Laurent Berger
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Laurent Berger has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Ridha Fezzani
Underwater Acoustics Laboratory,French national institute for ocean science and technology (IFREMER), Plouzané, France
3 shared publications - Verena M. Trenkel
DECOD (Ecosystem Dynamics and Sustainability), Institut‐Agro, IFREMER, INRAe Nantes France
2 shared publications - Chris Mesdag
Department of Applied Geology and Geophysics, Deltares, 3584 BK Utrecht, The Netherlands
1 shared publication - Cyrille Poncelet
Ifremer, Département NSE, BP 70, 29280 Plouzané, France
1 shared publication - Dan R. Parsons
Pro-Vice-Chancellor for Research and Innovation, Loughborough University
1 shared publication - Luciano Fonseca
Universidade de Brasília, Brazil
1 shared publication
Latest Publications
- Open Access
- 31 March 2024
- Published by MDPI AG in Journal of Marine Science and Engineering
- Vol. 12 (4) , 609
Bottom and Suspended Sediment Backscatter Measurements in a Flume—Towards Quantitative Bed and Water Column Properties
For health and impact studies of water systems, monitoring underwater environments is essential, for which multi-frequency single- and multibeam echosounders are commonly used state-of-the-art technologies. However, the current scarcity of sediment reference datasets of both bottom backscatter angular response and water column scattering hampers empirical data interpretation. Comprehensive reference data derived from measurements in a controlled environment should optimize the use of empirical backscatter data. To prepare for such innovative experiments, we conducted a feasibility experiment in the Delta Flume (Deltares, The Netherlands). Several configurations of sonar data were recorded of the flume floor and suspended sediment plumes. The results revealed that flume reverberation was sufficiently low and that the differential settling of fine-sand plumes in the water column was clearly detected. Following this successful feasibility test, future comprehensive experiments will feature multi-frequency multi-angle measurements on a variety of sediment types, additional scatterers and sediment plumes, resulting in reference datasets for an improved interpretation of underwater backscatter measurements for scientific observation and sustainable management.
- 31 March 2024
- Published by MDPI AG in Journal of Marine Science and Engineering
- Vol. 12 (4) , 609
Open AccessBottom and Suspended Sediment Backscatter Measurements in a Flume—Towards Quantitative Bed and Water Column Properties
For health and impact studies of water systems, monitoring underwater environments is essential, for which multi-frequency single- and multibeam echosounders are commonly used state-of-the-art technologies. However, the current scarcity of sediment reference datasets of both bottom backscatter angular response and water column scattering hampers empirical data interpretation. Comprehensive reference data derived from measurements in a controlled environment should optimize the use of empirical backscatter data. To prepare for such innovative experiments, we conducted a feasibility experiment in the Delta Flume (Deltares, The Netherlands). Several configurations of sonar data were recorded of the flume floor and suspended sediment plumes. The results revealed that flume reverberation was sufficiently low and that the differential settling of fine-sand plumes in the water column was clearly detected. Following this successful feasibility test, future comprehensive experiments will feature multi-frequency multi-angle measurements on a variety of sediment types, additional scatterers and sediment plumes, resulting in reference datasets for an improved interpretation of underwater backscatter measurements for scientific observation and sustainable management.
- Open Access
- 1 June 2021
- Published by Acoustical Society of America (ASA) in The Journal of the Acoustical Society of America
- Vol. 149 (6) , 4503-4515
Multispectral and multiangle measurements of acoustic seabed backscatter acquired with a tilted calibrated echosounder
A multispectral and multiangle analysis of seabed backscatter intensity has been conducted using data from a calibrated single-beam echosounder (SBES) with five frequency channels deployed over four homogeneous areas with different sediment types in the Bay of Brest (France). The SBES transducers were tilted at incidence angles from 0° to 70° to record the seafloor backscatter angular response at discrete frequencies ranging from 35 to 450 kHz. The recorded backscatter levels were analyzed for their angular dependence (average backscatter strength versus frequency and angle) as well as for their sample statistical distribution. The angle and frequency dependence of the seafloor backscatter obtained using a calibrated SBES can potentially be used to calibrate multibeam systems, and it can also help in elucidating the physical processes of backscatter controlled by the interaction between the acoustic wave characteristics and the sediment properties. Backscatter measurements for each area showed a consistent frequency dependence with little variation between the four sediment types.
- 1 June 2021
- Published by Acoustical Society of America (ASA) in The Journal of the Acoustical Society of America
- Vol. 149 (6) , 4503-4515
Open AccessMultispectral and multiangle measurements of acoustic seabed backscatter acquired with a tilted calibrated echosounder
A multispectral and multiangle analysis of seabed backscatter intensity has been conducted using data from a calibrated single-beam echosounder (SBES) with five frequency channels deployed over four homogeneous areas with different sediment types in the Bay of Brest (France). The SBES transducers were tilted at incidence angles from 0° to 70° to record the seafloor backscatter angular response at discrete frequencies ranging from 35 to 450 kHz. The recorded backscatter levels were analyzed for their angular dependence (average backscatter strength versus frequency and angle) as well as for their sample statistical distribution. The angle and frequency dependence of the seafloor backscatter obtained using a calibrated SBES can potentially be used to calibrate multibeam systems, and it can also help in elucidating the physical processes of backscatter controlled by the interaction between the acoustic wave characteristics and the sediment properties. Backscatter measurements for each area showed a consistent frequency dependence with little variation between the four sediment types.
