M. Karppinen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
M. Karppinen has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
H. Yamauchi
Materials and Structures Laboratory, Tokyo Institute of Technology, Yokohama, Japan
3 shared publications- Johan Linden
Åbo Akademi
3 shared publications - H Suematsu
Materials and Structures Laboratory, Tokyo Institute of Technology, 4259 Nagatsuta, Midoriku, Yokohama 226-8503, Japan
2 shared publications - Lauri Niinistö
Helsinki University of Technology
2 shared publications H Yamauchi
Materials and Structures Laboratory, Tokyo Institute of Technology, Yokohama 226-8503, Japan
1 shared publicationI. Tittonen
Department of Technical Physics, Helsinki University of Technology, SF-02150 Espoo, Finland
1 shared publication
Latest Publications
- 25 August 2000
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry
- Vol. 10 (10) , 2342-2345
Novel methods of synthesis and wet-chemical redox analysis for magnetoresistive double-perovskite Sr2FeMoO6 − w
An efficient encapsulation synthesis technique and an accurate wet-chemical analysis method for the redox state have been developed for the Sr2FeMoO6 − w double-perovskite compound known as a magnetoresistance (MR) material. Single-phase Sr2FeMoO6 − w samples are reproducibly obtained from Sr–Fe–Mo–O mixtures under very low oxygen partial pressures utilizing an Fe/FeO redox couple as the oxygen trap which is encapsulated together with the starting material mixture in an evacuated synthesis ampoule. Coulometric oxidation titration of the lower-valent iron and/or molybdenum species, formed upon dissolving the sample material in acidic solution, was found to reveal the oxygen content of a Sr2FeMoO6 − w sample with high reproducibility. Furthermore, the initial potential level in the titration is believed to indicate the nature of the reduced species. In the samples synthesized with the present encapsulation technique at 1150 °C the oxygen non-stoichiometry was found to be w ≈ 0.03 ± 0.02. No indication of lower-valent molybdenum was observed.
- 25 August 2000
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry
- Vol. 10 (10) , 2342-2345
Novel methods of synthesis and wet-chemical redox analysis for magnetoresistive double-perovskite Sr2FeMoO6 − w
An efficient encapsulation synthesis technique and an accurate wet-chemical analysis method for the redox state have been developed for the Sr2FeMoO6 − w double-perovskite compound known as a magnetoresistance (MR) material. Single-phase Sr2FeMoO6 − w samples are reproducibly obtained from Sr–Fe–Mo–O mixtures under very low oxygen partial pressures utilizing an Fe/FeO redox couple as the oxygen trap which is encapsulated together with the starting material mixture in an evacuated synthesis ampoule. Coulometric oxidation titration of the lower-valent iron and/or molybdenum species, formed upon dissolving the sample material in acidic solution, was found to reveal the oxygen content of a Sr2FeMoO6 − w sample with high reproducibility. Furthermore, the initial potential level in the titration is believed to indicate the nature of the reduced species. In the samples synthesized with the present encapsulation technique at 1150 °C the oxygen non-stoichiometry was found to be w ≈ 0.03 ± 0.02. No indication of lower-valent molybdenum was observed.
