RSRenato Herman Sundfeld

Renato Herman Sundfeld

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Renato Herman Sundfeld has a total of 49 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Dental bleaching on teeth submitted to enamel microabrasion 30 years ago—a case report of patients’ compliance during bleaching treatment

    by Daniel Sundfeld, Caio Cesar Pavani, Timm Cornelius Schott, Lucas Silveira Machado, Núbia Inocêncya Pavesi Pini, André Pinheiro de Magalhães Bertoz, Renato Herman Sundfeld

    The present dental bleaching case report describes a new method that precisely quantifies the daily wearing-times of the bleaching product by inserting a microsensor in the acetate custom tray. The bleaching efficacy was also discussed since the patient was previously submitted to enamel microabrasion.


  • Open Access

    Microabrasion in tooth enamel discoloration defects: three cases with long-term follow-ups

    by Renato Herman Sundfeld, Daniel Sundfeld-Neto, Lucas Silveira Machado, Laura Molinar Franco, Ticiane Cestari Fagundes, André Luiz Fraga Briso

    Superficial irregularities and certain intrinsic stains on the dental enamel surfaces can be resolved by enamel microabrasion, however, treatment for such defects need to be confined to the outermost regions of the enamel surface. Dental bleaching and resin-based composite repair are also often useful for certain situations for tooth color corrections. This article presented and discussed the indications and limitations of enamel microabrasion treatment. Three case reports treated by enamel microabrasion were also presented after 11, 20 and 23 years of follow-ups.


    • 1 May 2014
      • Vol. 33  (5) , 156-7

    An effective external bleaching technique.

    by Laura Molinar Franco, Andre Luiz Fraga Briso, Paulo Henrique Dos Santos, Renato Herman Sundfeld, Lucas Silveira Machado, Daniel Sundfeld Neto

    • 1 March 2013
      • Vol. 32  (3) , 110-1

    Combining enamel microabrasion and dental bleaching: recovering smile aesthetics.

    by Lucas Silveira Machado, Daniel Sundfeld Neto, Gustavo Barbosa De Oliveira, Thays Cristina Rodrigues Carvalho, Fernanda Garcia De Oliveira, Renato Herman Sundfeld


    • 1 December 2012
      • Vol. 31  (12) , 86-9

    A minimally invasive smile restoration. A case report describing a multitechnique approach over time.

    by Renato Herman Sundfeld, Fernanda Garcia De Oliveira, Roberta Mariano Toseto, Alex Mendez Arruda, Lucas Silveira Machado, André Luiz Fraga Briso, Sandra Rahal Mestrener

    • 1 March 2012
      • Vol. 31  (3) , 88, 90-1

    Integrating techniques to restore an adolescent's smile.

    by Ana Paula, Paulo Henrique Dos Santos, Fernanda Garcia De Oliveira, Lucas Silveira Machado, Daniel Sundfeld Neto, Renato Herman Sundfeld


  • Open Access

    Conservative reconstruction of the smile by orthodontic, bleaching, and restorative procedures

    by Renato Herman Sundfeld, Lucas Silveira Machado, Fernanda Garcia de Oliveira, Eduardo Almada Santos, Isabel Cristina Prado Torres Lugato, Daniel Sundfeld Neto

    The following is a clinical case report of a patient whose chief complaint was the presence of generalized spacing in the maxillary anterior segment following orthodontic treatment. After meticulous clinical analyses and discussions of the clinical procedures to be adopted, dental bleaching was performed in both arches with 10% hydrogen peroxide (Opalescence Trèswhite Supreme 10% Hydrogen Peroxide - Ultradent Products, Inc., South Jordan, USA) after the conclusion and stabilization of orthodontic treatment. Then, the orthodontic appliance was removed and the diastemas in the maxillary anterior teeth were closed with Amelogen Plus (Ultradent Products, Inc., South Jordan, USA) resin composite. It was observed that the association of orthodontic, bleaching, and restorative procedures was capable of restoring dental shape, function, and esthetics, allowing the patient to smile without hesitation. (Eur J Dent 2012;6:105-109)


    • 1 January 2011
      • Vol. 32  (3) , e53-7

    Smile restoration through use of enamel microabrasion associated with tooth bleaching.

    by Renato Herman Sundfeld, Vanessa Rahal, Rodrigo Sversut De Alexandre, André Luiz Fraga Briso, Daniel Sundfeld Neto

