Igor Jovanovic
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Igor Jovanovic has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
Christopher A. Ebbers
Lawrence Livermore National Laboratory, Mail Code L-470, 7000 East Avenue, Livermore, California 94550
3 shared publicationsC. Brown
Lawrence Livermore National Laboratory, Mail Code L-270, 7000 East Avenue, Livermore, CA 94550, USA
2 shared publicationsC. P. J. Barty
Photon Science and Applications Program, National Ignition Facility Programs Directorate, Lawrence Livermore National Laboratory, Mail Code L-470. 7000 East Avenue, Livermore, CA 94550, USA
2 shared publicationsM. Shverdin
Lawrence Livermore National Laboratory, Mail Code L-270, 7000 East Avenue, Livermore, CA 94550, USA
2 shared publicationsB J Comaskey
1 shared publicationBrian J. Comaskey
1 shared publication
Latest Publications
- 1 May 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
High-dynamic-range, 200-ps window, single-shot cross-correlator for ultrahigh intensity laser characterization
A novel high-dynamic-range cross-correlator is presented that enables single-shot characterization of pulse contrast for ultrahigh intensity lasers in the temporal region up to 200 ps.
- 1 May 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
High-dynamic-range, 200-ps window, single-shot cross-correlator for ultrahigh intensity laser characterization
A novel high-dynamic-range cross-correlator is presented that enables single-shot characterization of pulse contrast for ultrahigh intensity lasers in the temporal region up to 200 ps.
- 1 May 2005
- Published by Optica Publishing Group in Optics Letters
- Vol. 30 (9) , 1036-1038
Generation of high-contrast millijoule pulses by optical parametric chirped-pulse amplification in periodically poled KTiOPO_4
A new high-contrast, high-gain optical parametric chirped-pulse amplifier (OPCPA) architecture is demonstrated in periodically poled (PPKTP). This architecture overcomes parametric fluorescence contrast limitations of the OPCPA in periodically poled materials. The scheme is based on two passes of a single relay-imaged pump pulse and a free-propagating signal pulse through a PPKTP crystal. The output energy of is generated at a center wavelength of by of pump energy. A prepulse contrast level of was measured with saturated gain in the amplifier. Amplified pulses were compressed to . This simple and versatile concept requires only a modest pump energy from a commercial pump laser and represents a possible high-contrast front end for high-energy Nd:glass-based petawatt-class lasers.- 1 May 2005
- Published by Optica Publishing Group in Optics Letters
- Vol. 30 (9) , 1036-1038
Generation of high-contrast millijoule pulses by optical parametric chirped-pulse amplification in periodically poled KTiOPO_4
A new high-contrast, high-gain optical parametric chirped-pulse amplifier (OPCPA) architecture is demonstrated in periodically poled (PPKTP). This architecture overcomes parametric fluorescence contrast limitations of the OPCPA in periodically poled materials. The scheme is based on two passes of a single relay-imaged pump pulse and a free-propagating signal pulse through a PPKTP crystal. The output energy of is generated at a center wavelength of by of pump energy. A prepulse contrast level of was measured with saturated gain in the amplifier. Amplified pulses were compressed to . This simple and versatile concept requires only a modest pump energy from a commercial pump laser and represents a possible high-contrast front end for high-energy Nd:glass-based petawatt-class lasers.- 15 September 2002
- Published by Optica Publishing Group in Optics Letters
- Vol. 27 (18) , 1622-1624
Hybrid chirped-pulse amplification
Conversion efficiency in optical parametric chirped-pulse amplification is limited by spatiotemporal characteristics of the pump pulse. We have demonstrated a novel hybrid chirped-pulse amplification scheme that uses a single pump pulse and combines optical parametric amplification and laser amplification to achieve high gain, high conversion efficiency, and high prepulse contrast without utilization of electro-optic modulators. We achieved an overall conversion efficiency of 37% from the hybrid amplification system at a center wavelength of 820 nm. Generation of multiterawatt pulses is possible by use of this simple method and commercial -switched pump lasers.- 15 September 2002
- Published by Optica Publishing Group in Optics Letters
- Vol. 27 (18) , 1622-1624
Hybrid chirped-pulse amplification
Conversion efficiency in optical parametric chirped-pulse amplification is limited by spatiotemporal characteristics of the pump pulse. We have demonstrated a novel hybrid chirped-pulse amplification scheme that uses a single pump pulse and combines optical parametric amplification and laser amplification to achieve high gain, high conversion efficiency, and high prepulse contrast without utilization of electro-optic modulators. We achieved an overall conversion efficiency of 37% from the hybrid amplification system at a center wavelength of 820 nm. Generation of multiterawatt pulses is possible by use of this simple method and commercial -switched pump lasers.- 20 May 2002
- Published by Optica Publishing Group in Applied Optics
- Vol. 41 (15) , 2923-2929
Optical parametric chirped-pulse amplifier as an alternative to Ti:sapphire regenerative amplifiers
We demonstrated a high-pulse energy, femtosecond-pulse source based on optical parametric chirped-pulse amplification. We successfully amplified 1-µm broadband oscillator pulses to 31 mJ and recompressed them to 310-fs pulse duration, at a 10-Hz repetition rate. The gain in our system is 6 × 107, achieved by the single passing of only 40 mm of gain material pumped by a commercial Q-switched Nd:YAG laser. This relatively simple system replaces a more complex Ti:sapphire regenerative-amplifier-based chirped-pulse amplification system. Numerous features in design and performance of optical parametric chirped-pulse amplifiers make them a preferred alternative to regenerative amplifiers based on Ti:sapphire in the front end of high-peak-power lasers.
