in Advanced Materials
- Vol. 15 (6) , 541-545
Fabrication of Organic Light‐Emitting Devices by Low‐Pressure Cold Welding
Low‐pressure cold welding has been used to fabricate 200 μm diameter organic light‐emitting devices (OLEDs) (see Figure). The contacts are made by transferring a metal film from a patterned, soft elastomeric stamp onto unpatterned organic and metal layers on a substrate. The process does not adversely affect the OLED performance when compared with those fabricated by shadow mask patterning.
- 5 August 2002
- Published by Wiley in Advanced Materials
- Vol. 14 (15) , 1032-1036
White Light Emission Using Triplet Excimers in Electrophosphorescent Organic Light-Emitting Devices
- 5 August 2002
- Published by Wiley in Advanced Materials
- Vol. 14 (15) , 1032-1036
White Light Emission Using Triplet Excimers in Electrophosphorescent Organic Light-Emitting Devices
- 16 January 2002
- Published by Wiley in Advanced Materials
- Vol. 14 (2) , 147-151
Controlling Exciton Diffusion in Multilayer White Phosphorescent Organic Light Emitting Devices
- 16 January 2002
- Published by Wiley in Advanced Materials
- Vol. 14 (2) , 147-151
Controlling Exciton Diffusion in Multilayer White Phosphorescent Organic Light Emitting Devices
- 27 September 2001
- Published by Elsevier in Organic Electronics
- Vol. 2 (3-4) , 143-154
Characterization of bis(1,2,5-thiadiazolo)-p-quinobis(1,3-dithiole) thin films grown by organic molecular beam deposition
- 27 September 2001
- Published by Elsevier in Organic Electronics
- Vol. 2 (3-4) , 143-154
Characterization of bis(1,2,5-thiadiazolo)-p-quinobis(1,3-dithiole) thin films grown by organic molecular beam deposition
- Open Access
- 1 January 1999
- Published by Springer Nature in Nature
- Vol. 397 (6717) , 294-295
Lasing from a molecular sieve
- 1 January 1999
- Published by Springer Nature in Nature
- Vol. 397 (6717) , 294-295
Open AccessLasing from a molecular sieve
- 15 August 1994
- Published by AIP Publishing in Applied Physics Letters
- Vol. 65 (7) , 892-894
Low-threshold 1.3-μm wavelength, InGaAsP strained-layer multiple quantum well lasers grown by gas source molecular beam epitaxy
We report the growth, by gas source molecular beam epitaxy (GSMBE) of low‐threshold 1.3‐μm wavelength strained‐layer In0.86Ga0.14As0.52P0.48/In0.86Ga0.14 As0.3P0.7 separate confinement heterostructure multiple quantum well lasers. Threshold currents as low as 16 mA were measured for a 390×5‐μm ridge laser, and a threshold current density of Jth=490 A/cm2 was achieved for a 1200×5‐μm device. Apparently, this is the lowest value of Jth reported to date for 1.3‐μm lasers grown by GSMBE, and is comparable to the best devices grown by other techniques such as chemical beam epitaxy and metalorganic vapor phase epitaxy.
- 15 August 1994
- Published by AIP Publishing in Applied Physics Letters
- Vol. 65 (7) , 892-894
Low-threshold 1.3-μm wavelength, InGaAsP strained-layer multiple quantum well lasers grown by gas source molecular beam epitaxy
We report the growth, by gas source molecular beam epitaxy (GSMBE) of low‐threshold 1.3‐μm wavelength strained‐layer In0.86Ga0.14As0.52P0.48/In0.86Ga0.14 As0.3P0.7 separate confinement heterostructure multiple quantum well lasers. Threshold currents as low as 16 mA were measured for a 390×5‐μm ridge laser, and a threshold current density of Jth=490 A/cm2 was achieved for a 1200×5‐μm device. Apparently, this is the lowest value of Jth reported to date for 1.3‐μm lasers grown by GSMBE, and is comparable to the best devices grown by other techniques such as chemical beam epitaxy and metalorganic vapor phase epitaxy.
- 29 June 1992
- Published by AIP Publishing in Applied Physics Letters
- Vol. 60 (26) , 3223-3225
Evolution of quasi-epitaxial growth of a crystalline organic semiconductor on graphite
We have studied the evolution of the growth of a crystalline organic semiconductor thin film using reflection high energy electron diffraction (RHEED). Our results indicate that highly ordered crystalline films of an organic compound; namely 3, 4, 9, 10-perylenetetracarboxylic dianhydride (PTCDA), can be grown on graphite by the ultrahigh vacuum process of organic molecular beam deposition even though the crystal structures of the two materials are highly mismatched. The RHEED patterns show the evolution of planar crystal growth from 2 monolayer (∼6 Å) coverage until at least 50 Å as the films are deposited onto substrates cooled to 100 K. At larger film thicknesses, somewhat nonplanar but still crystalline growth occurs. Furthermore, crystalline thin films were obtained independent of growth rate, which was as high as 3.0 Å/s. To our knowledge, this is the first direct experimental evidence of the evolution of growth from monolayer to bulk film coverage into an ordered, quasi-epitaxial structure.
- 29 June 1992
- Published by AIP Publishing in Applied Physics Letters
- Vol. 60 (26) , 3223-3225
Evolution of quasi-epitaxial growth of a crystalline organic semiconductor on graphite
We have studied the evolution of the growth of a crystalline organic semiconductor thin film using reflection high energy electron diffraction (RHEED). Our results indicate that highly ordered crystalline films of an organic compound; namely 3, 4, 9, 10-perylenetetracarboxylic dianhydride (PTCDA), can be grown on graphite by the ultrahigh vacuum process of organic molecular beam deposition even though the crystal structures of the two materials are highly mismatched. The RHEED patterns show the evolution of planar crystal growth from 2 monolayer (∼6 Å) coverage until at least 50 Å as the films are deposited onto substrates cooled to 100 K. At larger film thicknesses, somewhat nonplanar but still crystalline growth occurs. Furthermore, crystalline thin films were obtained independent of growth rate, which was as high as 3.0 Å/s. To our knowledge, this is the first direct experimental evidence of the evolution of growth from monolayer to bulk film coverage into an ordered, quasi-epitaxial structure.