K. Osamura
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
K. Osamura has a total of 43 co-authors. Here are the top co-authors by number of shared publications:
- M. Sugano
High Energy Accelerator Research Organization, Tsukuba, Japan
3 shared publications - A. Nyilas
Forschungszentrum Karlsruhe, Institute for Technical Physics, D‐76021 Karlsruhe, Germany
2 shared publications - Gen Nishijima
National Institute for Materials Science (NIMS), Tsukuba, Japan
2 shared publications K Yamamoto
2 shared publications- Shojiro Ochiai
Kyoto University
2 shared publications - Akira Ibi
National Institute of Advanced Industrial Science and Technology, Tsukuba, Japan
1 shared publication
Latest Publications
- 2 July 2014
- Published by IOP Publishing in Superconductor Science and Technology
- Vol. 27 (8) , 85009
International round robin test for mechanical properties of REBCO superconductive tapes at room temperature
- 2 July 2014
- Published by IOP Publishing in Superconductor Science and Technology
- Vol. 27 (8) , 85009
International round robin test for mechanical properties of REBCO superconductive tapes at room temperature
- 10 November 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 22 (3) , 6600504
Strain Dependence of Superconducting Properties for GdBCO Coated Conductor in High Field Under Tensile Load
The strain dependence of Tc and Ic for the GdBCO coated conductor was measured at 77 and 4.2 K in magnetic fields. Tc decreased with increasing applied tensile strain. For the Ic measurements, the magnetic field was applied in the direction parallel to the c-axis (perpendicular to the tape surface). Ic in fields was degraded with increasing strain, and the strain dependence of Ic increased with increasing magnetic field. The ratio of the Ic degradation at 4.2 K was smaller than that at 77 K. These results mean that the Tc degradation is one of the reasons for Ic degradation at 77 K at least. Further, in order to understand the strain effect at 4.2 K, the internal strain of the GdBCO coated conductor under tensile strain was measured using synchrotron radiation. It was found that the strain behavior for the a-axis is different from that for the b-axis. This result suggests that the strain dependence of Ic for GdBCO coated conductors under external tensile strain is related with the Tc degradation behavior of the crystal.
- 10 November 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 22 (3) , 6600504
Strain Dependence of Superconducting Properties for GdBCO Coated Conductor in High Field Under Tensile Load
The strain dependence of Tc and Ic for the GdBCO coated conductor was measured at 77 and 4.2 K in magnetic fields. Tc decreased with increasing applied tensile strain. For the Ic measurements, the magnetic field was applied in the direction parallel to the c-axis (perpendicular to the tape surface). Ic in fields was degraded with increasing strain, and the strain dependence of Ic increased with increasing magnetic field. The ratio of the Ic degradation at 4.2 K was smaller than that at 77 K. These results mean that the Tc degradation is one of the reasons for Ic degradation at 77 K at least. Further, in order to understand the strain effect at 4.2 K, the internal strain of the GdBCO coated conductor under tensile strain was measured using synchrotron radiation. It was found that the strain behavior for the a-axis is different from that for the b-axis. This result suggests that the strain dependence of Ic for GdBCO coated conductors under external tensile strain is related with the Tc degradation behavior of the crystal.
- 8 August 2003
- Published by IOP Publishing in Superconductor Science and Technology
- Vol. 16 (9) , 1052-1058
Mechanical and superconducting properties of PIT-processed MgB2wire after heat treatment
The mechanical and superconducting properties of MgB2 wires heat treated at various conditions have been investigated. Superconducting MgB2 wires, fabricated by the powder-in-tube (PIT) method, show a transition temperature Tc at 32.4 K for the as-rolled wire as shown by dc-resistivity measurement. It is found that the Tc is improved (37.3–38.4 K) by subsequent Ar annealing treatment under various sintering temperatures and times. Remarkably, the annealed samples show significant improvement in the overall quality of the samples. On annealing at 1323 K for 0.6 ks, we obtained the best quality sample with a Jc of 470 A mm−2 at 2.0 T. In order to find out the irreversible field (Birr), the technique of the Kramer plot was applied. The Birr obtained was 7.6 and 9.6 T, for the as-rolled as well as the annealed samples at 1073 K for 3.6 ks, respectively. The mechanical properties were measured under tensile load. The yield stress was 450 MPa for the as-rolled sample and decreased by annealing at 1323 K for 0.6 ks to 110 MPa. After the wires were heat treated at temperatures between 1073 and 1323 K and tensile-stressed up to their yield stress at room temperature. The critical current measurements were carried on such samples at 4.2 K under applied magnetic fields of 2 and 5 T. The stress level for the 95% tolerance of critical current was determined to 97 MPa.
