Dirk Goossens
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Dirk Goossens has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
Jens Gross
Geological Survey of Lower Saxony (NLfB), Institute of Soil Technology, Friedrich-Missler-Strasse 46-50, D-28211 Bremen, Germany
2 shared publicationsWim Spaan
Erosion and Soil and Water Conservation Group, Wageningen Agricultural University and Research Centre, Nieuwe Kanaal 11, NL-6709 PA Wageningen, The Netherlands
2 shared publications- Jean Poesen
Department of Earth and Environmental Sciences, KU Leuven, Leuven, Belgium
1 shared publication
Latest Publications
- 11 July 2005
- Published by Wiley in Sedimentology
- Vol. 52 (4) , 859-873
Quantification of the dry aeolian deposition of dust on horizontal surfaces: an experimental comparison of theory and measurements
Eight techniques to quantify the deposition of aeolian dust on horizontal surfaces were tested in a wind tunnel. The tests included three theoretical techniques and five measurement techniques. The theoretical techniques investigated were: the gradient technique, the inferential technique without grain‐shape correction, and the inferential technique corrected for grain shape. The measuring techniques included the following surrogate surfaces: a water surface, a glass surface, a metal surface, a vertical array of metal plates, and an inverted frisbee filled with glass marbles. The efficiency of the techniques was investigated for the sediment as a whole (all grain sizes together) as well as for a large number of grain sizes extending from 1 to 104 μm. The surrogate surfaces showed more or less comparable catch efficiencies, although the water surface nearly always caught the highest quantities of dust and the marble‐filled frisbee and the vertical array of metal plates the lowest quantities of dust. The dust fluxes calculated by theoretical methods were markedly different from those obtained by direct measurements. The fluxes calculated by the inferential technique approximated those of the direct measurements only for grain sizes between 30 and 40 μm. For smaller and coarser grains, deviations from the measured fluxes were high. The gradient method, in its turn, provided extremely low calculated fluxes for grains in all size classes investigated. The latter technique was not considered very reliable for the dust used in the tests.
- 11 July 2005
- Published by Wiley in Sedimentology
- Vol. 52 (4) , 859-873
Quantification of the dry aeolian deposition of dust on horizontal surfaces: an experimental comparison of theory and measurements
Eight techniques to quantify the deposition of aeolian dust on horizontal surfaces were tested in a wind tunnel. The tests included three theoretical techniques and five measurement techniques. The theoretical techniques investigated were: the gradient technique, the inferential technique without grain‐shape correction, and the inferential technique corrected for grain shape. The measuring techniques included the following surrogate surfaces: a water surface, a glass surface, a metal surface, a vertical array of metal plates, and an inverted frisbee filled with glass marbles. The efficiency of the techniques was investigated for the sediment as a whole (all grain sizes together) as well as for a large number of grain sizes extending from 1 to 104 μm. The surrogate surfaces showed more or less comparable catch efficiencies, although the water surface nearly always caught the highest quantities of dust and the marble‐filled frisbee and the vertical array of metal plates the lowest quantities of dust. The dust fluxes calculated by theoretical methods were markedly different from those obtained by direct measurements. The fluxes calculated by the inferential technique approximated those of the direct measurements only for grain sizes between 30 and 40 μm. For smaller and coarser grains, deviations from the measured fluxes were high. The gradient method, in its turn, provided extremely low calculated fluxes for grains in all size classes investigated. The latter technique was not considered very reliable for the dust used in the tests.
- 15 April 2005
- Published by Wiley in Earth Surface Processes and Landforms
- Vol. 30 (4) , 443-460
Effect of rock fragment embedding on the aeolian deposition of dust on stone‐covered surfaces
Many stone‐covered surfaces on Earth are subject to aeolian deposition of atmospheric dust. This study investigates how the deposition of dust is affected when rock fragments become gradually more embedded in the ground or, inversely, become more concentrated on the surface. Experiments were executed in an aeolian dust wind tunnel with eight different types of pebbles. The following parameters were measured: dust deposition on the pebbles, dust deposition between and underneath pebbles, total dust deposition (pebbles + inter‐pebble space), and the fraction, of total deposition, of dust caught by the pebbles alone. The absolute amount of dust deposition and the dust deposition density (dust deposition per unit surface) were studied for each parameter. The effects exerted by pebble size, pebble flattening, pebble elongation and wind speed were also investigated. Dust patterns on and around pebbles were also studied via flow visualization.The absolute amount of dust settling on pebbles decreases the more that the pebbles become embedded. Dust deposition density on pebbles, on the other hand, increases with embedding. The more pebbles become embedded in the soil, the more efficient the process of dust deposition on pebbles becomes. Dust deposition between and underneath pebbles increases with pebble embedding. Dust deposition density between and underneath pebbles is maximum at 50 per cent embedding, showing that in this area dust deposition is most efficient when pebbles are halfway embedded. Total deposition slightly decreases the more pebbles become embedded, but total dust deposition density increases with embedding.Aerodynamic flow separation and diverging and converging airflow play an important role in the process of dust deposition on stone‐covered surfaces. The more pebbles protrude above the soil, the more they act as an obstacle and the more they disturb the air and dust flow creating scouring zones, flow separation bubbles and shelter areas for the dust. All these effects diminish as pebbles become more embedded in the soil. However, perturbations in dust patterns remain visible until pebbles have disappeared entirely. Copyright © 2005 John Wiley & Sons, Ltd.
