DBDorel Buta
Dorel Buta
*This is an algorithmically generated author record based on publicly available information.
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Dorel Buta has a total of 2 co-authors. Here are the top co-authors by number of shared publications:
Jeffrey J. Hoyt
Department of Materials Science and Engineering, McMaster University, Hamilton, Ontario, Canada L8S 4L7
2 shared publicationsMark Asta
Department of Chemical Engineering and Materials Science, University of California Davis, Davis, California 95616, USA
2 shared publications
Latest Publications
- 22 September 2008
- Published by American Physical Society (APS) in Physical Review E
- Vol. 78 (3) , 031605
Atomistic simulation study of the structure and dynamics of a faceted crystal-melt interface
A detailed analysis of the structure and dynamics of the crystal-melt interface region in silicon, modeled with the Stillinger-Weber potential, is performed via molecular dynamics simulations. The focus is on the faceted (111) crystal-melt interface, but properties of the rough (100) interface are also determined. We find an intrinsic 10-90 interface width of for the coarse-grained density profile at the (111) interface and a width at the (100) interface. Coarse-grained profiles of a suitably defined local order parameter are found to show a smaller width anisotropy between (111) and (100) interfaces while the order profiles exhibit a shift in position toward the crystal phase relative to the corresponding density profiles. The structural analysis of the layer of melt adjacent to the (111) facet of the crystal finds ordered clusters with average lifetimes of , as determined from autocorrelations of time-dependent layer structure factors, and cluster radii of gyration from for the smallest cells to as large as .- 22 September 2008
- Published by American Physical Society (APS) in Physical Review E
- Vol. 78 (3) , 031605
Atomistic simulation study of the structure and dynamics of a faceted crystal-melt interface
A detailed analysis of the structure and dynamics of the crystal-melt interface region in silicon, modeled with the Stillinger-Weber potential, is performed via molecular dynamics simulations. The focus is on the faceted (111) crystal-melt interface, but properties of the rough (100) interface are also determined. We find an intrinsic 10-90 interface width of for the coarse-grained density profile at the (111) interface and a width at the (100) interface. Coarse-grained profiles of a suitably defined local order parameter are found to show a smaller width anisotropy between (111) and (100) interfaces while the order profiles exhibit a shift in position toward the crystal phase relative to the corresponding density profiles. The structural analysis of the layer of melt adjacent to the (111) facet of the crystal finds ordered clusters with average lifetimes of , as determined from autocorrelations of time-dependent layer structure factors, and cluster radii of gyration from for the smallest cells to as large as .- 15 August 2007
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 127 (7) , 074703
Kinetic coefficient of steps at the Si(111) crystal-melt interface from molecular dynamics simulations
Nonequilibrium molecular dynamics simulations are applied to the investigation of step-flow kinetics at crystal-melt interfaces of silicon, modeled with the Stillinger-Weber potential [Phys. Rev. B 31, 5262 (1985)]. Step kinetic coefficients are calculated from crystallization rates of interfaces that are vicinals of the faceted (111) orientation. These vicinal interfaces contain periodic arrays of bilayer steps, and they are observed to crystallize in a step-flow growth mode at undercoolings lower than . Kinetic coefficients for both [110] and [121] oriented steps are determined for several values of the average step separation, in the range of . The values of the step kinetic coefficients are shown to be highly isotropic, and are found to increase with increasing step separation until they saturate at step separations larger than . The largest step kinetic coefficients are found to be in the range of , values that are more than five times larger than the kinetic coefficient for the rough (100) crystal-melt interface in the same system. The dependence of step mobility on step separation and the relatively large value of the step kinetic coefficient are discussed in terms of available theoretical models for crystal growth kinetics from the melt.- 15 August 2007
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 127 (7) , 074703
Kinetic coefficient of steps at the Si(111) crystal-melt interface from molecular dynamics simulations
Nonequilibrium molecular dynamics simulations are applied to the investigation of step-flow kinetics at crystal-melt interfaces of silicon, modeled with the Stillinger-Weber potential [Phys. Rev. B 31, 5262 (1985)]. Step kinetic coefficients are calculated from crystallization rates of interfaces that are vicinals of the faceted (111) orientation. These vicinal interfaces contain periodic arrays of bilayer steps, and they are observed to crystallize in a step-flow growth mode at undercoolings lower than . Kinetic coefficients for both [110] and [121] oriented steps are determined for several values of the average step separation, in the range of . The values of the step kinetic coefficients are shown to be highly isotropic, and are found to increase with increasing step separation until they saturate at step separations larger than . The largest step kinetic coefficients are found to be in the range of , values that are more than five times larger than the kinetic coefficient for the rough (100) crystal-melt interface in the same system. The dependence of step mobility on step separation and the relatively large value of the step kinetic coefficient are discussed in terms of available theoretical models for crystal growth kinetics from the melt.