GSGyu Tae Seo

Gyu Tae Seo

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Gyu Tae Seo has a total of 38 co-authors. Here are the top co-authors by number of shared publications:

  • Rawiwan Boonchai

    Changwon National University

    3 shared publications
  • Cho-Hee Yoon

    Department of Urban Environmental Engineering Kyungnam University 631-701 Changwon Korea

    2 shared publications
  • Dae-Woon Jeong

    Department of Environment & Energy Engineering, Changwon National University, 20 Changwondaehak-ro, Changwon, Gyeongnam 51140, Republic of Korea

    2 shared publications
  • Hyun-Hee Jang

    Department of Environmental and Chemical Engineering, Eco-Friendly Offshore Plant FEED Engineering Course, Changwon National University, 20 Changwondaehak-ro, Uichang-gu, Changwon-si, Gyeongsangnam-do 51140, Korea

    2 shared publications
  • J.T. Kim

    Department of Environmental Engineering, Changwon National University, Sarim dong 9, Changwon, Gyeongnam 641-773, Korea;

    2 shared publications
  • Jutamas Kaewsuk

    Department of Environmental Engineering, Changwon National University, Gyeongnam, Changwon 641-773, Republic of Korea, Tel. +82 55 213 3746; Fax: +82 55 281 3011

    2 shared publications

Latest Publications

  • Open Access

    Struvite for Recovery of N&P and Ozone Oxidation of Residual Pharmaceuticals in Human Urine

    by Hyun-Hee Jang, Gyu-Tae Seo

    An experimental study was conducted for struvite formation to recover N&P and ozone (O3) oxidation to remove residual pharmaceuticals in human urine. Sea water reverse osmosis (SWRO) concentrate was used as a magnesium source in the struvite production using hydrolyzed urine. The condition of struvite formation was set at pH 10 and volumetric ratio of the SWRO concentrate to urine 0.1 to adjust Mg/P molar ratio of 1.4. The residual pharmaceuticals were analyzed by LC/MS with solid-phase extraction (SPE) as a pre-treatment of samples. O3 oxidation was carried out at pH 11, O3 injection range 1 to 5 mg/L and contact time 15 minutes. The hydrolyzed urine contained N&P 4,117 mg/L and 638 mg/L mostly in the form of NH3-N (3,784 mg/L) and PO4-P (601 mg/L), of which 2.3% and 92.7% were recovered, respectively in formation of the struvite (2.65 g/L-urine). Caffeine (3,329 µg/L), diclofenac (666 µg/L) and ibuprofen (408 µg/L) were three major pharmaceuticals detected in the urine sample. The pharmaceutical content of the struvite was 57.21 µg/g for caffeine, 12.87 µg/g for diclofenac and 8.94 µg/g for ibuprofen. 43.9% of caffeine in the urine was removed at 1 mg/L of O3 injection, 33.6% for diclofenac at 4 mg/L and 28.68% for ibuprofen at 3 mg/L. It was considered that the O3 oxidation of the urine could reduce the pharmaceutical content in the struvite and encourage use of the struvite derived from the human urine as an agricultural fertilizer.

  • Open Access

    Advanced Oxidation Processes and Nanofiltration to Reduce the Color and Chemical Oxygen Demand of Waste Soy Sauce

    by Hyun-Hee Jang, Gyu-Tae Seo, Dae-Woon Jeong

    Currently, the ozone (O3) oxidation efficiency in the treatment of waste soy sauce provides 34.2% color removal and a 27.4% reduction in its chemical oxygen demand (COD). To improve the O3 oxidation efficiency, hydrogen peroxide (H2O2) is used to cause a H2O2/O3 process. In H2O2/O3 process experiments, a previously optimized pH of 11 and applied O3 dose of 50 mg L−1 were used and the H2O2/O3 ratio was varied between 0.1 and 0.9 in intervals of 0.2. The results show that an H2O2/O3 ratio of 0.3 results in the highest efficiencies in terms of color removal (51.6%) and COD reduction (33.8%). Nanofiltration (NF) was used to pretreat the waste soy sauce to improve color removal and COD reduction. The results showed that NF with an NE-70 membrane results in 80.8% color removal and 79.6% COD reduction. Finally, the combination of NF and H2O2/O3 process resulted in the best treatment efficiency: 98.1% color removal and 98.2% COD reduction. Thus, NF & H2O2/O3 process can be considered as one of the best treatment methods for waste soy sauce, which requires high intrinsic color removal and COD reduction efficiencies.


  • Open Access

    Investigation of Oxidation Methods for Waste Soy Sauce Treatment

    by Hyun-Hee Jang, Gyu-Tae Seo, Dae-Woon Jeong

    To obtain a suitable oxidation method for removing the color and lowering the chemical oxygen demand (COD) of waste soy sauce, Fenton (Fe2+), Fenton-like (Fe3+), and ozone (O3) oxidation methods are used as the target reactions. In experimental conditions for Fenton oxidation, the dose of Fe2+ and Fe3+ was varied between 100 mg/L and 300 mg/L. The dose of hydrogen peroxide for the reaction was injected from 100–1000 mg/L. For ozone oxidation, the pH was increased from 3 to 14 and the O3-containing gas was supplied continuously for 30 min through a gas diffuser at the bottom of the reactor at different applied O3 doses (10–90 mg/L). We subjected it to a simple 1:20 dilution with deionized water to identify the comparison result in detail. O3 oxidation shows the highest efficiencies of color removal (81.1%) and COD lowering (64.9%) among the three oxidation methods. This is mainly due to the fact that it has a relatively large amount of hydroxyl radical, resulting in the degradation of organics. Thus, O3 oxidation could be a promising method for removing the color and lowering the COD of waste soy sauce. The critical parameters (pH and applied O3 dose) were varied systematically to optimize O3 oxidation. It was found that the optimum pH and applied O3 dose are 11.0 mg/L and 50.0 mg/L, respectively (color removal = 34.2%, COD removal = 27.4%).


