Ton Spee
Ton Spee has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
Jeroen Terwoert
IVAM, University of Amsterdam, NL‐1001 ZB Amsterdam, The Netherlands
2 shared publicationsCon I Boeckhout
1 shared publicationCor VAN Duivenbooden
Arbouw, NL‐1005 AC Amsterdam, The Netherlands
1 shared publicationCor van Duivenbooden
1 shared publicationDook Noy
Arbo Unie PO Box 95030, 1090 HA Amsterdam, The Netherlands
1 shared publicationEsther VAN DE Rijdt-Van Hoof
Océ Technologies PO Box 101, 5600 JZ Eindhoven, The Netherlands
1 shared publication
Latest Publications
- 1 August 2012
- Published by Elsevier in NeuroToxicology
- Vol. 33 (4) , 727-733
A screening programme on chronic solvent-induced encephalopathy among Dutch painters
- 1 August 2012
- Published by Elsevier in NeuroToxicology
- Vol. 33 (4) , 727-733
A screening programme on chronic solvent-induced encephalopathy among Dutch painters
- Open Access
- 28 November 2006
- Published by Oxford University Press (OUP) in Annals of Occupational Hygiene
- Vol. 51 (3) , 241-248
Exposure to Wood Dust Among Carpenters in the Construction Industry in The Netherlands
Exposure to wood dust was measured among 26 carpenters at 13 building projects. Sampling days were chosen randomly. Individual tasks, based on technology applied and material used during a working day, were sampled separately. From these task-based measurements, 8 h time-weighted average concentrations were calculated. Sampling was performed in accordance with a protocol that was developed by the carpentry and furniture industry and which was especially designed for sampling of wood dust. Eight hours time-weighted average exposure to wood dust ranged from 0.8 to 11.6 mg m−3 with a geometric mean (GM) of 3.3 mg m−3 and a geometric standard deviation (GSD) of 2.1. The probability of exceedance of the OEL, when comparing the estimated concentrations against the Dutch OEL of 2 mg m−3, was 75%. The highest exposures were measured during sawing of Cempanel sheets. Task-based measurements showed lowest exposures when working outdoors (n = 11, AM = 2.2 mg m−3), but even then 5 out of 11 task-based exposures exceeded 2 mg m−3. Indoors the exposure was 5.2 mg m−3 (AM, n = 29) and when working both indoors and outdoors exposure was 16.2 mg m−3 (AM, n = 4). In conclusion, long-term average exposure to wood dust among carpenters at construction sites is more than 1.5 times the present occupational exposure limit of 2 mg m−3. The estimated probability of exceedance of the OEL was 75% and a reduction of exposure with a factor 5 is needed to bring the probability of exceedance below 5%. It is intended to lower the exposure limit to 1 mg m−3 by 1 January 2007. In that case the probability of exceedance of the OEL is 95% and a reduction of exposure with a factor 10 is needed to bring the probability of exceedance below 5%. This can be achieved by using alternative materials, preparation of building material in workshops equipped with exposure controls, alternative equipment and improved ventilation and good housekeeping.
- 28 November 2006
- Published by Oxford University Press (OUP) in Annals of Occupational Hygiene
- Vol. 51 (3) , 241-248
Open AccessExposure to Wood Dust Among Carpenters in the Construction Industry in The Netherlands
Exposure to wood dust was measured among 26 carpenters at 13 building projects. Sampling days were chosen randomly. Individual tasks, based on technology applied and material used during a working day, were sampled separately. From these task-based measurements, 8 h time-weighted average concentrations were calculated. Sampling was performed in accordance with a protocol that was developed by the carpentry and furniture industry and which was especially designed for sampling of wood dust. Eight hours time-weighted average exposure to wood dust ranged from 0.8 to 11.6 mg m−3 with a geometric mean (GM) of 3.3 mg m−3 and a geometric standard deviation (GSD) of 2.1. The probability of exceedance of the OEL, when comparing the estimated concentrations against the Dutch OEL of 2 mg m−3, was 75%. The highest exposures were measured during sawing of Cempanel sheets. Task-based measurements showed lowest exposures when working outdoors (n = 11, AM = 2.2 mg m−3), but even then 5 out of 11 task-based exposures exceeded 2 mg m−3. Indoors the exposure was 5.2 mg m−3 (AM, n = 29) and when working both indoors and outdoors exposure was 16.2 mg m−3 (AM, n = 4). In conclusion, long-term average exposure to wood dust among carpenters at construction sites is more than 1.5 times the present occupational exposure limit of 2 mg m−3. The estimated probability of exceedance of the OEL was 75% and a reduction of exposure with a factor 5 is needed to bring the probability of exceedance below 5%. It is intended to lower the exposure limit to 1 mg m−3 by 1 January 2007. In that case the probability of exceedance of the OEL is 95% and a reduction of exposure with a factor 10 is needed to bring the probability of exceedance below 5%. This can be achieved by using alternative materials, preparation of building material in workshops equipped with exposure controls, alternative equipment and improved ventilation and good housekeeping.
