Torsten Oekermann
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Torsten Oekermann has a total of 33 co-authors. Here are the top co-authors by number of shared publications:
Katrin Wessels
5 shared publications- Michael Wark
Institute of Physical Chemistry and Electrochemistry, University of Hannover, Callinstrasse 3A, Industriestraße 22, 63654 Büdingen, Germany, Germany
4 shared publications Hideki Minoura
Institute of Physical Chemistry and Electrochemistry, University of Hannover, Callinstrasse 3-3A, 30167 Hannover, Germany, and Graduate School of Engineering, Gifu University, Yanagido 1-1, Gifu 501-1193, Japan
3 shared publicationsTsukasa Yoshida
3 shared publications- Armin Feldhoff
Institute of Physical Chemistry and Electrochemistry Leibniz University Hannover Callinstraße 3A D‐30167 Hannover Germany
2 shared publications C. Boeckler
Institute of Physical Chemistry and Electrochemistry, Leibniz University Hannover, Callinstrasse 3-3a, 30167 Hannover, Germany
2 shared publications
Latest Publications
- 1 October 2012
- Published by Elsevier in Electrochimica Acta
- Vol. 80, 60-67
Investigation of the pulsed electrochemical deposition of ZnO
- 1 October 2012
- Published by Elsevier in Electrochimica Acta
- Vol. 80, 60-67
Investigation of the pulsed electrochemical deposition of ZnO
- 6 January 2012
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 14 (8) , 2774-2783
Comparison of the photoelectrochemical oxidation of methanol on rutile TiO2 (001) and (100) single crystal faces studied by intensity modulated photocurrent spectroscopy
The photooxidation of methanol as a model substance for pollutants on rutile TiO2 (001) and (100) surfaces was investigated using intensity modulated photocurrent spectroscopy (IMPS). The results are analyzed in view of the influence of the surface structure, the methanol concentration and the electrode potential on the rate constants of charge transfer and recombination. The obtained results have been explained with a model combining the theory of IMPS for a bulk semiconductor surface and the nature of the surface-bound intermediates (alternatively mobile or immobile OH˙ radicals). The results indicate that water photooxidation proceeds via mobile OH˙ radicals on both surfaces, while methanol addition gives rise to the involvement of immobile OH˙ radicals on the (100) surface. Detailed analysis in view of the surface structures suggests that the latter observation is due to efficient electron transfer from bridging OH˙ radicals on the (100) surface to methanol, while coupling of two of these radicals occurs in the absence of methanol, making them appear as mobile OH˙ radicals. In the case of the (001) surface, the coupling reaction dominates even in the presence of methanol due to the smaller distance between the bridging OH˙ radicals, leading to more efficient water oxidation, but less efficient methanol photooxidation on this surface.
- 6 January 2012
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 14 (8) , 2774-2783
Comparison of the photoelectrochemical oxidation of methanol on rutile TiO2 (001) and (100) single crystal faces studied by intensity modulated photocurrent spectroscopy
The photooxidation of methanol as a model substance for pollutants on rutile TiO2 (001) and (100) surfaces was investigated using intensity modulated photocurrent spectroscopy (IMPS). The results are analyzed in view of the influence of the surface structure, the methanol concentration and the electrode potential on the rate constants of charge transfer and recombination. The obtained results have been explained with a model combining the theory of IMPS for a bulk semiconductor surface and the nature of the surface-bound intermediates (alternatively mobile or immobile OH˙ radicals). The results indicate that water photooxidation proceeds via mobile OH˙ radicals on both surfaces, while methanol addition gives rise to the involvement of immobile OH˙ radicals on the (100) surface. Detailed analysis in view of the surface structures suggests that the latter observation is due to efficient electron transfer from bridging OH˙ radicals on the (100) surface to methanol, while coupling of two of these radicals occurs in the absence of methanol, making them appear as mobile OH˙ radicals. In the case of the (001) surface, the coupling reaction dominates even in the presence of methanol due to the smaller distance between the bridging OH˙ radicals, leading to more efficient water oxidation, but less efficient methanol photooxidation on this surface.
- 14 December 2011
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 116 (9) , 5610-5613
Influence of Coumarin 343 Monomer Codeposition on the Structure and Electronic Properties of Electrodeposited ZnO
- 14 December 2011
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 116 (9) , 5610-5613
Influence of Coumarin 343 Monomer Codeposition on the Structure and Electronic Properties of Electrodeposited ZnO
- 18 January 2011
- Published by Springer Nature in Journal of Applied Electrochemistry
- Vol. 41 (4) , 445-452
Solid-state dye-sensitized ZnO solar cells prepared by low-temperature methods
- 18 January 2011
- Published by Springer Nature in Journal of Applied Electrochemistry
- Vol. 41 (4) , 445-452
Solid-state dye-sensitized ZnO solar cells prepared by low-temperature methods
- 1 January 2011
- Published by Sycamore Global Publications in Journal of Advanced Oxidation Technologies
- Vol. 14 (1)
Low Temperature Preparation of Porous Crystalline TiO2 Films Using a Combination of Electrochemical and Electrophoretical Deposition
Crystalline TiO2 films were prepared at 80 °C using a combination of electrochemical and electrophoretical deposition. After optimization of the pre-treatment, the stirring rate and the nanoparticle content of the deposition suspension the solar conversion efficiency of the films could be increased by a factor of five compared to films electrodeposited under otherwise identical conditions without addition of nanoparticles.
