Rolf Erni
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Rolf Erni has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Nigel D. Browning
University of Liverpool
4 shared publications - Amita Gupta
Royal Institute of Technology, Stockholm, 100 44, Sweden
1 shared publication Bert Freitag
FEI Electron Optics, PO Box 80066, 5600 KA Eindhoven, The Netherlands
1 shared publication- Chunfei Li
Portland State University, Portland, OR, 97201, United States
1 shared publication Dominique Hubert
FEI Electron Optics, PO Box 80066, 5600 KA Eindhoven, The Netherlands
1 shared publicationHeiko Müller
CEOS GmbH, Englerstr. 28, D-69126 Heidelberg, Germany
1 shared publication
Latest Publications
- 1 February 2008
- Published by Elsevier in Ultramicroscopy
- Vol. 108 (3) , 270-276
Prospects for analyzing the electronic properties in nanoscale systems by VEELS
- 1 February 2008
- Published by Elsevier in Ultramicroscopy
- Vol. 108 (3) , 270-276
Prospects for analyzing the electronic properties in nanoscale systems by VEELS
- 1 January 2008
- Published by Elsevier in Ultramicroscopy
- Vol. 108 (2) , 84-99
The impact of surface and retardation losses on valence electron energy-loss spectroscopy
- 1 January 2008
- Published by Elsevier in Ultramicroscopy
- Vol. 108 (2) , 84-99
The impact of surface and retardation losses on valence electron energy-loss spectroscopy
- 1 February 2007
- Published by Elsevier in Ultramicroscopy
- Vol. 107 (2-3) , 267-273
Quantification of the size-dependent energy gap of individual CdSe quantum dots by valence electron energy-loss spectroscopy
- 1 February 2007
- Published by Elsevier in Ultramicroscopy
- Vol. 107 (2-3) , 267-273
Quantification of the size-dependent energy gap of individual CdSe quantum dots by valence electron energy-loss spectroscopy
- 1 January 2007
- Published by Springer Nature in MRS Proceedings
- Vol. 999
Structural Effects of Transition Metal Oxide Calcinations on Wurtzite Type Semiconductors That are Ferromagnetic at Room Temperature
Gallium nitride powders and zinc oxide powders were each calcined with a few weight percent of copper oxide and/or magnesium oxide either in air or N2. Powder X-ray diffractometry, transmission electron microscopy, energy dispersive X-ray spectroscopy, and electron energy loss spectroscopy were performed in order to observe calcination induced structural effects on these wurtzite type semiconductors. We note that our earlier magnetic results on Cu doped GaN are qualitatively consistent with recent first principle calculations [Wu et al., Appl. Phys. Lett. 89 (2006) 62505].
- 1 January 2007
- Published by Springer Nature in MRS Proceedings
- Vol. 999
Structural Effects of Transition Metal Oxide Calcinations on Wurtzite Type Semiconductors That are Ferromagnetic at Room Temperature
Gallium nitride powders and zinc oxide powders were each calcined with a few weight percent of copper oxide and/or magnesium oxide either in air or N2. Powder X-ray diffractometry, transmission electron microscopy, energy dispersive X-ray spectroscopy, and electron energy loss spectroscopy were performed in order to observe calcination induced structural effects on these wurtzite type semiconductors. We note that our earlier magnetic results on Cu doped GaN are qualitatively consistent with recent first principle calculations [Wu et al., Appl. Phys. Lett. 89 (2006) 62505].
- 1 July 2006
- Published by Oxford University Press (OUP) in Microscopy and Microanalysis
- Vol. 12 (6) , 492-497
Atomic Scale Analysis of Planar Defects in Polycrystalline Diamond
Planar defects in a polycrystalline diamond film were studied by high-resolution transmission electron microscopy (HRTEM) and high-resolution scanning transmission electron microscopy (STEM). In both modes, sub-Ångström resolution was achieved by making use of two aberration-corrected systems; a TEM and a STEM CS-corrected microscope, each operated at 300 kV. For the first time, diamond in 〈110〉 zone-axis orientation was imaged in STEM mode at a resolution that allows for resolving the atomic dumbbells of carbon at a projected interatomic distance of 89 pm. Twin boundaries that show approximately the Σ3 CSL structure reveal at sub-Ångström resolution imperfections; that is, local distortions, which break the symmetry of the ideal Σ3 type twin boundary, are likely present. In addition to these imperfect twin boundaries, voids on the atomic level were observed. It is proposed that both local distortions and small voids enhance the mechanical toughness of the film by locally increasing the critical stress intensity factor.
- 1 July 2006
- Published by Oxford University Press (OUP) in Microscopy and Microanalysis
- Vol. 12 (6) , 492-497
Atomic Scale Analysis of Planar Defects in Polycrystalline Diamond
Planar defects in a polycrystalline diamond film were studied by high-resolution transmission electron microscopy (HRTEM) and high-resolution scanning transmission electron microscopy (STEM). In both modes, sub-Ångström resolution was achieved by making use of two aberration-corrected systems; a TEM and a STEM CS-corrected microscope, each operated at 300 kV. For the first time, diamond in 〈110〉 zone-axis orientation was imaged in STEM mode at a resolution that allows for resolving the atomic dumbbells of carbon at a projected interatomic distance of 89 pm. Twin boundaries that show approximately the Σ3 CSL structure reveal at sub-Ångström resolution imperfections; that is, local distortions, which break the symmetry of the ideal Σ3 type twin boundary, are likely present. In addition to these imperfect twin boundaries, voids on the atomic level were observed. It is proposed that both local distortions and small voids enhance the mechanical toughness of the film by locally increasing the critical stress intensity factor.