- 15 April 2005
- Published by Wiley in Earth Surface Processes and Landforms
- Vol. 30 (4) , 443-460
Effect of rock fragment embedding on the aeolian deposition of dust on stone‐covered surfaces
Many stone‐covered surfaces on Earth are subject to aeolian deposition of atmospheric dust. This study investigates how the deposition of dust is affected when rock fragments become gradually more embedded in the ground or, inversely, become more concentrated on the surface. Experiments were executed in an aeolian dust wind tunnel with eight different types of pebbles. The following parameters were measured: dust deposition on the pebbles, dust deposition between and underneath pebbles, total dust deposition (pebbles + inter‐pebble space), and the fraction, of total deposition, of dust caught by the pebbles alone. The absolute amount of dust deposition and the dust deposition density (dust deposition per unit surface) were studied for each parameter. The effects exerted by pebble size, pebble flattening, pebble elongation and wind speed were also investigated. Dust patterns on and around pebbles were also studied via flow visualization.The absolute amount of dust settling on pebbles decreases the more that the pebbles become embedded. Dust deposition density on pebbles, on the other hand, increases with embedding. The more pebbles become embedded in the soil, the more efficient the process of dust deposition on pebbles becomes. Dust deposition between and underneath pebbles increases with pebble embedding. Dust deposition density between and underneath pebbles is maximum at 50 per cent embedding, showing that in this area dust deposition is most efficient when pebbles are halfway embedded. Total deposition slightly decreases the more pebbles become embedded, but total dust deposition density increases with embedding.Aerodynamic flow separation and diverging and converging airflow play an important role in the process of dust deposition on stone‐covered surfaces. The more pebbles protrude above the soil, the more they act as an obstacle and the more they disturb the air and dust flow creating scouring zones, flow separation bubbles and shelter areas for the dust. All these effects diminish as pebbles become more embedded in the soil. However, perturbations in dust patterns remain visible until pebbles have disappeared entirely. Copyright © 2005 John Wiley & Sons, Ltd.
- 28 September 2001
- Published by Wiley in Earth Surface Processes and Landforms
- Vol. 26 (11) , 1213-1219
The aeolian dust accumulation curve
This article presents a simple physical concept of aeolian dust accumulation, based on the behaviour of the subprocesses of dust deposition and dust erosion. The concept is tested in an aeolian dust wind tunnel. The agreement between the accumulation curve predicted by the model and the accumulation curve obtained in the experiments is close to perfect and shows that it is necessary to discriminate between the processes of aeolian dust deposition and aeolian dust accumulation. Two important thresholds determine the accumulation process. For wind speeds below the deflation threshold, the aeolian accumulation of dust increases linearly with the wind speed. For wind velocities between the deflation threshold and the accumulation limit, the sedimentation balance is above unity and there is still accumulation, though it rapidly drops once the deflation threshold has been exceeded. At wind speeds beyond the accumulation limit, the sedimentation balance is below unity and there will no longer be an accumulation of dust. The thresholds have been determined in a wind tunnel test at friction velocity u* = 0·34 m s−1 (deflation threshold) and u* = 0·43 m s−1 (accumulation limit), but these values are only indicative since they depend heavily on the characteristics of the accumulation surface and of the airborne grains. Copyright © 2001 John Wiley & Sons, Ltd.
- 28 September 2001
- Published by Wiley in Earth Surface Processes and Landforms
- Vol. 26 (11) , 1213-1219
The aeolian dust accumulation curve
This article presents a simple physical concept of aeolian dust accumulation, based on the behaviour of the subprocesses of dust deposition and dust erosion. The concept is tested in an aeolian dust wind tunnel. The agreement between the accumulation curve predicted by the model and the accumulation curve obtained in the experiments is close to perfect and shows that it is necessary to discriminate between the processes of aeolian dust deposition and aeolian dust accumulation. Two important thresholds determine the accumulation process. For wind speeds below the deflation threshold, the aeolian accumulation of dust increases linearly with the wind speed. For wind velocities between the deflation threshold and the accumulation limit, the sedimentation balance is above unity and there is still accumulation, though it rapidly drops once the deflation threshold has been exceeded. At wind speeds beyond the accumulation limit, the sedimentation balance is below unity and there will no longer be an accumulation of dust. The thresholds have been determined in a wind tunnel test at friction velocity u* = 0·34 m s−1 (deflation threshold) and u* = 0·43 m s−1 (accumulation limit), but these values are only indicative since they depend heavily on the characteristics of the accumulation surface and of the airborne grains. Copyright © 2001 John Wiley & Sons, Ltd.
