Ravi F. Saraf
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Ravi F. Saraf has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Seung-Woo Lee
Department of Fine Chemistry Seoul National University of Science and Technology Nowon-gu Seoul Republic of Korea
3 shared publications Vikas Berry
Department of Chemical Engineering, Kansas State University, USA
3 shared publicationsVivek Maheshwari
Department of Biomolecular and Chemical Engineering, University of Nebraska, Lincoln, 207 Othmer Hall, Lincoln NE 68588-0643 (USA), Fax: (+1) 402-472-6989
3 shared publicationsDavid Moore
Chemical and Biomolecular Engineering, Nebraska Center for Materials and Nanoscience, University of Nebraska‐Lincoln, Lincoln NE 68588, USA
2 shared publicationsChichao Yu
Chemical and Biomolecular Engineering, Nebraska Center for Materials and Nanoscience, University of Nebraska-Lincoln, Lincoln, NE 68588, USA
1 shared publicationChieu Nguyen
Department of Chemical and Biochemical Engineering, University of Nebraska ¿ Lincoln, Lincoln, NE 68516, USA
1 shared publication
Latest Publications
- 1 July 2014
- Published by Elsevier in Biosensors and Bioelectronics
- Vol. 57, 41-47
Multianalyte electrochemical biosensor on a monolith electrode by optically scanning the electrical double layer
- 1 July 2014
- Published by Elsevier in Biosensors and Bioelectronics
- Vol. 57, 41-47
Multianalyte electrochemical biosensor on a monolith electrode by optically scanning the electrical double layer
- 9 May 2013
- Published by Wiley in Electroanalysis
- Vol. 25 (6) , 1557-1566
Fabrication and Properties of Redox Ion Doped Few Monolayer Thick Polyelectrolyte Film for Electrochemical Biosensors at High Sensitivity and Specificity
- 9 May 2013
- Published by Wiley in Electroanalysis
- Vol. 25 (6) , 1557-1566
Fabrication and Properties of Redox Ion Doped Few Monolayer Thick Polyelectrolyte Film for Electrochemical Biosensors at High Sensitivity and Specificity
- 8 May 2013
- Published by Wiley in Advanced Materials
- Vol. 25 (22) , 3079-3084
Single Electron Transistor in Aqueous Media
A gold nanoparticle necklace array spanning a ∼30‐micrometer‐wide channel shows a robust coulomb blockade effect at room temperature with a threshold of 1V in air. When this device is operated in the aqueous solution, a gain of ∼130 fold in conductance is obtained in electrochemical gating, significantly higher than other nanomaterial‐based electrochemical transistors.
- 8 May 2013
- Published by Wiley in Advanced Materials
- Vol. 25 (22) , 3079-3084
Single Electron Transistor in Aqueous Media
A gold nanoparticle necklace array spanning a ∼30‐micrometer‐wide channel shows a robust coulomb blockade effect at room temperature with a threshold of 1V in air. When this device is operated in the aqueous solution, a gain of ∼130 fold in conductance is obtained in electrochemical gating, significantly higher than other nanomaterial‐based electrochemical transistors.
Modulation of Electron Tunneling in a Nanoparticle Array by Sound Waves: An Avenue to High‐Speed, High‐Sensitivity Sensors
Using an electrostatic self-assembly process, metal nanoparticles are deposited on polyelectrolyte fibers such that the interparticle distance between the nanoparticles is comparable to the polyelectrolyte's molecular width. By modulating the dielectric properties of the interparticle polymer layer, a highly sensitive, reversible humidity sensor with an ultrafast response time of ≈3 ms is demonstrated. The higher sensitivity at low humidity shows a conductivity increase by over two orders of magnitude in response to a change in relative humidity from 21 to 1%.
Modulation of Electron Tunneling in a Nanoparticle Array by Sound Waves: An Avenue to High‐Speed, High‐Sensitivity Sensors
Using an electrostatic self-assembly process, metal nanoparticles are deposited on polyelectrolyte fibers such that the interparticle distance between the nanoparticles is comparable to the polyelectrolyte's molecular width. By modulating the dielectric properties of the interparticle polymer layer, a highly sensitive, reversible humidity sensor with an ultrafast response time of ≈3 ms is demonstrated. The higher sensitivity at low humidity shows a conductivity increase by over two orders of magnitude in response to a change in relative humidity from 21 to 1%.
- 25 June 2009
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 81 (15) , 6055-6060
Localized Electrochemistry on a 10 μm Spot on a Monolith Large Electrode: An Avenue for Electrochemical Microarray Analysis
By measurement of the modulation of ions under an ac field at the electrode/electrolyte interface layer (EIL) at a spatial modulation of 0.0001 nm, a quantitative measurement of local redox current on a 10 μm spot of a working electrode is achieved at a sensitivity of 0.02 nA/spot. The spot is defined by the probe laser beam. We show the principle for two redox ions, [Fe(CN)6]3− and [Ru(NH3)6]3+, on a 4 mm2 Au electrode. The redox peaks from the optical and the electrochemical (cyclic voltammetry (CV)) responses, which are concomitantly measured, are within 0.005 V. The setup is identical to the conventional three-electrode measurement, and the laser beam does not perturb the electrochemical process. We demonstrate high sensitivity to “read” binding between two single-stranded DNA (ssDNA) on a 10 μm spot for DNA microarray analysis where the signal is “blind” to nonspecific binding. Potentially, quantitative combinatorial electrochemistry can be performed on a monolith electrode by scanning the laser beam on the electrode.
