V. I. Melik-Gaikazyan
V. I. Melik-Gaikazyan has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
N. P. Emel’YAnova
Southwest State University
5 shared publications- T. I. Yushina
Moscow State Mining University
3 shared publications - D. V. Dolzhenkov
Southwest State University
2 shared publications A. A. Moiseev
South Western State University
1 shared publicationD. V. Dolzhenkov
Southwest State University
1 shared publicationN. P. Emel'Yanova
1 shared publication
Latest Publications
- 1 July 2017
- Published by Allerton Press in Russian Journal of Non-Ferrous Metals
- Vol. 58 (4) , 335-344
Influence of the capillary pressure in nanobubbles on their adherence to particles during froth flotation: Part 5. Spreading curves of nanobubbles on the surface with different wettability
To increase the accuracy of results, two methods for investigating wetting and spreading processes on a solid substrate are studied. In the first method, liquid drops are used; in the second method, bubbles are used. The shapes of drops and bubbles vary upon spreading, and this fact can be evaluated quantitatively only by means of the Laplace equation, but the equation is applied only in the case of bubbles (the second method). In the case of the first method, this circumstance excludes the purity control of the spreading drop surface. The influence of microcontaminations on the results is considered based on precision calculations performed for both methods. Spreading curves of nanobubbles with initial diameters of 20 and 10 nm on the substrates with various wettabilities are calculated, and wettability is evaluated not by the numerical value of the wetting angle but by the corresponding easily implemented examples of such substrate Γ, Φ, and Hx, where x is the surface fraction under a bubble coated by ionogenic collector molecules: 0.8, 0.6, 0.4, and 0.2. Spreading curves clearly illustrate the range of possible nanobubble spreading from the limiting one on the Γ substrate to the almost zero one on the Φ substrate, as well as the sources of energy provision of spreading and their depletion causes. The informativity of spreading curves is caused by the fact that more than ten bubble and substrate parameters are applied in their calculation. When using the reagents, the flotation activation can spread to larger bubbles.
- 1 July 2017
- Published by Allerton Press in Russian Journal of Non-Ferrous Metals
- Vol. 58 (4) , 335-344
Influence of the capillary pressure in nanobubbles on their adherence to particles during froth flotation: Part 5. Spreading curves of nanobubbles on the surface with different wettability
To increase the accuracy of results, two methods for investigating wetting and spreading processes on a solid substrate are studied. In the first method, liquid drops are used; in the second method, bubbles are used. The shapes of drops and bubbles vary upon spreading, and this fact can be evaluated quantitatively only by means of the Laplace equation, but the equation is applied only in the case of bubbles (the second method). In the case of the first method, this circumstance excludes the purity control of the spreading drop surface. The influence of microcontaminations on the results is considered based on precision calculations performed for both methods. Spreading curves of nanobubbles with initial diameters of 20 and 10 nm on the substrates with various wettabilities are calculated, and wettability is evaluated not by the numerical value of the wetting angle but by the corresponding easily implemented examples of such substrate Γ, Φ, and Hx, where x is the surface fraction under a bubble coated by ionogenic collector molecules: 0.8, 0.6, 0.4, and 0.2. Spreading curves clearly illustrate the range of possible nanobubble spreading from the limiting one on the Γ substrate to the almost zero one on the Φ substrate, as well as the sources of energy provision of spreading and their depletion causes. The informativity of spreading curves is caused by the fact that more than ten bubble and substrate parameters are applied in their calculation. When using the reagents, the flotation activation can spread to larger bubbles.
