Gary J. Shiflet
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Gary J. Shiflet has a total of 37 co-authors. Here are the top co-authors by number of shared publications:
S. J. Poon
University of Virginia Department of Physics Charlottesville, Virginia 22904-4714, USA
6 shared publicationsR.E Hackenberg
Department of Materials Science and Engineering, University of Virginia, Charlottesville, VA 22903, USA
4 shared publicationsY. Shen
3 shared publicationsAleks Y. M. Ontman
University of Virginia
2 shared publications- Christopher R. Hutchinson
Department of Materials Science and Engineering, Monash University, Clayton, Australia
1 shared publication D. G. Granada
The National de Ingenieros Electromecanica
1 shared publication
Latest Publications
- 19 July 2011
- Published by Springer Nature in JOM
- Vol. 63 (7) , 44-48
Microstructure segmentation using active contours—Possibilities and limitations
- 19 July 2011
- Published by Springer Nature in JOM
- Vol. 63 (7) , 44-48
Microstructure segmentation using active contours—Possibilities and limitations
- 22 May 2010
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 41 (9) , 2236-2247
Application of Active Contours on Metallurgical Microstructures
- 22 May 2010
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 41 (9) , 2236-2247
Application of Active Contours on Metallurgical Microstructures
- 1 October 2007
- Published by AIP Publishing in Applied Physics Letters
- Vol. 91 (14) , 141910
The role of Y/lanthanides on the glass forming ability of amorphous steel
The effect of yttrium on improving the amorphous steel glass formability (GFA) is investigated through chemical analysis during the early devitrification stage by employing energy dispersive x-ray spectroscopy and three-dimensional atom probe techniques. Atomic segregation and partitioning are found to occur in association with the formation of the principal competing crystalline phase. The partitioning of Y from crystallite particles is confirmed, in agreement with first principles calculations. Additionally, the GFA improvement is also attributed to the strong interatomic bonding between lanthanide and metalloids. The role of Y on improving GFA is verified with growth kinetic measurements.- 1 October 2007
- Published by AIP Publishing in Applied Physics Letters
- Vol. 91 (14) , 141910
The role of Y/lanthanides on the glass forming ability of amorphous steel
The effect of yttrium on improving the amorphous steel glass formability (GFA) is investigated through chemical analysis during the early devitrification stage by employing energy dispersive x-ray spectroscopy and three-dimensional atom probe techniques. Atomic segregation and partitioning are found to occur in association with the formation of the principal competing crystalline phase. The partitioning of Y from crystallite particles is confirmed, in agreement with first principles calculations. Additionally, the GFA improvement is also attributed to the strong interatomic bonding between lanthanide and metalloids. The role of Y on improving GFA is verified with growth kinetic measurements.- 29 August 2007
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 38 (10) , 2540-2551
Glass Formation, Phase Equilibria, and Thermodynamic Assessment of the Al-Ce-Co System Assisted by First-Principles Energy Calculations
- 29 August 2007
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 38 (10) , 2540-2551
Glass Formation, Phase Equilibria, and Thermodynamic Assessment of the Al-Ce-Co System Assisted by First-Principles Energy Calculations
- 1 August 2005
- Published by Springer Nature in Journal of Materials Research
- Vol. 20 (8) , 1935-1938
Mg–Ca–Zn Bulk Metallic Glasses with High Strength and Significant Ductility
The development of Mg–Ca–Zn metallic glasses with improved bulk glass forming ability, high strength, and significant ductility is reported. A typical size of at least 3–4 mm amorphous samples can be prepared using conventional casting techniques. By varying the composition, the mass density of these light metal based bulk amorphous alloys ranges from 2.0 to 3.0 g/cm3. The typical measured microhardness is 2.16 GPa, corresponding to a fracture strength of about 700 MPa and specific strength of around 250–300 MPa cm3/g. Unlike other Mg- or Ca-based metallic glasses, the present Mg–Ca–Zn amorphous alloys show significant ductility.
- 1 August 2005
- Published by Springer Nature in Journal of Materials Research
- Vol. 20 (8) , 1935-1938
Mg–Ca–Zn Bulk Metallic Glasses with High Strength and Significant Ductility
The development of Mg–Ca–Zn metallic glasses with improved bulk glass forming ability, high strength, and significant ductility is reported. A typical size of at least 3–4 mm amorphous samples can be prepared using conventional casting techniques. By varying the composition, the mass density of these light metal based bulk amorphous alloys ranges from 2.0 to 3.0 g/cm3. The typical measured microhardness is 2.16 GPa, corresponding to a fracture strength of about 700 MPa and specific strength of around 250–300 MPa cm3/g. Unlike other Mg- or Ca-based metallic glasses, the present Mg–Ca–Zn amorphous alloys show significant ductility.
- 1 July 2004
- Published by Elsevier in Acta Materialia
- Vol. 52 (12) , 3745
Erratum to “Thermodynamics and phase equilibria of the Al–Fe–Gd metallic glass-forming system” [Acta Mater. 50 (2002) 2245–2258]
- 1 July 2004
- Published by Elsevier in Acta Materialia
- Vol. 52 (12) , 3745
Erratum to “Thermodynamics and phase equilibria of the Al–Fe–Gd metallic glass-forming system” [Acta Mater. 50 (2002) 2245–2258]
- 23 July 2003
- Published by IOP Publishing in Journal of Physics: Condensed Matter
- Vol. 15 (31) , S2357-S2364
Local structure of Al-and Fe-based metallic glasses
- 23 July 2003
- Published by IOP Publishing in Journal of Physics: Condensed Matter
- Vol. 15 (31) , S2357-S2364
Local structure of Al-and Fe-based metallic glasses
- 18 April 2003
- Published by American Association for the Advancement of Science (AAAS) in Science
- Vol. 300 (5618) , 443-444
The More Elements, the Merrier
New alloy materials are commonly discovered by trial and error, a labor-intensive approach that is not well suited for alloys containing more than two or three elements. But as Shiflet explains in his Perspective, new approaches based on computational thermodynamics and quantum mechanics are heralding a new age of alloy discovery. He highlights the report by Saito et al., who have used such an approach to discover a new superplastic, multifunctional Ti alloy containing five elements. Because of the strict chemical constraints, such a complex material would most likely never be designed using a trial-and-error approach.
- 18 April 2003
- Published by American Association for the Advancement of Science (AAAS) in Science
- Vol. 300 (5618) , 443-444
The More Elements, the Merrier
New alloy materials are commonly discovered by trial and error, a labor-intensive approach that is not well suited for alloys containing more than two or three elements. But as Shiflet explains in his Perspective, new approaches based on computational thermodynamics and quantum mechanics are heralding a new age of alloy discovery. He highlights the report by Saito et al., who have used such an approach to discover a new superplastic, multifunctional Ti alloy containing five elements. Because of the strict chemical constraints, such a complex material would most likely never be designed using a trial-and-error approach.
- 7 April 2003
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 353 (1-2) , 114-123
Thermodynamic assessment of the Al–Ni–Gd glass-forming system
- 7 April 2003
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 353 (1-2) , 114-123
Thermodynamic assessment of the Al–Ni–Gd glass-forming system
- 1 December 2002
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 33 (12) , 3619-3633
Austenite decomposition to carbide-rich products in Fe-0.30C-6.3W
- 1 December 2002
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 33 (12) , 3619-3633
Austenite decomposition to carbide-rich products in Fe-0.30C-6.3W