- 20 May 2002
- Published by Optica Publishing Group in Applied Optics
- Vol. 41 (15) , 2923-2929
Optical parametric chirped-pulse amplifier as an alternative to Ti:sapphire regenerative amplifiers
We demonstrated a high-pulse energy, femtosecond-pulse source based on optical parametric chirped-pulse amplification. We successfully amplified 1-µm broadband oscillator pulses to 31 mJ and recompressed them to 310-fs pulse duration, at a 10-Hz repetition rate. The gain in our system is 6 × 107, achieved by the single passing of only 40 mm of gain material pumped by a commercial Q-switched Nd:YAG laser. This relatively simple system replaces a more complex Ti:sapphire regenerative-amplifier-based chirped-pulse amplification system. Numerous features in design and performance of optical parametric chirped-pulse amplifiers make them a preferred alternative to regenerative amplifiers based on Ti:sapphire in the front end of high-peak-power lasers.
- 1 January 2002
- Published by Optica Publishing Group
- p. TuC3
Hybrid chirped pulse amplification
We present a novel chirped pulse amplification method which combines optical parametric amplification and laser amplification. High efficiency is achieved without the use of electro-optic modulators using a simple tabletop pump laser.
- 1 January 2002
- Published by Optica Publishing Group
- p. TuC3
Hybrid chirped pulse amplification
We present a novel chirped pulse amplification method which combines optical parametric amplification and laser amplification. High efficiency is achieved without the use of electro-optic modulators using a simple tabletop pump laser.
- 1 February 2001
- Published by Office of Scientific and Technical Information (OSTI)
New Front End Technology
The next generation of Petawatt class lasers will require the development of new laser technology. Optical parametric chirped pulse amplification (OPCPA) holds a potential to increase the peak power level to >10 PW with existing grating technology through ultrashort pulses. Furthermore, by utilizing a new type of front-end system based on optical parametric amplification, pulses can be produced with substantially higher contrast than with Ti:sapphire regenerative amplifier technology. We performed extensive study of OPCPA using a single crystal-based OPA. We developed a replacement for Ti:sapphire regenerative amplifier for high peak power lasers based on OPCPA, with an output of 30 mJ, at 10 Hz repetition rate and 16.5 nm spectral bandwidth. We developed a 3D numerical model for OPCPA and we performed a theoretical study of influences of pump laser beam quality on optical parametric amplification. Our results indicate that OPCPA represents a valid replacement for Ti:sapphire in the front end of high energy short pulse lasers.
- 1 February 2001
- Published by Office of Scientific and Technical Information (OSTI)
New Front End Technology
The next generation of Petawatt class lasers will require the development of new laser technology. Optical parametric chirped pulse amplification (OPCPA) holds a potential to increase the peak power level to >10 PW with existing grating technology through ultrashort pulses. Furthermore, by utilizing a new type of front-end system based on optical parametric amplification, pulses can be produced with substantially higher contrast than with Ti:sapphire regenerative amplifier technology. We performed extensive study of OPCPA using a single crystal-based OPA. We developed a replacement for Ti:sapphire regenerative amplifier for high peak power lasers based on OPCPA, with an output of 30 mJ, at 10 Hz repetition rate and 16.5 nm spectral bandwidth. We developed a 3D numerical model for OPCPA and we performed a theoretical study of influences of pump laser beam quality on optical parametric amplification. Our results indicate that OPCPA represents a valid replacement for Ti:sapphire in the front end of high energy short pulse lasers.