- 8 August 2003
- Published by IOP Publishing in Superconductor Science and Technology
- Vol. 16 (9) , 1052-1058
Mechanical and superconducting properties of PIT-processed MgB2wire after heat treatment
The mechanical and superconducting properties of MgB2 wires heat treated at various conditions have been investigated. Superconducting MgB2 wires, fabricated by the powder-in-tube (PIT) method, show a transition temperature Tc at 32.4 K for the as-rolled wire as shown by dc-resistivity measurement. It is found that the Tc is improved (37.3–38.4 K) by subsequent Ar annealing treatment under various sintering temperatures and times. Remarkably, the annealed samples show significant improvement in the overall quality of the samples. On annealing at 1323 K for 0.6 ks, we obtained the best quality sample with a Jc of 470 A mm−2 at 2.0 T. In order to find out the irreversible field (Birr), the technique of the Kramer plot was applied. The Birr obtained was 7.6 and 9.6 T, for the as-rolled as well as the annealed samples at 1073 K for 3.6 ks, respectively. The mechanical properties were measured under tensile load. The yield stress was 450 MPa for the as-rolled sample and decreased by annealing at 1323 K for 0.6 ks to 110 MPa. After the wires were heat treated at temperatures between 1073 and 1323 K and tensile-stressed up to their yield stress at room temperature. The critical current measurements were carried on such samples at 4.2 K under applied magnetic fields of 2 and 5 T. The stress level for the 95% tolerance of critical current was determined to 97 MPa.
- 13 May 2002
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 614 (1) , 485
Change of critical current of Ag/Bi2223 tapes under fatigue test
Fatigue behavior of critical current at 77 K under cyclic loading in Ag/Bi2223 multifilamentary tapes has been studied. The change of as a function of number of cycles can be divided into three stages: decreases gradually within a few hundreds of fatigue cycles (stage A); Then is kept at a certain value (stage B) and after stage B, starts to decrease again and soon after that the overall fracture of tapes takes place (stage C). From the result of microstructural observation, it was confirmed that some oxide filaments were fractured in stage A. The fracture surface of Ag matrix in the tape varies from a ductile pattern under static loading to a brittle one under cyclic loading. For the sample, of which started to decrease again after stage B, the static tensile test was carried out. As a result, the fracture strength is lower than the average tensile strength, and in the stress-strain curve the region of work hardening of Ag is not observed. Some fatigue cracks were found in the Ag matrix adjacent to fractured oxide filaments in stage B. These results indicate that the change of in stage A and stage C is caused by different mechanisms. The reduction in stage A is caused by fracture of some oxide filaments with low strength, while the degradation in stage C is related to the propagation of fatigue cracks initiated from Ag matrix around the fractured filaments.- 13 May 2002
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 614 (1) , 485
Change of critical current of Ag/Bi2223 tapes under fatigue test
Fatigue behavior of critical current at 77 K under cyclic loading in Ag/Bi2223 multifilamentary tapes has been studied. The change of as a function of number of cycles can be divided into three stages: decreases gradually within a few hundreds of fatigue cycles (stage A); Then is kept at a certain value (stage B) and after stage B, starts to decrease again and soon after that the overall fracture of tapes takes place (stage C). From the result of microstructural observation, it was confirmed that some oxide filaments were fractured in stage A. The fracture surface of Ag matrix in the tape varies from a ductile pattern under static loading to a brittle one under cyclic loading. For the sample, of which started to decrease again after stage B, the static tensile test was carried out. As a result, the fracture strength is lower than the average tensile strength, and in the stress-strain curve the region of work hardening of Ag is not observed. Some fatigue cracks were found in the Ag matrix adjacent to fractured oxide filaments in stage B. These results indicate that the change of in stage A and stage C is caused by different mechanisms. The reduction in stage A is caused by fracture of some oxide filaments with low strength, while the degradation in stage C is related to the propagation of fatigue cracks initiated from Ag matrix around the fractured filaments.- 26 April 2002
- Published by IOP Publishing in Superconductor Science and Technology
- Vol. 15 (6) , 888-893
The tensile property of commercial Bi2223 tapes: a report on the international round-robin test
- 26 April 2002
- Published by IOP Publishing in Superconductor Science and Technology
- Vol. 15 (6) , 888-893
The tensile property of commercial Bi2223 tapes: a report on the international round-robin test