J. C. Greeff

Genetic parameters for carcass and meat quality traits of about 18‐month‐old Merino rams (n = 5870), the progeny of 543 sires from three research resource flocks, were estimated. The estimates of heritability for hot carcass weight (HCW) and the various fat and muscle dimension measurements were moderate and ranged from 0.20 to 0.37. The brightness of meat (colour L*, 0.18 ± 0.03 standard error) and meat pH (0.22 ± 0.03) also had moderate estimates of heritability, although meat relative redness (colour a*, 0.10 ± 0.03) and relative yellowness (colour b*, 0.10 ± 0.03) were lower. Heritability estimates for live weights were moderate and ranged from 0.29 to 0.41 with significant permanent maternal environmental effects (0.13 to 0.10). The heritability estimates for the hogget wool traits were moderate to high and ranged from 0.27 to 0.60. The ultrasound measurements of fat depth (FATUS) and eye muscle depth (EMDUS) on live animals were highly genetically correlated with the corresponding carcass measurements (0.69 ± 0.09 FATC and 0.77 ± 0.07 EMD). Carcass tissue depth (FATGR) had moderate to low genetic correlations with carcass muscle measurements [0.18 ± 0.10 EMD and 0.05 ± 0.10 eye muscle area (EMA)], while those with FATC were negative. The genetic correlation between EMD and eye muscle width (EMW) was 0.41 ± 0.08, while EMA was highly correlated with EMD (0.89 ± 0.0) and EMW (0.78 ± 0.04). The genetic correlations for muscle colour with muscle measurements were moderately negative, while those with fat measurements were close to zero. Meat pH was positively correlated with muscle measurements (0.14 to 0.17) and negatively correlated with fat measurements (−0.06 to −0.18). EMDUS also showed a similar pattern of correlations to EMD with meat quality indicator traits, although FATUS had positive correlations with these traits which were generally smaller than their standard error. The genetic correlations among the meat colour traits were high and positive while those with meat pH were high and negative, which were all in the favourable direction. Generally, phenotypic correlations were similar or slightly lower than the corresponding genetic correlations. There were generally small to moderate negative genetic correlations between clean fleece weight (CFW) and carcass fat traits while those with muscle traits were close to zero. As the Merino is already a relatively lean breed, this implies that particular attention should be given to this relationship in Merino breeding programmes to prevent the reduction of fat reserves as a correlated response to selection for increased fleece weight. The ultrasound scan traits generally showed a similar pattern to the corresponding carcass fat and muscle traits. There was a small unfavourable genetic correlation between CFW and meat pH (0.19 ± 0.07).

Genetic changes for clean fleece weight, fibre diameter and hogget body weight were determined in the Katanning Merino Resource flocks from 1982 to 2004. From 1982 to 1992 genetic trends are presented for individual studs that used mainly subjective classing selection methods (Phase 1) and the genetic trends from 1997 to 2004 demonstrate the genetic changes that can be achieved from using estimated breeding values calculated from best linear unbiased prediction (BLUP) mixed methodology (Phase 2). The results during the first phase show that very few genetic changes occurred in most studs, except for the 4 studs of the Performance Sheep Breeding strain which showed genetic increases in hogget body weight. The genetic trends show that some studs generated change towards their breeding objective, while others show no changes or changes in the opposite direction. In contrast, the use of BLUP estimated breeding values resulted in positive changes in clean fleece weight, fibre diameter and body weight in accordance with the defined breeding objectives.

Fibre diameter can vary dramatically along a wool staple, especially in the Mediterranean environment of southern Australia with its dry summers and abundance of green feed in spring. Other research results have shown a very low phenotypic correlation between fibre diameter grown between seasons. Many breeders use short staples to measure fibre diameter for breeding purposes and also to promote animals for sale. The effectiveness of this practice is determined by the relative response to selection by measuring fibre traits on a full 12 months wool staple as compared to measuring them only on part of a staple. If a high genetic correlation exists between the part record and the full record, then using part records may be acceptable to identify genetically superior animals. No information is available on the effectiveness of part records. This paper investigated whether wool growth and fibre diameter traits of Merino wool grown at different times of the year in a Mediterranean environment, are genetically the same trait, respectively. The work was carried out on about 7 dyebanded wool sections/animal.year, on ewes from weaning to hogget age, in the Katanning Merino resource flocks over 6 years. Relative clean wool growth of the different sections had very low heritability estimates of less than 0.10, and they were phenotypically and genetically poorly correlated with 6 or 12 months wool growth. This indicates that part record measurement of clean wool growth of these sections will be ineffective as indirect selection criteria to improve wool growth genetically. Staple length growth as measured by the length between dyebands, would be more effective with heritability estimates of between 0.20 and 0.30. However, these measurements were shown to have a low genetic correlation with wool grown for 12 months which implies that these staple length measurements would only be half as efficient as the wool weight for 6 or 12 months to improve total clean wool weight. Heritability estimates of fibre diameter, coefficient of variation of fibre diameter and fibre curvature were relatively high and were genetically and phenotypically highly correlated across sections. High positive phenotypic and genetic correlations were also found between fibre diameter, coefficient of variation of fibre diameter and fibre curvature of the different sections and similar measurements for wool grown over 6 or 12 months. Coefficient of variation of fibre diameter of the sections also had a moderate negative phenotypic and genetic correlation with staple strength of wool staples grown over 6 months indicating that coefficient of variation of fibre diameter of any section would be as good an indirect selection criterion to improve stable strength as coefficient of variation of fibre diameter for wool grown over 6 or 12 months. The results indicate that fibre diameter, coefficient of variation of fibre diameter and fibre curvature of wool grown over short periods of time have virtually the same heritability as that of wool grown over 12 months, and that the genetic correlation between fibre diameter, coefficient of variation of fibre diameter and fibre curvature on part and on full records is very high (rg >0.85). This indicates that fibre diameter, coefficient of variation of fibre diameter and fibre curvature on part records can be used as selection criteria to improve these traits. However, part records of greasy and clean wool growth would be much less efficient than fleece weight for wool grown over 6 or 12 months because of the low heritability of part records and the low genetic correlation between these traits on part records and on wool grown for 12 months.