SASaud I. Al-Resayes

Saud I. Al-Resayes

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Saud I. Al-Resayes has a total of 31 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Correction: Azam et al. Removal of Chromium(III) and Cadmium(II) Heavy Metal Ions from Aqueous Solutions Using Treated Date Seeds: An Eco-Friendly Method. Molecules 2021, 26, 3718

    by Mohammad Azam, Saikh Mohammad Wabaidur, Mohammad Rizwan Khan, Saud I. Al-Resayes, Mohammad Shahidul Islam

    There was an error in the original publication

  • Open Access

    Correction: Azam et al. Heavy Metal Ions Removal from Aqueous Solutions by Treated Ajwa Date Pits: Kinetic, Isotherm, and Thermodynamic Approach. Polymers 2022, 14, 914

    by Mohammad Azam, Saikh Mohammad Wabaidur, Mohammad Rizwan Khan, Saud I. Al-Resayes, Mohammad Shahidul Islam

    In the original publication, there was a mistake in Figure 2B as the wrong image was uploaded

  • Open Access

    Isolation, Identification, Spectral Studies and X-ray Crystal Structures of Two Compounds from Bixa orellana, DFT Calculations and DNA Binding Studies

    by Mehtab Parveen, Mohammad Azeem, Afroz Aslam, Mohammad Azam, Sharmin Siddiqui, Mohammad Tabish, Ali Mohammad Malla, Kim Min, Vitor Hugo Rodrigues, Saud I. Al-Resayes, et al.

    4,6-Diacetylresorcinol (1) and 3-O-methylellagic acid dihydrate (2), both biologically significant compounds, were extracted from Bixa orellana and studied using IR, 1H, and 13C NMR, and UV-vis spectroscopic techniques. X-ray crystallographic techniques were also used to establish the molecular structure of the isolated compounds 1 and 2. Geometric parameters, vibrational frequencies, and gauge including atomic orbital (GIAO) 1H and 13C NMR of 1 and 2 in the ground state were computed by the density functional theory (DFT) using B3LYP/6-311G(d,p) basis set backing up experimental studies and established the correct structure of isolated compounds. The parameters obtained from the combined DFT, and X-ray diffraction studies are mutually agreed to establish correct structures of 1 and 2. In addition, an electrostatic potential map and HOMO−LUMO energy gap were made using the DFT calculation to determine the distribution of energy and the chemical reactivity region of the isolated compounds. The current study also provides further insights into the interaction of compound 2 with ct-DNA using numerous biophysical and in silico techniques. Moreover, in silico studies indicate that compound 2 binds to the DNA in the minor groove. Lipinski’s rule of five revealed a higher tendency of compound 2 towards drug-likeness. The bioavailability and synthetic accessibility score for compound 2 was found to be 0.55 and 3.21, suggesting that compound 2 could serve as an effective therapeutic candidate.


  • Open Access

    Heavy Metal Ions Removal from Aqueous Solutions by Treated Ajwa Date Pits: Kinetic, Isotherm, and Thermodynamic Approach

    by Mohammad Azam, Saikh Mohammad Wabaidur, Mohammad Rizwan Khan, Saud I. Al-Resayes, Mohammad Shahidul Islam

    In the current study we prepared cost-effective adsorbents based on ajwa date pits to remove Cu(II) ions from aqueous medium. Adsorbents were studied using scanning electron microscopy (SEM), FT-IR, and Brunauer-Emmett-Teller (BET) methods to characterize the surface functionalities, morphology, pore size, and particle size. The concentration of Cu(II) ions in the studied samples was determined by atomic adsorption spectrometry technique (AAS). Adsorption method was performed sequentially in a batch system followed by optimization by studying the numerous conditions, for instance the initial amounts of Cu(II) ions, dosages of the adsorbent, contact time, and pH of the solution. The ideal pH observed for maximum adsorption capacity was ~6.5. Langmuir and Freundlich isotherm models correctly predicted the investigation results, with the maximum monolayer adsorption capacities for Cu(II) ions at 328 K being 1428.57 mg/g (treated ajwa date pits, TADP) and 1111.1 mg/g for as produced ajwa date pits (ADP). It was revealed that TADP possess greater adsorption capability than ADP. Recovery investigations revealed that the saturated adsorbents eluted the maximum metal with 0.1 M HCl. Cu(II) ions adsorption was observed to be reduced by 80–89% after the second regeneration cycle. For the raw and chemically processed ajwa date pits adsorbent, the Langmuir model performed significantly better than the Freundlich model. The results demonstrated that the adsorbent made from ajwa date pits could be an economical and environmentally friendly alternative for removing Cu(II) ion pollutant from aqueous media.


