ABAmanda M. M. Bustin

Amanda M. M. Bustin

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Amanda M. M. Bustin has a total of 7 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Horseshoe Canyon and Belly River coal measures, south central Alberta: Part 2 -- Modeling reservoir properties and producible gas

    by A. M. M. Bustin, R. M. Bustin, J. Russel-Houston

    The gas reserves and well spacing units in the Horseshoe Canyon-Belly River Formation coal measures in Alberta are assigned based on gas-in-place determined by canister desorption tests of coal following ERCB (2010) guidelines. However, substantial gas, which is not measured by desorption tests, also occurs in the free state within the coals as well as adsorbed and in the free state within adjacent fine-grained strata (referred to here as shales) interbedded with the coals. A series of laboratory experiments (matrix flux, volumetric strain, rock mechanics) were conducted to quantify the reservoir properties of the coals and shales and were integrated with the results from field tests (well logs, pressure build-up) to be used as model inputs for a reservoir simulator. The purpose of the modeling was to address two main questions: 1) do variations in the amount of free gas within the matrix porosity of the coal seams affect production; and 2) to what extent is the gas stored within the strata interbedded with the coal seams co-produced? The free gas stored within a coal seam with an effective matrix porosity of 8% is shown to comprise on the order of 25% of the total original gas-in-place. The modeling results show that in high permeability coals (150 mD), an increase in production equivalent to the additional gas-in-place resulting from the free gas occurs after 25 years. Even very low permeability reservoirs (0.3 mD) are modeled to experience an approximately 2% increase in cumulative gas after 50 years of production. Including the gas bearing shales adjacent to the coal seams results in a substantial increase in producible gas. An increase of 144% in the cumulative gas produced after 50 years is observed when shales with a fracture permeability of 0.01 mD, matrix permeability of 1×10−4 mD, and an effective fracture spacing of 10 m are modeled with coal seams with a fracture permeability of 15 mD. The coal seams, being more permeable than the shales, act as horizontal drains for the over and underlying shale layers. The enhanced production is strongly dependent on the fracture and matrix permeability as well as the fracture spacing of the shales. The spacing of 4 wells/section, assumed in the above model, results in an estimated ultimate recovery (EUR) of 23% of the total original gas-in-place in the coals and 9% in the shales after 50 years of production. Downsizing to 8 wells/section increases the EUR to 35% for the coals and 15% for the shales and to 16 wells/section to 50% for the coals and 22% for the shales. The resulting increase in cumulative production with the decrease to 8 wells/section spacing is 57% and an additional 42% when further decreased to 16 wells/section.


  • Horseshoe Canyon and Belly River coal measures, south central Alberta: Part 1 -- Total original gas-in-place