- 1 August 2000
- Published by Elsevier in Physica C: Superconductivity and its Applications
- Vol. 338 (1-2) , 18-24
Oxygen non-stoichiometry and hole distribution in multi-layered copper oxides: understanding of the magnetic-irreversibility characteristics
- 1 August 2000
- Published by Elsevier in Physica C: Superconductivity and its Applications
- Vol. 338 (1-2) , 18-24
Oxygen non-stoichiometry and hole distribution in multi-layered copper oxides: understanding of the magnetic-irreversibility characteristics
- 1 January 1999
- Published by American Physical Society (APS) in Physical Review B
- Vol. 59 (2) , 1377-1382
Layered (Cu,Fe) oxides of double perovskite structure. II. Extension of solid solubility of copper invia high-pressure heat treatmentIn this paper, we report successful extension of the solid-solubility limit of copper at the transition element site in the phase of the double-perovskite “0112” structure. Upon the high-pressure heat treatment at 5 GPa and 1200 °C of the ambient-pressure synthesized samples that contained impurity phases, essentially single-phase samples were obtained for x up to 0.2 in the system. TEM observations and TEM energy dispersive x-ray analyses for the high-pressure synthesized material showed that the ratio of copper to iron varies in the sample with an average value of as measured for nine grains. It could thus be concluded that a 0112 phase in which the amount of copper is larger than that of iron in the oxygen pyramid was realized. In order to obtain the copper-rich 0112 phase, simultaneous substitution of the divalent barium site by trivalent lanthanum was found necessary. From Mössbauer spectroscopy data, the relative intensities of five- and six-coordinated iron atoms were evaluated and the amount of excess oxygen in the structure could be estimated at Furthermore, both Mössbauer and magnetic-susceptibility measurements of the sample showed that the Néel temperature of the copper-rich material is lower than the corresponding transition temperature observed for the material with the stoichiometric composition. Finally, conditions for the successful extension of the copper solubility are discussed and related to the tolerance factor of the 0112 structure.- 1 January 1999
- Published by American Physical Society (APS) in Physical Review B
- Vol. 59 (2) , 1377-1382
Layered (Cu,Fe) oxides of double perovskite structure. II. Extension of solid solubility of copper invia high-pressure heat treatmentIn this paper, we report successful extension of the solid-solubility limit of copper at the transition element site in the phase of the double-perovskite “0112” structure. Upon the high-pressure heat treatment at 5 GPa and 1200 °C of the ambient-pressure synthesized samples that contained impurity phases, essentially single-phase samples were obtained for x up to 0.2 in the system. TEM observations and TEM energy dispersive x-ray analyses for the high-pressure synthesized material showed that the ratio of copper to iron varies in the sample with an average value of as measured for nine grains. It could thus be concluded that a 0112 phase in which the amount of copper is larger than that of iron in the oxygen pyramid was realized. In order to obtain the copper-rich 0112 phase, simultaneous substitution of the divalent barium site by trivalent lanthanum was found necessary. From Mössbauer spectroscopy data, the relative intensities of five- and six-coordinated iron atoms were evaluated and the amount of excess oxygen in the structure could be estimated at Furthermore, both Mössbauer and magnetic-susceptibility measurements of the sample showed that the Néel temperature of the copper-rich material is lower than the corresponding transition temperature observed for the material with the stoichiometric composition. Finally, conditions for the successful extension of the copper solubility are discussed and related to the tolerance factor of the 0112 structure.- 1 December 1997
- Published by American Physical Society (APS) in Physical Review B
- Vol. 56 (22) , 14790-14796
Establishment of strongly overdoped states in the superconductorStrongly overdoped (Hg-1223) samples with superconducting transitions as low as 97 K were successfully obtained by using HgO, CuO, and mixtures of highly oxidized and/or powders as starting materials for the high-pressure synthesis at 5 GPa and 950 °C. The overdoped state was confirmed by observing negative values for the Seebeck coefficient throughout the temperature range from to 320 K in a thermoelectric power measurement. Also, both of the cell parameters and were found to decrease with decreasing reflecting, respectively, an increase in hole concentration in the planes and the incorporation of oxygen into the layer. The oxygen excess δ as determined by the coulometric titration method, was in the overdoped sample with Subsequent reducing annealing in an Ar atmosphere at 280 °C increased the to 131 K. Consistently, only positive Seebeck coefficient values were observed up to 320 K for the Ar-annealed sample. A clearly underdoped material with was obtained by annealing the same sample in Ar at a higher temperature Finally, high-pressure synthesis starting from less-oxidized yielded a Hg-1223 material with and- 1 December 1997
