Bhaskar D. Kulkarni
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Bhaskar D. Kulkarni has a total of 46 co-authors. Here are the top co-authors by number of shared publications:
Prashant P. Barve
3 shared publications- Sachin Arvind Mandavgane
Visvesvaraya National Institute of Technology
3 shared publications - Jyeshtharaj Bhalchandra Joshi
Institute of Chemical Technology
2 shared publications - Ketan Dinkar Sarode
Chemical Engineering and Process Development Division, CSIR-National Chemical Laboratory (CSIR-NCL), Pune 411008, India; Centre of Excellence in Scientific Computing, (CoESC), CSIR-NCL, Pune, India; Academy of Scientific and Innovative Research (AcSIR), CSIR-NCL Campus, Pune, India
2 shared publications - Ramdas B. Khomane
National Chemical Laboratory
2 shared publications Sanjay P. Kamble
Chemical Engineering and Process Development Division, National Chemical Laboratory (NCL, CSIR), Dr. Homi Bhabha Road, Pune-411008, India
2 shared publications
Latest Publications
- Open Access
- 22 June 2016
- Published by Elsevier in Desalination and Water Treatment
- Vol. 57 (59) , 28831-28846
Comparative evaluation of packed-bed performance of biomass ashes as adsorbents for removal of diuron from aqueous solution
The packed-bed performance of biomass ashes (BMA), namely rice husk ash (RHA) and bagasse fly ash (BFA), was investigated for adsorptive removal of diuron (herbicide) under dynamic conditions. The effects of influent concentration (10–30 mg/L), flow rate (1–3 mL/min), and bed height (3–11 cm) were studied at 30°C and results were analyzed using various packed-bed models. The saturation time and capacity of the BFA bed were found to be approximately 1.5 and 1.6 times higher due to higher BET surface area than that of RHA bed. However, the bed utilization of RHA was higher because of smaller mass transfer zone. At a constant influent concentration (20 mg/L) and flow rate (1 mL/min), the maximum volume of diuron treated was 1,325 and 1,685 mL using RHA (bed height 10 cm) and BFA (bed height 11 cm), respectively. Among the packed-bed models applied, the BDST model revealed the inconsistent MTZ and complex mechanism involving more than one rate-controlling step for the adsorption of diuron on both ashes. The kinetics in the initial part of the breakthrough curve was governed by external mass transfer according to the Bohart–Adams and Wolborska models. Better agreements between experimental and predicted values of bed capacities for each ash and the higher bed capacity of BFA than RHA were demonstrated by the Thomas model. The Yoon–Nelson model was found to be superior for BFA rather than for RHA to estimate 50% saturation time. However, the deactivation kinetic model, previously discovered and applied only for gas–solid adsorption, was found to be the best for the diuron–BMA (liquid–solid) adsorption system in this study.
- 22 June 2016
- Published by Elsevier in Desalination and Water Treatment
- Vol. 57 (59) , 28831-28846
Open AccessComparative evaluation of packed-bed performance of biomass ashes as adsorbents for removal of diuron from aqueous solution
The packed-bed performance of biomass ashes (BMA), namely rice husk ash (RHA) and bagasse fly ash (BFA), was investigated for adsorptive removal of diuron (herbicide) under dynamic conditions. The effects of influent concentration (10–30 mg/L), flow rate (1–3 mL/min), and bed height (3–11 cm) were studied at 30°C and results were analyzed using various packed-bed models. The saturation time and capacity of the BFA bed were found to be approximately 1.5 and 1.6 times higher due to higher BET surface area than that of RHA bed. However, the bed utilization of RHA was higher because of smaller mass transfer zone. At a constant influent concentration (20 mg/L) and flow rate (1 mL/min), the maximum volume of diuron treated was 1,325 and 1,685 mL using RHA (bed height 10 cm) and BFA (bed height 11 cm), respectively. Among the packed-bed models applied, the BDST model revealed the inconsistent MTZ and complex mechanism involving more than one rate-controlling step for the adsorption of diuron on both ashes. The kinetics in the initial part of the breakthrough curve was governed by external mass transfer according to the Bohart–Adams and Wolborska models. Better agreements between experimental and predicted values of bed capacities for each ash and the higher bed capacity of BFA than RHA were demonstrated by the Thomas model. The Yoon–Nelson model was found to be superior for BFA rather than for RHA to estimate 50% saturation time. However, the deactivation kinetic model, previously discovered and applied only for gas–solid adsorption, was found to be the best for the diuron–BMA (liquid–solid) adsorption system in this study.