- 20 June 2001
- Published by Wiley in Earth Surface Processes and Landforms
- Vol. 26 (7) , 701-720
Aeolian dust dynamics in agricultural land areas in Lower Saxony, Germany
The dynamics of fine aeolian dust emitted from agricultural land was investigated over 15 months near Grönheim, Lower Saxony, Germany. The following aspects were studied: airborne dust concentration, the ratio of mineral versus organic dust, the vertical distribution of the particles in the atmosphere, horizontal and vertically integrated horizontal dust flux, vertical dust flux, dust deposition at ground level, grain‐size distribution of the mineral dust component, and vertical distribution of organic matter in the dust. Standard meteorological parameters (wind speed and direction, precipitation) were measured as well. Dust activity in Grönheim is high in spring (March–May) and autumn (October–November) and low to very low during the rest of the year. There is a strong relationship between the periods of tillage and the intensity of dust activity. Also, there is high dust activity during wind erosion events. For the year 1999, dust emission due to tillage was 6·6 times higher than dust emission due to wind erosion. A dust transport of 15·8 ton km−1 a−1 was calculated for the first 10 m of the atmosphere in 1999. Total dust transport (in the entire mixing layer) was estimated between 16 and 20 ton km−1 a−1. About 25–30 per cent of this dust is mineral dust, emitted from the fields during tillage or during wind erosion events. In spring and autumn there is a strong vertical stratification in the airborne sediment, with much (coarse) dust in the lower air layers and significantly less (and finer) dust at higher altitudes. In summer and winter, when there is no local dust production, there is no stratification: equal amounts of dust are transported at all heights. The stratification in spring and autumn is exclusively caused by the mineral part of the dust. The organic particles are much better mixed in the atmosphere because of their lower density. Copyright © 2001 John Wiley & Sons, Ltd.
- 20 June 2001
- Published by Wiley in Earth Surface Processes and Landforms
- Vol. 26 (7) , 701-720
Aeolian dust dynamics in agricultural land areas in Lower Saxony, Germany
The dynamics of fine aeolian dust emitted from agricultural land was investigated over 15 months near Grönheim, Lower Saxony, Germany. The following aspects were studied: airborne dust concentration, the ratio of mineral versus organic dust, the vertical distribution of the particles in the atmosphere, horizontal and vertically integrated horizontal dust flux, vertical dust flux, dust deposition at ground level, grain‐size distribution of the mineral dust component, and vertical distribution of organic matter in the dust. Standard meteorological parameters (wind speed and direction, precipitation) were measured as well. Dust activity in Grönheim is high in spring (March–May) and autumn (October–November) and low to very low during the rest of the year. There is a strong relationship between the periods of tillage and the intensity of dust activity. Also, there is high dust activity during wind erosion events. For the year 1999, dust emission due to tillage was 6·6 times higher than dust emission due to wind erosion. A dust transport of 15·8 ton km−1 a−1 was calculated for the first 10 m of the atmosphere in 1999. Total dust transport (in the entire mixing layer) was estimated between 16 and 20 ton km−1 a−1. About 25–30 per cent of this dust is mineral dust, emitted from the fields during tillage or during wind erosion events. In spring and autumn there is a strong vertical stratification in the airborne sediment, with much (coarse) dust in the lower air layers and significantly less (and finer) dust at higher altitudes. In summer and winter, when there is no local dust production, there is no stratification: equal amounts of dust are transported at all heights. The stratification in spring and autumn is exclusively caused by the mineral part of the dust. The organic particles are much better mixed in the atmosphere because of their lower density. Copyright © 2001 John Wiley & Sons, Ltd.
- 1 April 2000
- Published by EDP Sciences in Agronomy for Sustainable Development
- Vol. 20 (3) , 271-282
Splash drift on light sandy soils: a field experiment
Agronomy for Sustainable Development, An International Journal in Agriculture and Environment
- 1 April 2000
- Published by EDP Sciences in Agronomy for Sustainable Development
- Vol. 20 (3) , 271-282
Splash drift on light sandy soils: a field experiment
Agronomy for Sustainable Development, An International Journal in Agriculture and Environment