S. R. Bhattacharyya
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
S. R. Bhattacharyya has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Rachid Ayouchi
Department of Physics and ICEMS, Instituto Superior Técnico, Lisbon, Portugal
3 shared publications - Reinhard Schwarz
Department of Physics and ICEMS, Instituto Superior Técnico, Lisbon, Portugal
2 shared publications A. Polity
I. Physikalisches Institut, Heinrich-Buff-Ring 16, D-35392 Giessen, Germany
1 shared publication- Andrei Leonidovitch Kholkin
Department of Physics & CICECO-Aveiro Institute of Materials, University of Aveiro, 3810-193 Aveiro, Portugal
1 shared publication - Augusto M. C. Moutinho
Centre for Physics and Technological Research (CeFITec), Dept. de Física da Faculdade de Ciências e Tecnologia (FCT) Universidade Nova de Lisboa 2829‐516 Caparica Portugal
1 shared publication - B. K. Meyer
1st Physics Institute, Justus‐Liebig University of Giessen, Heinrich‐Buff‐Ring 16, 35392 Giessen, Germany
1 shared publication
Latest Publications
- 1 January 2013
- Published by Taylor & Francis in Ferroelectrics
- Vol. 446 (1) , 118-127
Optical Properties of Lead-Free NKN Films from Transmission and Spectral Ellipsometry
Thin films of lead-free NaxK1-xNbO3 (NKN) were prepared by pulsed laser deposition (PLD) from ceramic targets of stoichiometric NKN or doped with 6% of lithium niobate (LN). At a deposition temperature of 600°C a strong dependence of film morphology on laser fluence is revealed by SEM microscopy. Optical properties like band gap and index of refraction were obtained through transmission measurements and analysis based on the Tauc model. The results were compared to spectral ellipsometry using a fit to the Tauc-Lorentz model, and slightly smaller band gap values were obtained. C-V characteristics of sandwich structures yielded high permittivity of 380 in pure NKN films and tunability at 1 kHz of 3.2% at 1.5 MV/m applied electric field.
- 1 January 2013
- Published by Taylor & Francis in Ferroelectrics
- Vol. 446 (1) , 118-127
Optical Properties of Lead-Free NKN Films from Transmission and Spectral Ellipsometry
Thin films of lead-free NaxK1-xNbO3 (NKN) were prepared by pulsed laser deposition (PLD) from ceramic targets of stoichiometric NKN or doped with 6% of lithium niobate (LN). At a deposition temperature of 600°C a strong dependence of film morphology on laser fluence is revealed by SEM microscopy. Optical properties like band gap and index of refraction were obtained through transmission measurements and analysis based on the Tauc model. The results were compared to spectral ellipsometry using a fit to the Tauc-Lorentz model, and slightly smaller band gap values were obtained. C-V characteristics of sandwich structures yielded high permittivity of 380 in pure NKN films and tunability at 1 kHz of 3.2% at 1.5 MV/m applied electric field.
- 23 April 2012
- Published by Wiley in physica status solidi (c)
- Vol. 9 (6) , 1501-1503
Secondary electron emission yield (SEY) in amorphous and graphitic carbon films prepared by PLD
High secondary emission yield (SEY), and the subsequent build‐up of a secondary electron cloud, may severely limit the stability of high‐intensity particle beams inside particle accelerators. One of the best candidates of beam pipe coating for reduced SEY has been amorphous carbon (a‐C) produced by direct current (D.C.) magnetron sputtering. Here we used pulsed laser deposition (PLD), to prepare a‐C films from a pure carbon target at substrate temperatures ranging from 300 K to 773 K. The ablating laser was a Nd:YAG system operating at 1064 nm wavelength. With increasing temperature the optical band gap dropped from about 2.1 eV to 1.0 eV. This trend indicates transition from predominantly a‐C films to films with more graphitic content, which was also confirmed by Raman measurements. SEY spectra were taken upto 1732 eV of primary electron energy. The maximum SEY value decreased from 1.9 in a‐C films down to 1.4 in highly graphitic films deposited at higher temperatures
- 23 April 2012
- Published by Wiley in physica status solidi (c)
- Vol. 9 (6) , 1501-1503
Secondary electron emission yield (SEY) in amorphous and graphitic carbon films prepared by PLD
High secondary emission yield (SEY), and the subsequent build‐up of a secondary electron cloud, may severely limit the stability of high‐intensity particle beams inside particle accelerators. One of the best candidates of beam pipe coating for reduced SEY has been amorphous carbon (a‐C) produced by direct current (D.C.) magnetron sputtering. Here we used pulsed laser deposition (PLD), to prepare a‐C films from a pure carbon target at substrate temperatures ranging from 300 K to 773 K. The ablating laser was a Nd:YAG system operating at 1064 nm wavelength. With increasing temperature the optical band gap dropped from about 2.1 eV to 1.0 eV. This trend indicates transition from predominantly a‐C films to films with more graphitic content, which was also confirmed by Raman measurements. SEY spectra were taken upto 1732 eV of primary electron energy. The maximum SEY value decreased from 1.9 in a‐C films down to 1.4 in highly graphitic films deposited at higher temperatures
- Open Access
- 1 December 2011
- Published by Institute of Physics, Polish Academy of Sciences in Acta Physica Polonica A
- Vol. 120 (6)
Photoconductivity Study of Sputter-Deposited Cu2O Films
- 1 December 2011
- Published by Institute of Physics, Polish Academy of Sciences in Acta Physica Polonica A
- Vol. 120 (6)
Open AccessPhotoconductivity Study of Sputter-Deposited Cu2O Films