- Open Access
- 1 January 2016
- Published by National University of Science and Technology MISiS in Izvestiya Vuzov. Tsvetnaya Metallurgiya (Proceedings of Higher Schools. Nonferrous Metallurgy)
- No. 4,p. 4-12
Effect of capillary pressure in nanobubbles on their adherence to particles during froth flotation. Part Four. Spreading nanobubbles – natural fractals
Рассматривается специфическое свойство нанопузырьков – самопроизвольное растекание по прилипшей к ним твердой гидрофобной подложке-частице, которое обусловлено высоким капиллярным давлением газа в нанопузырьках (Pк > > 106 Н/м2 ). Рассмотрен принцип расчета кривых растекания пузырьков и введен параметр X, характеризующий его интенсивность. Зависимость X(а) (а – диаметр основания пузырька) представлена бимодальной кривой, подтверждающей, что процесс растекания нанопузырьков энергетически обеспечивается двумя последовательно действующими независимыми источниками. Первый обусловлен сокращением (примерно на 11 %) площади криволинейной поверхности нанопузырька на начальном этапе растекания, а второй – работой расширения газа, вызванного падением Pк при растекании пузырька. Величина параметра X характеризуется значительно бóльшим наклоном зависимости X(а) на первом этапе растекания по сравнению со вторым. Обнаруженное свойство, как оказалось теперь, определяющее эффективность промышленных флотационных процессов в прошлом, после его распознания вновь обретает перспективу применения. Поскольку оно проявляется в ограниченном диапазоне размеров пузырьков, его предложено отнести к естественному, или природному, фракталу по аналогии с броуновским движением, проявляющимся в определенном интервале размеров частиц. Показано влияние поверхностной активности флотореагентов на форму кривых растекания пузырьков. Часть первая опубликована в [1], часть вторая – в [2], часть третья – в [3].
- 1 January 2016
- Published by National University of Science and Technology MISiS in Izvestiya Vuzov. Tsvetnaya Metallurgiya (Proceedings of Higher Schools. Nonferrous Metallurgy)
- No. 4,p. 4-12
Open AccessEffect of capillary pressure in nanobubbles on their adherence to particles during froth flotation. Part Four. Spreading nanobubbles – natural fractals
Рассматривается специфическое свойство нанопузырьков – самопроизвольное растекание по прилипшей к ним твердой гидрофобной подложке-частице, которое обусловлено высоким капиллярным давлением газа в нанопузырьках (Pк > > 106 Н/м2 ). Рассмотрен принцип расчета кривых растекания пузырьков и введен параметр X, характеризующий его интенсивность. Зависимость X(а) (а – диаметр основания пузырька) представлена бимодальной кривой, подтверждающей, что процесс растекания нанопузырьков энергетически обеспечивается двумя последовательно действующими независимыми источниками. Первый обусловлен сокращением (примерно на 11 %) площади криволинейной поверхности нанопузырька на начальном этапе растекания, а второй – работой расширения газа, вызванного падением Pк при растекании пузырька. Величина параметра X характеризуется значительно бóльшим наклоном зависимости X(а) на первом этапе растекания по сравнению со вторым. Обнаруженное свойство, как оказалось теперь, определяющее эффективность промышленных флотационных процессов в прошлом, после его распознания вновь обретает перспективу применения. Поскольку оно проявляется в ограниченном диапазоне размеров пузырьков, его предложено отнести к естественному, или природному, фракталу по аналогии с броуновским движением, проявляющимся в определенном интервале размеров частиц. Показано влияние поверхностной активности флотореагентов на форму кривых растекания пузырьков. Часть первая опубликована в [1], часть вторая – в [2], часть третья – в [3].
- 1 July 2014
- Published by Allerton Press in Russian Journal of Non-Ferrous Metals
- Vol. 55 (4) , 309-317
Effect of capillary pressure in nanobubbles on their adhesion to particles under foam flotation. Part 3
The energy possibility of the transition of free bubbles A to adherent bubbles M, or the A → M (TAM) transition, is calculated on substrates with different wetting abilities: extremely hydrophilic (Φ), extremely hydrophobic (Γ), and with incomplete wetting ability (H x ), where x is the substrate surface fraction covered by a monolayer of collector molecules). Calculations of TAM for bubbles with a diameter (d e ) of 2 mm to 20 nm on Φ, Γ, and H x substrates showed that the change in specific energy (ΔG/V) in a bubble in the case of TAM depends on the value of d e , substrate wetting ability, and surface area of its contact with the bubble. According to the results of studies, high capillary pressure (P c) in nanobubbles M promotes their instantaneous spreading over the substrate. Herewith, P c decreases considerably. The adhesion and spreading processes occur as a single process, irreversibly, one-way, and fast, because they are not complicated by counterprocesses. Upon a decrease in equatorial diameter d e and wetting ability of the substrate, the decrease in G/V reaches several million J/m3. The actual simultaneity of the processes of bubble adhesion and spreading is illustrated by microphotographs of larger bubbles with a luminescent apolar reagent eliminating the effect of wetting hysteresis that is easily overcome in nanobubbles in the case of high P c values.
