Frank Heatley
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Frank Heatley has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
Colin Price
Department of Chemistry, University of Manchester, Manchester M13 9PL, UK
3 shared publicationsColin Booth
Manchester Polymer Centre, Department of Chemistry, University of Manchester, M13 9PL, UK
2 shared publicationsOmar A Mkhatresh
Department of Chemistry, University of Manchester, Manchester M13 9PL, UK
2 shared publicationsAglaia Karali
NMR Laboratory, Department of Chemistry, University of Crete, 71490 Iraklion, Crete, Greece
1 shared publicationC. Price
1 shared publicationGa‐Er Yu
Manchester Polymer Centre, Department of Chemistry, University of Manchester, M13 9PL, UK
1 shared publication
Latest Publications
- 1 June 2004
- Published by Wiley in Polymer International
- Vol. 53 (9) , 1336-1342
A study of the products and mechanism of the thermal oxidative degradation of poly(ethylene oxide) using 1H and 13C 1‐D and 2‐D NMR
The products and mechanism of the thermal oxidative degradation of poly(ethylene oxide) at 150 °C have been analysed using 1H and 13C 1‐D and 2‐D NMR spectroscopy, including COSY, HMQC, HMBC and DOSY techniques. Peaks from methanoate ester chain ends (in the majority), in‐chain esters, peroxy groups, acetal links and ethanoyl chain ends have been assigned. Two small molecule degradation products, 2‐hydroxyethyl methanoate and ethylene glycol dimethanoate have been identified. Copyright © 2004 Society of Chemical Industry
- 1 June 2004
- Published by Wiley in Polymer International
- Vol. 53 (9) , 1336-1342
A study of the products and mechanism of the thermal oxidative degradation of poly(ethylene oxide) using 1H and 13C 1‐D and 2‐D NMR
The products and mechanism of the thermal oxidative degradation of poly(ethylene oxide) at 150 °C have been analysed using 1H and 13C 1‐D and 2‐D NMR spectroscopy, including COSY, HMQC, HMBC and DOSY techniques. Peaks from methanoate ester chain ends (in the majority), in‐chain esters, peroxy groups, acetal links and ethanoyl chain ends have been assigned. Two small molecule degradation products, 2‐hydroxyethyl methanoate and ethylene glycol dimethanoate have been identified. Copyright © 2004 Society of Chemical Industry
- 10 May 2004
- Published by Wiley in Polymer International
- Vol. 53 (7) , 959-971
Thermal oxidative and photo‐oxidative degradation of polytetrahydrofuran studied using 1H NMR, 13C NMR and GPC
The products and mechanism of the thermal oxidative degradation at 180 °C and the photo‐oxidative degradation at 40 °C of polytetrahydrofuran have been investigated using 1H NMR, 13C NMR and GPC. The NMR analysis was assisted by the use of DEPT 13C spectra, two‐dimensional NMR spectroscopy (COSY, HMQC and HMBC) and chemical shift simulation software. The NMR spectra of both thermally and photolytically degraded samples were similar showing that the degradation mechanisms were similar. GPC indicated that both chain scission, leading to lower molar mass products, and chain extension, leading to higher molar mass products, occurred initially. NMR analysis of the initial soluble degraded polymers showed that chain scission resulted in formate, aldehyde, propyl ether, butyl ether and propanoyl chain ends, and in‐chain ester groups were also formed. For longer periods of degradation, crosslinked gels were formed but these were not amenable to detailed structural characterisation by high‐resolution NMR to determine the crosslink mechanism. Copyright © 2004 Society of Chemical Industry
- 10 May 2004
- Published by Wiley in Polymer International
- Vol. 53 (7) , 959-971
Thermal oxidative and photo‐oxidative degradation of polytetrahydrofuran studied using 1H NMR, 13C NMR and GPC
The products and mechanism of the thermal oxidative degradation at 180 °C and the photo‐oxidative degradation at 40 °C of polytetrahydrofuran have been investigated using 1H NMR, 13C NMR and GPC. The NMR analysis was assisted by the use of DEPT 13C spectra, two‐dimensional NMR spectroscopy (COSY, HMQC and HMBC) and chemical shift simulation software. The NMR spectra of both thermally and photolytically degraded samples were similar showing that the degradation mechanisms were similar. GPC indicated that both chain scission, leading to lower molar mass products, and chain extension, leading to higher molar mass products, occurred initially. NMR analysis of the initial soluble degraded polymers showed that chain scission resulted in formate, aldehyde, propyl ether, butyl ether and propanoyl chain ends, and in‐chain ester groups were also formed. For longer periods of degradation, crosslinked gels were formed but these were not amenable to detailed structural characterisation by high‐resolution NMR to determine the crosslink mechanism. Copyright © 2004 Society of Chemical Industry
- 30 December 2002
- Published by Wiley in Macromolecular Chemistry and Physics
- Vol. 203 (16) , 2273-2280
A 13C NMR Study of the Products and Mechanism of the Thermal Oxidative Degradation of Poly(ethylene oxide)
The products and mechanism of the thermal oxidative degradation of poly(ethylene oxide) at 150 °C have been analysed using 13C NMR spectroscopy. The analysis was assisted by the use of distortionless enhancement by polarisation transfer spectra, longitudinal relaxation time measurements, long‐range 13C1H coupling and chemical shift simulation software. The major result of degradation was chain scission resulting in two formate ester chain ends. Minor products were in‐chain esters, peroxy groups, oxymethylene links and hydroxy and methoxy chain ends. Initial steps for the mechanism of chain scission. magnified image Initial steps for the mechanism of chain scission.
