Gérard Janin
Research Subjects
Gérard Janin has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
Abdelkader Dilem
Laboratoire de Biotechnologie de Tiaret, 14000 Tiaret, Algérie
1 shared publicationAhmed Haddad
Département de Foresterie, Faculté des sciences, Université de Tlemcen, Algérie
1 shared publicationAlain Marechal
LGP2 – E.F.P.G. 461, rue de la Papeterie, BP 65, 38402 St Martin d'Hères, France
1 shared publicationAli Loukkas
Parc National Thaniet El Had, 38000 Tissemsilt, Algérie
1 shared publicationBezerra Marques
1 shared publicationDominique Lachenal
LGP2 – E.F.P.G. 461, rue de la Papeterie, BP 65, 38402 St Martin d'Hères, France
1 shared publication
Latest Publications
- Open Access
- 24 December 2014
- Published by Universidad del Bio Bio in Maderas. Ciencia y Tecnología
- Vol. 16 (3) , 337-342
Effect of drying process on marupá wood color
This research was developed after consultations with tropical timber exporters, who were facing problems with the colors of the species under study. This work aimed at characterizing Simarouba amara tropical wood color and verifying possible differences between the colorimetric parameters determined for the tangential and the radial directions of the wood, kiln-dried and air-dried. S. amara wood presents a grayish-white color. This color is mainly characterized by the b* coordinate (yellow pigment). Depending on the drying method used, the wood may present different colors for both tangential and radial directions. In both drying methods conducted, the wood presented lighter color in the tangential direction. Kiln-drying appeared to reduce S. amara wood lightness.
- 24 December 2014
- Published by Universidad del Bio Bio in Maderas. Ciencia y Tecnología
- Vol. 16 (3) , 337-342
Open AccessEffect of drying process on marupá wood color
This research was developed after consultations with tropical timber exporters, who were facing problems with the colors of the species under study. This work aimed at characterizing Simarouba amara tropical wood color and verifying possible differences between the colorimetric parameters determined for the tangential and the radial directions of the wood, kiln-dried and air-dried. S. amara wood presents a grayish-white color. This color is mainly characterized by the b* coordinate (yellow pigment). Depending on the drying method used, the wood may present different colors for both tangential and radial directions. In both drying methods conducted, the wood presented lighter color in the tangential direction. Kiln-drying appeared to reduce S. amara wood lightness.
- Open Access
- 19 July 2006
- Published by EDP Sciences in Annals of Forest Science
- Vol. 63 (5) , 493-498
Caractéristiques papetières de la pâte de bois de thuya de Berbérie (Algérie) (Tetraclinis articulataVahl) obtenue par un procédé soude-anthraquinone
Le thuya de Berbérie « Tetraclinis articulata Vahl », espèce résineuse endémique d’Afrique du Nord se trouve généralement sous forme de taillis. La valorisation de la biomasse de thuya, et en particulier de son bois peut être envisagée par la filière papetière par le biais d’une cuisson soude en présence d’anthraquinone (AQ). Le bois jeune de thuya (20 ans) se délignifie bien à l’aide d’une cuisson soude-anthraquinone dans les conditions habituellement appliquées aux résineux avec un temps total de cuisson de 145 min et une température de palier de 165 ◦C. Le rendement brut obtenu est égal à 43,3 % avec un indice Kappa de 33,6. Dans les mêmes conditions de cuisson, le bois âgé (60 ans) peut être lessivé mais se délignifie moins facilement.The coniferous trees of the thuya de Berbérie (Tetraclinis articulata Vahl), from the North Africa (Algeria) is commonly grown as a coppice stand. The biomass of thuya, and especially its wood, can be transformed in pulp by the paper and pulp industry throughout the soda cooking process with the help of the anthraquinone (AQ). The young wood (20 years-old) is well delignified in the soda–anthraquinone process, in the usual conditions applied to the resinous species, in the cooking time schedule of 145 min with the level of 165 ◦C of temperature. The pulp yield of raw material obtained is 43.3% (oven dried wood), with a kappa number of: 33.6. In the same cooking conditions, the mature wood (60 years-old) can be also treated, but with some lower delignification level
- 19 July 2006
- Published by EDP Sciences in Annals of Forest Science
- Vol. 63 (5) , 493-498
Open AccessCaractéristiques papetières de la pâte de bois de thuya de Berbérie (Algérie) (Tetraclinis articulataVahl) obtenue par un procédé soude-anthraquinone