- 1 July 2014
- Published by Allerton Press in Russian Journal of Non-Ferrous Metals
- Vol. 55 (4) , 309-317
Effect of capillary pressure in nanobubbles on their adhesion to particles under foam flotation. Part 3
The energy possibility of the transition of free bubbles A to adherent bubbles M, or the A → M (TAM) transition, is calculated on substrates with different wetting abilities: extremely hydrophilic (Φ), extremely hydrophobic (Γ), and with incomplete wetting ability (H x ), where x is the substrate surface fraction covered by a monolayer of collector molecules). Calculations of TAM for bubbles with a diameter (d e ) of 2 mm to 20 nm on Φ, Γ, and H x substrates showed that the change in specific energy (ΔG/V) in a bubble in the case of TAM depends on the value of d e , substrate wetting ability, and surface area of its contact with the bubble. According to the results of studies, high capillary pressure (P c) in nanobubbles M promotes their instantaneous spreading over the substrate. Herewith, P c decreases considerably. The adhesion and spreading processes occur as a single process, irreversibly, one-way, and fast, because they are not complicated by counterprocesses. Upon a decrease in equatorial diameter d e and wetting ability of the substrate, the decrease in G/V reaches several million J/m3. The actual simultaneity of the processes of bubble adhesion and spreading is illustrated by microphotographs of larger bubbles with a luminescent apolar reagent eliminating the effect of wetting hysteresis that is easily overcome in nanobubbles in the case of high P c values.
- 1 July 2013
- Published by Allerton Press in Russian Journal of Non-Ferrous Metals
- Vol. 54 (4) , 281-286
Influence of capillary pressure in bubbles on their attachment to particles during froth flotation: Part two
The calculation of the energy possibility of the transfer of spherical bubble A into adhered bubble M or the A → M transition (AMT) shows how large the influence of the capillary pressure ( Pc) on...
- 1 July 2013
- Published by Allerton Press in Russian Journal of Non-Ferrous Metals
- Vol. 54 (4) , 281-286
Influence of capillary pressure in bubbles on their attachment to particles during froth flotation: Part two
The calculation of the energy possibility of the transfer of spherical bubble A into adhered bubble M or the A → M transition (AMT) shows how large the influence of the capillary pressure ( Pc) on...
- 1 March 2013
- Published by Allerton Press in Russian Journal of Non-Ferrous Metals
- Vol. 54 (2) , 119-127
Influence of the capillary pressure in bubbles on their adherence to particles during froth flotation
A new procedure of calculating the energy possibility of the transition of free bubble A with shape β = 0 into bubble M with shape β < 0 adhered to the substrate particle, namely, the A → M...
- 1 March 2013
- Published by Allerton Press in Russian Journal of Non-Ferrous Metals
- Vol. 54 (2) , 119-127
Influence of the capillary pressure in bubbles on their adherence to particles during froth flotation
A new procedure of calculating the energy possibility of the transition of free bubble A with shape β = 0 into bubble M with shape β < 0 adhered to the substrate particle, namely, the A → M...
- 1 December 2011
- Published by Allerton Press in Russian Journal of Non-Ferrous Metals
- Vol. 52 (6) , 463-468
Investigation into the froth flotation and selection of reagents on the basis of the mechanism of their action report 2. A comparison of flotation properties of millimeter, micrometer, and nanometer bubbles based on equations of capillary physics (Part Two)
The influence of the capillary pressure Pcaof gas in microbubbles on bubble spread over a substrate (particle) after adhesion is considered (for bubbles ranging in size from 2 mm to 20 nm). The...
- 1 December 2011
- Published by Allerton Press in Russian Journal of Non-Ferrous Metals
- Vol. 52 (6) , 463-468
Investigation into the froth flotation and selection of reagents on the basis of the mechanism of their action report 2. A comparison of flotation properties of millimeter, micrometer, and nanometer bubbles based on equations of capillary physics (Part Two)
The influence of the capillary pressure Pcaof gas in microbubbles on bubble spread over a substrate (particle) after adhesion is considered (for bubbles ranging in size from 2 mm to 20 nm). The...