Bruno Grandidier
Research Subjects
Bruno Grandidier has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
M. Lannoo
Department ISEN, IEMN, UMR 8520, CNRS, 59046 Lille Cédex, France
3 shared publicationsChristophe Delerue
Institut d'Electronique et de Microélectronique du Nord UMR 8520) Département ISEN, 41 bd Vauban 59046 Lille Cédex IEMN, (CNRS France
2 shared publications- Christophe Delerue
Univ. Lille
2 shared publications Christophe Krzeminski
Institut d'Electronique et de Microélectronique du Nord UMR 8520) Département ISEN, 41 bd Vauban 59046 Lille Cédex IEMN, (CNRS France
2 shared publications- Didier Stievenard
Institute of Electronics, Microelectronics and Nanotechnology (IEMN), CNRS, Université de Lille, Avenue Poincaré, F-59652 cedex, Villeneuve d'Ascq, France.
2 shared publications Didier Stiévenard
2 shared publications
Latest Publications
- Open Access
Adsorption behavior of conjugated {C}3-oligomers on Si(100) and HOPG surfaces
A pi-conjugated {C}3h-oligomer involving three dithienylethylene branches bridged at the meta positions of a central benzenic core has been synthesized and deposited either on the Si(100) surface or on the HOPG surface. On the silicon surface, scanning tunneling microscopy allows the observation of isolated molecules. Conversely, by substituting the thiophene rings of the oligomers with alkyl chains, a spontaneous ordered film is observed on the HOPG surface. As the interaction of the oligomers is different with both surfaces, the utility of the Si(100) surface to characterize individual oligomers prior to their use into a 2D layer is discussed.
Open AccessAdsorption behavior of conjugated {C}3-oligomers on Si(100) and HOPG surfaces
A pi-conjugated {C}3h-oligomer involving three dithienylethylene branches bridged at the meta positions of a central benzenic core has been synthesized and deposited either on the Si(100) surface or on the HOPG surface. On the silicon surface, scanning tunneling microscopy allows the observation of isolated molecules. Conversely, by substituting the thiophene rings of the oligomers with alkyl chains, a spontaneous ordered film is observed on the HOPG surface. As the interaction of the oligomers is different with both surfaces, the utility of the Si(100) surface to characterize individual oligomers prior to their use into a 2D layer is discussed.
- Open Access
Effect of alkyl substituents on the adsorption of thienylenevinylene oligomers on the Si (100) surface
The adsorption of thienylenevinylene oligomers on the Si(100) surface has been investigated using scanning tunneling microscopy. The mode of substitution of the thiophene ring exerts a strong influence on the adsorption configurations and the images of the oligomer based on 3,4-dihexyl thiophene are highly voltage dependent. We discuss the influence of the alkyl chains on the adsorption process and on the appearance of the molecules in the STM images.
Open AccessEffect of alkyl substituents on the adsorption of thienylenevinylene oligomers on the Si (100) surface
The adsorption of thienylenevinylene oligomers on the Si(100) surface has been investigated using scanning tunneling microscopy. The mode of substitution of the thiophene ring exerts a strong influence on the adsorption configurations and the images of the oligomer based on 3,4-dihexyl thiophene are highly voltage dependent. We discuss the influence of the alkyl chains on the adsorption process and on the appearance of the molecules in the STM images.
- 8 November 2001
- Published by AIP Publishing in Applied Physics Letters
- Vol. 79 (20) , 3278-3280
H–Si doping profile in GaAs by scanning tunneling microscopy
Hydrogen incorporation in n-type Si-doped GaAs layers results in the neutralization of the active dopants and a change of the conductivity along the growth direction. To characterize the active dopant concentration of doped GaAs layers containing hydrogen, we have used secondary ion mass spectroscopy and cross-sectional scanning tunneling microscopy. Spectroscopic measurements are performed as well as conductance images to visualize the variation of the conduction band-edge position. Such a variation, which is related to the concentration of Si–H complexes, allows the determination of the doping profile.