- 25 June 2009
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 81 (15) , 6055-6060
Localized Electrochemistry on a 10 μm Spot on a Monolith Large Electrode: An Avenue for Electrochemical Microarray Analysis
By measurement of the modulation of ions under an ac field at the electrode/electrolyte interface layer (EIL) at a spatial modulation of 0.0001 nm, a quantitative measurement of local redox current on a 10 μm spot of a working electrode is achieved at a sensitivity of 0.02 nA/spot. The spot is defined by the probe laser beam. We show the principle for two redox ions, [Fe(CN)6]3− and [Ru(NH3)6]3+, on a 4 mm2 Au electrode. The redox peaks from the optical and the electrochemical (cyclic voltammetry (CV)) responses, which are concomitantly measured, are within 0.005 V. The setup is identical to the conventional three-electrode measurement, and the laser beam does not perturb the electrochemical process. We demonstrate high sensitivity to “read” binding between two single-stranded DNA (ssDNA) on a 10 μm spot for DNA microarray analysis where the signal is “blind” to nonspecific binding. Potentially, quantitative combinatorial electrochemistry can be performed on a monolith electrode by scanning the laser beam on the electrode.
- 24 September 2008
- Published by Wiley in Angewandte Chemie International Edition
- Vol. 47 (41) , 7808-7826
Tactile Devices To Sense Touch on a Par with a Human Finger
Our sense of touch enables us to recognize texture and shape and to grasp objects. The challenge in making an electronic skin which can emulate touch for applications such as a humanoid robot or minimally invasive and remote surgery is both in mimicking the (passive) mechanical properties of the dermis and the characteristics of the sensing mechanism, especially the intrinsic digital nature of neurons. Significant progress has been made towards developing an electronic skin by using a variety of materials and physical concepts, but the challenge of emulating the sense of touch remains. Recently, a nanodevice was developed that has achieved the resolution to decipher touch on a par with the human finger; this resolution is over an order of magnitude improvement on previous devices with a sensing area larger than 1 cm2. With its robust mechanical properties, this new system represents an important step towards the realization of artificial touch.
- 24 September 2008
- Published by Wiley in Angewandte Chemie International Edition
- Vol. 47 (41) , 7808-7826
Tactile Devices To Sense Touch on a Par with a Human Finger
Our sense of touch enables us to recognize texture and shape and to grasp objects. The challenge in making an electronic skin which can emulate touch for applications such as a humanoid robot or minimally invasive and remote surgery is both in mimicking the (passive) mechanical properties of the dermis and the characteristics of the sensing mechanism, especially the intrinsic digital nature of neurons. Significant progress has been made towards developing an electronic skin by using a variety of materials and physical concepts, but the challenge of emulating the sense of touch remains. Recently, a nanodevice was developed that has achieved the resolution to decipher touch on a par with the human finger; this resolution is over an order of magnitude improvement on previous devices with a sensing area larger than 1 cm2. With its robust mechanical properties, this new system represents an important step towards the realization of artificial touch.
- 24 September 2008
- Published by Wiley in Angewandte Chemie
- Vol. 120 (41) , 7926-7945
Tastsysteme mit künstlichem Tastsinn wie beim menschlichen Finger
- 24 September 2008
- Published by Wiley in Angewandte Chemie
- Vol. 120 (41) , 7926-7945
Tastsysteme mit künstlichem Tastsinn wie beim menschlichen Finger
- 3 January 2008
- Published by Wiley in Advanced Materials
- Vol. 20 (2) , 284-287
Self‐Assembly of a Micrometers‐Long One‐Dimensional Network of Cemented Au Nanoparticles
- 3 January 2008
- Published by Wiley in Advanced Materials
- Vol. 20 (2) , 284-287
Self‐Assembly of a Micrometers‐Long One‐Dimensional Network of Cemented Au Nanoparticles
- 1 August 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 21605033,p. 35-36
Linear Tactile Nanodevice with Resolution on Par with Human Finger
A large area thin-film nanodevice made by self-assembly containing electroluminescent nanoparticles is reported. The ~100 nm thick device on application of potential across the top and bottom surface of the film converts local pressure to light. The intensity of the electroluminescent light is linearly proportional to the applied local compressive stress. By imaging the light, the stress distribution over the area of contact is obtained at resolution on par with human finger.
- 1 August 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 21605033,p. 35-36
Linear Tactile Nanodevice with Resolution on Par with Human Finger
A large area thin-film nanodevice made by self-assembly containing electroluminescent nanoparticles is reported. The ~100 nm thick device on application of potential across the top and bottom surface of the film converts local pressure to light. The intensity of the electroluminescent light is linearly proportional to the applied local compressive stress. By imaging the light, the stress distribution over the area of contact is obtained at resolution on par with human finger.
- Open Access
- 14 October 2005
- Published by Wiley in Angewandte Chemie International Edition
- Vol. 44 (41) , 6668-6673
Self‐Assembly of Nanoparticles on Live Bacterium: An Avenue to Fabricate Electronic Devices
- 14 October 2005
- Published by Wiley in Angewandte Chemie International Edition
- Vol. 44 (41) , 6668-6673
Open AccessSelf‐Assembly of Nanoparticles on Live Bacterium: An Avenue to Fabricate Electronic Devices