- 1 September 2006
- Published by Wiley in Annals of the New York Academy of Sciences
- Vol. 1076 (1) , 429-438
Epoxy Resins in the Construction Industry
Abstract: Epoxy resins are used as coatings, adhesives, and in wood and concrete repair. However, epoxy resins can be highly irritating to the skin and are strong sensitizers. Some hardeners are carcinogenic. Based on the results of earlier Dutch studies, an international project on “best practices,”—Epoxy Code—with epoxy products was started. Partners were from Denmark, Germany, the Netherlands, and the UK. The “Code” deals with substitution, safe working procedures, safer tools, and skin protection. The feasibility of an internationally agreed “ranking system” for the health risks of epoxy products was studied. Such a ranking system should inform the user of the harmfulness of different epoxies and stimulate research on less harmful products by product developers.
- 1 September 2006
- Published by Wiley in Annals of the New York Academy of Sciences
- Vol. 1076 (1) , 429-438
Epoxy Resins in the Construction Industry
Abstract: Epoxy resins are used as coatings, adhesives, and in wood and concrete repair. However, epoxy resins can be highly irritating to the skin and are strong sensitizers. Some hardeners are carcinogenic. Based on the results of earlier Dutch studies, an international project on “best practices,”—Epoxy Code—with epoxy products was started. Partners were from Denmark, Germany, the Netherlands, and the UK. The “Code” deals with substitution, safe working procedures, safer tools, and skin protection. The feasibility of an internationally agreed “ranking system” for the health risks of epoxy products was studied. Such a ranking system should inform the user of the harmfulness of different epoxies and stimulate research on less harmful products by product developers.
- Open Access
- 15 June 2006
- Published by Oxford University Press (OUP) in Annals of Occupational Hygiene
- Vol. 50 (5) , 431-435
Occupational Hygiene in Africa
In an editorial 6 years ago, Hans Kromhout (1999) commented on the scarcity of occupational hygiene publications, which took into account developing countries, and looked forward to the 4th International Occupational Hygiene Association (IOHA) Conference in Cairns, where their problems were to be a major theme. In September 2005, the 6th IOHA Conference became the first IOHA Conference to be held in Africa, after three conferences in Europe, one in Asia and one in Australia. The conference, at Pilanesberg, South Africa, was an excellent opportunity to raise the profile of occupational hygiene in the African continent.
- 15 June 2006
- Published by Oxford University Press (OUP) in Annals of Occupational Hygiene
- Vol. 50 (5) , 431-435
Open AccessOccupational Hygiene in Africa
In an editorial 6 years ago, Hans Kromhout (1999) commented on the scarcity of occupational hygiene publications, which took into account developing countries, and looked forward to the 4th International Occupational Hygiene Association (IOHA) Conference in Cairns, where their problems were to be a major theme. In September 2005, the 6th IOHA Conference became the first IOHA Conference to be held in Africa, after three conferences in Europe, one in Asia and one in Australia. The conference, at Pilanesberg, South Africa, was an excellent opportunity to raise the profile of occupational hygiene in the African continent.
- 1 January 2005
- p. 37-42
The conditions and perception of work during painting behind screening.
This study attempted to reveal whether airborne solvent concentrations during painting behind screening are comparable to solvent concentrations during painting indoors, what factors potentially influence work conditions during painting behind screens, both positively and negatively, and what can be done to eliminate the disadvantages of screening. Measurements of volatile organic compounds (VOC), climate, light, and noise were made at three sites during 1 day each. VOC were measured at another 10 sites, again during 1 day each. Questionnaires were sent to painters working in 305 firms. The results of the first series of measurements (exposure to VOC) ranged from 3.4 to 22.9 mg/m3 with a geometric mean of 11.7 and a geometric standard deviation of 2.1. This range was less than the level expected in well-ventilated rooms. In the second series of measurements, with a few exceptions, the concentrations of the individual compounds were below 1 mg/m3. In both series, the exposure index was generally < or = 0.05. The advantages of working behind screening were more certainty of work during the winter months, better temperature conditions, better quality of work, less draft, and less temperature fluctuation. Painting behind screening, as studied in this project, results in low exposure to VOC when compared with indoor situations. The main factors that need to be improved are temperature, lighting, view from the workplace, and ventilation.
- 1 January 2005
- p. 37-42
The conditions and perception of work during painting behind screening.
This study attempted to reveal whether airborne solvent concentrations during painting behind screening are comparable to solvent concentrations during painting indoors, what factors potentially influence work conditions during painting behind screens, both positively and negatively, and what can be done to eliminate the disadvantages of screening. Measurements of volatile organic compounds (VOC), climate, light, and noise were made at three sites during 1 day each. VOC were measured at another 10 sites, again during 1 day each. Questionnaires were sent to painters working in 305 firms. The results of the first series of measurements (exposure to VOC) ranged from 3.4 to 22.9 mg/m3 with a geometric mean of 11.7 and a geometric standard deviation of 2.1. This range was less than the level expected in well-ventilated rooms. In the second series of measurements, with a few exceptions, the concentrations of the individual compounds were below 1 mg/m3. In both series, the exposure index was generally < or = 0.05. The advantages of working behind screening were more certainty of work during the winter months, better temperature conditions, better quality of work, less draft, and less temperature fluctuation. Painting behind screening, as studied in this project, results in low exposure to VOC when compared with indoor situations. The main factors that need to be improved are temperature, lighting, view from the workplace, and ventilation.