- 8 November 2001
- Published by AIP Publishing in Applied Physics Letters
- Vol. 79 (20) , 3278-3280
H–Si doping profile in GaAs by scanning tunneling microscopy
Hydrogen incorporation in n-type Si-doped GaAs layers results in the neutralization of the active dopants and a change of the conductivity along the growth direction. To characterize the active dopant concentration of doped GaAs layers containing hydrogen, we have used secondary ion mass spectroscopy and cross-sectional scanning tunneling microscopy. Spectroscopic measurements are performed as well as conductance images to visualize the variation of the conduction band-edge position. Such a variation, which is related to the concentration of Si–H complexes, allows the determination of the doping profile.
- 22 May 2000
- Published by AIP Publishing in Applied Physics Letters
- Vol. 76 (21) , 3142-3144
Defect-assisted tunneling current: A revised interpretation of scanning tunneling spectroscopy measurements
- 22 May 2000
- Published by AIP Publishing in Applied Physics Letters
- Vol. 76 (21) , 3142-3144
Defect-assisted tunneling current: A revised interpretation of scanning tunneling spectroscopy measurements
- 15 January 2000
- Published by American Physical Society (APS) in Physical Review B
- Vol. 61 (3) , 2138-2145
Theory of scanning tunneling microscopy of defects on semiconductor surfaces
We present a detailed theory of scanning tunneling microscopy (STM) of point defects located near the surface of semiconductors. We derive several conditions required to get a permanent current through the gap states of a defect and we deduce general rules concerning the current spectroscopy of defects with one or two ionization levels in the gap. We obtain that these ionization levels may be completely invisible in STM spectroscopy. In the particular case of low-temperature-grown GaAs containing a high density of arsenic-related defects, we show that the observation of gap states in STM spectroscopy is related to the conductivity of the material due to thermally activated hopping between defects. We propose the use of STM to measure the rates of capture and emission of carriers by surface defects and we describe two methods to perform it.
- 15 January 2000
- Published by American Physical Society (APS) in Physical Review B
- Vol. 61 (3) , 2138-2145
Theory of scanning tunneling microscopy of defects on semiconductor surfaces
We present a detailed theory of scanning tunneling microscopy (STM) of point defects located near the surface of semiconductors. We derive several conditions required to get a permanent current through the gap states of a defect and we deduce general rules concerning the current spectroscopy of defects with one or two ionization levels in the gap. We obtain that these ionization levels may be completely invisible in STM spectroscopy. In the particular case of low-temperature-grown GaAs containing a high density of arsenic-related defects, we show that the observation of gap states in STM spectroscopy is related to the conductivity of the material due to thermally activated hopping between defects. We propose the use of STM to measure the rates of capture and emission of carriers by surface defects and we describe two methods to perform it.
- 2 February 1998
- Published by AIP Publishing in Applied Physics Letters
- Vol. 72 (5) , 569-571
Influence of barrier height on scanning tunneling spectroscopy experimental and theoretical aspects
Scanning tunneling spectroscopy allows the determination of the density of states of the involved electrodes as well as the associated barrier height. We have measured the barrier height between tungsten tip and the GaAs (110) surface with a scanning tunneling microscope (STM) in ultrahigh vacuum. When the tunneling junction exhibited a low barrier height, we observed and explained an apparent widening of the GaAs gap which can mislead the real doping concentration of the sample. A theoretical model based on the self-consistent Keldysh–Green functions formalism is used to calculate the STM current. It shows a possible lowering of the barrier height according to the adsorption of As or Ga atoms on the apex of the tungsten tip.
- 2 February 1998
- Published by AIP Publishing in Applied Physics Letters
- Vol. 72 (5) , 569-571
Influence of barrier height on scanning tunneling spectroscopy experimental and theoretical aspects
Scanning tunneling spectroscopy allows the determination of the density of states of the involved electrodes as well as the associated barrier height. We have measured the barrier height between tungsten tip and the GaAs (110) surface with a scanning tunneling microscope (STM) in ultrahigh vacuum. When the tunneling junction exhibited a low barrier height, we observed and explained an apparent widening of the GaAs gap which can mislead the real doping concentration of the sample. A theoretical model based on the self-consistent Keldysh–Green functions formalism is used to calculate the STM current. It shows a possible lowering of the barrier height according to the adsorption of As or Ga atoms on the apex of the tungsten tip.