    by R. M. Bustin, A. M. M. Bustin, J. Russel-Houston

    Continuously cored Horseshoe Canyon-Belly River (HSC-BR) coal measures in four wells in the middle of the coalbed methane producing fairway in south-central Alberta have been evaluated in order to quantify the total original gas-in-place. Gas contents were determined in all lithologies by a combination of canister desorption experiments and log and laboratory analyses that included adsorption isotherms, measurement of effective matrix porosity to gas, and calculation of fracture porosity and solution gas. The gas-in-place in coals, following the Alberta Energy Resources Conservation Board guidelines (ERCB), only quantifies the desorbed gas, which underestimates the gas-in-place in the coals by 18 to 28%. The balance of the gas occurs as free gas in pores and about 1% to 3% of the gas is calculated to be in solution at reservoir conditions. Inasmuch as the coals are dry (no mobile water), any effective porosity not occupied by adsorbed gas will be occupied by free gas in equilibrium, with the adsorbed and solution gas at the reservoir pressure and temperature. The average effective porosity of most coals ranges from about 4 to 8%, with the duller coals having higher porosity. Gas in fracture porosity, estimated based on measured system permeability and assuming a match stick fracture model, contributes less than 0.4% of the total porosity of the coal seams. With increasing reservoir pressures, there is a proportionally greater amount of gas stored in the free state than the adsorbed state. This is due to flattening of the adsorption isotherm with pressure and thus coal desorption tests result in a greater underestimation of total gas-in-place. Gas also occurs in non-coal lithologies throughout the coal measures. The gas content measured and calculated for each reservoir facies varies primarily because of varying organic content. Canister desorption tests show that adsorbed gas comprises between about 60% and 85% of the total gas-in-place in fine-grained lithologies and that the amount is correlated with organic content (r2 = 0.68). The highest average adsorbed gas contents from desorption experiments occur in the black mudstone (0.42 to 0.52 cc/g; 13.4 to 16.7 scf/ton), followed by the dark grey mudstone (0.23 to 0.32 cc/g; 7.3 to 10.3 scf/ton), siltstone (0.21 to 0.29 cc/g; 6.6 to 9.4 scf/ton) and medium grey mudstone reservoir facies (0.18 to 0.21 c/g; 5.9 to 6.8 scf/ton). The organic matter in most lithologies is particulate carbonaceous material derived from vascular plants (Type III kerogen). Effective porosity to gas in the fine-grained lithologies ranges from about 3.1% to 7.6% and contributes between about 14% to 34% of the total gas-in-place in the coal measures. Solution gas contributes between 1% and 6% to the gas-in-place. Gas storage in the sandstones determined by conventional core analyses indicates effective porosity values ranging from 0.7% to 6.3%, which represents up to 10% of the gas-in-place in the coal measures. Gas in the coal (desorbed plus free and solution gas) represents between approximately 10% and 19% (5.09×107 m3 to 8.34×107 m3/259 ha; 1.8 to 2.95 BCF/section) of the total gas in the coal measures. In the interval from the Upper Horseshoe Canyon coal zone through to and including the Lethbridge coal zone of the Dinosaur Park Formation, the total gas-in-place of the coal measures ranges from 4.32×108 m3 to 4.88×108 m3/259 ha 15.28 to 17.25 BCF/section). Gas contents determined solely by desorption analyses using ERCB guidelines for coal in the HSR-BR results in significant underestimation of the total gas resource, which in turn leads to errors in calculated recovery efficiencies and thus non-optimal well spacing and development strategies.


  • Top Cited Papers

    Measurements of gas permeability and diffusivity of tight reservoir rocks: different approaches and their applications

    by X. Cui, A. M. M. Bustin, R. M. Bustin

    Permeability and diffusivity are critical parameters of tight reservoir rocks that determine their viability for commercial development. Current methods for measuring permeability and/or diffusivity may lead to erroneous results when applied to very tight rocks including gas shales, coal, and tight gas sands, as well as rocks considered as seals for nuclear waste repositories and strata for geological sequestration of CO2. The use of He as routinely applied to measure porosity, permeability, and diffusivity may result in non‐systematic errors because of the molecular sieving effect of the fine pore structure to larger molecules such as reservoir gases. Utilizing gases with larger adsorption potentials than He, such as N2, and including all reservoir gases to measure porosity or permeability of rocks with high surface area is a viable alternative, but requires correcting for adsorption in the analyses. This study expands several approaches to measure permeability and diffusivity with considerations for gas adsorption, which has not been explicitly considered in previous studies. We present new models that explicitly correct for adsorption during pulse‐decay measurements of core under reservoir conditions, as well as on crushed samples used to approximate permeability or diffusivity. We also present a method to determine permeability or diffusivity from on‐site drill‐core desorption test data as carried out to determine gas in place in coals or gas shales. Our new approach utilizes late‐time data from experimental pressure‐decay tests, which we show to be more reliable and theoretically (and practically) accurate than the early‐time approach commonly used to estimate gas‐transport properties.


  • Coal reservoir saturation: Impact of temperature and pressure

    by Amanda M. M. Bustin

    Methane adsorption isotherms measured for a series of coals with varying rank at a wide range of temperatures and pressures allows the prediction of the change in sorption capacity as a function of tectonic history. Changes in sorption capacity in response to declining pressure and temperature associated with uplift may increase or decrease the capacity of the coal and, if the coal is initially saturated, result in excess gas or a deficiency of gas (undersaturation). Assuming reasonable geothermal and pressure gradients, our data indicate that the sorption capacity will generally decrease with uplift and associated exhumation, suggesting that an initially gas-saturated coal will desorb gas during uplift of the reservoir. The desorbed gas would be available for migration and/or, potentially, resaturation of an undersaturated coal. Our results argue against the generally accepted theory that undersaturation of coal reservoirs results from an increase in the sorption capacity with uplift except for coals at such high pressures that the isotherms are essentially flat or for very high pressure and geothermal gradients.