- 30 December 2002
- Published by Wiley in Macromolecular Chemistry and Physics
- Vol. 203 (16) , 2273-2280
A 13C NMR Study of the Products and Mechanism of the Thermal Oxidative Degradation of Poly(ethylene oxide)
The products and mechanism of the thermal oxidative degradation of poly(ethylene oxide) at 150 °C have been analysed using 13C NMR spectroscopy. The analysis was assisted by the use of distortionless enhancement by polarisation transfer spectra, longitudinal relaxation time measurements, long‐range 13C1H coupling and chemical shift simulation software. The major result of degradation was chain scission resulting in two formate ester chain ends. Minor products were in‐chain esters, peroxy groups, oxymethylene links and hydroxy and methoxy chain ends. Initial steps for the mechanism of chain scission. magnified image Initial steps for the mechanism of chain scission.
- 19 June 2002
- Published by Wiley in Polymer International
- Vol. 51 (7) , 627-634
Blends of natural rubber and polyurethane latices studied by 1H wideline and 13C MAS solid‐state NMR
1H wideline and 13C magic‐angle spinning NMR have been used to study the morphology and dynamics of latex‐cast and solution‐cast film blends of natural rubber (NR) and a polyurethane (PU) based on poly(ϵ‐caprolactone) diol and isophorone di‐isocyanate. 1H T1 and T1ρ relaxation times have been measured, and the extent of interpenetration of the NR and PU constituents has been monitored using the Goldman–Shen technique. The NMR spectra and relaxation properties indicated that the NR and PI constituents largely occupy separated domains on a distance scale of >10 nm. The Goldman–Shen experiments indicated that there was slightly greater contact between NR and PU in the solution‐cast samples than in the latex‐cast. The tensile properties of the films have been measured. The tensile strength and initial Young's modulus pass through a maximum at a PU content of about 50 wt%.© 2002 Society of Chemical Industry
- 19 June 2002
- Published by Wiley in Polymer International
- Vol. 51 (7) , 627-634
Blends of natural rubber and polyurethane latices studied by 1H wideline and 13C MAS solid‐state NMR
1H wideline and 13C magic‐angle spinning NMR have been used to study the morphology and dynamics of latex‐cast and solution‐cast film blends of natural rubber (NR) and a polyurethane (PU) based on poly(ϵ‐caprolactone) diol and isophorone di‐isocyanate. 1H T1 and T1ρ relaxation times have been measured, and the extent of interpenetration of the NR and PU constituents has been monitored using the Goldman–Shen technique. The NMR spectra and relaxation properties indicated that the NR and PI constituents largely occupy separated domains on a distance scale of >10 nm. The Goldman–Shen experiments indicated that there was slightly greater contact between NR and PU in the solution‐cast samples than in the latex‐cast. The tensile properties of the films have been measured. The tensile strength and initial Young's modulus pass through a maximum at a PU content of about 50 wt%.© 2002 Society of Chemical Industry
- 24 July 2001
- Published by Wiley in Polymer International
- Vol. 50 (9) , 1004-1009
An investigation of 1H and 13C longitudinal relaxation and relaxation in the rotating frame in solid poly(N‐vinylcarbazole)
1H and 13C longitudinal relaxation times (T1) and relaxation times in the rotating frame (T1ρ) have been measured for poly(N‐vinylcarbazole) in the solid state in air and nitrogen atmospheres in an attempt to elucidate molecular motions. In air, the T1 relaxation of both 1H and 13C was dominated by interaction with absorbed paramagnetic oxygen. In nitrogen, the 13C T1 relaxation times were long (>300 s) and were averaged by 13C–13C spin diffusion. The 13C T1ρ relaxation times showed an exponential dependence on the strength of the rotating 13C magnetic field and were thus controlled by spin–spin processes rather than spin–lattice processes.© 2001 Society of Chemical Industry
