Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Eric Sonnenthal has a total of 45 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Fracture Sustainability in Enhanced Geothermal Systems: Experimental and Modeling Constraints

    by Patrick F. Dobson, Timothy J. Kneafsey, Seiji Nakagawa, Eric L. Sonnenthal, Marco Voltolini, J. Torquil Smith, Sharon E. Borglin

    Enhanced geothermal systems (EGS) offer the potential for a much larger energy source than conventional hydrothermal systems. Hot, low-permeability rocks are prevalent at depth around the world, but the challenge of extracting thermal energy depends on the ability to create and sustain open fracture networks. Laboratory experiments were conducted using a suite of selected rock cores (granite, metasediment, rhyolite ash-flow tuff, and silicified rhyolitic tuff) at relevant pressures (uniaxial loading up to 20.7 MPa and fluid pressures up to 10.3 MPa) and temperatures (150–250 °C) to evaluate the potential impacts of circulating fluids through fractured rock by monitoring changes in fracture aperture, mineralogy, permeability, and fluid chemistry. Because a fluid in disequilibrium with the rocks (deionized water) was used for these experiments, there was net dissolution of the rock sample: this increased with increasing temperature and experiment duration. Thermal-hydrological-mechanical-chemical (THMC) modeling simulations were performed for the rhyolite ash-flow tuff experiment to test the ability to predict the observed changes. These simulations were performed in two steps: a thermal-hydrological-mechanical (THM) simulation to evaluate the effects of compression of the fracture, and a thermal-hydrological-chemical (THC) simulation to evaluate the effects of hydrothermal reactions on the fracture mineralogy, porosity, and permeability. These experiments and simulations point out how differences in rock mineralogy, fluid chemistry, and geomechanical properties influence how long asperity-propped fracture apertures may be sustained. Such core-scale experiments and simulations can be used to predict EGS reservoir behavior on the field scale.


  • Open Access

    Commemorating Dr. Gudmundur “Bo” Bodvarsson (1951–2006), a Leader of the Deep Unsaturated Flow and Transport Investigations

    by Chin-Fu Tsang, Marcelo Lippmann, Patrick Dobson, Yvonne Tsang, Boris Faybishenko, Sally Benson, Jens Birkholzer, Stefan Finsterle, Daniel Hawkes, Susan Hubbard, et al.

    The Special Issue “Water and Solute Transport in Vadose Zone” in the journal Water is dedicated to the memory of Dr. Gudmundur “Bo” Bodvarsson, the former director of the Earth Sciences Division of Lawrence Berkeley National Laboratory (http://eesa.lbl.gov/profiles/gudmundur-bo-sbodvarsson/).

  • TOUGH Symposium 2012

    by Stefan Finsterle, Eric L. Sonnenthal


  • Coupled THM Modeling of Hydroshearing Stimulation in Tight Fractured Volcanic Rock

    by A. P. Rinaldi, J. Rutqvist, E. L. Sonnenthal, T. T. Cladouhos


  • Disposal systems evaluations and tool development : Engineered Barrier System (EBS) evaluation.

    by Jonny (Lbnl) Rutqvist, Hui-Hai (Lbnl) Liu, Carl I. (Lbnl) Steefel, M. A. (Llnl) Serrano de Caro, Florie Andre (Lanl) Caporuscio, Jens T. (Lbnl) Birkholzer, James A. (Llnl) Blink, Mark A. (Llnl) Sutton, Hongwu (Lanl) Xu, Thomas A. (Llnl) Buscheck, et al.