- 1 January 2011
- Published by Sycamore Global Publications in Journal of Advanced Oxidation Technologies
- Vol. 14 (1)
Low Temperature Preparation of Porous Crystalline TiO2 Films Using a Combination of Electrochemical and Electrophoretical Deposition
Crystalline TiO2 films were prepared at 80 °C using a combination of electrochemical and electrophoretical deposition. After optimization of the pre-treatment, the stirring rate and the nanoparticle content of the deposition suspension the solar conversion efficiency of the films could be increased by a factor of five compared to films electrodeposited under otherwise identical conditions without addition of nanoparticles.
- 1 September 2010
- Published by Elsevier in Electrochimica Acta
- Vol. 55 (22) , 6352-6357
Efficiency improvement of dye-sensitized solar cells based on electrodeposited TiO2 films by low temperature post-treatment
- 1 September 2010
- Published by Elsevier in Electrochimica Acta
- Vol. 55 (22) , 6352-6357
Efficiency improvement of dye-sensitized solar cells based on electrodeposited TiO2 films by low temperature post-treatment
- 1 October 2008
- Published by Wiley in Physica Status Solidi (a)
- Vol. 205 (10) , 2388-2391
Influence of the supporting salt concentration on the electrodeposition of ZnO/eosin Y hybrid films
ZnO/eosin Y hybrid films were electrodeposited from O2‐saturated ZnCl2‐solution under variation of the concentration of the supporting salt KCl. The supporting salt concentration was found to have a significant influence on the amount of dye loading and the morphology of the ZnO/eosin Y films. By decreasing the supporting salt concentration to 0.01 M KCl, porous films with a high dye loading can be obtained at potentials of –0.8 V vs. SCE at low eosin Y concentrations in the electrodeposition bath, which usually only lead to porous films at potentials where eosin Y is reduced (< –0.9 V vs. SCE).
- 1 October 2008
- Published by Wiley in Physica Status Solidi (a)
- Vol. 205 (10) , 2388-2391
Influence of the supporting salt concentration on the electrodeposition of ZnO/eosin Y hybrid films
ZnO/eosin Y hybrid films were electrodeposited from O2‐saturated ZnCl2‐solution under variation of the concentration of the supporting salt KCl. The supporting salt concentration was found to have a significant influence on the amount of dye loading and the morphology of the ZnO/eosin Y films. By decreasing the supporting salt concentration to 0.01 M KCl, porous films with a high dye loading can be obtained at potentials of –0.8 V vs. SCE at low eosin Y concentrations in the electrodeposition bath, which usually only lead to porous films at potentials where eosin Y is reduced (< –0.9 V vs. SCE).
- 1 August 2008
- Published by Elsevier in Thin Solid Films
- Vol. 516 (20) , 7120-7124
Variation of the morphology of electrodeposited copper thiocyanate films
- 1 August 2008
- Published by Elsevier in Thin Solid Films
- Vol. 516 (20) , 7120-7124
Variation of the morphology of electrodeposited copper thiocyanate films
- 15 April 2008
- Published by Elsevier in Microporous and Mesoporous Materials
- Vol. 111 (1-3) , 55-61
Highly porous TiO2 films from anodically deposited titanate hybrids and their photoelectrochemical and photocatalytic activity
- 15 April 2008
- Published by Elsevier in Microporous and Mesoporous Materials
- Vol. 111 (1-3) , 55-61
Highly porous TiO2 films from anodically deposited titanate hybrids and their photoelectrochemical and photocatalytic activity
- 23 November 2007
- Published by Wiley in Advanced Functional Materials
- Vol. 17 (18) , 3864-3869
Electrodeposited Zinc Oxide/Phthalocyanine Films – An Inorganic/Organic Hybrid System with Highly Variable Composition
Hybrid films of zinc oxide (ZnO) and tetrasulfonated nickel phthalocyanine (TSPcNi) have been electrodeposited by cathodic electrodeposition from aqueous O2‐saturated solutions of ZnCl2 and TSPcNi. The TSPcNi content of the films can be varied in a wide range by variation of dye concentration in the electrodeposition bath – from single TSPcNi molecules embedded in compact crystalline ZnO to films based on an amorphous TSPcNi framework. With increasing dye content the colour of the films changes from green, indicating the presence of the TSPcNi monomers, to blue, caused by TSPcNi aggregates. At the same time, changes in the electrical and photoelectrical properties of the films are observed, enabling the tuning of these properties in view of optoelectronic applications.
- 23 November 2007
- Published by Wiley in Advanced Functional Materials
- Vol. 17 (18) , 3864-3869
Electrodeposited Zinc Oxide/Phthalocyanine Films – An Inorganic/Organic Hybrid System with Highly Variable Composition
Hybrid films of zinc oxide (ZnO) and tetrasulfonated nickel phthalocyanine (TSPcNi) have been electrodeposited by cathodic electrodeposition from aqueous O2‐saturated solutions of ZnCl2 and TSPcNi. The TSPcNi content of the films can be varied in a wide range by variation of dye concentration in the electrodeposition bath – from single TSPcNi molecules embedded in compact crystalline ZnO to films based on an amorphous TSPcNi framework. With increasing dye content the colour of the films changes from green, indicating the presence of the TSPcNi monomers, to blue, caused by TSPcNi aggregates. At the same time, changes in the electrical and photoelectrical properties of the films are observed, enabling the tuning of these properties in view of optoelectronic applications.