W. G. Weng
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
W. G. Weng has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
H.Y. Yuan
Center for Public Safety Research, Department of Engineering Physics Tsinghua University, Beijing, 100084, PR China
1 shared publicationR. Yang
Center for Public Safety Research, Department of Engineering Physics Tsinghua University, Beijing, 100084, PR China
1 shared publicationW. C. Fan
State Key Laboratory of Fire Science, University of Science and Technology of China, Hefei, Anhui, P.R. China, 230026
1 shared publicationW.C Fan
State Key Laboratory of Fire Science, University of Science and Technology of China, Hefei, Anhui PR230026, PR China
1 shared publication
Latest Publications
- 1 September 2007
- Published by SAGE Publications in Journal of Fire Sciences
- Vol. 25 (5) , 383-401
A New Approach for Predicting Flame Spread along Combustible Solid based on Cellular Automaton
In this study, a new approach for predicting flame spread along a combustible solid is developed. This presented approach consists of a two-dimensional flame spread model coupled with a one-dimensional pyrolysis model in the thickness direction. The flame spread model is based on a cellular automaton combined with piloted ignition temperature, spontaneous ignition temperature, and pyrolysis temperature of a combustible solid. In addition, this approach is used to predict two typical kinds of flame spread, i.e., upward flame spread and ceiling flame spread. The existing experimental data including the upward flame spread over plywood and the ceiling flame spread beneath medium density fiberboard (MDF) are used for comparison to validate this approach. The results obtained from numerical simulations using this approach are consistent with these two kinds of experimental tests.
- 1 September 2007
- Published by SAGE Publications in Journal of Fire Sciences
- Vol. 25 (5) , 383-401
A New Approach for Predicting Flame Spread along Combustible Solid based on Cellular Automaton
In this study, a new approach for predicting flame spread along a combustible solid is developed. This presented approach consists of a two-dimensional flame spread model coupled with a one-dimensional pyrolysis model in the thickness direction. The flame spread model is based on a cellular automaton combined with piloted ignition temperature, spontaneous ignition temperature, and pyrolysis temperature of a combustible solid. In addition, this approach is used to predict two typical kinds of flame spread, i.e., upward flame spread and ceiling flame spread. The existing experimental data including the upward flame spread over plywood and the ceiling flame spread beneath medium density fiberboard (MDF) are used for comparison to validate this approach. The results obtained from numerical simulations using this approach are consistent with these two kinds of experimental tests.
- 1 September 2004
- Published by Elsevier in Fire Safety Journal
- Vol. 39 (6) , 447-464
Nonlinear analysis of the backdraft phenomenon in room fires
- 1 September 2004
- Published by Elsevier in Fire Safety Journal
- Vol. 39 (6) , 447-464
Nonlinear analysis of the backdraft phenomenon in room fires
- 1 September 2003
- Published by Wiley in Process Safety Progress
- Vol. 22 (3) , 163-168
Mitigation of backdraft with water mist: A reduced‐scale experimental study
Backdraft is a special fire behavior in a limited‐ventilation building. It can develop from fires of either ordinary combustibles, or ignitable liquids that become oxygen‐starved, yet continue to generate a fuel‐rich environment. If abundant fresh air is abruptly supplied by opening a door or breaking a window, the hot gas in this vitiated building will rapidly combust and a fireball and blast wave will take place. Backdraft can occur abruptly with powerful destruction, which may cause fatalities and the collapse of buildings. In this paper, the results of a reduced‐scale experimental test series using water mist to mitigate backdraft are presented. This reduced‐scale compartment (length x width x height with 1.2 m x 0.6 m x 0.6 m) was fitted with a door end opening geometry (width x height with 0.2 m x 0.4 m). Water mist was generated by a downward‐directed pressure nozzle operated at pressure of 0.2 MPa. The experimental results show that water mist is an effective mitigating tactic able to suppress backdraft in a building fire, primarily by means of reducing unburned fuel mass fraction, rather than by a thermal mechanism of cooling.
- 1 September 2003
- Published by Wiley in Process Safety Progress
- Vol. 22 (3) , 163-168
Mitigation of backdraft with water mist: A reduced‐scale experimental study
Backdraft is a special fire behavior in a limited‐ventilation building. It can develop from fires of either ordinary combustibles, or ignitable liquids that become oxygen‐starved, yet continue to generate a fuel‐rich environment. If abundant fresh air is abruptly supplied by opening a door or breaking a window, the hot gas in this vitiated building will rapidly combust and a fireball and blast wave will take place. Backdraft can occur abruptly with powerful destruction, which may cause fatalities and the collapse of buildings. In this paper, the results of a reduced‐scale experimental test series using water mist to mitigate backdraft are presented. This reduced‐scale compartment (length x width x height with 1.2 m x 0.6 m x 0.6 m) was fitted with a door end opening geometry (width x height with 0.2 m x 0.4 m). Water mist was generated by a downward‐directed pressure nozzle operated at pressure of 0.2 MPa. The experimental results show that water mist is an effective mitigating tactic able to suppress backdraft in a building fire, primarily by means of reducing unburned fuel mass fraction, rather than by a thermal mechanism of cooling.