- 1 May 2016
- Published by Elsevier in Mathematical Biosciences
- Vol. 275, 93-106
Inverse problem studies of biochemical systems with structure identification of S-systems by embedding training functions in a genetic algorithm
- 1 May 2016
- Published by Elsevier in Mathematical Biosciences
- Vol. 275, 93-106
Inverse problem studies of biochemical systems with structure identification of S-systems by embedding training functions in a genetic algorithm
- 16 February 2016
- Published by Springer Nature in Clean Technologies and Environmental Policy
- Vol. 18 (6) , 1971-1983
Adsorptive removal of 2,4-dichlorophenoxyacetic acid from aqueous solution using bagasse fly ash as adsorbent in batch and packed-bed techniques
- 16 February 2016
- Published by Springer Nature in Clean Technologies and Environmental Policy
- Vol. 18 (6) , 1971-1983
Adsorptive removal of 2,4-dichlorophenoxyacetic acid from aqueous solution using bagasse fly ash as adsorbent in batch and packed-bed techniques
- Open Access
- 19 January 2016
- Published by Current Science Association in Current Science
- Vol. 110 (2) , 180
Behaviour of Biomass Multicomponent Ashes as Adsorbents
- 19 January 2016
- Published by Current Science Association in Current Science
- Vol. 110 (2) , 180
Open AccessBehaviour of Biomass Multicomponent Ashes as Adsorbents
- Top Cited Papers
- 3 December 2015
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 54 (49) , 12217-12232
Role of Surfactants in Promoting Gas Hydrate Formation
- 3 December 2015
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 54 (49) , 12217-12232
Top Cited PapersRole of Surfactants in Promoting Gas Hydrate Formation
- 1 September 2015
- Published by Elsevier in Chemical Engineering Science
- Vol. 134, 605-618
Embedded multiple shooting methodology in a genetic algorithm framework for parameter estimation and state identification of complex systems
- 1 September 2015
- Published by Elsevier in Chemical Engineering Science
- Vol. 134, 605-618
Embedded multiple shooting methodology in a genetic algorithm framework for parameter estimation and state identification of complex systems
- Open Access
- 18 May 2015
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 5 (55) , 44679-44686
The freezing tendency towards 4-coordinated amorphous networks causes an increase in the heat capacity of supercooled Stillinger–Weber silicon
Supercooled liquid silicon (Si), modeled by the Stillinger–Weber (SW) potential, has been shown to undergo transition to low density amorphous phases at 1060 K in previous studies. Furthermore, the constant pressure heat capacity Cp has been found to exhibit a large increase as the liquid is cooled to 1060 K. In this work, we examine the nature of the equilibrium and the relaxation process of supercooled SW Si in the temperature range of 1060 K to 1070 K at zero pressure. We find that the relaxation of the supercooled liquid leads to a sharp irreversible decrease in the fluctuation of the two body energy of the largest connected network of 4-coordinated particles. Such a process implies a tightening of the bonds (i.e. freezing or jamming) of the network, and is accompanied by a sharp increase in the fraction of the 4-coordinated particles in the system. We find that the jamming (or freezing) process shows a sudden acceleration across a dynamical instability point that occurs at a unique potential energy state of the network. Further, we find that the occurrence of the dynamical instability is associated with the appearance of a straight line region in the cumulative potential energy distributions with a configurational temperature close to 1060 K. We conclude that the supercooled liquid state must be regarded as a constrained equilibrium state, since the accessible microstates are constrained by the inherent tendency of the system to approach the dynamical instability point. Thus all properties of supercooled liquid SW-Si, including the rise in Cp at 1060 K, can be attributed to the freezing tendency of the 4-coordinated particle network.
- 18 May 2015
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 5 (55) , 44679-44686
Open AccessThe freezing tendency towards 4-coordinated amorphous networks causes an increase in the heat capacity of supercooled Stillinger–Weber silicon
Supercooled liquid silicon (Si), modeled by the Stillinger–Weber (SW) potential, has been shown to undergo transition to low density amorphous phases at 1060 K in previous studies. Furthermore, the constant pressure heat capacity Cp has been found to exhibit a large increase as the liquid is cooled to 1060 K. In this work, we examine the nature of the equilibrium and the relaxation process of supercooled SW Si in the temperature range of 1060 K to 1070 K at zero pressure. We find that the relaxation of the supercooled liquid leads to a sharp irreversible decrease in the fluctuation of the two body energy of the largest connected network of 4-coordinated particles. Such a process implies a tightening of the bonds (i.e. freezing or jamming) of the network, and is accompanied by a sharp increase in the fraction of the 4-coordinated particles in the system. We find that the jamming (or freezing) process shows a sudden acceleration across a dynamical instability point that occurs at a unique potential energy state of the network. Further, we find that the occurrence of the dynamical instability is associated with the appearance of a straight line region in the cumulative potential energy distributions with a configurational temperature close to 1060 K. We conclude that the supercooled liquid state must be regarded as a constrained equilibrium state, since the accessible microstates are constrained by the inherent tendency of the system to approach the dynamical instability point. Thus all properties of supercooled liquid SW-Si, including the rise in Cp at 1060 K, can be attributed to the freezing tendency of the 4-coordinated particle network.
- 1 June 2014
- Published by Elsevier in Chemical Engineering Research and Design
- Vol. 92 (6) , 1119-1132
Biodegradable iron chelate for H2S abatement: Modeling and optimization using artificial intelligence strategies
- 1 June 2014
- Published by Elsevier in Chemical Engineering Research and Design
- Vol. 92 (6) , 1119-1132
Biodegradable iron chelate for H2S abatement: Modeling and optimization using artificial intelligence strategies
- 22 April 2014
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 53 (49) , 18678-18689
Artificial Intelligence-based Modeling of High Ash Coal Gasification in a Pilot Plant Scale Fluidized Bed Gasifier
- 22 April 2014
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 53 (49) , 18678-18689
Artificial Intelligence-based Modeling of High Ash Coal Gasification in a Pilot Plant Scale Fluidized Bed Gasifier
- 30 September 2011
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 51 (4) , 1506-1514
Purification of Lactic Acid via Esterification of Lactic Acid Using a Packed Column, Followed by Hydrolysis of Methyl Lactate Using Three Continuously Stirred Tank Reactors (CSTRs) in Series: A Continuous Pilot Plant Study
- 30 September 2011
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 51 (4) , 1506-1514
Purification of Lactic Acid via Esterification of Lactic Acid Using a Packed Column, Followed by Hydrolysis of Methyl Lactate Using Three Continuously Stirred Tank Reactors (CSTRs) in Series: A Continuous Pilot Plant Study