  • Open Access

    Cationic Dye Degradation and Real Textile Wastewater Treatment by Heterogeneous Photo-Fenton, Using a Novel Natural Catalyst

    by Sirine Ben Ayed, Mohammad Azam, Saud I. Al-Resayes, Fadhila Ayari, Luigi Rizzo

    A photo-Fenton process using a local iron oxide as a natural catalyst was compared to Fenton and UV/H2O2 advanced oxidation processes for degrading crystal violet (CV) dye in aqueous solutions. The catalyst was characterized by transmission electron microscopy (TEM), energy dispersive X-ray microanalysis (EDX), Fourier transform infrared spectroscopy (FT-IR), Raman spectrum, X-ray diffraction (XRD), UV-vis spectroscopy, and Brunauer–Emmett–Teller (BET) analysis. The optical properties proved that the catalyst represents a good candidate for photocatalytic activity. The impact of different parameters (catalyst dose, initial CV concentration, initial H2O2 concentration, pH) on the photo-Fenton efficiency was evaluated. A photo-Fenton process operated under UVC light irradiation, at spontaneous pH, with 1.0 g/L of catalyst and 30 mg/L of H2O2 was the most effective process, resulting in 98% CV dye removal within 3 h. LC-MS and ion-chromatography techniques were used to identify demethylated organic intermediates during the process. Furthermore, a regeneration study of the catalyst showed its stability and reusability (after three treatment cycles, CV dye degradation decreased from 94% to 83%). Finally, the photo-Fenton process was tested in the treatment of real textile wastewater, and the effluent was found to be in compliance with standards for industrial wastewater disposal into sewerage.


  • Open Access

    Removal of Chromium(III) and Cadmium(II) Heavy Metal Ions from Aqueous Solutions Using Treated Date Seeds: An Eco-Friendly Method

    by Mohammad Azam, Saikh Mohammad Wabaidur, Mohammad Rizwan Khan, Saud I. Al-Resayes, Mohammad Shahidul Islam

    The aim of the research was to prepare low-cost adsorbents, including raw date pits and chemically treated date pits, and to apply these materials to investigate the adsorption behavior of Cr(III) and Cd(II) ions from wastewater. The prepared materials were characterized using SEM, FT-IR and BET surface analysis techniques for investigating the surface morphology, particle size, pore size and surface functionalities of the materials. A series of adsorption processes was conducted in a batch system and optimized by investigating various parameters such as solution pH, contact time, initial metal concentrations and adsorbent dosage. The optimum pH for achieving maximum adsorption capacity was found to be approximately 7.8. The determination of metal ions was conducted using atomic adsorption spectrometry. The experimental results were fitted using isotherm Langmuir and Freundlich equations, and maximum monolayer adsorption capacities for Cr(III) and Cd(II) at 323 K were 1428.5 and 1302.0 mg/g (treated majdool date pits adsorbent) and 1228.5 and 1182.0 mg/g (treated sagai date pits adsorbent), respectively. It was found that the adsorption capacity of H2O2-treated date pits was higher than that of untreated DP. Recovery studies showed maximal metal elution with 0.1 M HCl for all the adsorbents. An 83.3–88.2% and 81.8–86.8% drop in Cr(III) and Cd(II) adsorption, respectively, were found after the five regeneration cycles. The results showed that the Langmuir model gave slightly better results than the Freundlich model for the untreated and treated date pits. Hence, the results demonstrated that the prepared materials could be a low-cost and eco-friendly choice for the remediation of Cr(III) and Cd(II) contaminants from an aqueous solution.