- Published by American Physical Society (APS) in Physical Review B
- Vol. 56 (22) , 14790-14796
Establishment of strongly overdoped states in the superconductorStrongly overdoped (Hg-1223) samples with superconducting transitions as low as 97 K were successfully obtained by using HgO, CuO, and mixtures of highly oxidized and/or powders as starting materials for the high-pressure synthesis at 5 GPa and 950 °C. The overdoped state was confirmed by observing negative values for the Seebeck coefficient throughout the temperature range from to 320 K in a thermoelectric power measurement. Also, both of the cell parameters and were found to decrease with decreasing reflecting, respectively, an increase in hole concentration in the planes and the incorporation of oxygen into the layer. The oxygen excess δ as determined by the coulometric titration method, was in the overdoped sample with Subsequent reducing annealing in an Ar atmosphere at 280 °C increased the to 131 K. Consistently, only positive Seebeck coefficient values were observed up to 320 K for the Ar-annealed sample. A clearly underdoped material with was obtained by annealing the same sample in Ar at a higher temperature Finally, high-pressure synthesis starting from less-oxidized yielded a Hg-1223 material with and- 1 January 1995
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry
- Vol. 5 (6) , 875-878
Effect of LiF addition on the formation of the superconducting YBa2Cu4O8phase
Several possible flux materials have been investigated for preparing the superconducting YBa2Cu4O8 phase under 1 atm of oxygen. LiF was a promising flux and the YBa2Cu4O8 phase was successfully obtained at 815 °C with 0.5–1.0 wt.% LiF. Large amounts of LiF (>1.0 wt.%) accelerated the formation of side products, i.e. BaCuO2 and Y2BaCuO5, instead of the superconducting phase. LiF was also used as a flux in the syntheses of the superconducting Y0.9Ca0.1Ba2Cu4O8 and EuBa2Cu4O8 phases, and synthesis conditions for these compounds were optimized.
- 1 January 1995
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry
- Vol. 5 (6) , 875-878
Effect of LiF addition on the formation of the superconducting YBa2Cu4O8phase
Several possible flux materials have been investigated for preparing the superconducting YBa2Cu4O8 phase under 1 atm of oxygen. LiF was a promising flux and the YBa2Cu4O8 phase was successfully obtained at 815 °C with 0.5–1.0 wt.% LiF. Large amounts of LiF (>1.0 wt.%) accelerated the formation of side products, i.e. BaCuO2 and Y2BaCuO5, instead of the superconducting phase. LiF was also used as a flux in the syntheses of the superconducting Y0.9Ca0.1Ba2Cu4O8 and EuBa2Cu4O8 phases, and synthesis conditions for these compounds were optimized.
- 1 September 1990
- Published by American Physical Society (APS) in Physical Review B
- Vol. 42 (7) , 4212-4218
Characterization of superconductingBi2Sr2Can−1CunO4+2nphases withFe57Mössbauer spectroscopy
In order to study the dependence of superconductivity on sample preparation and the influence of cationic doping, samples were prepared using various sintering temperatures and nominal starting compositions. After each sintering the samples were characterized with x-ray-diffraction and magnetic-ac-susceptibility measurements. In all cases the corresponding samples were also made for Mössbauer measurements. The Mössbauer measurements usually show three quadrupole components arising from the different phases in the samples. The site assignment of is discussed.- 1 September 1990
- Published by American Physical Society (APS) in Physical Review B
- Vol. 42 (7) , 4212-4218
Characterization of superconductingBi2Sr2Can−1CunO4+2nphases withFe57Mössbauer spectroscopy
In order to study the dependence of superconductivity on sample preparation and the influence of cationic doping, samples were prepared using various sintering temperatures and nominal starting compositions. After each sintering the samples were characterized with x-ray-diffraction and magnetic-ac-susceptibility measurements. In all cases the corresponding samples were also made for Mössbauer measurements. The Mössbauer measurements usually show three quadrupole components arising from the different phases in the samples. The site assignment of is discussed.