Teh-Liang Chen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Teh-Liang Chen has a total of 102 co-authors. Here are the top co-authors by number of shared publications:
- Hui-Min David Wang
National Chung Hsing University
3 shared publications Jau-Yann Wu
Department of Chemical Engineering, I‐Shou University, Ta‐Hsu Hsiang, Kaohsiung County 840, Taiwan
3 shared publicationsJau‐Yann Wu
Department of Chemical Engineering, I‐Shou University, Ta‐Hsu Hsiang, Kaohsiung County 840, Taiwan
3 shared publicationsChuh‐Yung Chen
Department of Chemical Engineering, National Cheng Kung University, Tainan 701, Taiwan
2 shared publicationsShu-Jen Chen
Department of Chemical Engineering, National Kaohsiung University of Applied Sciences, Kaohsiung 807, Taiwan
2 shared publications(The ARGO-YBJ Collaboration)
1 shared publication
Latest Publications
- Open Access
- 25 September 2014
- Published by American Astronomical Society in The Astrophysical Journal
- Vol. 794 (1) , 82
SEARCH FOR GeV GAMMA-RAY BURSTS WITH THE ARGO-YBJ DETECTOR: SUMMARY OF EIGHT YEARS OF OBSERVATIONS
The search for gamma-ray burst (GRB) emission in the energy range of 1-100 GeV in coincidence with the satellite detection has been carried out using the Astrophysical Radiation with Ground-based Observatory at YangBaJing (ARGO-YBJ) experiment. The high-altitude location (4300 m a.s.l.), the large active surface (~6700 m2 of Resistive Plate Chambers), the wide field of view (~2 sr, limited only by the atmospheric absorption), and the high duty cycle (>86%) make the ARGO-YBJ experiment particularly suitable to detect short and unexpected events like GRBs. With the scaler mode technique, i.e., counting all the particles hitting the detector with no measurement of the primary energy and arrival direction, the minimum threshold of ~1 GeV can be reached, overlapping the direct measurements carried out by satellites. During the experiment lifetime from 2004 December 17 to 2013 February 7, a total of 206 GRBs occurring within the ARGO-YBJ field of view (zenith angle θ ≤ 45°) have been analyzed. This is the largest sample of GRBs investigated with a ground-based detector. Two light curve models have been assumed and since in both cases no significant excess has been found, the corresponding fluence upper limits in the 1-100 GeV energy region have been derived, with values as low as 10–5 erg cm–2. The analysis of a subset of 24 GRBs with known redshift has been used to constrain the fluence extrapolation to the GeV region together with possible cutoffs under different assumptions on the spectrum.
- 25 September 2014
- Published by American Astronomical Society in The Astrophysical Journal
- Vol. 794 (1) , 82
Open AccessSEARCH FOR GeV GAMMA-RAY BURSTS WITH THE ARGO-YBJ DETECTOR: SUMMARY OF EIGHT YEARS OF OBSERVATIONS
The search for gamma-ray burst (GRB) emission in the energy range of 1-100 GeV in coincidence with the satellite detection has been carried out using the Astrophysical Radiation with Ground-based Observatory at YangBaJing (ARGO-YBJ) experiment. The high-altitude location (4300 m a.s.l.), the large active surface (~6700 m2 of Resistive Plate Chambers), the wide field of view (~2 sr, limited only by the atmospheric absorption), and the high duty cycle (>86%) make the ARGO-YBJ experiment particularly suitable to detect short and unexpected events like GRBs. With the scaler mode technique, i.e., counting all the particles hitting the detector with no measurement of the primary energy and arrival direction, the minimum threshold of ~1 GeV can be reached, overlapping the direct measurements carried out by satellites. During the experiment lifetime from 2004 December 17 to 2013 February 7, a total of 206 GRBs occurring within the ARGO-YBJ field of view (zenith angle θ ≤ 45°) have been analyzed. This is the largest sample of GRBs investigated with a ground-based detector. Two light curve models have been assumed and since in both cases no significant excess has been found, the corresponding fluence upper limits in the 1-100 GeV energy region have been derived, with values as low as 10–5 erg cm–2. The analysis of a subset of 24 GRBs with known redshift has been used to constrain the fluence extrapolation to the GeV region together with possible cutoffs under different assumptions on the spectrum.