Le thuya de Berbérie « Tetraclinis articulata Vahl », espèce résineuse endémique d’Afrique du Nord se trouve généralement sous forme de taillis. La valorisation de la biomasse de thuya, et en particulier de son bois peut être envisagée par la filière papetière par le biais d’une cuisson soude en présence d’anthraquinone (AQ). Le bois jeune de thuya (20 ans) se délignifie bien à l’aide d’une cuisson soude-anthraquinone dans les conditions habituellement appliquées aux résineux avec un temps total de cuisson de 145 min et une température de palier de 165 ◦C. Le rendement brut obtenu est égal à 43,3 % avec un indice Kappa de 33,6. Dans les mêmes conditions de cuisson, le bois âgé (60 ans) peut être lessivé mais se délignifie moins facilement.The coniferous trees of the thuya de Berbérie (Tetraclinis articulata Vahl), from the North Africa (Algeria) is commonly grown as a coppice stand. The biomass of thuya, and especially its wood, can be transformed in pulp by the paper and pulp industry throughout the soda cooking process with the help of the anthraquinone (AQ). The young wood (20 years-old) is well delignified in the soda–anthraquinone process, in the usual conditions applied to the resinous species, in the cooking time schedule of 145 min with the level of 165 ◦C of temperature. The pulp yield of raw material obtained is 43.3% (oven dried wood), with a kappa number of: 33.6. In the same cooking conditions, the mature wood (60 years-old) can be also treated, but with some lower delignification level
- Open Access
- 1 September 2004
- Published by EDP Sciences in Annals of Forest Science
- Vol. 61 (6) , 589-595
Propriétés physiques du bois d'éclaircie des cèdres (Cedrus atlantica), contenant du bois de compression, provenant de l’Atlas du Djurdjura (Algérie)
Annals of Forest Science, is a source of information about current developments and trends in forest research and forestry
- 1 September 2004
- Published by EDP Sciences in Annals of Forest Science
- Vol. 61 (6) , 589-595
Open AccessPropriétés physiques du bois d'éclaircie des cèdres (Cedrus atlantica), contenant du bois de compression, provenant de l’Atlas du Djurdjura (Algérie)
Annals of Forest Science, is a source of information about current developments and trends in forest research and forestry
- Open Access
- 1 January 2003
- Published by SciELO Agencia Nacional de Investigacion y Desarrollo (ANID) in Maderas. Ciencia y Tecnología
- Vol. 5 (2) , 153-161
APRECIACIÓN CUANTITATIVA DEL COLOR DE LA MADERA POR COLORIMETRÍA: PARTE 2: MEDICIONES DE LOS CAMBIOS DE COLOR EN PINO RADIATA (PINUS RADIATA) SECADO BAJO UN PROGRAMA CONVENCIONAL ACELERADO
En la primera parte de este trabajo se presentaron las bases teóricas en las que se sustenta la medición cuantitativa y objetiva del color de un material. En base al sistema CIELab, se cuantifican los cambios de color de la madera de pino radiata Pinus radiata observados durante el secado industrial bajo un programa convencional acelerado. Los resultados confirman que las mediciones cuantitativas del color en la superficie de la madera permiten detectar la presencia de los cambios de color productos del secado por debajo de la superficie hasta una profundidad de 3 mm. Tales cambios de color son influenciados por la heterogeneidad de los anillos de crecimiento: relación madera inicial/madera final y el ancho de anillos. Además permiten adaptar el programa de secado de acuerdo al nivel de intensidad de la coloración permitida. _______________________________________________________________________________ ABSTRACTOn the first part of this work the colorimetry theory for the CIELAB system was presented. In this paper the drying discoloration of radiata pine Pinus radiata at accelerated temperature was measured quantitatively and objectively. The results showed that the kiln brown drying would be detected until 3 mm below the surface by colorimetry and that this parameters values were influenced by the heterogeneity of the annual ring: earlywood/latewood relation and annual ring width. Also this measurements of the wood colour changes can allow to adjust the drying schedule in according to the coloration intensity allowed
- 1 January 2003
- Published by SciELO Agencia Nacional de Investigacion y Desarrollo (ANID) in Maderas. Ciencia y Tecnología
- Vol. 5 (2) , 153-161
Open AccessAPRECIACIÓN CUANTITATIVA DEL COLOR DE LA MADERA POR COLORIMETRÍA: PARTE 2: MEDICIONES DE LOS CAMBIOS DE COLOR EN PINO RADIATA (PINUS RADIATA) SECADO BAJO UN PROGRAMA CONVENCIONAL ACELERADO
En la primera parte de este trabajo se presentaron las bases teóricas en las que se sustenta la medición cuantitativa y objetiva del color de un material. En base al sistema CIELab, se cuantifican los cambios de color de la madera de pino radiata Pinus radiata observados durante el secado industrial bajo un programa convencional acelerado. Los resultados confirman que las mediciones cuantitativas del color en la superficie de la madera permiten detectar la presencia de los cambios de color productos del secado por debajo de la superficie hasta una profundidad de 3 mm. Tales cambios de color son influenciados por la heterogeneidad de los anillos de crecimiento: relación madera inicial/madera final y el ancho de anillos. Además permiten adaptar el programa de secado de acuerdo al nivel de intensidad de la coloración permitida. _______________________________________________________________________________ ABSTRACTOn the first part of this work the colorimetry theory for the CIELAB system was presented. In this paper the drying discoloration of radiata pine Pinus radiata at accelerated temperature was measured quantitatively and objectively. The results showed that the kiln brown drying would be detected until 3 mm below the surface by colorimetry and that this parameters values were influenced by the heterogeneity of the annual ring: earlywood/latewood relation and annual ring width. Also this measurements of the wood colour changes can allow to adjust the drying schedule in according to the coloration intensity allowed