- 31 January 2018
- Published by Springer Nature in Marine Geophysical Research
- Vol. 39 (1-2) , 169-181
Analysis of calibrated seafloor backscatter for habitat classification methodology and case study of 158 spots in the Bay of Biscay and Celtic Sea
- 31 January 2018
- Published by Springer Nature in Marine Geophysical Research
- Vol. 39 (1-2) , 169-181
Analysis of calibrated seafloor backscatter for habitat classification methodology and case study of 158 spots in the Bay of Biscay and Celtic Sea
- Open Access
- 8 May 2009
- Published by Oxford University Press (OUP) in ICES Journal of Marine Science
- Vol. 66 (6) , 1155-1161
A method for reducing uncertainty in estimates of fish-school frequency response using data from multifrequency and multibeam echosounders
Berger, L., Poncelet, C., and Trenkel, V. M. 2009. A method for reducing uncertainty in estimates of fish-school frequency response using data from multifrequency and multibeam echosounders. – ICES Journal of Marine Science, 66: 1155–1161. Fish schools can be insonified simultaneously with multifrequency echosounders (e.g. Simrad EK60s) and a multibeam echosounder (e.g. Simrad ME70). This paper presents a method for combining these data to improve estimates of the relative frequency response r(f) of fish schools. Values of r(f) are now commonly used to classify echoes in fishery surveys. The data from the roll- and pitch-stabilized, high-resolution ME70 are used to correct beam-width effects in the multifrequency EK60 data. First, knowing the exact position and orientation of the transducers and the position of the vessel, the echoes are placed into a common geographic coordinate system. Then, the EK60 data are rejected if they do not include a significant percentage of the fish school imaged with the multibeam echosounder. Echoes that exceed the overlap threshold are used to estimate the r(f). The proposed method is applied to simulated and actual data for sardine and mackerel schools in the Bay of Biscay to estimate their r(f) values. The results for different overlap thresholds are compared with the results of a different method, one that uses adaptive thresholds on volume-backscattering strength Sv. The proposed method reduces uncertainty in estimates of r(f) for schools with an overlap of greater than 80%, and it outperforms the Sv-thresholding technique.
- 8 May 2009
- Published by Oxford University Press (OUP) in ICES Journal of Marine Science
- Vol. 66 (6) , 1155-1161
Open AccessA method for reducing uncertainty in estimates of fish-school frequency response using data from multifrequency and multibeam echosounders
Berger, L., Poncelet, C., and Trenkel, V. M. 2009. A method for reducing uncertainty in estimates of fish-school frequency response using data from multifrequency and multibeam echosounders. – ICES Journal of Marine Science, 66: 1155–1161. Fish schools can be insonified simultaneously with multifrequency echosounders (e.g. Simrad EK60s) and a multibeam echosounder (e.g. Simrad ME70). This paper presents a method for combining these data to improve estimates of the relative frequency response r(f) of fish schools. Values of r(f) are now commonly used to classify echoes in fishery surveys. The data from the roll- and pitch-stabilized, high-resolution ME70 are used to correct beam-width effects in the multifrequency EK60 data. First, knowing the exact position and orientation of the transducers and the position of the vessel, the echoes are placed into a common geographic coordinate system. Then, the EK60 data are rejected if they do not include a significant percentage of the fish school imaged with the multibeam echosounder. Echoes that exceed the overlap threshold are used to estimate the r(f). The proposed method is applied to simulated and actual data for sardine and mackerel schools in the Bay of Biscay to estimate their r(f) values. The results for different overlap thresholds are compared with the results of a different method, one that uses adaptive thresholds on volume-backscattering strength Sv. The proposed method reduces uncertainty in estimates of r(f) for schools with an overlap of greater than 80%, and it outperforms the Sv-thresholding technique.
- 1 November 2006
- Published by Acoustical Society of America (ASA) in The Journal of the Acoustical Society of America
- Vol. 120 (5_Suppleme) , 3017
First results with the new scientific multibeam echo-sounder ME70
Multibeam echo-sounders and sonars are increasingly used in fisheries acoustics for studying school structure and behavior and for abundance estimation. However, data quality and a poor signal-to-noise ratio obtained with the existing multibeam echo-sounders preclude quantitative biomass estimation as carried out with the traditional single beam echo-sounders. In order to overcome these shortcomings, Ifremer and Simrad AS started in 2003 the development of the new and highly flexible calibrated multibeam echo-sounder ME70 designed for studying a wide range of scientific questions. This paper will present the full functionalities of the ME70 and preliminary results obtained with the system installed onboard the research vessel Thalassa. It will also provide first indications of its performance. Data have been collected on small pelagic fish species in the bay of Biscay, using simultaneously the traditional single beam echo-sounders and the ME70 with different beam configurations. Preliminary comparisons of fish school descriptors and biomass estimates based on single- and multibeam data allow us to quantify the effect of the gain in sampling coverage and the high angular resolution of the new system.
- 1 November 2006
- Published by Acoustical Society of America (ASA) in The Journal of the Acoustical Society of America
- Vol. 120 (5_Suppleme) , 3017
First results with the new scientific multibeam echo-sounder ME70
Multibeam echo-sounders and sonars are increasingly used in fisheries acoustics for studying school structure and behavior and for abundance estimation. However, data quality and a poor signal-to-noise ratio obtained with the existing multibeam echo-sounders preclude quantitative biomass estimation as carried out with the traditional single beam echo-sounders. In order to overcome these shortcomings, Ifremer and Simrad AS started in 2003 the development of the new and highly flexible calibrated multibeam echo-sounder ME70 designed for studying a wide range of scientific questions. This paper will present the full functionalities of the ME70 and preliminary results obtained with the system installed onboard the research vessel Thalassa. It will also provide first indications of its performance. Data have been collected on small pelagic fish species in the bay of Biscay, using simultaneously the traditional single beam echo-sounders and the ME70 with different beam configurations. Preliminary comparisons of fish school descriptors and biomass estimates based on single- and multibeam data allow us to quantify the effect of the gain in sampling coverage and the high angular resolution of the new system.