  • Open Access

    Synthesis, Spectral Characterization and Biological Activities of Co(II) and Ni(II) Mixed Ligand Complexes

    by P. Manimaran, S. Balasubramaniyan, Mohammad Azam, D. Rajadurai, Saud I. Al-Resayes, G. Mathubala, A. Manikandan, S. Muthupandi, Zishan Tabassum, Imran Khan

    2,4-Dinitrophynylhydrazine and two thiocyanate ions in a (M:L1:L2) 1:2:2 molar ratio was synthesized in the complexes of Co(II) and Ni(II). The prepared compounds were identified through a C.H.N.S. analysis, conductivity measurements, powder X-ray diffraction (PXRD), the infrared spectrum, and a UV-visible spectrum analysis, in addition to the magnetic properties being measured. The measurements of the molar conductance implieda nonelectrolytic nature of compounds Co(II) and Ni(II). The magnetic susceptibility, as well as electronic spectra, represented all the metal complexesthroughoctahedral geometry, respectively. The PXRD patterns suggested that all the complexes were an orthorhombic system with unit cell parameters. The in-vitro biological activity of the ligand and the metal complexes were screened against the Gram-positive and negative pathogenic bacteria Staphylococcus aureus, Bacillus subtilis, Pseudomonas, aeruginosa and Escherichia coli, as well as the fungal species of Aspergillusniger and Candida albicans.Thus, the metal complexes showeda high efficiency of antimicrobial activity compared with the ligand. Furthermore, applications of the ligand, as well as the metal complexes, were tested for in-vitro antioxidant potential in aDPPH assay. The results showed that the activity of the metal complexes with the in-vitro antioxidant was more active than that of 2,4-dinitrophenylhydrazine(DNPH).


  • Open Access

    Synthesis, Structural Characterization and Antimicrobial Activity of Cu(II) and Fe(III) Complexes Incorporating Azo-Azomethine Ligand

    by Mohammad Azam, Saud I. Al-Resayes, Saikh Mohammad Wabaidur, Mohammad Altaf, Bhaskar Chaurasia, Mahboob Alam, Satyendra Nath Shukla, Pratiksha Gaur, Nader Talmas M. Albaqami, Mohammad Shahidul Islam, et al.

    We are reporting a novel azo-azomethine ligand, HL and its complexes with Cu(II) and Fe(III) ions. The ligand and its complexes are characterized by various physico-chemical techniques using C,H,N analyses, FT-IR, 1H-NMR, ESI-MS and UV-Vis studies. TGA analyses reveal complexes are sufficiently stable and undergo two-step degradation processes. The redox behavior of the complexes was evaluated by cyclic voltammetry. Furthermore, the ligand and its complexes were tested for antimicrobial activity against bacterial and fungal strains by determining inhibition zone, minimal inhibitory concentration (MIC) and minimal bactericidal concentration (MBC). The complexes showed moderate antimicrobial activity when tested against Gram +ve and Gram −ve bacterial strains. To obtain insights into the structure of ligand, DFT studies are recorded. The results obtained are quite close to the experimental results. In addition, the energy gap, chemical hardness, softness, electronegativity, electrophilic index and chemical potential were calculated using HOMO, LUMO energy value of ligand.


  • Open Access

    Kinetics analysis for non-isothermal decomposition γ-irradiated indium acetate

    by Saud I. Al-Resayes

    Kinetics analysis for non-isothermal decomposition of un-irradiated and pre-γ-irradiated anhydrous indium acetate was studied in the temperature range (298–1273 K) in static air using dynamics thermogravimetric techniques. The data were analyzed using various solid state reaction models. Integral method using Coats–Redfern equation was applied in dynamic data analysis. The results showed that the kinetic of non-isothermal (dynamic) decomposition was controlled by phase boundary process. The activation energies for un-irradiated and pre-γ-irradiated anhydrous indium acetate were calculated and evaluated.


  • Open Access

    2-Methyl-2-(2-pyridyl)hexahydropyrimidine

    by Saud Al-Resayes

    In the aminal-type title compound, C(10)H(15)N(3), the six-membered hexa-hydro-pyrimidine ring adopts a chair conformation and the N atoms are pyramidally coordinated. One of the two amido -NH units engages in inter-molecular hydrogen bonding with the pyridyl N atom, generating a helical chain running along the b axis of the ortho-rhom-bic unit cell.