  • Open Access

    pH Effect at Thermophilic Solubilization Pretreatment of Food Waste in Two Phase Anaerobic Digestion

    by Won-Soo Lee, Young-Jun Kang, Gyu-Tae Seo

    The study on pH control at the themophilic solubilization (pretreatment process) was investigated in order to improve the methane gas production of two phase anaerobic digestion of food waste. From a batch experiment, it was observed that the solubilization efficiency was increased from 26.2% to 47.1% and 55.6% by the pH increament from 4.20 ± 0.40 (without pH control) to 7.00 ± 0.50, and 12.00 ± 0.50, respectively. However there was immaterial increase (8.5%) in solubilization efficiency when the pH was increased from 7.00 ± 0.50 to 12.00 ± 0.50. The two phase anaerobic digestion system was operated for laboratory scale experiment under the solubilization condition of pH 4.20 ± 0.40 (Run1) and 7.00 ± 0.50 (Run2). Higher soluble chemical oxygen demand (SCOD) and total volatile fatty acid (TVFA) concentration were observed in Run2 throughout the system resulted by the solubilization effect at the pH 7.00 ± 0.50. The TVFA concentration in acidogenic reactor was 18.4 g/L which was 1.8 times higher than the result of Run1. Consequently the methane gas production was enhanced to 0.333 L/g VS in the methanogenic reactor, which is 18% higher than the result (0.282 L/g VS) of Run1.

  • Open Access

    Characteristic Evaluation of Graphene Oxide for Bisphenol A Adsorption in Aqueous Solution

    by Thatchaphong Phatthanakittiphong, Gyu Tae Seo

    This paper investigates the characteristics of graphene oxide (GO) for Bisphenol A (BPA) adsorption in water. Batch experiments on the influence of significant parameters were performed. While an improvement of the adsorption capacity of BPA was obtained by the increment of contact time and the initial BPA concentration, the increment of pH above 8, GO dosage, and temperature showed the reverse results. The thermodynamic study suggested that BPA adsorption on GO was an exothermic and spontaneous process. The kinetics was explained by the pseudo-second-order model which covers all steps of adsorption. The fit of the results with the Langmuir isotherm indicated the monolayer adsorption. At 298 K, the adsorption reached equilibrium within 30 min with the maximum adsorption capacity of 49.26 mg/g. The low BPA adsorption capacity of GO can be interpreted by the occurrence of oxygen-containing functional groups (OCFGs) that are able to form hydrogen bonds with the surrounding OCFGs and water molecules. This effect inhibited the role of π–π interactions that are mainly responsible for the adsorption of BPA.


  • Open Access

    Hydrogen Production in the Anaerobic Treatment of Domestic-Grade Synthetic Wastewater

    by Sachin Paudel, Youngjun Kang, Yeong-Seok Yoo, Gyu Tae Seo

    The aim of this study was to evaluate the potential of domestic wastewater for anaerobic hydrogen production. High-strength and ordinary-strength organic loadings of synthetic wastewater, i.e., real-time domestic wastewater with and without a mixture of food waste, were tested. During operation at a high strength loading, the initial pH was maintained at 7 and then gradually decreased, and a pH of 5–5.5 was observed as the best experimental condition. A pH of 5–5.5 was controlled during the operation at an ordinary-strength loading. Maximum hydrogen yields of 1.125 mol H2/mol glucose and 1.01 mol H2/mol glucose were observed during operation at high (48 g COD/L·day) and ordinary (3 g COD/L·day) strength loadings in terms of chemical oxygen demand (COD), respectively, with hydrogen contents of 42%–53%. The operating environment of the hydrogen production system was found to be very crucial because the metabolic pathway of the microorganism and production of intermediates were found to be dynamic with the controlled environment. Smaller COD removals of 30% and 26% were observed in high-strength and ordinarystrength loadings, respectively. Organic mass balance in terms of COD described the distribution of organics in the system via reactor byproducts. The findings of this study can be applied during the design of onsite domestic wastewater and energy recovery systems.


  • Open Access

    Effect of nutrient starvation on nutrient uptake and extracellular polymeric substance for microalgae cultivation and separation

    by Rawiwan Boonchai, Jutamas Kaewsuk, Gyutae Seo

    The purpose of the present study is to investigate the effects of nutrient starvation of microalgae on its nitrogen (N) and phosphorus (P) uptake, characteristics of extracellular polymeric substances (EPS), and algal sedimentation. An experiment was carried out by starving the wastewater-tolerant microalgae Chlorella sp. ADE4. The algal cultivation was put under various conditions of nutrient starvation in order to enhance nutrient removal and algal cell separation. The experimental results showed that 40 h of nutrient starvation prior to the cultivation did affect nutrient removal of Chlorella sp. ADE4. When using synthetic wastewater, the N-starved algae was the most effective in removing 82% of N in 48 h and 92% of P in 24 h. However, the starvation conditions did not cause noticeable removal improvement when microalgae were tested with real wastewater effluent. N and P removal efficiencies of 57 and 100%, respectively, were achieved in 48 h in real wastewater effluent. The lower N removal efficiency was caused by P limitation in the real sewage effluent. EPS were analyzed to evaluate if they play a role in algal cell agglomeration and subsequent microalgal separation. Carbohydrates and protein were indicated as major components in soluble and bound EPS. It was found that starvation of microalgae for 40 h could induce higher EPS production. Interestingly, the N-starved microalgae contained a large protein fraction in their EPS and low N content in their biomass. However, a significant correlation between EPS content and sedimentation efficiency was not observed in this study.