    Enamel microabrasion can eliminate enamel irregularities and discoloration defects, improving the appearance of teeth. This article presents the latest treatment protocol of enamel microabrasion to remove stains on the enamel surface. It has been verified that teeth submitted to microabrasion acquire a yellowish color because of the thinness of the remaining enamel, revealing the color of dentinal tissue to a greater degree. In these clinical conditions, correction of the color pattern of these teeth can be obtained with a considerable margin of clinical success using products containing carbamide peroxide in custom trays. Thus, patients can benefit from combined enamel microabrasion/tooth bleaching therapy, which yields attractive cosmetic results. Esthetics plays an important role in contemporary dentistry, especially because the media emphasizes beauty and health. Currently, in many countries, a smile is considered beautiful if it imitates a natural appearance, with clear, well-aligned teeth and defined anatomical shapes. Enamel microabrasion is one technique that can be used to correct discolored enamel. This technique has been elucidated and strongly advocated by Croll and Cavanaugh since 1986, and by other investigators who suggested mechanical removal of enamel stains using acidic substances in conjunction with abrasive agents. Enamel microabrasion is indicated to remove intrinsic stains of any color and of hard texture, and is contraindicated for extrinsic stains, dentinal stains, for patients with deficient labial seals, and in cases where there is no possibility to place a rubber dam adequately during the microabrasion procedure. It should be emphasized that enamel microabrasion causes a microreduction on the enamel surface, and, in some cases, teeth submitted to microabrasion may appear a darker or yellowish color because the thin remaining enamel surface can reveal some of the dentinal tissue color. In these situations, according to Haywood and Heymann in 1989, correction of the color pattern of teeth can be obtained through the use of whitening products containing carbamide peroxide in custom trays. A considerable margin of clinical success has been shown when diligence to at-home protocols is achieved by the patient and supervised by the professional. Considering these possibilities, this article presents the microabrasion technique for removal of stains on dental enamel, followed by tooth bleaching with carbamide peroxide and composite resin restoration, if required.


    • 1 January 2009
      • Vol. 22  (3) , 177-81

    Correlation of the hybrid layer thickness and resin tags length with the bond strength of a self-etching adhesive system.

    by Fernanda Garcia De Oliveira, Rodolfo Anchieta, Vanessa Rahal, Rodrigo Sversut De Alexandre, Lucas Silveira Machado, Maria Lúcia Marçal Mazza Sundefeld, Marcelo Giannini, Renato Herman Sundfeld

    The objective of this study was to measure the thickness of the hybrid layer (HLT), length of resin tags (RTL) and bond strength (BS) in the same teeth, using a self-etching adhesive system Adper Prompt L Pop to intact dentin and to analyze the correlation between HLTand RTL and their BS. Ten human molars were used for the restorative procedures and each restored tooth was sectioned in mesio-distal direction. One section was submitted to light microscopy analysis of HLT and RTL (400x). Another section was prepared and submitted to the microtensile bond test (0.5 mm/min). The fractured surfaces were analyzed using scanning electron microscopy to determine the failure pattern. Correlation between HLT and RTL with the BS data was analyzed by linear regression. The mean values of HLT, RTL and BS were 3.36 microm, 12.97 microm and 14.10 MPa, respectively. No significant relationship between BS and HLT (R2= 0.011, p>0.05) and between BS and RTL (R2= 0.038) was observed. The results suggested that there was no significant correlation between the HLT and RTL with the BS of the self-etching adhesive to dentin.


    • 1 April 2008
      • Vol. 29  (3) , 186-92

    Length of resin tags in pit-and-fissure sealants: all-in-one self-etching adhesive vs phosphoric acid etching.

    by Karina Tonini Dos Santos, Renato Herman Sundfeld, Cléa Garbin, Rodrigo Sversut De Alexandre, Maria Lúcia Marçal Mazza Sundefeld, Bruna Nakae Ceolim

    To investigate the penetration (tags) of adhesive materials into enamel etched with phosphoric acid or treated with a self-etching adhesive, before application of a pit-and-fissure sealant. The sample comprised six study groups with six specimens each. Before pit-and-fissure sealing with the materials Clinpro SealantTM (Groups I and II), Vitro Seal ALPHA (Groups III and IV) and Fuji II LC (Groups V and VI), the teeth in Groups I, III, and V were etched with 35% phosphoric acid for 30 seconds. Teeth in Groups II, IV, and VI received application of the self-etching adhesive Adper Prompt L-Pop. The treated teeth were sectioned buccolingually, ground to 100-microm thickness, decalcified, and analyzed by conventional light microscopy at 400x magnification. The teeth etched with phosphoric acid exhibited significantly greater penetration than specimens treated with self-etching adhesive. When compared with enamel treated with a self-etching adhesive, the penetration (tags) of adhesive materials into enamel was greater when applied on enamel etched with phosphoric acid.