    Key components of the nuclear fuel cycle are short-term storage and long-term disposal of nuclear waste. The latter encompasses the immobilization of used nuclear fuel (UNF) and radioactive waste streams generated by various phases of the nuclear fuel cycle, and the safe and permanent disposition of these waste forms in geological repository environments. The engineered barrier system (EBS) plays a very important role in the long-term isolation of nuclear waste in geological repository environments. EBS concepts and their interactions with the natural barrier are inherently important to the long-term performance assessment of the safety case where nuclear waste disposition needs to be evaluated for time periods of up to one million years. Making the safety case needed in the decision-making process for the recommendation and the eventual embracement of a disposal system concept requires a multi-faceted integration of knowledge and evidence-gathering to demonstrate the required confidence level in a deep geological disposal site and to evaluate long-term repository performance. The focus of this report is the following: (1) Evaluation of EBS in long-term disposal systems in deep geologic environments with emphasis on the multi-barrier concept; (2) Evaluation of key parameters in the characterization of EBS performance; (3) Identification of keymore » knowledge gaps and uncertainties; and (4) Evaluation of tools and modeling approaches for EBS processes and performance. The above topics will be evaluated through the analysis of the following: (1) Overview of EBS concepts for various NW disposal systems; (2) Natural and man-made analogs, room chemistry, hydrochemistry of deep subsurface environments, and EBS material stability in near-field environments; (3) Reactive Transport and Coupled Thermal-Hydrological-Mechanical-Chemical (THMC) processes in EBS; and (4) Thermal analysis toolkit, metallic barrier degradation mode survey, and development of a Disposal Systems Evaluation Framework (DSEF). This report will focus on the multi-barrier concept of EBS and variants of this type which in essence is the most adopted concept by various repository programs. Empasis is given mainly to the evaluation of EBS materials and processes through the analysis of published studies in the scientific literature of past and existing repository research programs. Tool evaluations are also emphasized, particularly on THCM processes and chemical equilibria. Although being an increasingly important aspect of NW disposition, short-term or interim storage of NW will be briefly discussed but not to the extent of the EBS issues relevant to disposal systems in deep geologic environments. Interim storage will be discussed in the report Evaluation of Storage Concepts FY10 Final Report (Weiner et al. 2010). « less


  • Modeling Coupled Processes in Clay Formations for Radioactive Waste Disposal

    by Hui-Hai Liu, Jonny Rutqvist, Liange Zheng, Eric Sonnenthal, Jim Houseworth, Jens Birkholzer

    As a result of the termination of the Yucca Mountain Project, the United States Department of Energy (DOE) has started to explore various alternative avenues for the disposition of used nuclear fuel and nuclear waste. The overall scope of the investigation includes temporary storage, transportation issues, permanent disposal, various nuclear fuel types, processing alternatives, and resulting waste streams. Although geologic disposal is not the only alternative, it is still the leading candidate for permanent disposal. The realm of geologic disposal also offers a range of geologic environments that may be considered, among those clay shale formations. Figure 1-1 presents the distribution of clay/shale formations within the USA. Clay rock/shale has been considered as potential host rock for geological disposal of high-level nuclear waste throughout the world, because of its low permeability, low diffusion coefficient, high retention capacity for radionuclides, and capability to self-seal fractures induced by tunnel excavation. For example, Callovo-Oxfordian argillites at the Bure site, France (Fouche et al., 2004), Toarcian argillites at the Tournemire site, France (Patriarche et al., 2004), Opalinus clay at the Mont Terri site, Switzerland (Meier et al., 2000), and Boom clay at Mol site, Belgium (Barnichon et al., 2005) have all been under intensivemore » scientific investigations (at both field and laboratory scales) for understanding a variety of rock properties and their relations with flow and transport processes associated with geological disposal of nuclear waste. Clay/shale formations may be generally classified as indurated and plastic clays (Tsang et al., 2005). The latter (including Boom clay) is a softer material without high cohesion; its deformation is dominantly plastic. For both clay rocks, coupled thermal, hydrological, mechanical and chemical (THMC) processes are expected to have a significant impact on the long-term safety of a clay repository. For example, the excavation-damaged zone (EDZ) near repository tunnels can modify local permeability (resulting from induced fractures), potentially leading to less confinement capability (Tsang et al., 2005). Because of clay's swelling and shrinkage behavior (depending on whether the clay is in imbibition or drainage processes), fracture properties in the EDZ are quite dynamic and evolve over time as hydromechanical conditions change. To understand and model the coupled processes and their impact on repository performance is critical for the defensible performance assessment of a clay repository. Within the Natural Barrier System (NBS) group of the Used Fuel Disposition (UFD) Campaign at DOE's Office of Nuclear Energy, LBNL's research activities have focused on understanding and modeling such coupled processes. LBNL provided a report in this April on literature survey of studies on coupled processes in clay repositories and identification of technical issues and knowledge gaps (Tsang et al., 2010). This report will document other LBNL research activities within the natural system work package, including the development of constitutive relationships for elastic deformation of clay rock (Section 2), a THM modeling study (Section 3) and a THC modeling study (Section 4). The purpose of the THM and THC modeling studies is to demonstrate the current modeling capabilities in dealing with coupled processes in a potential clay repository. In Section 5, we discuss potential future R&D work based on the identified knowledge gaps. The linkage between these activities and related FEPs is presented in Section 6.« less

