Katlakunta Sadhana
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Katlakunta Sadhana has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
- Praveena Kuruva
Department of Physics, Post Graduate College, Palamuru University, Mahabubnagar, India
5 shared publications - Dachepalli Ravinder
Department of Physics, University College of Science, Osmania University, Hyderabad, India
2 shared publications K. Praveena
Indian Institute of Science
2 shared publicationsN. Maramu
2 shared publicationsS. R. Murthy
Osmania University
2 shared publicationsG. Sriramulu
Department of Physics, Saifabad, University College of Science, Osmania University, Hyderabad, India
1 shared publication
Latest Publications
- Open Access
- 5 May 2021
- Published by IntechOpen
Investigation of Structural, Magnetic and Electrical Properties of Chromium Substituted Nickel Ceramic Nanopowders
Nano-ceramic of NiCrxFe2-xO4 (0.1 ≤ x ≤ 1.0) ferrites were synthesized by citrate-gel auto combustion method. The structural parameter such as lattice parameter, X-ray density, bulk density and porosity variations with Cr doping were studied. The average crystallite size is in the range 8.5–10.5 nm. The surface morphology and elemental analysis was studied with SEM (EDAX) spectrum and the structural information analyzed with FTIR spectra. Magnetic properties were discussed with Cr3+ion concentration. Electrical parameters like dc resistivity and drift mobility were reported with function of temperature and dopent concentration from room temperature to well beyond Curie temperature and explained with hopping mechanism between Fe2+↔Fe3+ ions. The activation energies in ferri and para magnetic regions were investigated. Dielectric parameters like dielectric constant, dielectric loss and ac conductivity were investigated variation with frequency and composition.
- 5 May 2021
- Published by IntechOpen
Open AccessInvestigation of Structural, Magnetic and Electrical Properties of Chromium Substituted Nickel Ceramic Nanopowders
Nano-ceramic of NiCrxFe2-xO4 (0.1 ≤ x ≤ 1.0) ferrites were synthesized by citrate-gel auto combustion method. The structural parameter such as lattice parameter, X-ray density, bulk density and porosity variations with Cr doping were studied. The average crystallite size is in the range 8.5–10.5 nm. The surface morphology and elemental analysis was studied with SEM (EDAX) spectrum and the structural information analyzed with FTIR spectra. Magnetic properties were discussed with Cr3+ion concentration. Electrical parameters like dc resistivity and drift mobility were reported with function of temperature and dopent concentration from room temperature to well beyond Curie temperature and explained with hopping mechanism between Fe2+↔Fe3+ ions. The activation energies in ferri and para magnetic regions were investigated. Dielectric parameters like dielectric constant, dielectric loss and ac conductivity were investigated variation with frequency and composition.
- 30 March 2021
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 32 (8) , 10376-10387
Crystal chemistry, Rietveld analysis, magnetic and microwave properties of Cu-doped strontium hexaferrites
- 30 March 2021
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 32 (8) , 10376-10387
Crystal chemistry, Rietveld analysis, magnetic and microwave properties of Cu-doped strontium hexaferrites
- 6 April 2017
- Published by Springer Nature in Journal of Superconductivity and Novel Magnetism
- Vol. 30 (9) , 2673-2682
Structural, Magnetic, Optical, and MEM Studies on Co-precipitated X 0 . 4 Zn 0 . 6 Fe 2 O 4 (X = Co, Mn) Nanoferrite Particles
- 6 April 2017
- Published by Springer Nature in Journal of Superconductivity and Novel Magnetism
- Vol. 30 (9) , 2673-2682
Structural, Magnetic, Optical, and MEM Studies on Co-precipitated X 0 . 4 Zn 0 . 6 Fe 2 O 4 (X = Co, Mn) Nanoferrite Particles
- 23 November 2016
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 28 (5) , 4179-4191
Effect of pH on electrical and magnetic properties of Al3Fe5O12 nanoparticles
- 23 November 2016
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 28 (5) , 4179-4191
Effect of pH on electrical and magnetic properties of Al3Fe5O12 nanoparticles
- 11 November 2014
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 44 (1) , 524-531
Structural, Magnetic, and Electrical Properties of Microwave-Sintered Cr3+-Doped Sr Hexaferrites
- 11 November 2014
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 44 (1) , 524-531
Structural, Magnetic, and Electrical Properties of Microwave-Sintered Cr3+-Doped Sr Hexaferrites
- 10 April 2013
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 113 (17) , 17C731
Magnetic field induced polarization and magnetoelectric effect of Ba0.8Ca0.2TiO3-Ni0.2Cu0.3Zn0.5Fe2O4 nanomultiferroic
The xBa0.8Ca0.2TiO3-(1 − x)NiCuZn ferrite (x = 0.1, 0.3, 0.5, 0.7, and 0.9) nanocomposites were prepared by using sol-gel method. The densification of these composites was carried out using microwave sintering method. The magnetic field induced changes in the ferroelectric polarization loop may support the possible magnetoelectric coupling between Ba0.8Ca0.2TiO3 and NiCuZn ferrite phases. The observed change in ferroelectric polarization with applied magnetic field proves the coupling between magnetic and ferroelectric order parameters. The loop change is observed with the composition and with magnetic field. The magnetoelectric coefficient of the nanocomposite with x = 0.3 shows a value of 280 mV/cm Oe is obtained.
