DGD. J. Goldie

D. J. Goldie

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


D. J. Goldie has a total of 14 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Optical characterisation of a camera module developed for ultra-low NEP TES detector arrays at FIR wavelengths

    by D. Morozov, R. Sudiwala, P. A. R. Ade, D. J. Goldie, D. M. Glowacka, S. Withington, N. A. Trappe

  • Open Access

    Non-Equilibrium Superconductivity in Kinetic Inductance Detectors for THz Photon Sensing

    by D. J. Goldie, S. Withington

    Low temperature Kinetic Inductance Detectors (KIDs) are attractive candidates for producing quantumsensitive, arrayable sensors for astrophysical and other precision measurement applications. The readout uses a low frequency probe signal with quanta of energy well-below the threshold for pair-breaking in the superconductor. We have calculated the detailed non-equilibrium quasiparticle and phonon energy spectra generated by the probe signal of the KID when operating well-below its superconducting transition temperature Tc within the framework of the coupled kinetic equations described by Chang and Scalapino.[1] At the lowest bath temperature studied Tb/Tc = 0.1 the quasiparticle distributions can be driven far from equilibrium. In addition to the low frequency probe signal we have incorporated a high frequency (~ 1 THz) source signal well-above the pair-breaking threshold of the superconductor. Calculations of source signal detection efficiency are discussed

  • Open Access

    Towards Ultra-Low-NoiseMoAu Transition Edge Sensors

    by D. J. Goldie, A. V. Velichko, D. M. Glowacka, S. Withington

    We report initial measurements on our firstMoAu Transition Edge Sensors (TESs). The TESs formed from a bilayer of 40 nm of Mo and 106 nm of Au showed transition temperatures of about 320 mK, higher than identical TESs with a MoCu bilayer which is consistent with a reduced electron transmission coefficient between the bilayer films. We report measurements of thermal conductance in the 200 nm thick silicon nitride SiNx support structures at this temperature, TES dynamic behaviour and current noise measurements.

  • Open Access

    Quasiparticle generation efficiency in superconducting thin-films

    by T. Guruswamy, D. J. Goldie, S. Withington

    Thin-film superconductors with thickness 30 to 500 nm are used as non-equilibrium quantum detectors for photons, phonons or more exotic particles. One of the most basic questions in determining their limiting sensitivity is the efficiency with which the quanta of interest couple to the detected quasiparticles. As low temperature superconducting resonators, thin-films are attractive candidates for producing quantum-sensitive arrayable sensors and the readout uses an additional microwave probe. We have calculated the quasiparticle generation efficiency eta_s for low energy photons in a representative, clean thin-film superconductor (Al) operating well-below its superconductingtransition temperature as a function of film thickness, within the framework of the coupled kineticequations described by Chang and Scalapino.[J. J. Chang and D. J. Scalapino, J. Low Temp. Phys. 31, 1 (1978)]. We have also included the effect of a lower frequency probe. We show that phonon loss from the thin-film reduces eta_s by as much as 40% compared to earlier models that considered relatively thick films or infinite volumes. We also show that the presence of the probe and signal enhances the generation efficiency slightly. We conclude that the ultimate limiting noise equivalent power of this class of detector is determined by the thin-film geometry.

  • Dynamical behaviour of superconducting microresonators with readout-power heating

    by S E Thompson, S Withington, D J Goldie, C N Thomas

    We consider the effects of quasiparticle heating on the dynamical behaviour of superconducting microresonators operating with high readout powers. It is seen that resonance-curve distortion and hysteretic switching are an inevitable consequence of the forms of the quasiparticle heating and cooling functions. The model uses a diagrammatic representation of dynamical behaviour to gain an insight into how the instantaneous operating point moves in response to step changes in readout power, signal power, bath temperature, and frequency. The coupling quality factor has a marked effect on non-linear behaviour. The model is used to calculate the waveforms generated when a device switches between hysteretic states. The work suggests that measured response times need not be representative of intrinsic quasiparticle relaxation rates.