- 1 July 2004
- Published by Elsevier in Biochemical Engineering Journal
- Vol. 19 (3) , 211-215
A modified osmotic shock for periplasmic release of a recombinant creatinase from Escherichia coli
- 1 July 2004
- Published by Elsevier in Biochemical Engineering Journal
- Vol. 19 (3) , 211-215
A modified osmotic shock for periplasmic release of a recombinant creatinase from Escherichia coli
- 12 May 2004
- Published by Elsevier in Journal of Membrane Science
- Vol. 238 (1-2) , 1-7
Abatement of concentration polarization in ultrafiltration using n-hexadecane/water two-phase flow
- 12 May 2004
- Published by Elsevier in Journal of Membrane Science
- Vol. 238 (1-2) , 1-7
Abatement of concentration polarization in ultrafiltration using n-hexadecane/water two-phase flow
- 17 September 2003
- Published by Wiley in Journal of Chemical Technology & Biotechnology
- Vol. 78 (11) , 1128-1134
Recovery of lipase by adsorption at then-hexadecane-water interface
- 17 September 2003
- Published by Wiley in Journal of Chemical Technology & Biotechnology
- Vol. 78 (11) , 1128-1134
Recovery of lipase by adsorption at then-hexadecane-water interface
- 31 May 2003
- Published by Elsevier in Biochemical Engineering Journal
- Vol. 14 (2) , 101-107
Effect of specific growth rate on the production of a recombinant nuclease by Escherichia coli
- 31 May 2003
- Published by Elsevier in Biochemical Engineering Journal
- Vol. 14 (2) , 101-107
Effect of specific growth rate on the production of a recombinant nuclease by Escherichia coli
- 1 January 2003
- Published by Wiley in Biotechnology Progress
- Vol. 19 (2) , 464-468
Recovery of Acinetobacter radioresistens Lipase by Hydrophobic Adsorption to n ‐Hexadecane Coated on Nonwoven Fabric
A simple and clean adsorption/desorption process was proposed for recovering Acinetobacter radio resisten s lipase from fermentation broth. The adsorbent used was n ‐hexadecane coated on a hydrophobic nonwoven fabric (NWF). n ‐Hexadecane has a melting point of 16–18 °C, and its affinity for lipase decreases markedly from liquid to solid state. Accordingly, performing the adsorption and desorption above and below, respectively, the melting point would need no extraneous materials for separation. The adsorption isotherms at various temperatures were found to follow the Langmuir model. Simulation of the batch adsorption/desorption process showed that there exists an optimal amount of adsorbent for both concentration factor and enzyme recovery; the process is restrained by equilibrium. The performance of column adsorption/desorption could also be simulated using the adsorption isotherm, and it was shown that the concentration factor was proportional to the amount of adsorbent used. The benefits of this process include easy preparation of adsorbent, low operational cost, no extraneous materials needed, negligible enzyme denaturation, high efficiency, and simple process simulation.
- 1 January 2003
- Published by Wiley in Biotechnology Progress
- Vol. 19 (2) , 464-468
Recovery of Acinetobacter radioresistens Lipase by Hydrophobic Adsorption to n ‐Hexadecane Coated on Nonwoven Fabric
A simple and clean adsorption/desorption process was proposed for recovering Acinetobacter radio resisten s lipase from fermentation broth. The adsorbent used was n ‐hexadecane coated on a hydrophobic nonwoven fabric (NWF). n ‐Hexadecane has a melting point of 16–18 °C, and its affinity for lipase decreases markedly from liquid to solid state. Accordingly, performing the adsorption and desorption above and below, respectively, the melting point would need no extraneous materials for separation. The adsorption isotherms at various temperatures were found to follow the Langmuir model. Simulation of the batch adsorption/desorption process showed that there exists an optimal amount of adsorbent for both concentration factor and enzyme recovery; the process is restrained by equilibrium. The performance of column adsorption/desorption could also be simulated using the adsorption isotherm, and it was shown that the concentration factor was proportional to the amount of adsorbent used. The benefits of this process include easy preparation of adsorbent, low operational cost, no extraneous materials needed, negligible enzyme denaturation, high efficiency, and simple process simulation.