- 24 July 2001
- Published by Wiley in Polymer International
- Vol. 50 (9) , 1004-1009
An investigation of 1H and 13C longitudinal relaxation and relaxation in the rotating frame in solid poly(N‐vinylcarbazole)
1H and 13C longitudinal relaxation times (T1) and relaxation times in the rotating frame (T1ρ) have been measured for poly(N‐vinylcarbazole) in the solid state in air and nitrogen atmospheres in an attempt to elucidate molecular motions. In air, the T1 relaxation of both 1H and 13C was dominated by interaction with absorbed paramagnetic oxygen. In nitrogen, the 13C T1 relaxation times were long (>300 s) and were averaged by 13C–13C spin diffusion. The 13C T1ρ relaxation times showed an exponential dependence on the strength of the rotating 13C magnetic field and were thus controlled by spin–spin processes rather than spin–lattice processes.© 2001 Society of Chemical Industry
- 1 December 1997
- Published by Wiley in Macromolecular Rapid Communications
- Vol. 18 (12) , 1085-1093
Preparation and characterization of cyclic poly(oxypropylene)
- 1 December 1997
- Published by Wiley in Macromolecular Rapid Communications
- Vol. 18 (12) , 1085-1093
Preparation and characterization of cyclic poly(oxypropylene)
- 1 July 1994
- Published by Wiley in Macromolecular Chemistry and Physics
- Vol. 195 (7) , 2547-2558
A study of chain dynamics in water‐swollen gels of poly(ethylene oxide) dialkyl ethers using NMR and differential scanning calorimetry
- 1 July 1994
- Published by Wiley in Macromolecular Chemistry and Physics
- Vol. 195 (7) , 2547-2558
A study of chain dynamics in water‐swollen gels of poly(ethylene oxide) dialkyl ethers using NMR and differential scanning calorimetry
- 1 January 1993
- Published by Royal Society of Chemistry (RSC) in Journal of the Chemical Society, Faraday Transactions
- Vol. 89 (18) , 3471-3475
1H Nuclear magnetic relaxation study of the phase structure of polystyrene-block-poly(ethylene/propylene) copolymer micelles
1 H NMR longitudinal and transverse relaxation measurements have been made as a function of temperature for micellar solutions of a polystyrene-block-poly(ethylene/propylene) copolymer in [2H1]octane. Spin diffusion following selective inversion of protons from one component has been used to probe the extent of mixing of the blocks in the interface between the micelle core consisting of slightly swollen polystyrene and the micelle fringe consisting of highly solvated poly(ethylene/propylene). At 80 °C a small degree of spin diffusion was detected, indicating that a mixed phase existed. A simple analysis of the magnitude of the effect showed that ca. 50% of the polystyrene lay in the boundary compared with only 3% of the poly(ethylene/propylene).
- 1 January 1993
- Published by Royal Society of Chemistry (RSC) in Journal of the Chemical Society, Faraday Transactions
- Vol. 89 (18) , 3471-3475
1H Nuclear magnetic relaxation study of the phase structure of polystyrene-block-poly(ethylene/propylene) copolymer micelles
1 H NMR longitudinal and transverse relaxation measurements have been made as a function of temperature for micellar solutions of a polystyrene-block-poly(ethylene/propylene) copolymer in [2H1]octane. Spin diffusion following selective inversion of protons from one component has been used to probe the extent of mixing of the blocks in the interface between the micelle core consisting of slightly swollen polystyrene and the micelle fringe consisting of highly solvated poly(ethylene/propylene). At 80 °C a small degree of spin diffusion was detected, indicating that a mixed phase existed. A simple analysis of the magnitude of the effect showed that ca. 50% of the polystyrene lay in the boundary compared with only 3% of the poly(ethylene/propylene).