- 10 April 2013
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 113 (17) , 17C731
Magnetic field induced polarization and magnetoelectric effect of Ba0.8Ca0.2TiO3-Ni0.2Cu0.3Zn0.5Fe2O4 nanomultiferroic
The xBa0.8Ca0.2TiO3-(1 − x)NiCuZn ferrite (x = 0.1, 0.3, 0.5, 0.7, and 0.9) nanocomposites were prepared by using sol-gel method. The densification of these composites was carried out using microwave sintering method. The magnetic field induced changes in the ferroelectric polarization loop may support the possible magnetoelectric coupling between Ba0.8Ca0.2TiO3 and NiCuZn ferrite phases. The observed change in ferroelectric polarization with applied magnetic field proves the coupling between magnetic and ferroelectric order parameters. The loop change is observed with the composition and with magnetic field. The magnetoelectric coefficient of the nanocomposite with x = 0.3 shows a value of 280 mV/cm Oe is obtained.
- Open Access
- 30 March 2012
- Published by Springer Nature in Applied Nanoscience
- Vol. 2 (3) , 203-210
Electromagnetic properties of microwave sintered xTiO2 + (1 − x) CoFe2O4 nanocomposites
- 30 March 2012
- Published by Springer Nature in Applied Nanoscience
- Vol. 2 (3) , 203-210
Open AccessElectromagnetic properties of microwave sintered xTiO2 + (1 − x) CoFe2O4 nanocomposites
- 1 December 2011
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 323 (23) , 2977-2981
A study of ultrasonic velocity and attenuation on nanocystalline MgCuZn ferrites
- 1 December 2011
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 323 (23) , 2977-2981
A study of ultrasonic velocity and attenuation on nanocystalline MgCuZn ferrites
- 17 March 2011
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 323 (16) , 2122-2128
Structural and magnetic properties of NiCuZn ferrite/SiO2 nanocomposites
- 17 March 2011
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 323 (16) , 2122-2128
Structural and magnetic properties of NiCuZn ferrite/SiO2 nanocomposites
- 12 November 2010
- Published by Taylor & Francis in Integrated Ferroelectrics
- Vol. 119 (1) , 122-134
Microwave-Hydrothermal Synthesis of Ni0.53Cu0.12Zn0.35Fe2O4/SiO2 Nanocomposites for MLCI
The nanocomposites of NiCuZnFe2O4-SiO2 were prepared using Microwave-Hydrothermal method at 160°C/45 min.The as-synthesized powders were characterized using X-ray diffraction and Transmission Electron Microscope (TEM).The average particle size of the powders were found to be ∼20 nm.The powders were densified at 900°C/30 min using Microwave sintering method. The sintered composite samples were characterized using XRD and Scanning Electron Microscopy (SEM). Crystallite size of the ferrites decreases with an increase of SiO2 content. The density of the composites varies of 93–98% of theoretical density. The densities of the present composites were increasing with the addition of SiO2. The bulk densities of the present composites were increasing with the addition of SiO2. The structural changes in these samples were characterized using Fourier Transform Infrared Spectrometer (FTIR) in the 400–4000 cm−1. The bands in the range of 580–880 cm−1 show a slight increase in intensity, which could be ascribed to the enhanced interactions between the NiCuZnFe2O4 clusters and silica matrix. The resistivity of the sintered samples was increased with an addition of ferrite content. The real and imaginary parts of permittivity and permeability were measured in the frequency range of 1 MHz–1.8 GHz.The addition of SiO2 alters the values of dielectric constant and permeability which is useful to the Multilayer Chip Inductors (MLCI) fabrication.
- 12 November 2010
- Published by Taylor & Francis in Integrated Ferroelectrics
- Vol. 119 (1) , 122-134
Microwave-Hydrothermal Synthesis of Ni0.53Cu0.12Zn0.35Fe2O4/SiO2 Nanocomposites for MLCI
The nanocomposites of NiCuZnFe2O4-SiO2 were prepared using Microwave-Hydrothermal method at 160°C/45 min.The as-synthesized powders were characterized using X-ray diffraction and Transmission Electron Microscope (TEM).The average particle size of the powders were found to be ∼20 nm.The powders were densified at 900°C/30 min using Microwave sintering method. The sintered composite samples were characterized using XRD and Scanning Electron Microscopy (SEM). Crystallite size of the ferrites decreases with an increase of SiO2 content. The density of the composites varies of 93–98% of theoretical density. The densities of the present composites were increasing with the addition of SiO2. The bulk densities of the present composites were increasing with the addition of SiO2. The structural changes in these samples were characterized using Fourier Transform Infrared Spectrometer (FTIR) in the 400–4000 cm−1. The bands in the range of 580–880 cm−1 show a slight increase in intensity, which could be ascribed to the enhanced interactions between the NiCuZnFe2O4 clusters and silica matrix. The resistivity of the sintered samples was increased with an addition of ferrite content. The real and imaginary parts of permittivity and permeability were measured in the frequency range of 1 MHz–1.8 GHz.The addition of SiO2 alters the values of dielectric constant and permeability which is useful to the Multilayer Chip Inductors (MLCI) fabrication.