- 1 October 2001
- Published by Wiley in Biotechnology and Bioengineering
- Vol. 76 (3) , 214-218
Production of Acinetobacter radioresistens lipase with repeated batch culture in presence of nonwoven fabric
Cultivation of Acinetobacter radioresistens on n‐hexadecane for lipase production was investigated with repeated batch culture in the presence of a hydrophobic nonwoven fabric. Lipase production followed the growth‐associated model, and the repeated batch culture could achieve both high enzyme yield and increased volumetric productivity. The fabric was shown to be able to disperse n‐hexadecane, to adsorb the unused hydrocarbon, and to retain bioemulsifiers excreted from the cells; therefore, it enhanced cell growth and, in turn, lipase production. In the repeated batch culture in the absence of the fabric, lipase yield and volumetric productivity were found to be 21 U/mL and 875 U/L · h, respectively. However, if the fabric was equipped in the fermentor, lipase yield and volumetric productivity increased to 30 U/mL and 2500 U/L · h, respectively. The lipase production profile could be further improved by raising the amount of nitrogen source and, as a result, a lipase yield of 54 U/mL and a volumetric productivity of 2250 U/L · h were obtained. In this study we assess the beneficial effects of nonwoven fabric on lipase production. © 2001 John Wiley & Sons, Inc. Biotechnol Bioeng 76: 214–218, 2001.
- 1 October 2001
- Published by Wiley in Biotechnology and Bioengineering
- Vol. 76 (3) , 214-218
Production of Acinetobacter radioresistens lipase with repeated batch culture in presence of nonwoven fabric
Cultivation of Acinetobacter radioresistens on n‐hexadecane for lipase production was investigated with repeated batch culture in the presence of a hydrophobic nonwoven fabric. Lipase production followed the growth‐associated model, and the repeated batch culture could achieve both high enzyme yield and increased volumetric productivity. The fabric was shown to be able to disperse n‐hexadecane, to adsorb the unused hydrocarbon, and to retain bioemulsifiers excreted from the cells; therefore, it enhanced cell growth and, in turn, lipase production. In the repeated batch culture in the absence of the fabric, lipase yield and volumetric productivity were found to be 21 U/mL and 875 U/L · h, respectively. However, if the fabric was equipped in the fermentor, lipase yield and volumetric productivity increased to 30 U/mL and 2500 U/L · h, respectively. The lipase production profile could be further improved by raising the amount of nitrogen source and, as a result, a lipase yield of 54 U/mL and a volumetric productivity of 2250 U/L · h were obtained. In this study we assess the beneficial effects of nonwoven fabric on lipase production. © 2001 John Wiley & Sons, Inc. Biotechnol Bioeng 76: 214–218, 2001.
- 1 January 2000
- Published by Springer Nature in Applied Biochemistry and Biotechnology
- Vol. 87 (2) , 73-80
Semicontinuous Production of Lipase by Acinetobacter radioresistens in Presence of Nonwoven Fabric
The effect of a hydrophobic nonwoven fabric on the lipase production by Acinetobacter radioresistens was investigated with semicontinuous culture. The fermentation medium contained n-hexadecane as the carbon source. The nonwoven fabric was made from nylon 6 and coated with an acrylic resin. Equipping the nonwoven fabric around the baffles of a 2.5-L agitated fermentor could provide a fine dispersion of n-hexadecane, thus enhancing lipase production. The improvement on lipase yield by using the nonwoven fabric was found to be comparable to that of using an emulsifier (gum arabic). Compared with the corresponding culture in the absence of nonwoven fabric, the employment of the nonwoven fabric could significantly enhance both lipase yield and volumetric productivity.
- 1 January 2000
- Published by Springer Nature in Applied Biochemistry and Biotechnology
- Vol. 87 (2) , 73-80
Semicontinuous Production of Lipase by Acinetobacter radioresistens in Presence of Nonwoven Fabric
The effect of a hydrophobic nonwoven fabric on the lipase production by Acinetobacter radioresistens was investigated with semicontinuous culture. The fermentation medium contained n-hexadecane as the carbon source. The nonwoven fabric was made from nylon 6 and coated with an acrylic resin. Equipping the nonwoven fabric around the baffles of a 2.5-L agitated fermentor could provide a fine dispersion of n-hexadecane, thus enhancing lipase production. The improvement on lipase yield by using the nonwoven fabric was found to be comparable to that of using an emulsifier (gum arabic). Compared with the corresponding culture in the absence of nonwoven fabric, the employment of the nonwoven fabric could significantly enhance both lipase yield and volumetric productivity.
- 5 February 1999
- Published by Wiley in Biotechnology and Bioengineering
- Vol. 62 (3) , 311-316
Effect of oxygen transfer on lipase production byAcinetobacter radioresistens
- 5 February 1999
- Published by Wiley in Biotechnology and Bioengineering
- Vol. 62 (3) , 311-316
Effect of oxygen transfer on lipase production byAcinetobacter radioresistens