  • Open Access

    Modeling acid-gas generation from boiling chloride brines

    by Guoxiang Zhang, Nicolas Spycher, Eric Sonnenthal, Carl Steefel

    This study investigates the generation of HCl and other acid gases from boiling calcium chloride dominated waters at atmospheric pressure, primarily using numerical modeling. The main focus of this investigation relates to the long-term geologic disposal of nuclear waste at Yucca Mountain, Nevada, where pore waters around waste-emplacement tunnels are expected to undergo boiling and evaporative concentration as a result of the heat released by spent nuclear fuel. Processes that are modeled include boiling of highly concentrated solutions, gas transport, and gas condensation accompanied by the dissociation of acid gases, causing low-pH condensate.


  • Temperature Effects on seepage Fluid Compositions at Yucca Mountain

    by Nicolas Spycher, Eric Sonnenthal

    This project investigated the effect of two repository operating temperature modes on coupled thermal, hydrological, and chemical processes around potential nuclear waste-emplacement tunnels (drifts) at Yucca Mountain, Nevada. The main objective of this study was to evaluate the composition of fluids (water and gas) that could enter the drifts, because these data directly relate to the performance of waste canisters and other in-drift engineered systems over the life of the potential repository. Multicomponent reactive transport simulations were performed using TOUGHREACT, initially written by T. Xu and K. Pruess at LBNL and modified here to handle high-temperature and boiling environments. Two repository operating temperature modes were investigated: (1) a ''high-temperature'' mode, which considered a short preclosure ventilation period (50 years) and gave rise to above-boiling temperatures in rocks around the drift for hundreds of years, and (2) a ''low-temperature'' mode with a smaller heat load and longer preclosure ventilation (300 years), yielding temperatures at the surface of the waste package below 85 C (a design threshold) and thus below boiling conditions. Simulations under ambient conditions (no heat load) were also conducted to serve as a baseline for comparing results of thermal-loading simulations.

  • The Skaergaard Layered Series. Part IV. Reaction-Transport Simulations of Foundered Blocks

    by Eric L. Sonnenthal, Alexander R. McBirney

    During the middle stages of crystallization of the Skaergaard Layered Series large numbers of blocks became detached from the Upper Border Series and settled into the mush of crystals on the floor. It has been recognized for some time that these blocks now have compositions and textures that differ markedly from those of the units from which they came. They tend to be more plagioclase rich and seem to have lost mafic components to the surrounding gabbro. Numerical simulations coupling crystallization, melting, and heat and mass transfer for a multicomponent system show how the blocks reacted with the mush in which they were emplaced. Enhanced cooling and crystallization of a compositionally stratified mush adjacent to the blocks resulted in patterns of melt compositions similar to those of layering around the blocks. Volume changes during crystallization and melting induced convection of the interstitial melt leading to changes in the bulk compositions of the blocks and the surrounding mush. Inhomogeneities such as inclusions are likely to facilitate the onset of compositional convection in a chemically stratified solidification zone.