  • Open Access

    Non-equilibrium superconductivity in superconducting resonators

    by D. J. Goldie, S. Withington

    We have calculated the non-equilibrium quasiparticle and phonon distributions $f(E)$, $n(\Omega)$, where $E$ and $\Omega$ are the quasiparticle and phonon energies respectively, generated by the photons of the probe signal of a low temperature superconducting resonator SR operating well-below its transition temperature $T_c$ as the absorbed probe power per unit volume $P_{abs}$ was changed. The calculations give insight into a rate equation estimate which suggests that the quasiparticle distributions can be driven far from the thermal equilibrium value for typical readout powers. From $f(E)$ the driven quasiparticle number density $N_{qp}$ and lifetime $\tau_r$ were calculated. Using $N_{qp}$ we defined an effective temperature $T_N^*$ to describe the driven $f(E)$. The lifetime was compared to the distribution averaged thermal lifetime at $T_N^*$ and good agreement was found typically within a few percent. We used $f(E)$ to model a representative SR. The complex conductivity and hence the frequency dependence of the experimentally measured forward scattering parameter $S_{21}$ of the SR as a function of $P_{abs}$ were found. The non-equilibrium $S_{21}$ cannot be accurately modeled by a thermal distribution at an elevated temperature $T_{21}^*$ having a higher quality-factor in all cases studied and for low $P_{abs}$ $T_{21}^*\sim T_N^*$. Using $\tau_r$ and $N_{qp}$ we determined the achievable Noise Equivalent Power of the resonator used as a detector as a function of $P_{abs}$. Simpler expressions for $T_N^*$ as a function of $P_{abs}$ were derived which give a very good account of $T_N^*$ and also $N_{qp}$ and $\tau_r$. We conclude that multiple photon absorption from the probe increases the quasiparticle number above the thermal background and ultimately limits the achievable NEP of the resonator.

  • Towards Ultra-Low-Noise MoAu Transition Edge Sensors

    by D. J. Goldie, A. V. Velichko, D. M. Glowacka, S. Withington


  • Low-temperature thermal conductances of amorphous dielectric microbridges in the diffusive to ballistic transition

    by S. Withington, D. J. Goldie, A. V. Velichko

    Through a lossy acoustic-wave model we explore the effect of inelastic scattering on the low-temperature thermal conductances of amorphous dielectric microbridges in the diffusive to ballistic transition. The model gives not only the thermal flux as a function of geometry and temperature, but also the temperature distribution of the internal degrees of freedom that constitute the loss, which in turn can be used for calculating noise. The approach leads to powerful conceptual insights and provides a numerical framework for analyzing experimental data. SixNy tends to behave ballistically at low frequencies and diffusively at high frequencies, and when integrated over all frequency, the diffusive to ballistic transition becomes apparent at lengths of around a few hundred microns. It is possible to include flux-dependent acoustic loss, which leads to counterintuitive thermal behavior. A sample can behave diffusively when measured using a small temperature difference, but ballistically when measured using a large temperature difference. There is compelling circumstantial evidence that the effects of acoustic saturation have been seen, but not explicitly recognized, on many occasions. DOI: http://dx.doi.org/10.1103/PhysRevB.83.195418 ©2011 American Physical Society


  • Ultra-low-noise MoCu transition edge sensors for space applications

    by D. J. Goldie, A. V. Velichko, D. M. Glowacka, S. Withington

    A study of ultra-low-noise MoCu transition edge sensors (TESs) has been performed in the context of realizing the highly sensitive far infrared imaging arrays needed for the next generation of space telescopes. More than 50 TESs, on four different chips, cut out of two different wafers were characterized. The TESs were in the form of 16-element arrays and were read out using superconducting quantum interference device (SQUID) time division multiplexing. The devices were fabricated on 200-nm-thick silicon nitride membranes, with leg widths and lengths covering the ranges of 1–4 μm and 160–960 μm, respectively. The apparent critical temperatures varied over 110–127 mK, but it is shown that much of the variation was due to differential loading by stray light, amounting to 2 ± 2 fW across the array. The measured thermal conductances to the heat bath spanned the range 0.12–1.1 pW/K, with the lowest values being typical of those needed for ultra-low-noise operation. We also studied the inherent variation in the conductances of 15 nominally identical TESs on the same chip and found a value of ±10%, which is higher than that seen on our high-conductance devices designed for ground-based operation. We measured and modeled the electrical input impedance of a subset of these TESs, and studied their step responses. The models, based on previously determined material parameters, are in excellent agreement with the measurements. Dark noise spectra were recorded and compared with the same electrothermal models using the same parameters as the dynamical simulations. The measured noise is reasonably well described by the sum of the contributions from phonon noise in the legs, Johnson noise in the bilayer, and SQUID readout noise. Dark noise equivalent powers as low as 4.2 × 10−19 W/Hz were measured. The NEP was higher than the theoretical limit by a factor of about 1.6.